• Korean Journal of Soil Science and Fertilizer
• /
• v.43 no.1
• /
• pp.90-95
• /
• 2010

The application of livestock manure to cropland is a practice that has been used for centuries. Agricultural crops can utilize nutrients from manure, and the producer can utilize land for disposal, although in a "sustainable system" the concept is manure utilization and not waste disposal. However, meeting regulatory criteria regarding microbial quality remains an expensive and time consuming process. The purpose of this study was to quantify the level of environmental impact of soil moisture and temperature on fecal coliform (Escherichia coli or E. coli) survival in upland soils for sound application of livestock manure. Samples were collected up to 30 days depending on the given conditions. The inactivation rate of E. coli increased linearly with increased temperature while the inactivation rate gradually decreased with decreased soil moisture level. The overall findings of this study showed that the temperature was the limited factor on E. coli survival in soils over soil moisture content. This study will provide useful and practical guidelines to applicators of soil in deciding appropriate handling and time frames for land application for sustainable agriculture.

• Journal of the Korean GEO-environmental Society
• /
• v.6 no.2
• /
• pp.51-60
• /
• 2005

The disposal problem of waste lime which is a residual product of lime industry have caused a lots of arguments in the past few years. Further more, waste lime contains a high moisture content which causes the disposal of waste lime is a great difficulty. The purpose of this study is to investigate for the effective dewatering solutions by placing various prefabricated vertical drains. The moisture content and degree of consolidation, pore water pressure, changes of settlement, bearing capacity with various vertical drains in waste lime were analyzed. The laboratory test results indicate that PBD is 2 times higher than circular drain in coefficient of consolidation. Based on the laboratory test results, settlement, pore water pressure, and dewatering measurements are shown in similar tendency. It is considered that PBD can drain primitive pore water much efficiently. The picture of SEM shows that circular drain filter has a serious clogging problem in comparison with PBD. In conclusion, PBD holds a superiority in waste lime's ground improvement and dewatering pore water pressure from the waste lime sludge. Also, circular drain is desired for some modification in its filtering system.

• Journal of the Korea Academia-Industrial cooperation Society
• /
• v.12 no.2
• /
• pp.985-992
• /
• 2011

The 3D computational fluid dynamics (CFD) was performed in relation to the internal fluid characteristics and flow distribution for the development of the most optimal model in the complex post-disposal device. As it is expected that a channeling (drift) would be made by the semi-dry reactor due to the large difference in the flow distribution by the compartment in the bag filter, a structural improvement should be urgently made for more uniformed flow distribution in the bag filter. Three types of modifications such as i) changing the plenum shape, ii) orifice install in the exit part of cleaned gas, iii) increasing the plenum number were established. From the results of computational fluid dynamics, it was revealed that the changing of plenum shape and orifice install in the exit part of cleaned gas was more reasonable than the increasing the plenum number because of the difficulties of retrofit. The complex post-disposal device, modified and supplemented with this analysis, integrated the semi-dry reactor and the bag filter in a single body, so it follows that the improvement can make the device compact, save the installation area, save the operation fee, and management more convenient.

• Journal of Nuclear Fuel Cycle and Waste Technology(JNFCWT)
• /
• v.8 no.3
• /
• pp.239-245
• /
• 2010

There are 11,811 LWR spent fuels stored at reactor sites, as of 2009. Source terms based on reference spent fuel which represents entire spent fuels with bounding values in the aspect of source term has been applied to a design of nuclear installations, instead of those which are generated by weighting respective source term for each spent fuel. Simplified regression models to estimate total decay heat, radioactivity, and ingestion hazard index for spent fuel from Westinghouse-type reactors were developed in this study, because it can be used as a fundamental model for weighting source term for respective spent fuel to exclude conservativeness in source terms. It was found that the estimated source terms agreed with calculated value from ORIGEN-ARP within 5%. It was also found that the conservativeness could be excluded if the weight source terms were used as reference source term in the design. Therefore, it is expected that the developed regression model could be widely used in the conceptual design process of nuclear facilities related with storage and disposal of spent nuclear fuel.

• Journal of the Korea Academia-Industrial cooperation Society
• /
• v.11 no.11
• /
• pp.4656-4663
• /
• 2010

In this study, the 3D computational fluid dynamics (CFD) was performed in relation to the internal fluid characteristics, flow distribution, air mean ages, and residence time for the development of the most optimal model in the complex post-disposal device. As it is expected that a channeling (drift) would be made by the semi-dry reactor due to the large difference in the flow distribution by the compartment in the bag filter, a structural improvement should be urgently made for more uniformed flow distribution in the bag filter. In addition, it showed the possibility that the velocity field and distribution characteristics of the residence time could be improved through a modification to inlet structure of the spray dryer reactor. The complex post-disposal device, modified and supplemented with this analysis, integrated the semi-dry reactor and the bag filter in a single body, so it follows that the improvement can make the device compact, the installation area, the operation fee, and management more convenient.

• Journal of Korean Society of Industrial and Systems Engineering
• /
• v.46 no.1
• /
• pp.84-90
• /
• 2023

ASL estimation of public building is based on how appropriate the maximum age of the asset is derived based on the age record of the asset in the statistical data owned by public institutions. This is because we get a 'constrained' ASL by that number. And it is especially true because other studies have assumed that the building is an Iowa curve R3. Also, in this study, the survival rate is 1% as the threshold value at which the survival curve and the predictable life curve almost coincide. Rather than a theoretical basis, in the national statistical survey, the value of residual assets was recognized from the net value of 10% of the acquisition value when the average service life has elapsed, and 1% when doubling the average service life has elapsed. It is based on the setting mentioned above. The biggest constraint in fitting statistical data to the Iowa curve is that the maximum ASL is selected at R3 150%, and the 'constrained' ASL is calculated by the proportional expression on the assumption that the Iowa curve is followed. In like manner constraints were considered. First, the R3 disposal curve for the RCC(reinforced cement concrete) building was prepared according to the discarding method in the 2000 work, and it was jointly worked on with the National Statistical Office to secure the maximum amount of vintage data, but the lacking of sample size must be acknowledged. Even after that, the National Statistical Office and the Bank of Korea have been working on estimating the Iowa curve for each asset class in the I-O table. Another limitation is that the asset classification uses the broad classification of buildings as a subcategory. Second, if there were such assets with a lifespan of 115 years that were acquired in 1905 and disposed of in 2020, these discarded data would be omitted from this ASL calculation. Third, it is difficult to estimate the correct Iowa curve based on the stub-curve even if there is disposal data because Korea has a relatively shorter construction history, accumulated economic wealth since the 1980's. In other words, "constrained" ASL is an under-estimation of its ASL. Considering the fact that Korea was an economically developing country in the past and during rapid economic development, environmental factors such as asset accumulation and economic ability should be considered. Korea has a short period of accumulation of economic wealth, and the history of 'proper' architectures faithful to building regulations and principles is short and as a result, buildings 'not built properly' and 'proper' architectures are mixed. In this study, ASL of RCC public building was estimated at 70 years.

• Journal of the Korea institute for structural maintenance and inspection
• /
• v.11 no.2
• /
• pp.69-76
• /
• 2007

As amount of waste matter rapidly increases with fast growth of cities and industry, how to dispose them has arisen as an important problem. Current policy of the government on disposal of waste is repressing generation of waste itself and in case of already generated waste, resource cycle waste management system that recycles waste after proper environmental process is getting established. Therefore recycling of waste and industrial by-products is rising hugely. One of largely wasted matters is waste gypsum, which was categorized as designated waste but changed to general since 1994. Due to disposal cost and lack of impurities removal technology, recycling of it was quite low. However, as impurities removal technology using semi-dried desulfurization process is developed lately, study on recycling of waste gypsum is going on lively. This study examines possibility of utilizing waste gypsum as alternative for concrete cement and analyzed attributes of waste gypsum before and after ball mill process to find out proper alternation ratio, and conducted strength and property tests on concrete subject whose percentage of cement use is substituted with 0, 5.0, 7.5, 10.0 and 12.5% of waste gypsum.

• Journal of Nuclear Fuel Cycle and Waste Technology(JNFCWT)
• /
• v.4 no.2
• /
• pp.117-131
• /
• 2006

A coupled T-H-M(Thermo-Hydro-Mechanical) analysis was carried out for KENTEX (KAERI Engineering-scale T-H-M Experiment for Engineered Barrier System), which is a facility for validating the coupled T-H-M behavior in the engineered barrier system of the Korean reference HLW(high-level waste) disposal system. The changes of temperature, water saturation, and stress were estimated based on the coupled T-H-M analysis, and the influence of the types of mechanical constitutive material laws was investigated by using elastic model, poroelastic model, and poroelastic-plastic model. The analysis was done using ABAQUS, which is a commercial finite element code for general purposes. From the analysis, it was observed that the temperature in the bentonite increased sharply for a couple of days after heating the heater and then slowly increased to a constant value. The temperatures at all locations were nearly at a steady state after about 37.5 days. In the steady state, the temperature was maintained at $90^{\circ}C$ at the interface between the heater and the bentonite and at about $70^{\circ}C$ at the interface between the bentonite and the confining cylinder. The variation of the water saturation with time in bentonite was almost same independent of the material laws used in the coupled T-H-M processes. By comparing the saturation change of T-H-M and that of H-M(Hydro-Mechanical) processes using elastic and poroelastic material mod31 respectively, it was found that the degree of saturation near the heater from T-H-M calculation was higher than that from the coupled H-M calculation mainly because of the thermal flux, which seemed to speed up the saturation. The stresses in three cases with different material laws were increased with time. By comparing the stress change in H-M calculation using poroelasetic and poroelasetic-plastic model, it was possible to conclude that the influence of saturation on the stress change is higher than the influence of temperature. It is, therefore, recommended to use a material law, which can model the elastic-plastic behavior of buffer, since the coupled T-H-M processes in buffer is affected by the variation of void ratio, thermal expansion, as well as swelling pressure.

• Korean Journal of Clinical Pharmacy
• /
• v.13 no.2
• /
• pp.82-90
• /
• 2003

Dopamine is an effective pressor for the treatment of shock and hypotension when patients do not respond to plasma volume expansion. Two dopamine intravenous delivery systems are currently available in Korea. The objective of this study was to compare dopamine premixed with prefilled system in terms of supply costs (preparation costs + personnel time), contamination rates and convenience. Time-and-motion studies were conducted to determine the time and costs associated with preparation and administration of the two systems. They were analyzed and compared by Mann-Whitney test. To evaluate the contaminaton rates of the two systems, both systems were prepared in an open environment similar to that of practical situations. Premixed and compounded solutions were then filtered by $0.22{\mu}m$ membrane filters, which were cultured at $37^{\circ}C$ for 10 days and their contents were visually checked for bacterial contamination. The convenience of the two systems was compared by itemized user assessments on preparation, dose calculation, admixture, administration and disposal of waste matters. They were analyzed by Wilcoxon's signed rank test and 100 part percentage. It was found that the preparation costs $(mean{\pm}SD)$ for premixed and prefilled systems were $271.70\pm293.55\;Won$ (Korean currency) and $1521.04\pm510.63\;Won$, respectively. The preparation time $(mean{\pm}SD)$ for premixed system was $68.10\pm35.69\;sec.$ while at for prefilled system was $154.03\pm50.06\;sec.$ (n=59 each, p<0.001). No bacterium was observed in the samples of both systems (n=20, each). User assessments indicated that the premixed system was more convenient than the prefilled system except for the item of dose calculation (n=24, p<0.001). Subjective evaluations have proven that the use of the dopamine premixed system resulted in increased efficiency of intravenous preparation by allowing personnel to devote more time to other labor-intensive duties and lower total medical costs.

• Journal of the Korea institute for structural maintenance and inspection
• /
• v.20 no.4
• /
• pp.35-43
• /
• 2016

Recently, the pipeline system for waste transportation has been increasingly constructed as new solution for the waste collection and disposal system by constantly increasing domestic waste which issued as social problem. The pipeline system is constructed through long distance, so proper long-term monitoring system is necessary which available to detect the damage location for the effective maintenance. In this paper, the experimental study is carried out to evaluate the applicability of optical strain gauge sensor based on FBG for the long-term monitoring system. Three test parameters such as pressure leaking, blockage and deformation are considered as typical damages for real-scale pipeline test specimen. In order to measure flexural and volumetric strain and temperature, three FBG sensors are installed at each monitoring sections. From the test results, this study suggested effective methods of sensor installation and arrangement. Also the sensor spacing for the design of monitoring system using FBG sensor is derived by the correlation of distances from deformation between sensor responses.