• 한국해양환경ㆍ에너지학회지
• /
• 제2권1호
• /
• pp.34-39
• /
• 1999

Removal of spilled oil over the sea and the river has become one of the urgent problems in these days. Removing oil using mechanical devices by adhesion method is known to be closely related with the problem of estimating the thickness of film remaining on the surface of solid withdrawn from a quiescent liquid. In the present study a series of experimental results are compared with the analytic estimation for the thickness of film remaining on the solid surface using non-dimensional analysis. For the case of pure water both results show the remarkable agreement. However, discrepancy has been found for the case of Bunker C oil and diesel oil. The analytic estimation over-predicts the experimental value for the case of Bunker C oil and under-predicts it for the case of diesel oil. Further study is required to investigate the real situation including a contact angle and the property difference between oil and water.

• Tribology and Lubricants
• /
• 제22권5호
• /
• pp.290-300
• /
• 2006

The dielectric constants of used diesel engine oils were obtained at a few temperatures and a frequency. Through analyzing the characteristics of dielectric constant, the related correlation between the changes in dielectric constants of oil and the degree of oil deterioration is going to be found. The dielectric constant was calculated using cross capacitances measured by a sensor tube. As results of the measurement of the fresh engine oil's dielectric constant, it was found that the value of dielectric constant was set down below $60^{\circ}C$ regardless changing frequency. Further, above 6 kHz, the dielectric constant was set down even if temperature was above $100^{\circ}C$. Therefore, for the measurement of used oils, it was selected the frequency of 6 kHz, and the temperature of $80^{\circ}C$ preventing a certain ionic-conduction effects on the measured dielectric constant and the evaporation of a certain fluid mixed with engine oil. Specially, the effects of the mixing fluid like coolant, water and fuel on the fresh engine oil's dielectric constant were studied. It was found that the oil mixed with coolant showed the highest value, next water, and the lowest fuel. As results of the measurement of the used engine oil's dielectric constant, it was found that the possible changed rate of the used engine oil's dielectric constant based on the warning limit for engine oil in service was below 10% for diesel engine oil.

• 한국철도학회:학술대회논문집
• /
• 한국철도학회 2011년도 정기총회 및 추계학술대회 논문집
• /
• pp.861-864
• /
• 2011

Since national GHG reduction target by 2020 has been presented in Korea, the role of railroad has been reinforced within transport system due to the allocation of reduction target into sector. So, it is necessary to manage activity data systematically for the calculation of GHG emission in railroad. Now, the activity data of diesel consumption for NIR(National Inventory Report) are provided from oil supply and demand statistics. On the other hands, the activity data collected directly from railroad operating companies are used for GHG & Energy Target Management Act. This study aimed to assess the GHG emissions using two kinds of activity data related to the diesel consumption of railroad in 2009 and 2010. As a result, GHG emissions based on oil supply and demand statistics was 636 thousands ton $CO_{2e}$, but the activity data collected from railroad operating companies showed 649 thousands ton $CO_{2e}$ in 2009. Also, the gap of $CO_{2e}$ emission was increased in 2010. These trends were caused because oil supply and demand statistics included total diesel sales volume during 1 year and the activity data collected from railroad operating companies were the amount of diesel consumption only at railcar operation and maintenance step. In conclusion, it is important to develop the management and verification system of activity data with high reliability to substitute oil supply and demand statistics in railroad sector.

• 대한기계학회논문집
• /
• 제16권1호
• /
• pp.180-188
• /
• 1992

본 연구에서는 와류실식 디젤 기관에 경유-물의 유화연료 사용시 시관의 회전 속도(1500rpm)가 일정인 경우 물의 첨가량(체적비, 0~20%)과 기관의 부하(BMEP,2.1~ 7.5kg/$\textrm{cm}^2$)변화에 따른 연소실내 압력, 압력상승률 및 열발생률, 착화지연 기간, 연료 소비율 등의 연소특성과 CO, HC, NOx 및 매연의 배출능도 등 유해 배출 가스에 미치는 영향에 관하여 실험적으로 구한 것이다.

• Journal of Advanced Marine Engineering and Technology
• /
• 제30권5호
• /
• pp.552-561
• /
• 2006

The single droplet combustion characteristics of diesel fuel and low quality oil with additive oxygenate and paraffin under high ambient temperature and atmospheric pressure were investigated in the study. The results of the study may are concluded as follows: In the combustion of diesel fuel and low quality oil droplet with additive of oxygenate and paraffin. the dimensionless droplet size of $(D/Do)^2$ was linearly decreased with time. A fuel droplet with low boiling temperature additives and in high boiling temperature base fuel evaporates and burns faster than usual base fuel. Especially. these trends were remarkably obtained by decreasing boiling point and increasing blending contents of additives in case of oxygenated agents rather than n-paraffin agents. This rapid burning may result from so-called 'micro-explosion' and its burning intensity varies with the types of additives. The results above may suggest that rapid evaporation of oxygenate additive in the middle stage of combustion can contribute much to combustion improvement of blended fuels.

• 한국항공운항학회지
• /
• 제32권2호
• /
• pp.151-158
• /
• 2024

Microalgae are aquatic microorganisms capable of photosynthetic growth using water, carbon dioxide and sunlight, and can replace petroleum for transportation. It is receiving great attention as a potential next-generation biological resource. The microalgae biodiesel production process is largely based on the development of highly efficient strains and mass production. It consists of cultivation, harvesting, oil extraction, fuel conversion and by-product utilization. Currently, microalgae diesel is 3-5 times more expensive than petroleum diesel. However, with the optimization of each element technology and the development of integrated systems, not only biofuels, but also industrial materials, wastewater treatment, and greenhouse gases As application expands to various fields such as abatement, the timing of commercialization may be brought forward. Oil prices have recently fallen due to the influence of sail gas. Although there has been a significant drop, global warming is an urgent challenge for current and future generations. In particular, Korea, which does not have oil resources, We must always prepare for political environmental changes, high oil prices, and energy crises. In this paper, the need for eco-friendly biofuel for carbon dioxide conversion. In addition to research trends, domestic and international research trends, and economic prospects, the concept of microalgae and the element technologies of the biodiesel production process are briefly discussed introduced.

• 임산에너지
• /
• 제7권1호
• /
• pp.28-36
• /
• 1987

To know the possibility of fuel substitution for Diesel engine with the seed oil of Evodia daniellii, which is one of the native oil seed trees in Korea. the refined seed oil mixed with light oil in the various rates was tested in the 8 PS Diesel engine: the output, the fuel consumption rate, the governor performance, the rpm stability in the total loading condition. the content of graphite in the burned gas, and the traction coefficients at the different gear stages were maintained The following results were discussed. 1. The output at the normal revolution (2200rpm)was increased as the percent seed oil increased. At the lower rpm (2000-1500rpm )there were no consistent difference in the outputs among fuels of the different percent seed oil 2. The rate of fuel consumption was inclosed as the percent seed oil increased in each loading condition. 3. The more percent sud oil was mixed in the fuel. the better governor performance appeared at both the instantaneous and stable speed. 4. The more percent seed oil was mixed In the fuel, the more stable rpm ratio was maintained 5. The graphite content In the burned gas was increased as the load increased, but there was no apparent difference in the content at each load among the 100$\%$ seed oil, the 100$\%$ light oil, and the mixtures in various rates. 6. In all fuel mixtures the maximam traction coefficent appeared at the third transmission gear stage. Generally in over all transmission gear stages the fuel mixtures of the seed oil:light oil ratio from 7:3 to 5:5 resulted greater traction force than the other fuels.

• Journal of Advanced Marine Engineering and Technology
• /
• 제34권2호
• /
• pp.243-249
• /
• 2010

디젤기관에 있어서 PM과 NO의 동시저감을 위한 에멀전연료의 적용은 급속도로 발전되어져왔다. 하지만, C중유 에멀젼연료의 연소계측 해석은 다른 연료에 비하여 복잡한 연소형태 때문에 어려움이 많다. 본 연구에서는 높은 압력과 온도의 정적연소실에서 에멀젼 C중유를 분사 연소시켜, 연소해석에 대한 실질적인 근거를 제시한다.

• 한국가스학회지
• /
• 제11권1호
• /
• pp.9-12
• /
• 2007

본 연구에서는 디젤기관에서 배출되는 배출가스의 저감을 위하여 경유와 천연가스의 혼합비율이 서로 다르게 연료의 분사량을 조절 전부하 운전시의 토크값을 4:0, 3:1, 2:2및 1:3의 4종류로 설정 디젤기관의 연소특성을 살펴보았다. 엔진회전수의 변화에 의한 배출가스의 변화를 알아보기 위하여 회전수를 1500, 2000, 2500 및 3000 rpm으로 설정 NOx, 흑연, 일산화탄소 및 탄화수소의 배출농도값을 측정하였다. 그 결과 디젤연료만을 사용하였을 경우보다 천연가스를 혼합하였을 경우 NOx, 일산화탄소 및 탄화수소의 배출농도는 다소 증가하였으나, 흑연의 배출농도는 감소하는 경향을 나타내었다.

• 대한환경공학회지
• /
• 제22권11호
• /
• pp.1977-1983
• /
• 2000

천연가스를 사용하는 복합화력발전소에서 발생되는 질소산화물(NOx)에 대한 귀금속촉매(Pt/Zeolite)의 활성을 디젤유를 환원제로 사용하여 파일럿 규모의 선택적촉매환원장치(selective catalytic reduction)에서 환원제 주입량, 반응온도, 공간속도에 따라 고찰하였다. 시험결과, 디젤유의 주입량을 증가시킬수록 NOx의 전환율은 증가하였으며 C/N비(C/N비: 배기가스 중에 포함된 NOx의 분자수에 대한 환원제 탄소 원자수의 비) 5.5 이상에서는 일정한 전환율을 유지하였다. NOx 전환율에 대한 반응온도의 영향을 알아본 결과, 온도가 증가함에 따라 NOx의 전환율이 증가하여 $190^{\circ}C$의 온도에서 최고 50%의 전환율을 보였다. 7,200/hr~27,000/hr의 범위에서 NOx 전환율에 대한 공간속도의 영향은, 18,500/hr까지 일정한 전환율을 유지하였으며 그 이상에서는 감소하였다. 이상의 결과에서 디젤유를 환원제로 사용하는 질소산화물 제거를 위한 SCR 공정의 적용 가능성을 확인할 수 있었다.