• The Journal of Korean Institute of Electromagnetic Engineering and Science
• /
• v.15 no.8
• /
• pp.765-774
• /
• 2004

In this paper, a novel approximate solution for scattering by a very thin planar homogeneous dielectric scatterer with an arbitrary shape is formulated. This solution is based on a volumetric integral equation and is expressed in terms of Fourier transform. It is shown that the obtained solution is reduced to an exact solution for an infinite dielectric slab. For 2D, or 3D scatterers, the formulation is verified numerically. Especially fur edge-on TM polarized wave incidence a closed-form solution of backscattering from a thin dielectric half-plane is formulated, which is very accurate for wide range of normalized surface impedance except very low impedances(│η│〈0.5).

• Progress in Superconductivity and Cryogenics
• /
• v.17 no.3
• /
• pp.33-36
• /
• 2015

A liquid nitrogen ($LN_2$) is usually used to be a coolant and insulant for a HTS coil system. HTS wires for a superconducting apparatus may be surrounded by gaseous nitrogen ($GN_2$) due to film boiling generated by a quench or voids occurred by electrical breakdown. The increased maximum electric field intensity at $GN_2$ may result in the degradation of dielectric strength of a HTS coil system. In this paper, a study on the dielectric characteristics of a composite insulation system composed of $LN_2$ and $GN_2$ is performed. A sphere-to-plane electrode system made with stainless steel is used to perform the experiments under AC and lightning impulse voltage condition. A sphere electrode is surrounded by $GN_2$ and a plane electrode is immersed into $LN_2$ to conduct dielectric experiments with a composite insulation system. The dielectric experiments are performed according to the level of $LN_2$ from the plane electrode to a sphere electrode. It is found that the dielectric characteristics of a composite insulation system are dependent on the level of $LN_2$ and the field utilization factor of an electrode system.

• The Journal of Korean Institute of Communications and Information Sciences
• /
• v.11 no.6
• /
• pp.371-378
• /
• 1986

In the reflection and transmission of a transverse magnetic wave(TM wave) from a dielectric plane osillating sinusoidally perpendicular to ist surface, one could assume that the boundary moves with a uniform nelocity equal to the instantaneous socillating velodity. According to the extended Lorentz transform, the reflected and the transmitted field are obatained as the function of the dielectric permittivity, the oscillating velocities, and the incident angles. The above results are analyzed graphically.

• Proceedings of the Optical Society of Korea Conference
• /
• 2000.02a
• /
• pp.146-147
• /
• 2000

The electromagnetic wave scattering from active objects has only recently attracted attention.$^{(1).(3)}$ Theoretical studies have considered normal-incidence plane-wave interactions with active dielectric cylinders with the prediction of large enhancements in the scattered field for bound mode structures. According to the theory of the electromagnetic wave scattering from a dielectric cylinder, the eigenvector solutions are discrete and have both guided (non-radiative) and leaky (radiative) mode solutions. By using an anti-guiding (leaky) structure instead of a guided structure and scattering at oblique incident angles near critical angle, the scattering resonances predicted by theoretical studies were obtained for the first time. A fine-grained scan of the plane-wave incident angle a reveals the existence of discrete scattering resonances. The diameter and real part of the index of refraction determine the resonant conditions and the imaginary part of the refractive index has a threshold value to make mode up for its radiation loss. The cross coupling between transverse electric (TE) and transverse magnetic (TM) modes is clearly detected for both active and passive scattering as theoretically expected. (omitted)

• Proceedings of the KIEE Conference
• /
• 1996.07c
• /
• pp.1870-1872
• /
• 1996

This paper presents dielectric characteristics of $SF_6$ gas stressed by the non-oscillating and oscillating impulse voltages in inhomogeneous fields disturbed by metallic protrusion. The propose of this investigation is to present the predischarge development and dielectric characteristics of $SF_6$ gas under VFTOs. The experiments were carried out using a needle-to-plane and two needles-to-plane gap geometries in the gas pressure ranges from 0.1 to 0.5 MPa. The gap separation was 22 mm and the needle-shaped protrusions were made of stainless steel 10 mm in length and 1.0 mm in diameter. As a result, it was found that the breakdown mechanism and predischarge current are principally dependent on applied voltage waveform and polarity.

• The Journal of Korean Institute of Electromagnetic Engineering and Science
• /
• v.11 no.2
• /
• pp.217-227
• /
• 2000

A rectangular ceramic dielectric antenna, placed on the top of a ground plane and fed by coaxial probe, is analyzed by using the finite element method. To verify the proposed code, a rectangular ceramic dielectric antenna was fabricated and the characteristics of antenna were measured. The numerical data obtained is in good agreements with experimental result. Thus we checked the validity of our FEM code, and it can be possible to extend the analysis of the arbitrary 3-D antenna on a ground plane fed by coaxial probe.

• The Journal of Korean Institute of Communications and Information Sciences
• /
• v.22 no.4
• /
• pp.605-610
• /
• 1997

An analysis method for the electromagnetic scattering of a Tm polarized plane wave from a periodic strip grating over a grounded dielectric slab is considered from the viewpoint of reflection grating problem. The parameters of strip gratings showing Bargg and Off-Bragg blazing phenomena at the frequency of 10GHz are derived teoretically. The strip grating structure is implemented using Aluminum plate(groung conductor), paraffin(dielectric material.epsilon.$_{r}$=2.24), and copper(strip conductor0.08m thickness). The experimental results(reflection power) of Bragg as well as Off-Bragg blazing phenomenon for TM polarized plane wave have been compared with the theoretical results and fairly good agreements between theory and experiment have been observed.d.

• Journal of electromagnetic engineering and science
• /
• v.18 no.1
• /
• pp.52-57
• /
• 2018

Surface dielectric barrier discharge (SDBD), which is widely used to control turbulence in aerodynamics, has a significant effect on the radar cross-section (RCS). A four-way linearly synthesized SDBD air plasma actuator is designed to bolster the plasma effects on electromagnetic waves. The diffraction angle is calculated to predict the RCS because of the periodic structure of staggered electrodes. The simplified plasma modeling is utilized to calculate the inhomogeneous surface plasma distribution. Monostatic RCS shows the diffraction in the plane perpendicular to the electrode array and the notable distortion by plasma. In comparison, the overall pattern is maintained in the parallel plane with minor plasma effects. The trends also appear in the bistatic RCS, which has a significant difference in the observation plane perpendicular to the electrodes. The peaks by Bragg's diffraction are shown, and the RCS is reduced by 10 dB in a certain range by the plasma effect. The diffraction caused by the actuator and the inhomogeneous air plasma should be considered in designing an SDBD actuator for a wide range of application.

• Journal of Advanced Navigation Technology
• /
• v.14 no.1
• /
• pp.11-19
• /
• 2010

In this paper, H-plane filtering-horn antenna operating at millimeter frequency band is proposed with embedded filter and three-layered dielectric lens for frequency selection and maintenance of main beam direction, respectively. The waveguide-typed filter and H-plane sectoral horn antenna are replaced with considerably size-reduced PCB substrate-typed filtering antenna using via fences and several posts. The waveguide-typed filter and H-plane sectoral horn antenna were designed in air-filled waveguide and then combined into size-reduced PCB substrate. For the control of the thickness of dielectric lens, single and multi dielectric lens have been employed. As a result of antenna gain, 8 and 13.5 dBi have been obtained at 41.5 GHz, respectively, from the simulations of single and multi-lens antennas.

• The Journal of Korean Institute of Communications and Information Sciences
• /
• v.10 no.4
• /
• pp.193-200
• /
• 1985

In the reflection and transmission of a plane wave(TE) from a dielectric plane surface oscillating sinusoidally perpendicular to its surface, one could assume that the boundary moves with a uniform velocity equal to the instantaneous oscillating velocity. The reflected and the transmitted fields are obtained as the function of the incident angles, the dielecri'c permittivity, and the oscillating velocities according to the extended Lorentz transform.