• Tunnel and Underground Space
• /
• v.28 no.4
• /
• pp.343-357
• /
• 2018

Algorithm which can analyze the slope failure behavior utilizing the comprehensive information of the dense point of joint poles and the joint set orientations, both of which are obtained statistically, and the defect pattern of pole distribution has been developed. This method overcomes the potential incorrectness of the hemispheric projection method utilizing the joint set orientations only and also enhances the reliability of slope failure analysis. To this end a method capable of calculating the joint dispersion index directly from the joint pole distribution, instead of contour map, has been devised. The representative orientations for the slope failure analysis has been determined by considering the number and orientations of cone angle-dependent joint sets as well as the joint dispersion index. By engaging these representative orientations to the hemispheric projection analysis more reliable slope failure examination has been carried out. Sensitivity analysis for the potentially unstable slope of plane failure mode has been performed. Significance of joint strength index and the external seismic loading on the slope stability has been fully analyzed.

• Particle and aerosol research
• /
• v.17 no.4
• /
• pp.81-89
• /
• 2021

Understanding particle-laden flow around cylindrical bodies is essential for the better design of various applications such as filters. In this study, laminar flows around two tandem cylinders and the motions of particles in the flow are numerically investigated at low Reynolds numbers. We aim to reveal the effects of the spacing between cylinders, Reynolds number and particle Stokes number on the characteristics of particle trajectories. When the cylinders are placed close, the unsteady flow inside the inter-cylinder gap at Re = 100 shows a considerable modification. However, the steady recirculation flow in the wake at Re = 10 and 40 shows an insignificant change. The change in the flow structure leads to the variation of particle dispersion pattern, particularly of small Stokes number particles. However, the dispersion of particles with a large Stokes number is hardly affected by the flow structure. As a result, few particles are observed in the cylinder gap regardless of the cylinder spacing and the Reynolds number. The deposition efficiency of the upstream cylinder shows no difference from that of a single cylinder, increasing as the Stokes number increases. However, the deposition on the downstream cylinder is found only at Re = 100 with large spacing. At this time, the deposition efficiency is generally small compared to that of an upstream cylinder, and the deposition location is also changed with no deposited particles near the stagnation point.

• Journal of the Korea Institute of Military Science and Technology
• /
• v.18 no.5
• /
• pp.582-593
• /
• 2015

For military training and course-of-action analysis, OneSAF Int'l version being used in ROK Army has a limited capability to simulate NBC(nuclear, biological, and chemical) damages. For high-fidelity NBC combat simulation, it is required to visualize NBC contamination dispersion in consideration of weather conditions and terrain characteristics. However, OneSAF itself handling interaction among thousands of combat entities cannot carry out a simulation of NBC contamination dispersion because it brings about an excess burden. To resolve this problem, this research aims to design simulation federation for analysis on NBC operational effects. After examining design consideration to connect OneSAF and a NBC contamination dispersion model, we design a federation architecture that facilitates the interaction between OneSAF and a NBC contamination dispersion model. Afterwards, we implement a federation interface to share simulation data by publish-subscribe pattern and to translate them into the proprietary format for each model. We prove the possibility of federation between both models, as showing that dispersion of NBC contaminated cloud and changes in concentration are reflected in OneSAF-based engagement simulation.

• 한국방재학회:학술대회논문집
• /
• 2008.02a
• /
• pp.799-802
• /
• 2008

General behaviors based on hydraulic characteristics of natural streams and channels have been recently analyzed and developed via various numerical models. However in the states of natural hydraulics, an experimental research must be performed simultaneously with the mathematical analysis due to effects of hydraulic properties such as meander, sediment, and so on. In this study based on 2-D advection-dispersion equation, flow and tracer experiments were performed in the S-curved meandering laboratory channel with a rectangular cross-section. The channel was equipped with instrument carriages which was equipped with an auto-traversing system to be used with velocity measuring sensors throughout the depth and breadth of the flow field. To measure concentration distribution of the salt solution was adjusted to that of the flume water by adding methanol and a red dye (KMnO4) was added to aid the visualization of the tracer cloud, the tracer was instantaneously injected into the flow as a full-depth vertical line source by the instantaneous injector and the initial concentration of the tracer was 100,000 mg/l. The secondary current as well as the primary flow pattern was analyzed to investigate the flow distribution in the meandering channels. The velocity distribution of the primary flow for all cases skewed toward the inner bank at the first bend, and was almost symmetric at the crossovers, and then shifted toward the inner bank again at the next alternating bend. Thus, one can clearly notice that the maximum velocity occurs taking the shortest course along the channel, irrespective of the flow conditions. The result of the tracer tests shows that pollutant clouds are spreading following the maximum velocity lines in each cases with various mixing patterns like superposition, separation, and stagnation of pollutant clouds. Flow characteristics in each cases performed in this study can be compared with tracer dispersion characteristics with using evaluation of longitudinal and transverse dispersion coefficients(LDC, TDC). As expected, LDC and TDC in meandering parts have been evaluated with increasing distribution and straight parts have effected to evaluate minimum of LDC and TDC due to symmetric flow patterns and attenuations of secondary flow.

• Journal of the Korean Society of Clothing and Textiles
• /
• v.33 no.5
• /
• pp.741-751
• /
• 2009

In order to design and develop the various silhouette of pants pattern for standardized pants patterns, this study is to classify the pants style by the silhouette and to characterize each pants pattern which are classified. Recent 37 ready-made pants patterns of various style were collected in order to analyze their silhouette from April to July 2007. Measurement of each region of the pants pattern were compared and analysed. After analyse the standard deviation, coefficient of variance, minimum, maximum, range about the measurement of each region of the pants pattern, major pattern design factors were extracted. Five major factors are the angle of center front line and center back line, the crotch extension, the position of center back line against center front line, the curvature of center back line, and amount of waist dart. As a result, pants style were grouped as the culottes, formal, basic and tight style after considering the extracted design factors, and analysing correlation, degree of dispersion of the measurement by part. As the silhouette of pants classification from culotte to tight, the fits are closer to the figure, crotch depth increases, crotch extensions are shorter, and angle of the center back increases. The shape of the connected front and back center lines is U-shape for culotte and is closer to V-shape as the silhouette becomes tight.

• Journal of Environmental Science International
• /
• v.13 no.7
• /
• pp.655-660
• /
• 2004

This paper demonstrates the numerical simulation of three dimensional flow pattern for vehicular exhaust dispersion in the street canyons. The wind flow around buildings in urban is computed by the SIMPLEST method. The convection-diffusion equation was used to compute the $NO_X$ concentration level near buildings. Details are given of important boundary conditions and turbulence quantities variations. The simple turbulence model was used for unisotropic viscous effect. A control-volume based finite-difference method with the upwind scheme is employed for discretization equation. The simple turbulence model applied in this study has been verified through comparison between predicted and measured data near buildings. By the predictive results, the updraft induced by the presence of high-rise buildings is important in the transport of street level pollutant out from the street canyons. Our suggestion for reducing ground level pollution is to have high-rise buildings constructed or to reduce the channelling effect of street canyons.

• Macromolecular Research
• /
• v.14 no.2
• /
• pp.132-139
• /
• 2006

The dispersion of organoclay in ethylene propylene diene terpolymer (EPDM) matrix was correlated with the rheological and swelling properties of nanocomposites. X-ray diffraction pattern (XRD) and transmission electron microscopic (TEM) analysis exhibited the disordered-intercalated structure of EPDM/organoclay nanocomposite. The extent of the disordered phase increased with increasing organoclay content up to a limiting value of 3 wt% after which equilibrium tended towards intercalation. The dispersion effect of organoclay in EPDM matrix was clarified by the physicochemical properties like rheological response and swelling thermodynamics in toluene. The increase in viscoelastic properties of EPDM nanocomposite with increasing organoclay content up to 3 wt%, followed by a subsequent decrease up to 4 wt%, was correlated in terms of the disordered and ordered states of the dispersed nano-clay sheets. Swelling measurements revealed that the change in entropy of the swelling increased with the increase in disorder level but decreased with the increase in intercalation level of organoclay in the disordered-intercalated nanocomposite. The increase in solvent uptake was comparable with the free volume in EPDM matrix upon inclusion of silicate particles, whereas the inhibition in solvent uptake for higher organoclay loading was described by bridging flocculation.

• Environmental Sciences Bulletin of The Korean Environmental Sciences Society
• /
• v.10 no.S_1
• /
• pp.23-28
• /
• 2001

A new numerical weather prediction and dispersion model, the Operational Multi-scale Environment model with Grid Adaptivity(OMEGA) including an embedded Atmospheric Dispersion Model(ADM), is introduced as a next generation atmospheric simulation system for real-time hazard predictions, such as severe weather or the transport of hazardous release. OMEGA is based on an unstructured grid that can facilitate a continuously varying horizontal grid resolution ranging from 100 km down to 1 km and a vertical resolution from 20 -30 meters in the boundary layer to 1 km in the free atmosphere. OMEGA is also naturally scale spanning and time. In particular, the unstructured grid cells in the horizontal dimension can increase the local resolution to better capture the topography or important physical features of the atmospheric circulation and cloud dynamics. This means the OMEGA can readily adapt its grid to a stationary surface, terrain features, or dynamic features in an evolving weather pattern. While adaptive numerical techniques have yet to be extensively applied in atmospheric models, the OMEGA model is the first to exploit the adaptive nature of an unstructured gridding technique for atmospheric simulation and real-time hazard prediction. The purpose of this paper is to provide a detailed description of the OMEGA model, the OMEGA system, and a detailed comparison of OMEGA forecast results with observed data.

• Journal of Environmental Science International
• /
• v.19 no.2
• /
• pp.157-170
• /
• 2010

Air mass recirculation is a common characteristic in the coastal area as a result of the land-sea breeze circulation. This study simulates the recirculation of air mass over the Gwangyang Bay using WRF-FLEXPART and offers a basic information about the effective domain size that can reflect recirculation. For this purpose, WRF is set up four nested domains and three cases are selected. Subsequently FLEXPART is operated on the basis of WRF output. During the clear summer days with weak wind speed, particles that emitted from Yeosu national industrial complex and Gwangyang iron works flow into emission sources because of the land-sea breeze. When land-sea breeze is strengthen, the recirculation phenomena appears clearly. However particles aren't recirculated under weak synoptic condition. Also plume trajectory is analyzed and as a consequence, the smallest domain area have to be multiplied by 1.3 to understand recirculated dispersion pattern of particles.

• The Bulletin of The Korean Astronomical Society
• /
• v.46 no.2
• /
• pp.81.1-81.1
• /
• 2021

Stellar kinematics is a useful tool to understand the formation and evolution of young stellar systems. Here, we present a kinematic study of the HII region, NGC 821, using the Gaia Early Data Release 3. NGC 281 contains the open cluster IC 1590. This cluster has a core and a low-stellar density halo. We detect a pattern of cluster expansion from the Gaia proper motion vectors. Most stars radially escaping from the cluster are distributed in the halo. We measure the 1-dimensional velocity dispersion of stars in the core. The velocity dispersion (1 km/s) is comparable to the expected virial velocity dispersion of this cluster, and therefore the core is at a virial state. The core has an initial mass function shallower than that of the halo, which is indicative of mass segregation. However, there is no significant correlation between stellar masses and tangential velocities. This result suggests that the mass segregation has a primordial origin. On the other hand, it has been believed that the formation of young stars in NGC 281 West was triggered by feedback from massive stars in IC 1590. We investigate the ages of stars in the two regions, but the age difference between the two regions is not comparable to the timescale of the passage of an ionization front. Also, the proper motion vectors of the NGC 281 West stars relative to IC 1590 do not show any systematic receding motion from the cluster. Our results suggest that stars in NGC 281 West might have been formed spontaneously. In conclusion, the formation of NGC 281 can be understood in the context of hierarchical star formation model.