• Membrane Journal
• /
• v.8 no.3
• /
• pp.117-129
• /
• 1998

The atmospheric pollution by diesel emission is mainly attributed to particulate matters and NO$_x$. Their regulation limits have become tighter. This paper reviews the characteristics and the fabrication method of the diesd particulate filter(DPF) which is used to control the particulate matters of diesel emission. First the constituent of particulate matters and the regulation standard are discussed and then the state of the art post-treatment system is reviewed. The materials, the fabrication method and the control of thermal expansion of the ceramic honeycomb filter, which is widely used as the DPF, are also reviewed.

• Proceedings of the KSR Conference
• /
• 2007.11a
• /
• pp.994-999
• /
• 2007

The particulate matters emitted by diesel locomotives cause serious air pollution in stations and railroad. There have been various attempt to reduce the air pollution from diesel bus or trucks. However, the air pollution from the diesel locomotives has been out of control because there has not any adaptable technology. In this study, a diesel particulate filter was developed and applied to the diesel locomotives. A 3,000 horsepower large-scale locomotive and a 1,500 horsepower middle-scale locomotive were used for the test of the filter. The particulate matter emissions before and after the treatment was monitored by a scanning mobility particle sizer and a dust monitor. As a result, it was observed that the particulate matters could be successfully removed from the emission gases by using the filter.

• Proceedings of the KSME Conference
• /
• 2003.04a
• /
• pp.2245-2250
• /
• 2003

Particulate matters(PM) have bad effect on the health. We carried out measurements of diesel PM under $10{\mu}m$ diameter from a HSDI diesel engine with a diesel oxidation catalyst(DOC) by using the ELPI. This paper compares the two results of the smoke level and the PM level of masses and numbers. We also investigated the effect of the DOC. Under high speed and load, HSDI diesel engine exhausts much masses of particulate matters over 100nm diameter, and a number of PM from 7 to 100nm diameters at the same condition. DOC could reduce the total mass of the PM. However, the DOC could increase the number of ultra fine PM. Before light-off of the soot, the DOC absorb the PM and the DOC oxidize the PM after light-off temperature. The fine PM could be made during the oxidation. Therefore, the advanced DOC is needed to reduce the number of the fine PM.

• Transactions of the Korean Society of Automotive Engineers
• /
• v.14 no.3
• /
• pp.75-80
• /
• 2006

Since air pollution has become a globally critical issue and exhaust emissions from automobiles cause a major source of air pollution, many countries including advanced countries have stipulated stringent emission regulations. Particularly in diesel vehicles, NOx and particulate matters exhaust in significant amounts even though diesel vehicles provide merits in aspects of higher thermal efficiency and lower $CO_2$. To reduce Particulate matters and NOx, after-treatment technology such as filter trap, oxidation catalysts and EGR has been applied. This test was conducted on the effect of continuous regeneration diesel particulate filter and cooled-EGR, and 15ppm low sulfur diesel was used as a test fuel. Exhaust emissions, PM, NOx, CO, HC and Soots were measured and compared under D-13 and D-3 modes.

• Transactions of the Korean Society of Automotive Engineers
• /
• v.9 no.6
• /
• pp.8-15
• /
• 2001

An aftertreatment system of diesel exhaust gas was attempted to extract particulate matters. The system consisted of a corona-less electrostatic precipitator to agglomerate soot particles and a counter-flow cyclone to collect them. When the effect of high voltage was examined at different configuration of electrode plates, the case of positive 15kV at both plates showed the maximum reduction of 38% in diesel smoke level. However, the back pressure became quite high as engine speed increased, so that minimizing pressure drop in cyclone should be studied with improving collection efficiency of soot particles.

• Proceedings of the KSR Conference
• /
• 2008.11b
• /
• pp.1646-1651
• /
• 2008

Due to the complaints on the emission gases from diesel locomotives, the diesel locomotives are replaced by electric locomotives, resulting in the decrease of diesel locomotives in Korea. However, the emission gases from diesel locomotives have become serious environmental concern at stations and car depots. In this study, a diesel particluate filter (DPF) for diesel locomotive was developed in order to reduce the emission gases. The concentration of nano particulate matters before and after the DPF was analyzed using a SMPS (Scanning mobility particle sizer) and MOUDI (Micro orifice uniform deposited impactor) to evaluate the performance of DPF in particulate matters removal.

• Fire Science and Engineering
• /
• v.26 no.4
• /
• pp.70-76
• /
• 2012

This paper deal with vehicle fire caused by damage of diesel particulate filter (DPF) on diesel passenger vehicles. In order to reduce particulate matters included exhaust gases, a DPF in the exhaust system were installed diesel vehicles. A DPF was broken by excessively trapped particulate matters, regeneration error with a malfunction of ECU and defect of suction system such as swirl valve. If the DPF was broken, hot exhaust gases was released to the bottom of vehicle and released hot exhaust gases lead to occur the fire through combustible materials around the exhaust system. When a fire happened in the diesel vehicle caused by damage of DPF, silicate inorganic compounds were attached to the exhaust ventilation pipe and muffler. The silicate inorganic compounds were created by DPF combustion consisting of raw material ceramics. If the silicate inorganic compounds attached to the tail pipe in the diesel passenger vehicles, its fire cause will be assumed damage of DPF.

• Transactions of the Korean Society of Automotive Engineers
• /
• v.21 no.5
• /
• pp.176-180
• /
• 2013

After-treatment apparatus ceramic DPF (diesel particulate filter) have been applied to reduce harmful particulate matters(PM) among emissions from diesel engines so far, but they are easy to be fragile and weak in thermal shock. This research aims to investigate a metal type filter which is superior in mechanical strength and heat conduction rate and is beneficial economically in manufacturing. Basic performance of metal DPF such asloading test, temperature gradient test, thermal shock test, heat resistant test and back pressure was carried out. And then their experimental data provided key informations in designing and manufacturing such as detailed structures of metal mesh filter. Also diesel engine and vehicle of 2957cc displacement was tested under lug-down 3 mode and CVS-75 mode. PM reduction efficiency was 54.5% using metal DPF without loss of performance and fuel consumption.

• Transactions of the Korean Society of Automotive Engineers
• /
• v.16 no.1
• /
• pp.114-120
• /
• 2008

Recently, the nano-PM's number concentration emitted by diesel internal combustion engine has focused on attention because this particulate matters are suspected being hazardous of human health. In this study, The nano-PM mass and size of diesel passenger vehicles were measured on chassis dynamometer test bench. The particulate matters(PM) emissions of these vehicles were investigated by number concentration too. A condensation particle counter(CPC) system was applied to measure the particle number and size concentration of diesel exhaust particles at the end of dilution tunnel along the NEDC(ECE15+EUDC) and CVS-75 vehicle test mode. As the research result, the characteristic of vehicle test mode on the diesel nano-particle number and size distribution was investigated in this study.

• Journal of Korean Society for Atmospheric Environment
• /
• v.10 no.E
• /
• pp.325-331
• /
• 1994

Organic extracts of diesel- exhaust particulates were analyzed for mutagenicity using Ames Salmonella typhimurium assay system. An experimental diesel microbus used was drived on the chassis dynamometer according to CVS-75 mode. The samples were taken from the mixed gases in a dilution tunnel. With a high-volume air sampler equipped with double filter holders, particulate matters were collected on a teflon-coated glass fiber filter placed behind a activated carbon filter. After ultrasonic extraction with benzene- ethanol and evaporation to dryness, the residue was dissolved in dimethylsulfoxide. Each sample was tested toward 2 strains, TA100 and TA98 by the pre-incubation method in the absence and presence of S-9mix. Average concentration of diesel- exhaust particulates was about 116.6mg/m$^3$, and 44.1~62.2 ％ to the total weight of particulates, consisted of organic matters. The mutagenicities of diesel- exhaust particulate organic matters were 4,512 and 2,205 revertants/m$^3$ toward TA100 without and with S-9mix, respectively. Those toward TA98 were 13,367 and 3,715 revertants/m$^3$, respectively.