• International Journal of Automotive Technology
• /
• v.3 no.1
• /
• pp.33-40
• /
• 2002

Increasingly stringent emission regulations of EU and CARB (California Air resource Board) require mandatory OBD (On Board Diagnostics) far the catalytic converters of a vehicle. It demands that MIL(Malfunction Indication Light) should be tuned on to inform the driver of catalytic converter failures. Currently dual oxygen sensor method Is widely used for the converter OBD. However, since it works only alter converter light-off, it has a serious limitation when applied to TLEV or more stringent emission regulations where more than 85% of total emission is coming out before converter light-off. In addition, a recent development in catalyst material. coating technology and additive catalysts leads to a much improved OSC (Oxygen Storage Capacity) after converter light-off, current methods are very difficult to determine levels of converter aging. Therefore, it is desired to develop an OSC detecting method before converter light-off to diagnose converter failures with higher reliability. In this study, OSCs of converters are measured by an absolute measuring method and a dynamic measuring method, and some of fundamental ideas are suggested about converter OBD before converter light-off. The converters are aged with two different aging methods; those are a furnace aging and an engine bench aging: to represent aging conditions in actual field applications. Dual oxygen sensor method at the lower temperature than light-off is also studied at a model gas bench with the converters. It is fecund that there is a certain point in temperature lower than light-off where difference due to aging level becomes maximum, thus a proper dynamic method to effectively monitor catalytic converters could be implemented fur the range lower than light-off temperatures. With this result, the aging level of converters is examined at an engine bench.

• Proceedings of the Korean Institute of IIIuminating and Electrical Installation Engineers Conference
• /
• 2009.10a
• /
• pp.15-18
• /
• 2009

Photopia, LightTools, and ASAP are typical software for optical design of a luminaire. Through using various lighting simulation software some different results can be found under the same conditions. Therefore, the purpose of this paper is to compare simulated photometric data and values illuminance of different types of LED prism luminaires under the same conditions. Then, LED prism luminaires were divided into the linear type and the planar type. Also three kinds of prism angles were divided into $30^{\circ}$, $45^{\circ}$, and $60^{\circ}$. In addition, the reasons for such differences were analyzed.

• Proceedings of the Korean Institute of IIIuminating and Electrical Installation Engineers Conference
• /
• 2008.10a
• /
• pp.307-310
• /
• 2008

This paper is proposed the vector control of 3-phase induction motor drive system by photovoltaic generation. For performance of vector control using a current control voltage source inverter(CC-VSI). CC-VSI is controlled by torque and flux producing component of motor current, relating with current and voltage value of photovoltaic arrays at maximum power point that varies follow different level of insolation. The MPPT using a DC-DC converter controlled the duty cycle to track maximum power from PV under different insolation conditions. The simulation results are shown that the characteristics and performance of drive system, which varies as each conditions of light by expresses in voltage($V_{dq}$), current($I_{dq}$), speed of motor and torque.

• Textile Coloration and Finishing
• /
• v.18 no.5 s.90
• /
• pp.22-29
• /
• 2006

The purpose of this study was to investigate the dyeability and antibacterial activity on wool fabric dyed with cochineal at variable dyeing conditions. Al, Cr, Fe, Cu and Sn were used as mordants and adsorption was compared with different mordanting methods. The optimum dyeing conditions of wool fabrics were dyeing concentration 2.0%(o.w.s), dyeing temperature $60^{\circ}C$, pH 3 and dyeing time 30 minutes. The pre-mordanting method was preferred for Al and Cr, and the post-mordanting one was preferred for Cu, Sn and Fe to achieve better dyeing. The optimum mordanting conditions of wool fabrics dyed with cochineal were mordanting concentration of 1%(o.w.s), mordanting temperature $60^{\circ}C$, and dyeing time 30 minutes. Wool fabrics dyed with cochineal showed a little antibacterial activity, but it was increased by Cu and Sn mordanting. The light fastness and perspiration fastness of wool fabric treated with cochineal were improved by mordanting.

• Journal of the Korean Institute of Educational Facilities
• /
• v.18 no.2
• /
• pp.25-33
• /
• 2011

This study performs the objective evaluation on simple comparison and calculation works by students under LED illumination conditions according to three types of color temperatures (7000K, 5000K, 3000K) in the classroom, Since the objective of this study is to develop an electric lighting conditions suitable for students in the classroom, the learning performance under three types of LED illumination conditions were analyzed. The 4 kinds of simple tests concerning with learning performance were developed and test results under natural light and LED illumination by 3 types of color temperatures were analyzed. There were differences by t-test in most cases among simple experiment results of different illumination conditions ($p{\leq}.05$). It was confirmed that illumination condition plays an important role when students simply compare words or perform arithmetic calculations. The experimental results of this study might be applied to designing better luminous environment.

• Journal of the Korean Society of Environmental Restoration Technology
• /
• v.11 no.5
• /
• pp.79-91
• /
• 2008

Research was initiated to investigate germination characteristics of creeping bentgrass (CB, Agrostis palustris Huds.). Seven varieties of CB were evaluated with different experiments. An alternative environment condition requiring for a CB germination test by International Seed Testing Association (ISTA) was applied in the Experiment I, consisting of 8-hr light at $25^{\circ}C$ and 16-hr dark at $15^{\circ}C$(ISTA conditions). Experiment II was conducted under a room temperature condition of 5 to $25^{\circ}C$(natural conditions). In each experiment, data such as seed germinating vigor, early germination characteristics, germination speed and germination peak time were measured. Significant differences were observed in seed germinating vigor, early germination characteristics, germination speed and germination peak time. Seed germinating vigor was variable with different environments and varieties. It was 61.50 to 98.25% under ISTA conditions and 55.00 to 98.50% under natural conditions. There were considerable variations in early germination characteristics among CB varieties according to different conditions. Early germination characteristics indicated that all varieties were 1 to 4 days faster in germination under ISTA conditions, when compared with natural conditions. The germination speed, measured as days to seed germination of 70% and 90%, was much faster with Penn A-1, Penn A-4 and Penncross under ISTA conditions. But it was even faster with L-93 and Penncross when grown under natural conditions. Differences were also observed in germination peak time with varieties and growing conditions. It was 0.57 to 2.86 days under ISTA conditions and 0.74 to 1.74 days under natural conditions. Regardless of the environment conditions, the shortest variety was L-93 and the longest one T-1. Considering germinating vigor, early germination characteristics, germination speed and germination peak time, Penn A-1, Penn A-4 and Penncross were regarded as excellent varieties under ISTA conditions in terms of early establishment characteristics, while L-93, Penn A-1 and Penncross under natural conditions. These results suggest that an intensive germination test be needed prior to planting, for the early germinating vigor, germination speed and germination peak time. Also, a proper variety selection and comprehensive site analysis for the growing environmental conditions should be done before golf course construction.

• Journal of the Korean Society of Environmental Restoration Technology
• /
• v.18 no.3
• /
• pp.23-38
• /
• 2015

The study was initiated with Kentucky bluegrass (KB, Poa pratensis L.) to investigate germination and early establishment characteristics of new cultivars for a practical application to turfgrass establishment such as parks, athletic field and golf course etc. Fifteen cultivars were evaluated in different experiments. An alternative condition for a KB germination test required by International Seed Testing Association (ISTA) was applied in Experiment I, consisting of 8-hr light at $25^{\circ}C$ and 16-hr dark at $15^{\circ}C$ (ISTA conditions). Experiment II was conducted under a room temperature condition of 5 to $25^{\circ}C$ (natural conditions). Seed germinating vigor, germination speed and germination peak time were measured in both experiments. Significant differences were observed in seed germinating vigor, germination speed and germination peak time. Seed germinating vigor was variable with different environments and cultivars. It was 75.25 to 89.50% under ISTA conditions and 75.75 to 90.25% under natural conditions. There were considerable variations in early germination characteristics among KB cultivars according to different environments. Early germination characteristics showed that all cultivars were 3 to 5 days faster in germination under ISTA conditions, when compared with natural conditions. The germination speed, measured as days to seed germination of 50% to 80%, was much faster with 'Midnight II', 'Excursion' and 'Midnight' under ISTA conditions. But it was faster with 'Midnight II', 'Excursion' and 'Odyssey' under natural conditions. Differences was also observed in germination peak time with cultivars and growing conditions. It ranged 5.94 to 14.88 days under ISTA conditions and 4.71 to 13.06 days under natural conditions. Regardless of the environment conditions, the shortest cultivars were 'Odyssey' and 'Midnight II'. The longest ones were 'Nuglade' under ISTA condition and 'Moonlight' under natural conditions. Considering germinating vigor, germination speed and germination peak time, 'Midnight II', 'Excursion', 'Midnight', and 'Odyssey' were regarded as excellent cultivars under ISTA conditions in terms of early establishment characteristics, while 'Midnight II', 'Excursion', 'Odyssey', and 'Courtyard' under natural conditions. These results suggest that an intensive germination test be needed prior to planting, for investigating the early germinating vigor, germination speed and germination peak time. Also, a proper cultivar selection and comprehensive site analysis for the growing environmental conditions should be done before turfgrass establishment such as golf course construction.

• KOREAN JOURNAL OF CROP SCIENCE
• /
• v.42 no.1
• /
• pp.22-32
• /
• 1997

This experiment was conducted to obtain information for the cultivation of Korean valerian(Valeriana lauriei var. dasycarpa Hara) which will be useful for medicinal and aromatic resources. The effect of different temperature conditions, light intensities and soil water conditions on growth, yield and component of essential oil of V. fauriei were measured at the Dankook University, Cheonan, and a study on the shading treatment was at Umsung, Chungchongbukdo, and Jinbu, Kangwondo, in 1995. V. laudei was planted at five different temperature conditions, 10, 15, 20, 25 and 3$0^{\circ}C$, eight light intensity conditions, 1, 000, 2, 500, 5, 000, 20, 000, 30, 000, 40, 000, 50, 000 and 60, 000lux, six soil water contents, 30, 45, 55, 70, 80 and 90％ of the saturated soil, during growth stage. Shading treatment was three conditions, 0, 25 and 50％, during the daytime in field conditions. Photosynthesis had a highly significant relationship with temperature conditions in a quadratic regression model, from which the temperature for the plant growth was estimated to be 17.7$^{\circ}C$. A highly significant quadratic regression was noted between temperature and leaf width or root weight of V. fauriei. It was estimated from the regression equation that the optimum temperature for root growth was 20.3$^{\circ}C$. The content of essential oil and extract rate of root was the highest in the 15~2$0^{\circ}C$. Photosynthesis also was significantly affected by light intensity in a quadratic regression model, from which the optimum light intensity for the growth was estimated to be 40, 000lux. Root yield was more produced in Jinbu than that of in Umsung. The root yield was increased by the shading treatment in Umsung, whereas it was decreased by the shading treatment in Jinbu. The content of essential oil was not affected by the shading treatment of plants during the cultivation, while the compositions of components of essential oil were related to the growing locations. As soil water content was higher, the growth and content of root extract were increased. The optimum soil moisture for the growth of V. fauriei was 80~90％ of the saturated soil. In summary, the results indicated that the growth, yield and component of essential oil in V. fauriei were affected by environmental factors as well as soil moisture.

• Korean Journal of Fisheries and Aquatic Sciences
• /
• v.42 no.1
• /
• pp.8-14
• /
• 2009

To prevent the food poisoning originated by consumption of shellfish contaminated with domoic acid, the quantitative analysis of domoic acid is to be very important. The stability of domoic acid at different temperature, pH and light was investigated using high performance liquid chromatography (HPLC). The mean recoveries of domoic acid in the methanol extracts from oyster (Crassostrea gigas), blue mussel (Mytilus edulis), short neck clam (Ruditapes philippinarum) and ark shell (Scapharca broughtonii) were 85.4-104.5%, 94.8-101.2%, 91.0-104.6%, and 95.7-109.6%, respectively. The working solutions of domoic acid standard were very stable for one month at $-18^{\circ}C$, $4^{\circ}C$, and room temperature. And domoic acid in the methanol extract from oyster was stable for a day at $4^{\circ}C$ and room temperature, and for a week at $-18^{\circ}C$. Therefore, this implies that quantitative analysis for domoic acid must consider the storage conditions of the standard solutions and the methanol extracts from shellfish. The standard solutions adjusted to pH 3-9 were also stable after heating at $121^{\circ}C$ for 30 min. The effect of light exposure on domoic acid was tested by exposing the methanol extracts to light. Domoic acid degraded slowly when the samples were kept in the dark (brown vial). However, following the light exposure the photodegradation became more rapid; no detectable domoic acid remained in $1.0{\mu}g/mL$ of methanol extract after 5 hours.

• Journal of the Korean Solar Energy Society
• /
• v.37 no.1
• /
• pp.39-45
• /
• 2017

This paper presents the effect of solar collectors on the performance of solar tracking daylighting systems. A series of measurements were made for two different types of solar collectors mounted on double axis solar trackers: Parabolic dish concentrator and Fresnel Lens. Indoor light levels were measured at different locations of an office space (longitude: 126.33 E, latitude 33.45 N) as photo sensors were placed on a task plane 80 cm above the floor. To accurately monitor the applicability of the systems, measurements were performed under clear and overcast sky conditions with the roll-screen (on the south window) in the down position. Comparing the illuminance data, the system with Fresnel lens outperformed that of parabolic dish concentrator. On clear days, the former delivered the light levels of 400~600 lux on the task plane whereas the latter recorded 100~200 lux. Depending on the amount of cloud cover, on overcast days, illuminance readings fluctuated to some extent.