• The Magazine of the IEIE
• /
• v.30 no.4
• /
• pp.76-88
• /
• 2003

본 논문에서는 기존의 기지국과 W-CDMA 시스템을 상호 연동하기 위한 SDR(Software Defined Radio) 기반의 멀티 밴드 디지털 IF 모듈 구현에 대해 소개한다. 하드웨어 플랫폼상에 테스트 및 시험 검증하기 위해서 크게 광대역 ADC, DAC, FPGA로 구성하였으며, FPGA 내에 디지털 필터 및 NCO등의 응용 소프트웨어는 VHDL로 코딩하였다. 디지털 필터는 FPGA의 허용 자원을 고려하여 인터폴레이션 및 데시메이션을 위한 폴리페이즈 필터 뱅크로 구현하였다. 또한 송신단에서는 이미지 성분을 제거하기 위해 2단의 DCQM(Digital Complex Quadrature Modulation)을 적용하였으며, 이때 적용되는 NCO (Numerically Controlled Oscillator)는 1/4주기의 LUT를 사용하여 설계하였다. 수신단에서는 IF 단에 SAW필터를 사용하지 않기 때문에 W-CDMA의 블록커 규약에 준하면서 근접 채널을 제거하기 위한 고출력의 감쇄 특성을 갖는 필터를 설계하였다. 본 논문에서는 컴퓨터 시뮬레이션 결과와 스펙트럼 분석기를 통해 측정된 결과를 비교 분석하였으며 이에 대한 디지털 IF 모듈의 성능을 검증하였다.

• The Journal of Korean Institute of Communications and Information Sciences
• /
• v.21 no.10
• /
• pp.2579-2585
• /
• 1996

In this paper, a complex fuzzy adaptive decision feedback equalizer(CFADFE) based on the LMS algorithm is proposed. The propoed equalizer is based on the complex fuzzy adaptive equalizer. The CFADFE isconstructed from a set of changeable complex fuzzy IF-THEN rules, where the 'IF' part of the rule is characterized by the state from a set of changealble complex fuzzy IF-THEN rules, where the 'IF' part of the rule is characterized by the state of the desision feedback. the role of decision feedback is to reduce the computational complexity. Computer simulation of the decision feedback. The role of decision feedback is to reduce the computational complexity. Computer simulation shosw that the CFADFE notonly reduces the computational complexity but also improves the performance compared with the conventional complex fuzzy adaptive equalizers. We also show that the adaptation speed is greatly improved by incorporating some linguistic information about the channel into the equalzer. It is applied to M-ary QAM digital communication system with linear and nonlinear complex channel characteristics.

• Journal of the Institute of Electronics Engineers of Korea CI
• /
• v.49 no.4
• /
• pp.31-41
• /
• 2012

The law enforcement agencies in the worldwide are confiscating or retaining computer systems involved in a crime/civil case, if there are any, at the preliminary investigation stage, even though the case does not involve a cyber-crime. They are collecting digital evidences from the suspects's systems and using them in the essential investigation procedure. It requires much time, though, to collect, duplicate and analyze disk images in general crime cases, especially in cases in which rapid response must be taken such as kidnapping and murder cases. The enterprise forensics, moreover, it is impossible to acquire and duplicate hard disk drives in mass storage server, database server and cloud environments. Therefore, it is efficient and effective to selectively collect only traces of the behavior of the user activities on operating systems or particular files in focus of triage investigation. On the other hand, if we acquire essential digital evidences from target computer, it is not forensically sound to collect just files. We need to use standard digital evidence container from various sources to prove integrity and probative of evidence. In this article, we describe a new digital evidence container, we called Xebeg, which is easily able to preserve collected digital evidences selectively for using general technology such as XML and PKZIP compression technology, which is satisfied with generality, integrity, unification, scalability and security.

• The Journal of Korean Institute of Communications and Information Sciences
• /
• v.40 no.1
• /
• pp.23-31
• /
• 2015

In this paper, we design a SSD(simultaneous single band duplex) system using RF cancellation and digital cancellation. And then, we analyze performance of the SSD system using pre-distorter with HPA non-linearity. Also, we analyze digital cancellation performance of the SSD system using pre-distorter with HPA non-linearity. Additionally, digital cancellation cancels residual self-interference. In linear conditions, digital cancellation can cancel self-interference of 40dB. Therefore, the SSD system has good BER performance because most of self-interference is canceled. But, in HPA non-linearity conditions, digital cancellation cancels residual self-interference of 25dB. In this conditions, self-interference is greater than desired signal. Therefore, bit informations of distant station can not be received. But, we confirm that if the proposed system uses pre-distorter then bit information of distant station can be received by HPA non-linearity compensation. Also, we confirm that even though the proposed system uses pre-distorter, if HPA non-linearity increases then digital cancellation performance is degraded by imperfect compensation of HPA non-linerity.

• KSII Transactions on Internet and Information Systems (TIIS)
• /
• v.8 no.2
• /
• pp.601-617
• /
• 2014

In digital radio broadcasting systems, long delays are incurred in service start time when tuning to a particular frequency because several synchronization steps, such as symbol timing synchronization, frame synchronization, and carrier frequency offset and sampling frequency offset compensation are necessary. Therefore, the operation of the synchronization blocks causes delays ranging from several hundred milliseconds to a few seconds until the start of the radio service after frequency tuning. Furthermore, if spectrum inversed signals are transmitted in digital radio broadcasting systems, the receivers are unable to decode them, even though most receivers can demodulate the spectral inversed signals in analog radio broadcasting systems. Accordingly, fast synchronization techniques and a method for spectral inversion detection are required in digital radio broadcasting systems that are to replace the analog radio systems. This paper presents a joint detection method of frame, integer carrier frequency offset, and spectrum inversion for DRM Plus digital broadcasting systems. The proposed scheme can detect the frame and determine whether the signal is normal or spectral inversed without any carrier frequency offset and sampling frequency offset compensation, enabling fast frame synchronization. The proposed method shows outstanding performance in environments where symbol timing offsets and sampling frequency offsets exist.

• Journal of the Korean Institute of Illuminating and Electrical Installation Engineers
• /
• v.26 no.6
• /
• pp.87-93
• /
• 2012

In this paper, we propose an analog-to-digital converter to set the address of a I2C slave chip. The proposed scheme converts a fixed voltage between 0 and VDD to the digital value which can be used as the address of the slave chip. The rising time and the falling time are measured with digital counter in a serially connected RC circuit, while the circuit is being charged and discharged with the voltage to be measured. The ratio of the two measured values is used to get the corresponding digital value. This scheme gives a strong point which is to be implementable all the parts except comparator using digital logic. Although the method utilizes RC circuit, it has no relation with the RC value if the quantization error is disregarded. Experimental result shows that the proposed scheme gives 32-level resolution thus it can be used to configure the address of the I2C slave chip.

• Spatial Information Research
• /
• v.8 no.1
• /
• pp.31-50
• /
• 2000

In establishing the NGIS (The National Geographic Information System) , the Korean Government has been computerizing maps such as topographical maps as well as thematic maps. If the digital maps are mapped according to their use purpose, they can be efficiently used. The goals of this study is to describes the reasonable inspection process of digital maps. For these goals, quality controls and test processes of digital maps are investigated and then the error types of digital maps are analyzed. Nine standards which are data lineage, data format, positional accuracy, attribute accuracy, topology, logical consistency, edge-matching , completeness, outline range are established and nine steps, multi steps, which are making a work plan, analysing error types of digital maps, inspection with the naked eyes, a computerized inspection , a automatic inspection, the judge of results, the analysis of results are proposed.

• Journal of Institute of Control, Robotics and Systems
• /
• v.17 no.4
• /
• pp.289-294
• /
• 2011

Digital redesign is yet another efficient tool to convert a pre-designed analog controller into a sampled-data one to maintain the analog closed-loop performance in the sense of state matching. A rising difficulty in developing a digital redesign technique for trackers with time-varying references is the unavailability of a closed-form discrete-time model of a system, even if it is linear time-invariant. A way to resolve this is to approximate the time-varying reference as a piecewise constant one, which deteriorates the state matching performance. Another remedy may be to decrease a sampling period, which however could numerically destabilize the optimization-based digital redesign condition. In this paper, we develop a digital redesign condition for time-varying trackers by approximating the time-varying reference through a triangular hold and by introducing delta-operated discrete-time models. It is shown that the digitally redesigned sampled-data tracker recovers the performance of the pre-designed analog tracker under a fast sampling limit. Simulation results on the formation flying of satellites convincingly show the effectiveness of the development.

• Journal of the Institute of Convergence Signal Processing
• /
• v.1 no.2
• /
• pp.131-137
• /
• 2000

In this paper, as a compatible software radio transmission system, Digital-Radio conversion system which can directly change the digital signal generated by the logic circuit into radio signal is proposed. By the vector synthesis method, the digital signals can change directly into radio signal. If such a circuit is realized, RF circuit and an antenna can be composed by the simple one device, and the radio is directly controlled and performed by the software processing which is the essence of software radio. This Digital-Radio conversion system of this paper give many number of communication channels being offered by PN code and offer a hardware design flexibility by digitization, therefore it decrease the percentage ratio of hardware of system and give a more flexible function of software basis. In this paper, the principle of digital to radio signal generation algorithm is explained and the performance characteristics of proposed algorithm is shown in time base by the computer simulation method.

• Journal of Korea Society of Digital Industry and Information Management
• /
• v.10 no.4
• /
• pp.71-78
• /
• 2014

Method a target estimation in spatial are mobile wireless communication using network cell and GPS. It have much error that mobile wireless communication depend on cell size. GPS method can't find a target in shadow and inner area. In this paper, we estimate a target as direction of arrival method using adaptive array antenna system. Adaptive array antenna system can obtain desired signal to remove other signal This paper studied digital beamforming method in order to estimation a target. Proposed method is modified optimum weight and antenna error correction to estimation an optimal receive signal. Digital beamforming method decided a signal phase and amplitude from received signal on array antenna element. But if it is not to do error correction of received signal, system performance have decreased. Firstly, we proposed modified optimum weight in order to finding desired target. Secondly, we are error correction of antenna incident signals by optimal weight before digital beamforming method. Thirdly, throughly simulation, we showed that system performance of proposed method compare proposal method with general method. It have improved resolution of estimation target to good performance more proposed method than general method.