• Journal of the Korean Institute of Intelligent Systems
• /
• v.14 no.6
• /
• pp.759-763
• /
• 2004

In this paper, real-time voice change method using pitch change technique is proposed to change one's voice to the other voice. For this purpose, sampling rate change method using DFT (Discrete Fourier Transform) method and time scale modification method using SOLA (Synchronized Overlap and Add) method is combined to change pitch. In order to evaluate the performance of the proposed method, voice transformation experiments were conducted. Experimental results showed that original speech signal is changed to the other speech signal in which original speaker's identity is difficult to find. The system is implemented using TI TMS320C6711DSK board to verify the system runs in real time.

• Journal of the Korean Institute of Illuminating and Electrical Installation Engineers
• /
• v.24 no.8
• /
• pp.84-93
• /
• 2010

This paper describes a method of visualization and fast estimation of parameter in continuous time signal. The parameter estimation method of this paper directly estimate the parameters on the basis of the discrete Fourier transform. Also, this paper present to efficient visualization method of dominant parameters obtained in continuous time signal. The proposed methods are applied to test functions with three dominant modes. The results show that the proposed methods are highly applicable to parameter estimation and visualization in continuous time signal.

• ETRI Journal
• /
• v.37 no.1
• /
• pp.32-42
• /
• 2015

Orthogonal frequency-division multiplexing (OFDM) suffers from spectral nulls of frequency-selective fading channels. Linear precoded (LP-) OFDM is an effective method that guarantees symbol detectability by spreading the frequency-domain symbols over the whole spectrum. This paper proposes a computationally efficient and low-cost implementation for discrete Hartley transform (DHT) precoded OFDM systems. Compared to conventional DHT-OFDM systems, at the transmitter, both the DHT and the inverse discrete Fourier transform are replaced by a one-level butterfly structure that involves only one addition per symbol to generate the time-domain DHT-OFDM signal. At the receiver, only the DHT is required to recover the distorted signal with a single-tap equalizer in contrast to both the DHT and the DFT in the conventional DHT-OFDM. Theoretical analysis of DHT-OFDM with linear equalizers is presented and confirmed by numerical simulation. It is shown that the proposed DHT-OFDM system achieves similar performance when compared to other LP-OFDMs but exhibits a lower implementation complexity and peak-to-average power ratio.

• Transactions of Materials Processing
• /
• v.12 no.4
• /
• pp.277-283
• /
• 2003

In a closed-die forging process, blocker has been used to fill and distribute metal well in finisher die. Generally, the blocker shape was determined by an expert with many experiences. However, the manual blocker design process takes much time and efforts, so various automatic methods for the blocker design process have been suggested for the last three decades. The method with filtering in FFT (Fast Fourier Transform) for the blocker design provides general solution than other methods. But. due to the properties of FFT in time-frequency domain, this method has some drawbacks such as long calculation time, difficulty of local control and additional boundary process after filtering. In this study. DWT (Discrete Wavelet Transform), which is more flexible and is more wildly used than FFT, is applied to the blocker design. The method with filtering in DWT is very proper to design blocker in both 2-D and 3-D shapes. To verify the efficiency of this method, blockers of some models are designed and the results show that blocker design with DWT is effective for the blocker designs.

• Journal of the Korea Academia-Industrial cooperation Society
• /
• v.11 no.4
• /
• pp.1342-1347
• /
• 2010

Various researches have been studied on WSN(wireless sensor network) for barbed wire entanglements surveillance applications such as industry facilities, security area, prison, military area, airport, etc. Currently, barbed wire entanglements surveillance is formed wire sensor network environment. Traditional wire sensor network guarantee high data transmission rate. Therefore, wire sensor network use fast fourier transform of data of high transmission rate for extraction of feature parameter. However, wireless sensor network in comparison with wire sensor network has very low data transmission rate. Therefore, wireless sensor network doesn't use fast fourier transform of wire sensor network for extraction of feature parameter. In this paper, proposed method use 1 level approximation coefficient of DTW(dynamic time-warped) algorithms based on DWT(discrete wavelet transform) for extraction of detection feature parameter and classification feature parameter for barbed wire entanglements surveillance. l level approximation coefficient have time information and frequency information of signal. Therefore, Dynamic time-warped algorithms based on discrete wavelet transform improve detection and classification of target rather than using energy of signal.

• Journal of the Korean Institute of Telematics and Electronics
• /
• v.14 no.6
• /
• pp.26-30
• /
• 1977

Redundancies in the Calculation of DFT and FFT are analized and new algorithms are proposed which are capable of reducing the machine time by a considerable amount. New extensions of T.D C.F. and T.D.F.T. are given for the discrete case which permit a deeper insights for the techniques of digital signal Proessing i. e. Discrete Fourier Transform, Convolution Sum and Correlation sequences.

• The Journal of Korean Institute of Communications and Information Sciences
• /
• v.38B no.4
• /
• pp.305-313
• /
• 2013

As an FMT (Filtered Multi-Tone) transmission method of Wideband VHF communication system specified by the ETS (European Telecommunications Standards) EN 300 392-2, this paper introduces three existing realization methods, i.e., the direct filtering method using different band SRRC (Square-Root Raised Cosine) filters for each subcarrier, the PPN-DFT method using the IDFT-PPN (Poly-Phase Network) and PPN-DFT at the transmitter and receiver, respectively, and the Extended DFT method. Then, it proposes the extended IDFT-SDFT (Sliding Discrete Fourier Transform) that computes the DFT values only for interested subcarriers every sample time, and shows that it has an advantage of blind symbol timing (using no training symbol) individually for each user signal (independently of other users' signals) in the multi-user environment where the subcarriers are assigned in contiguous or interleaved blocks to each user and each user signal possibly experiences different channels.

• 제어로봇시스템학회:학술대회논문집
• /
• 1996.10a
• /
• pp.303-306
• /
• 1996

We propose a robust tuning method of the quadratic criterion based iterative learning control(Q-ILC) algorithm for discrete-time linear batch system. First, we establish the frequency domain representation for batch systems. Next, a robust convergence condition is derived in the frequency domain. Based on this condition, we propose to optimize the weighting matrices such that the upper bound of the robustness measure is minimized. Through numerical simulation, it is shown that the designed learning filter restores robustness under significant model uncertainty.

• Proceedings of the KSME Conference
• /
• 2001.06b
• /
• pp.540-545
• /
• 2001

In this paper dynamic responses of an engine, which is supported by hydraulic mount, to throttle tip-in/tip out are analyzed. Because the hydraulic mounts have non-linearity which the characteristics of stiffness and damping vary with frequencies, it is difficult to analyze the dynamic behavior of an engine using general integral algorithms. Convolution integrals and relationships between unit impulse response functions and frequency response functions are therefore used to simulate the transient behavior of an engine indirectly. In time domain, impulse response functions are calculated by two-side discrete inverse Fourier transform of frequency response function achieved by Laplace transform of equations of motion. Considering the fact that the shapes of behavior of an engine simulated by the proposed method are in good agreement with test results, it is confirmed that the proposed method is very effective for the analysis of transient response to throttle tip-in/out of an engine with hydraulic mounts.

• Honam Mathematical Journal
• /
• v.37 no.3
• /
• pp.299-315
• /
• 2015

In this paper, we study the first-order system least-squares (FOSLS) spectral method for parabolic partial differential equations. There were lots of least-squares approaches to solve elliptic partial differential equations using finite element approximation. Also, some approaches using spectral methods have been studied in recent. In order to solve the parabolic partial differential equations in parallel, we consider a parallel numerical method based on a hybrid method of the frequency-domain method and first-order system least-squares method. First, we transform the parabolic problem in the space-time domain to the elliptic problems in the space-frequency domain. Second, we solve each elliptic problem in parallel for some frequencies using the first-order system least-squares method. And then we take the discrete inverse Fourier transforms in order to obtain the approximate solution in the space-time domain. We will introduce such a hybrid method and then present a numerical experiment.