• 전자공학회논문지D
• /
• 제34D권5호
• /
• pp.45-51
• /
• 1997

Low temperature activation of dopants which were doped using ion mass doping system in amorphous silicon(a-Si) thin films was investigated. With a 20.angs.-thick Ni film on top of the a-Si thin film, the activation temperature of dopants lowered to 500.deg. C. When the doping was performaed after the deposition of Ni thin film on the a-Si thin films (post-doping), the activation time was shorter than that of dopants mass, the activation time of the dopants doped by pre-doping method increased. It turned NiSi2 formation, while the decrease of activation time was mainly due to the enhancement of the NiSi2 formation by mixing of Ni and a-Si at the interface of Ni and a -Si thin during the ion doping process.

• 한국전기전자재료학회:학술대회논문집
• /
• 한국전기전자재료학회 2007년도 추계학술대회 논문집
• /
• pp.68-69
• /
• 2007

To make cost-effective solar cells, We have to use low cost material or make short process time or high temperature process. In solar cells, formation of emitter is basic and important technique according to build-up P-N junction. Diffusion process using spin-on dopants has all of this advantage. In this paper, We investigated n+ emitter formation spin-on dopants to apply crystalline silicon solar cells. We known variation of sheet resistance according to variation of temperature and single-crystalline and multi-crystalline silicon wafer using Honeywell P-8545 phosphorus spin-on dopants. We obtain uniformity of sheet resistance within 3~5% changing RPM of spin coater.

• 한국정보디스플레이학회:학술대회논문집
• /
• 한국정보디스플레이학회 2008년도 International Meeting on Information Display
• /
• pp.1311-1314
• /
• 2008

We have developed new electrical dopants of rhenium oxide ($ReO_3$) and cupper iodide (CuI) as p-dopants and rubidium carbonate ($Rb_2CO_3$) as an n-dopant, respectively. $ReO_3$ has advantage of low temperature evaporation (about $300^{\circ}C$) with enhanced device stability. Various kinds of high performance organic light emitting diodes have been realized, including bottom emission, tandem, and top-emission OLEDs.

• 한국해양공학회지
• /
• 제13권2호통권32호
• /
• pp.35-40
• /
• 1999

Effects of CuO addition on the sintering ability and the phase stability of Y-TZP. (Yttria doped Tetragonal Zirconia Polycrystals) were studied. The CuO dopants were found to be quite effective in reducing the sintering temperature to obtain full density and refining the grain size. The maximum allowable concentration of the dopants was limited to 0.3%mol% for CuO to maintain fully tetragonal phase. With the addition of these dopants, the flexual strength decreased by 20% in comparison with the undoped specimen but the fracture toughness increased by 15%.

• Bulletin of the Korean Chemical Society
• /
• 제24권1호
• /
• pp.49-54
• /
• 2003

TiO₂nanoparticles were synthesized using the metallorganic chemical vapor deposition process. Particles with and without metal ion dopants were obtained. X-ray photoelectron and energy dispersive X-ray spectroscopic measurements confirmed the stoichiometry of the TiO₂nanoparticles. X-ray diffraction patterns showed a polycrystalline anatase structure of TiO₂. Transmission electron microscopy revealed that these particles are of nanoscale dimensions. Exact particle size and size distribution analyses were carried out by dynamic light scattering. The average particle size was determined to be 22 nm. The nanosize particles provided large surface area for photocatalysis and a large number of free surface-charge carriers, which are crucial for the enhancement of photocatalytic activity. To improve the photocatalytic activity, metal ions, including transition metal ions $(Pd^{2+},\;Pt^{4+},\;Fe^{3+})$ and lanthanide ion $(Nd^{3+})$ were added to pure TiO₂nanoparticles. The effects of dopants on photocatalytic kinetics were investigated by the degradation of 2-chlorophenol under an ultraviolet light source. The results showed that the TiO₂nanoparticles with the metal ion dopants have higher photocatalytic activity than undoped TiO₂. The $Nd^{3+}$ ion of these dopant metal ions showed the highest catalytic activity. The difference in the photocatalytic activity with different dopants is related to the different ionic radii of the dopants.

• 한국자기학회:학술대회 개요집
• /
• 한국자기학회 1996년도 추계연구발표회 논문개요집
• /
• pp.94-95
• /
• 1996

• Membrane and Water Treatment
• /
• 제7권6호
• /
• pp.539-553
• /
• 2016

As a novel hydrophobic monomer, polytetrahydrofuran diacrylate (PTMGDA) was synthesized by the esterification reaction between polyethylene tetrahydrofuran (PTMG) and acryloyl chloride (AC). In situ free radical polymerization reaction method was utilized to fabricate poly (vinylidene fluoride) (PVDF)-PTMGDA-poly(ethylene oxide) dimethacrylate (PEGMA) ulrafiltration (UF) membranes. The performances of PVDF-PTMGDA-PEGMA UF membranes in terms of morphologies, mechanical properties, separation properties and hydrophilicities were investigated. The introduction of the PTMGDA-PEGMA dopants not only increased the membranes' pure water flux, but also improved their mechanical properties and the dynamic contact angles. The addition of the PTMGDA/PEGMA dopants led to the formation of the finger-like structure in the membrane bulk. With the increase concentration of PTMGDA/PEGMA dopants, the porosity and the mean effective pore size increased. Those performances were coincide with the physicochemical properties of the casting solutions.

• 한국전기전자재료학회논문지
• /
• 제22권9호
• /
• pp.724-727
• /
• 2009

We have fabricated (Ba,Sr)TiO3$TiO_3$ thick films doped with various amount of ZnBO dopants (1, 3, and 5 wt%) by screen printing method on the alumina substrates, which were sintered at the temperature below $1200^{\circ}C$. With increasing the amount of ZnBO dopants, the relative dielectric permittivity of ZnBO doped (Ba,Sr)$TiO_3$ was decreased, while loss tangent was increased. 1 wt% ZnBO doped (Ba,Sr)$TiO_3$ thick film has relative dielectric permittivity of 759 at 1 MHz, while 3 and 5 wt% of ZnBO doped (Ba,Sr)$TiO_3$ thick films have 624 and 554, respectively. By introducing ZnBO dopants to the (Ba,Sr)$TiO_3$ thick films, leakage current densities were decreased. The decreased leakage current with increasing ZnBO dopants can be explained by increased density and grain size of thick film on alumina substrate. We believe this decreased leakage current density probably come from the increased grain size and increased density.

• 전기화학회지
• /
• 제6권2호
• /
• pp.134-140
• /
• 2003

기능성 도판트인 dodecylbenzensulfonic acid(DBSA)와 혼합도판트{(DBSA와 $LiClO_4$, NSA(2-naphthalenesulfonic acid), DEHSA[di(2-ethylhexyl)sulfosuccinic acid]}를 사용하여 전기화학적방법에 의한 연신성 폴리피롤(Ppy-DBSA, Ppy-mixed dopants)필름을 제조하였다. 전기화학적 방법에 의해 제조된 폴리피를 괼름은 zone drawing방법을 사용하여 1.0-2.5배 연신시킬 수 있었으며, 연신된 폴리피롤 필름의 전기전도도를 측정하였다. 연신율이 증가함에 따라 필름의 전기전도도가 증가함을 볼 수 있었다. 이 현상은 연신율에 따른 결정성 증가로 설명 할 수 있었다. 1.0-2.5배 연신된 폴리피를 필름(Ppy-DBSA, Ppy-mixed dopants)을 온도변화에 따른 전하 이동 경로는 모두 power raw에 적합함을 볼 수 있었다.

• 청정기술
• /
• 제21권1호
• /
• pp.12-21
• /
• 2015

전도성 고분자를 이용한 새로운 기능성 재료의 개발은 에너지, 환경, 나노 기술 분야 발전에 크게 기여할 것으로 기대를 모으고 있다. 최근에는 전도성 고분자에 기능성 도펀트(functional dopant)를 삽입하여 고성능화에 초점을 맞춘 연구들이 많이 수행되고 있다. 본 총설은 새로운 전도성 고분자 합성의 관점으로 쓰여진 다른 문헌들과 달리, 삽입되는 기능성 도펀트의 역할과 응용 분야를 중심으로 서술하였다. 대표적인 기능성 도펀트의 종류로는 산화환원 활성(redox-active) 분자, 카본나노물질, 바이오물질, 킬레이팅(Chelating) 분자 등이 있으며, 각각의 도펀트의 고유한 특징에 따라 베터리, 수처리용 분리막, 센서 등 다양한 분야에 활용될 수 있다. 본 총설에서는 각각의 기능성 도펀트가 첨가 되었을 때 장점과 응용 방향에 대해 살펴 보고, 전도성 고분자의 안정성 향상을 위한 방법과 고려해야 할 점들에 대하여 제안하고자 한다.