• Korean Journal of Breeding Science
• /
• v.41 no.3
• /
• pp.271-278
• /
• 2009

The growth performance of eastern white pine (Pinus strobus L.) was studied with six provenances originated from U.S. in a Hwasong plantation. Height and diameter growth were significantly different among provenances. In general, the growth of southern provenances were larger than that of northern provenances. Georgia and North Carolina provenances proved to be appropriate ones in our plantation, while Minnesota was worst in growth. Annual height growth was still increased at age 27, whereas annual diameter growth was highest at age 11, after that growth rate was gradually decreased. Pearson's correlation among ages was highly positively correlated. The rank of growth has not almost been changed from juvenile stages to at age 27.

• Korean Journal of Agricultural and Forest Meteorology
• /
• v.10 no.1
• /
• pp.9-16
• /
• 2008

In this study we investigated the effects of the microclimatic conditions on tree growth in different site types for natural deciduous forests in Korea. First, we classified all the sites into 36 types according to their aspect (east, west, south, and north), elevation (higher than 1,000 m, 700$\sim$1,000 m, and lower than 700 m), and topographical conditions (ridge, slope, and valley). For each site type, we measured diameter growth with increment borer, and then estimated periodic annual increment of diameter, height and volume. We applied a topoclimatological technique for estimating microclimatic conditions, and produced monthly climatic estimates from which 17 weather variables (including indices of warmth, coldness, and aridity) were computed for each site type. The periodic annual increments of diameter, height, and volume were then correlated by regression analysis with those weather variables to examine effects of microclimate on tree growth by site type. We found that the correlation of diameter growth by site type was significantly correlated with most weather variables except daily photoperiod. Water condition was the most important factor for the height growth. For volume growth, on the other hand, the conditions such as relatively high temperature and low humidity provided favorable environment. Our regression analysis shows that aridity index is a good predictor for tree growth including diameter, height and volume increments.

• Plant Disease and Agriculture
• /
• v.1 no.2
• /
• pp.18-21
• /
• 1995

Mycosphaerella nawae, the causal organism, of spotted leaf casing disease of persimmon, was isolated from infected leaves showing typical symptom. The cultural characteristics of the fungus were compared on artificial media. Among 24 different combinations of culture media and supplements, oatmeal agar+persimmon leaf extract (PLE) and PAD+ PLE+streptomycin showed the highest rate of isolating as 57.1%. The best medium for mycelial growth of the fungus was PDA+persimmon leaf powder (PLP). The colony diameter was reached 47mm for 30 days at 2$0^{\circ}C$. PDA+PLE also supported good mcyelial growth showing 46mm of diameter in same condition. The optimum growth temperature of this fungus in PDA was recognized fairly low. The mycelial growth was higher at 2$0^{\circ}C$ than 15$^{\circ}C$. The variation of pH between pH 4 to pH 8 did not affect to the mycelial growth of the pathogen.

• Journal of Korean Society of Forest Science
• /
• v.74 no.1
• /
• pp.61-66
• /
• 1986

This study was conducted to estimate the heritabilities of height and stem diameter growth in 5- and 6-year-old Pinus koraiensis. Estimates of individual tree and family heritability for height growth were $h^2_I=0.40$, $h^2_F=0.77$ in 5-year-old and $h^2_I=0.57$, $h^2_F=0.89$ in 6-year-old, respectively. Heritabilities for diameter growth were estimated as $h^2_I=0.16$, $h^2_F=0.53$ and $h^2_I=0.26$, $h^2_F=072$ in 5-and 6-year-old seedlings.

• Journal of Korean Society of Forest Science
• /
• v.90 no.4
• /
• pp.445-449
• /
• 2001

The objective of this study was to develop a new technique to control crown form of Hiscus syriacus to be used for an upright street tree with a single stem. Fertilization and raising the clear-bole length were the main treatments to compare the diameter and height growth of this species. The trees maintained with clear-bole length of 100, 150, and 200cm showed diameter growth of 15.7. 13.8, and 10.8mm, respectively, indicating the reduced diameter growth of trees with increasing clear-bole length, which is known as a typical characteristics in tending trees in silviculture. The effects of fertilization was not shown in this study. At the end of the two-year study from 1999 to 2,000, optimum diameter growth was obtained with the treatments of clear-bole length of 80-120cm, or 121-150cm. It is concluded that height and clear-bole length should be considered first in raising Hibiscus syriacus for street trees. Further study may be needed to obtain the effects of fertilization and raising the clear-bole length on uprightness of this species.

• Journal of Forest and Environmental Science
• /
• v.30 no.2
• /
• pp.218-225
• /
• 2014

Studies were carried out to standardize and develop a suitable macro-propagation technology for large scale production of superior clonal stock through stem cuttings in Commiphora wightii Arnott (Bhandari), a data deficient medicinal plant of arid region. For the purpose, three experiments were conducted. The first experiment was tried to elucidate the impact of various cutting diameters (0.50-0.75 cm, 0.75-1.00 cm, 1.00-1.50 cm, and >1.50 cm) in combination with varying growing conditions (sunlight, shade house and mist chamber) on shoot sprouting and rooting without using exogenous plant growth regulators. Cutting diameter (size 0.75-1.00 cm) in mist chamber has shown maximum sprouting (90.00%) and rooting (73.33%), primary root (6.67) and secondary root (16.67) followed by 1.00-1.51 cm in mist chamber. Minimum sprouting (40.00%), rooting (33.33%), number of shoot (1.33), primary root (1.00) and number of secondary root (1.00) was recorded in cutting diameter (size >1.50 cm) in sunlight. Second experiment was performed to find out optimum growth regulator concentration of rooting hormone (100, 200, 500 and 1000 ppm) of Indole-3-acetic acid (IAA) and Indole-3-butyric Acid (IBA) on adventitious root formation on cuttings diameter (size 0.25-0.50 cm) in comparison to control. Maximum rooting percentage (93.33%) was recorded in 200 ppm followed by 500 ppm (86.66%) of IBA as compared to control, which showed only 60 per cent sprouting. Third experiment was performed with newly formed juvenile micro-cuttings treated with varying concentrations of IAA and IBA. The juvenile cuttings (size 6-10 cm, basal dia <0.25 cm) were selected as micro-cuttings. The cuttings treated with IBA (500 ppm) showed 64.30% rooting as compared to other treatments. Results of above experiments indicate that cuttings (size 0.75-1.00 cm dia) may be developed in mist chamber for better performance. While using heavier cuttings, no growth promoting hormones is required however; growth regulator 200 ppm concentration of IBA rooting hormone was observed optimum for promoting macro-propagation in stem cuttings of lower diameter class (0.25-0.50 cm).

• Journal of the Korean institute of surface engineering
• /
• v.52 no.6
• /
• pp.357-363
• /
• 2019

We investigated a synthesis yield and diameter distribution of single-walled carbon nanotubes (SWNTs) with respect to the growth position in a horizontal chemical vapor deposition (CVD) chamber. Thin films and line-patterned Fe films (0.1 nm thickness) were prepared onto ST-cut quartz substrates as catalyst to compare the growth behavior. The line-patterned samples showed higher growth density and parallel alignment than those of the thin film catalyst samples. In addition, line density of the aligned SWNTs at central region of the chamber was 7.7 tubes/㎛ and increased to 13.9 tubes/㎛ at rear region of the CVD chamber. We expect that the enhanced amount of thermally decomposed feedstock gas may contribute to the growth yield enhancement at the rear region. In addition, the lamina flow in the chamber also contribute to the perfect alignment of the SWNTs based on the value of gas velocity, Reynold number, and Knudsen coefficient we employed.

• Journal of Korea Foresty Energy
• /
• v.19 no.1
• /
• pp.1-6
• /
• 2000

This study was carried out to investigate the growth responses of Pinus densiflora seedlings to enhanced UV-B environment for 16 weeks in the field condition. The seedlings were treated with one of three levels of UV-B dosages - ambient UV-B, ambient + 3.2, and ambient + 5.2 KJ m$^{-2}$day$^{-1}$ and the irradiation was performed at the stage before the germination, the fully expanded cotyledon, and the primary needles grown more than 0.8cm in length of the seedlings, respectively. Enhanced UV-B irradiation reduced the height and the root collar diameter growth, and dry mass production of the seedling, and T/R ratio was increased by the UV-B treatment. Difference in seedling growth was observed by difference in time of the UV-B treatment. Among the seedlings which were treated with ambient - 3.2 KJ m$^{-2}$day$^{-1}$, height and root collar diameter growth was relatively high in the seedling received the UV-B treatment at the stage before the germination. The lowest dry mass production was observed in the seedlings received the UV-B at stage of cotyledon both in two levels of enhanced UV-B treatment. Chlorophyll concentration was reduced by enhanced UV-B irradiation, and chlorophyll a/b ratio was increased by the UV-B treatment.

• FLOWER RESEARCH JOURNAL
• /
• v.17 no.4
• /
• pp.256-261
• /
• 2009

This study was carried out to examine the effects of cutting condition on the rooting and their subsequent growth of cut flower in plug cutting of summer-flowering chrysanthemum 'Iwanohakusen'. The more leaves were attached to the cutting, the higher shoot growth and rooting were. Shoot growth of cuttings was not affected by cutting length, but rooting was better in over 5 cm long cutting. Shoot growth was enhanced by increasing thickness of cutting, and 5.5 mm thick cutting was favored in rooting. When the many leaves were attached on the cutting, the length and weight of cut flower increased. Over 7 cm long cutting showed higher values in growth of cut flower and ray flower number. Cutting of 5.5 mm diameter showed more favorable growth of cut flower than the other treatments. Therefore, it is concluded that rooting of cutting and consecutive growth of cut flower was improved when 7 cm long and 5.5 mm diameter cutting with 4 leaves was used in plug cutting of chrysanthemum 'Iwanohakusen'.

• Journal of Ecology and Environment
• /
• v.29 no.3
• /
• pp.185-189
• /
• 2006

Optimum tapping size and number for sap collection were investigated to minimize damage on tree growth and secure resources for sap by sap collection of Acer mono. The amounts of sap collected by tapping size of 12 mm, 10 mm and 8 mm was 189 L, 140 L and 193 L, respectively. Fusion rates by tapping size were 100% for 8 mm, 89% for 10 mm and 85% for 12 mm, respectively. Amount of sap by size and number of tapping were much at three, two and three tappings to small, middle and large diameter tree in case of 8 mm tapping, and it was large in quantity at two tappings of 12 mm tapping to large diameter tree, respectively. Trees tapped from one to three tappings of 8 mm size for small diameter tree with treatment of DB ointment (mixture of thiophane ointment and 2% bamboo charcoal powder) were completely filled up within 6 months. Diameter growth by number of tapping of 8 mm size was 0.60 mm for one tapping, 1.12 mm for two tappings and 0.47 mm for three tappings to small, middle and large diameter tree, respectively. In case of 12 mm tapping size, diameter growth was fast in the order of large (0.55 mm), middle (0.30 mm) and small (0.23 mm) diameter tree, respectively.