• Korean journal of food and cookery science
• /
• v.31 no.3
• /
• pp.248-254
• /
• 2015

We conducted this study to investigate the amount of RS and cooking characteristics of the commercial extrusion-cooked noodles. Ten kinds of noodles were selected and grouped according to the storage conditions; dry noodles (3), refrigerated noodles (2), freeze noodles (4), and dry noodle made from wheat flour as a control (not extrusion-cooked). The total starch of commercial noodles ranged from 62.50% to 84.13%, Refrigerated Naengmyeon and dry Dangmyun had high proportions of total starch (respectively 84.13% and 80.13%, respectively). The amounts of apparent amylose ranged from 25.01% to 42.93% and RS ranged from 0.61% to 5.99%. A high proportion of the total starch was rendered digestible by extrusion cooking, and a small amount of RS remained in the samples. Dry Dangmyun had the highest percentages of RS (5.99%), followed by refrigerated Naengmyeon C (2.41%) and dry Jjolmyeon (1.94%), and those of the other noodles were lower than that of the control (1.86%). Cooking properties and texture measurements were evaluated. Cooking loss and turbidity of cooking water were highest in dry Jjolmyeon and dry Naengmyeon. There was little cooking loss in dry Dangmyun and freeze rice noodles. In particular, dry Dangmyun and refrigerated Naengmyeon C containing high amounts of RS and amylose had relatively high measurements of hardness and tensile strength.

• Korean Journal of Food Science and Technology
• /
• v.22 no.6
• /
• pp.651-658
• /
• 1990

Starch phosphates were prepared by dry heating, gelatinizing method and extrusion process using sodium tripolyphosphote (STPP) as a substitution reagent and their physicochemical properities were compared. In the preparation of starch phosphate by dry heating method(DSP), the effect of reaction temperature was the most significant to the DS(Degree of substitution). In the phosphorylation reaction with gelatinized starch(GSP), the substitution ratio was increased with increasing the reaction temperature, but the increase was insignificant above $85^{\circ}C$. By extrusion with the corn starch containing 2.0% STPP at various moisture contents of 20, 25 and 30%, the DS values of extrudate(WESP) were within the range of between 0.0066 and 0.0083. The starch phosphate(DSP) products showed lowering the gelatinization temperature, increasing the clarity of the starch paste. However, WESP showed higher gelatinization temperature than that of raw starch. The starch phosphate prepared by extrusion process showed lower apparent viscosity of paste than that of the DSP at same condition. All of starch phosphates showed reducing the tendency of the paste retrogradation.

• Proceedings of the Korea Concrete Institute Conference
• /
• 2006.11a
• /
• pp.441-444
• /
• 2006

Extrusion molding concrete panel is cured two times, that is the steam curing at atmospheric pressure and a high-pressure steam curing(autoclaving). Steam curing at atmospheric pressure is done before autoclaving and to acquire the proper strength for treat in process. Though this curing is the important factor on the quality of product and the speed in manufacturing process, it was not evaluated properly so far. Because of ignorance about curing, some engineers even think that the dry curing is better than the steam curing. This study is to investigate the properties of specimen according to variation of curing conditions in the coring chamber such as laboratory scale, pilot plant, and commercial plant. As estimating, in case of steam curing at atmospheric pressure to make extrusion molding concrete panel, moisture curing is better than dry curing and the desirable maximum temperature in curing chamber is about $50^{\circ}C$.

• Animal Bioscience
• /
• v.37 no.6
• /
• pp.1085-1095
• /
• 2024

Objective: The main objective of this study was to determine available energy and nutritional digestibility of extruded cereals and the effect of extrusion on the nutritional value of feed ingredients, aiming to provide scientific basis for efficient application of extrusion in the diets of growing pigs. Methods: In Exp. 1, 48 crossbred growing pigs (Duroc×Landrace×Yorkshire) with an initial body weight (BW) of 34.6±2.2 kg were selected and fed with eight diets (non-extrusion or extrusion) to determine the digestible energy (DE), metabolizable energy (ME), and nutrients digestibility. Eight diets included extruded grains (barley, wheat, sorghum, or broken rice), while four had unprocessed grains. In Exp. 2, 9 diets were formulated including 4 cereals with extrusion or non-extrusion and a N-free diet. In addition, 9 growing pigs (BW = 22.3±2.8 kg) were fitted with T-cannula in the distal ileum and arranged in a 9×6 Youden square design. Results: Results show that apparent total tract digestibility of gross energy, dry matter, organic meal, ether extract, neutral and acid detergent fiber was not affected by the extrusion process and there was no interaction between cereal type and extrusion treatment on DE, ME. However, the apparent total tract digestibility for crude protein (CP) increased markedly (p<0.05). The standardized ileal digestibility (SID) of all amino acids (AA) except for leucine remarkably increased by extrusion (p<0.05). There was an interaction on the SID of arginine, leucine, isoleucine, methionine, phenylalanine, cystine, and tyrosine in growing pigs between type of grain and extrusion treatment (p<0.05). Conclusion: Extrusion increased the ileal digestibility of CP and most AA in cereals, however, the DE and ME of cereals were not affected in growing pigs.

• Korean Journal of Food Science and Technology
• /
• v.26 no.1
• /
• pp.98-101
• /
• 1994

The amount of added water for rice cooking was determined by extrusion test and sensory evaluation of cooked rice. The extrusion force was positively correlated with hardness and negatively correlated with moisture content and wetness of cooked rice. The extrusion force and moisture content of cooked rice were 57.9 kg and 62.3% respectively at the 'medium' wetness (neither too hard and dry nor too soft and watery) of cooked rice. The optimum water to rice ratio for the cooked rice haying 'medium' wetness was 1.46.

• Proceedings of the Korea Concrete Institute Conference
• /
• 2006.05b
• /
• pp.49-52
• /
• 2006

Extrusion concrete panel is made by extrusion of high viscosity paste. The high viscosity paste is made by mix of cement, silica, reinforced fiber and thickening agent in the dry mixer and wet mixer subsequently, extrusion in the extruder, and curing in the normal steam curer and high pressure steam curer subsequently. To increase a flexural strength of the panel, it is used inorganic fiber as like asbestos. But it was known that the asbestos was harmful to human being lately, in the domestic area it is restricted usage in the construction materials. So, it is demanded the alternative material for asbestos in the extrusion concrete panel. This study is to investigate that the sepiolite is possible to be the alternative of asbestos. The 3 types of sepiolite is applied to the extrusion concrete panel. To investigate the properties of the panel with sepiolite, it is compared the control with asbestos in the flexural strength, the specific density and the spot compressive strength. From the test results, it was found that the panel with sepiolite B is higher than the control with asbestos in the flexural strength and in the density.

• Proceedings of the Korean Society for Technology of Plasticity Conference
• /
• 2009.10a
• /
• pp.354-357
• /
• 2009

The effect of texture of an extruded OFHC Cu rod on its sliding wear has been explored. Disk specimens with three different orientations were machined from the Cu rod for the wear test; surfaces of the disk were perpendicular ($0^{\circ}$), inclined with a specific angle ($45^{\circ}$), and parallel ($90^{\circ}$) to the extrusion axis of the rod. The texture was analyzed using an X-ray goniometer by measuring {111}, {200}, and {220} pole figures of each specimen. The analyzed texture was correlated with wear-test results of the Cu specimen. Dry sliding wear tests were performed at room temperature using a pin-on-disk wear tester against an Al2O3 ball. Applied load, sliding distance, sliding speed were fixed as 20 N, 200 m, and 0.5 m/sec, respectively. The $45^{\circ}$-inclined (to the extrusion axis) disk specimen showed the lowest wear resistance with the least data scatters. It has been found that distribution of cube texture strongly influences wear rate of the extruded Cu rod.

• Asian-Australasian Journal of Animal Sciences
• /
• v.5 no.3
• /
• pp.571-582
• /
• 1992

Soybeans were dry extruded at three different temperatures (125, 135 and $145^{\circ}C$) for 30 s. Four lambs fitted with cannulae in the rumen and abomasums were used in a balanced $4{\times}4$ Latin square design. Lambs were fed at 2 h intervals for 12 times a day with automatic feeder to maintain steady state conditions in digestive tract. A dual-phase marker system was used to estivate ruminal flow rate of both liquid and solid digesta. Objectives of this study were to determine the effect of extrusion temperature of raw soybean on the ruminal liquid and solid dilution rate, nitrogen digestion and flow at the abomasum and availability of amino acid in lambs. There were no significant effects of extrusion on liquid and solid dilution rate, and liquid volume. Ruminal liquid flow rate was not influenced by extrusion and ranged from 389 to 435 ml/hr. Extrusion had no influence on ruminal OM digestion and flow rate to the abomasums. Dietary N flow to the abomasums increased (p < 0.05) as extruding temperature increased. Extruding temperature had a significant effect (p < 0.05) on flow of N escaping ruminal degradation and ranged from 34.91 to 57.38%. Microbial N synthesized/kg OMTDR ranged from 27 to 37 g and highest with $145^{\circ}C$ ESB diet. Extrusion decreased the amount of degradable amino acid in the rumen and increased the supply of amino acid to the lower gut, especially with 135 and $145^{\circ}C$ ESB diets.

• Asian-Australasian Journal of Animal Sciences
• /
• v.12 no.5
• /
• pp.783-787
• /
• 1999

To study the effects of different extrusion conditions of barley on growth performance, nutrient digestibility and nutrient excretion in feces, a total of 150 growing pigs ($Landrace{\times}Duroc{\times}Large$ White; average 24.4 kg body weight) were allotted to five treatments, in a completely randomized block design. The experimental diets were based on corn-soybean and 30% of barley was included in each diet; barley was the only extruded ingredient. The treatments were 1) no extrusion (Control); 2) extrusion at $100^{\circ}C$ without preconditioning (ENLT); 3) extrusion at $150^{\circ}C$ without preconditioning (ENHT); 4) extrusion at $100^{\circ}C$ with preconditioning (ECLT); 5) extrusion at $150^{\circ}C$ with preconditioning (ECHT). Temperature in the barrel was controlled within ${\pm}5^{\circ}C$ by feed rate with the addition of water at the rate of $3{\ell}\;per\;min$. in the extruder for each treatment. For the 6 week experimental period, extrusion of barley improved the average daily gain (ADG) and digestibilities of dry matter, crude protein and gross energy in growing pigs. As compared to control, significant improvements in ADG (p<0.05) were shown in the groups of feeding extruded barley at high temperature (ENHT and ECHT). There were also significant differences in the digestibilities of DM, CP and P between extrusion temperatures. Barley extruded at high temperature gave better digestibilities of DM, CP and GE than barley extruded at low temperature. Extruded barley diet groups showed significantly (p<0.05) lower excretions of DM, nitrogen (N) and P per kg gain as compared to the ground barley group. DM, N and P excretion per kg gain were also significantly lower in pigs fed barley extruded at $150^{\circ}C$ than at $100^{\circ}C$. In conclusion, extrusion considerably improved the nutritive value of barley and it appeared that temperature is the most important variable.

• Korean Journal of Poultry Science
• /
• v.17 no.4
• /
• pp.284-295
• /
• 1990

Dietary levels of 0%, 0225%, 0.45% inorganic phosphorus in the form of tricalcium phosphate were included in two different experimental diets, which contains 40% of wheat bran with or without extrusion. It is to examine the effects of extruded wheat bran containing different Bevels of inorganic phosphorus on the performance of broiler chicks, including the nutrient availabilities, compared with that of the diet containing non－extruded wheat bran. The results are as follows； 1. Regardless dietary levels of inorganic phosphorus, the weight gain in general was higher for the groups fed non－extruded wheat bran but little significance was seen between the groups of extruded and the non－extruded. However, the effect of dietary inclusion of inorganic phosphorus on the weight gain was evident and the gain was higher in the groups receiving the higher levies of inorgainc phosphorus but failed to observe the significant difference between the added groups of 0.225% and 0.45% of inorganic phosphorus, suggesting that a considerable amount of phytin phosphorus in wheat bran is available to meet the requirement. 2. For the feed intake, there was a tendency for the groups fed extruded wheat bran consuming more feed, compared with that of the non－extruded but little significance was observed. This was also true between the groups of receiving 0.225% and 0.45% inorganic phosphorus t The feed efficiency was improved by the addition of inorgainc phosphorus, but failed to observe the significance between the added groups. 4. The dry matter digestibility was improved in proportion to increasing the levels of inorganic phosphorus for the both groups of extruded and the non－extruded This indicates that addition of extruded wheat bran has little effects on improving the digestibility. 5. Within the added groups of 0.225% and 0.45% inorganic phosphorus, the protein digestibility was increased with including the extruded wheat bran in the diet However, the effect on body weight gain was not evident. 6. The calcium and phosphorus content of tibia was shown the tendency of increasing with increasing the dietary levels of inorganic phosphorus but close correlation with dietary levels of inorganic phosphorus was not noted in tibia contents of calcium and phosphorus.