• Journal of Power Electronics
• /
• v.12 no.6
• /
• pp.992-1002
• /
• 2012

In this paper, the series chopper based power train for electric vehicle is proposed for aiming the increase of one battery charge driving distance. Both the motor test bench based experiments and the chassis dynamo based experiments are tested and then analyzed for EV driving performance that the proposed power train with SAZZ chopper and Quasi-PAM control scheme is compared with or without the series chopper. It is confirmed through two kinds of experimental analyses that the series chopper power train for EV can be useful to extend the driving distance if the high efficiency and the low weight of chopper are satisfied.

• Journal of Hydrogen and New Energy
• /
• v.29 no.6
• /
• pp.661-667
• /
• 2018

Electric vehicles are taken a long time to charge and are restricted driving where charging infrastructure was not sufficiently constructed. The vehicle developed to solve these problems is a plug-in hybrid vehicle. It is possible to drive a certain distance by using electric motor and when the battery runs out, it operate the engine. Plug-in hybrid vehicle have a complicated structure and a lot of parts comparing a general vehicle because the electric parts and the internal combustion engine are installed together. Therefore, as the aging (mileage) of the plug-in hybrid vehicle, the influence which change of fuel consumption is expected to be larger than a general vehicle, but an experimental data are lacking. In this paper, we cumulate a mileage of the plug-in hybrid vehicle about 15,000 km and measured the fuel economy when the cumulated distance reached within 160 km, 6,500 km, 15,000 km respectively, by using domestic public test method. For measuring fuel economy of the vehicle, CD mode (driving distance on a single charge) which use only motor and the CS mode which operate motor and combustion engine were measured respectively. As a result, the fuel economy slightly increased at cumulated mileage of 6,500 km compared to the 160 km and the fuel economy of 15,000 km was similar to 160 km.

• Journal of the Korean Applied Science and Technology
• /
• v.38 no.1
• /
• pp.1-8
• /
• 2021

The purpose of this study was to analyze relationship between biomechancal factors and diver's distance during golf driver swing. Fifteen professional golfers were participated in as subject. Eight motion capture cameras(250 Hz), 2 force plates(1000 Hz), and Trackman were used to collect kinematic and kinetic datas. It was performed Pearson's correlation analysis using SPSS 24.0. The level of significance was at .05. Ball speed, club head speed, X-Factor, and ground reaction force were correlated on driving distance, However, smash factor and knee moment were not correlated on driving distnace. Ball speed, club head speed, X-Factor, and ground reaction force were effected to driving distance, but smash factor and knee moment were not effected to driving distance.

• The Transactions of The Korean Institute of Electrical Engineers
• /
• v.65 no.1
• /
• pp.150-157
• /
• 2016

In this paper, a control system for E-bike based on IOT was developed, which collects and monitors information of states of E-bike and surrounding environments from several sensors and control devices in E-bike, and informs the possible dangers to rider when riding the E-bike. Developed electronic control system can manage battery efficiently, obtain battery's remaining power in real-time and provide possible riding distance to rider. It makes possible for rider to schedule near optimal riding route in terms of battery usage and respond quickly to battery discharge. Results of applying developed system to E-bike show that according to driving-mode, possible driving distance can be calculated efficiently and using user application App, real-time driver position marking and driving route searching functions lead to energy efficient E-bike driving. Later we will endeavor to integrate BMS, ECU, smart-phone and PC(server) to provide stable driving system based on various driving information of E-bike.

• KSCE Journal of Civil and Environmental Engineering Research
• /
• v.14 no.5
• /
• pp.999-1011
• /
• 1994

Driving maneuvers in car-following are affected not only by the factors related to road and traffic conditions, but also by factors related to drivers' cognition to them. This paper attempts to analyse drivers' car-following distance tests on road characteristics. Driving maneuvers are directly observed by video recorder sets in the vehicle. At the same time drivers are interviewed about their cognitive degree of car-following distance according to a given level of cognitive language. As a result, linguistical cognition of car-following distance is well fitted in with Weber-Fechner's law. This paper suggests a modeling method that takes into account the driver's cognition for acquiring traffic visible information on driving maneuver.

• Journal of Institute of Control, Robotics and Systems
• /
• v.21 no.7
• /
• pp.621-626
• /
• 2015

This paper presents a camera calibration method in order to estimate the lane detection and inter-vehicle distance estimation system for an automotive safety driving system. In order to implement the lane detection and vision-based inter-vehicle distance estimation to the embedded navigations or black box systems, it is necessary to consider the computation time and algorithm complexity. The process of camera calibration estimates the horizon, the position of the car's hood and the lane width for extraction of region of interest (ROI) from input image sequences. The precision of the calibration method is very important to the lane detection and inter-vehicle distance estimation. The proposed calibration method consists of three main steps: 1) horizon area determination; 2) estimation of the car's hood area; and 3) estimation of initial lane width. Various experimental results show the effectiveness of the proposed method.

• Journal of Hydrogen and New Energy
• /
• v.28 no.1
• /
• pp.56-62
• /
• 2017

Although most electricity production contributes to air pollution, the vehicle organizations and environmental agency categorizes all EVs as zero-emission vehicles because they produce no direct exhaust or emissions. Currently available EVs have a shorter range per charge than most conventional vehicles have per tank of gas. EVs manufacturers typically target a range of 160 km over on a fully charged battery. The energy efficiency and driving range of EVs varies substantially based on driving conditions and driving habits. Extreme outside temperatures tend to reduce range, because more energy must be used to heat or cool the cabin. High driving speeds reduce range because of the energy required to overcome increased drag. Compared with gradual acceleration, rapid acceleration reduces range. Additional devices significant inclines also reduces range. Based on these driving modes and climate conditions, this paper discusses the performance characteristics of EVs on energy efficiency and driving range. Test vehicles were divided by low / high-speed EVs. The difference of test vehicles are on the vehicle speed and size. Low-speed EVs is a denomination for battery EVs that are legally limited to roads with posted speed limits as high as 72 km/h depending on the particular laws, usually are built to have a top speed of 60 km/h, and have a maximum loaded weight of 1,400 kg. Each vehicle test was performed according to the driving modes and test temperature ($-25^{\circ}C{\sim}35^{\circ}C$). It has a great influence on fuel efficiency amd driving distance according to test temperature conditions.

• Transactions of the Korean Society of Automotive Engineers
• /
• v.24 no.6
• /
• pp.635-641
• /
• 2016

Regenerative braking performance of an electrically powered vehicle is closely related to driving distance per battery charge. An electric vehicle uses appropriate amounts of mechanical braking force and electromagnetic regenerative braking force to recover energy and increase driving efficiency. In particular, when it drives on a downhill road, energy recovery rate is maximized through regenerative braking during coasting based on the mass inertia of the vehicle. Since an electric two-wheeled vehicle covered in this paper is lighter than an electric four-wheeled vehicle, the improvement of its driving distance per battery charge through regenerative braking is different from an electric four-wheeled vehicle. This study compared the driving characteristics of an electric two-wheeled vehicle based on regenerative braking. Two driving test modes were simulated with a chassis dynamometer system. By analyzing the measurement of a chassis dynamometer, the driving characteristics of a two-wheel electric vehicle, such as driving efficiency, were analyzed. In addition, test results were reviewed to draw the limitations of conventional test methods for regenerative braking performance of an electric two-wheel vehicle.

• Journal of Mechanical Science and Technology
• /
• v.18 no.1
• /
• pp.132-144
• /
• 2004

This paper presents a new method driving multiple robots to their goal position without collision. To consider the movement of the robots in a work area, we adopt the concept of avoidability measure. The avoidability measure figures the degree of how easily a robot can avoid other robots considering the velocity of the robots. To implement the concept to avoid collision among multiple robots, relative distance between the robots is proposed. The relative distance is a virtual distance between robots indicating the threat of collision between the robots. Based on the relative distance, the method calculates repulsive force against a robot from the other robots. Also, attractive force toward the goal position is calculated in terms of the relative distance. These repulsive force and attractive force are added to form the driving force for robot motion. The proposed method is simulated for several cases. The results show that the proposed method steers robots to open space anticipating the approach of other robots. In contrast, since the usual potential field method initiates avoidance motion later than the proposed method, it sometimes fails preventing collision or causes hasty motion to avoid other robots. The proposed method works as a local collision-free motion coordination method in conjunction with higher level of task planning and path planning method for multiple robots to do a collaborative job.

• The Journal of The Korea Institute of Intelligent Transport Systems
• /
• v.20 no.1
• /
• pp.146-159
• /
• 2021

vehicle simulator as part of an empirical analysis the driving characteristics of elderly drivers. To this end, the driving characteristics of the elderly driver from previous study review. he driving characteristics of the elderly the driving elderly driver and general driverIn summarizing these experimental results, the -test showed different driving characteristics from general drivers in all items except for one side of the lane, such as driving speed and driving operation (brake, throttle, steering operation) at a significance level of 95%. Second, when changing lanes, it was difficult for elderly driver to maintain speed and secure an appropriate distance between carslderly driver changed lanes even in inappropriate situations (short distances between cars). Third, in unexpected situation, elderly drivers needed more distance and time.