• Proceedings of the KIEE Conference
• /
• 1995.07b
• /
• pp.735-737
• /
• 1995

Linear pulse motor(LPM) has been used in a wide range of application due to many advantages for the precision position and speed control system for the bidirectional linear motion. In this study, the hybrid, single-side type LPM was designed and examined for characteristics of position detection. Precision position detection signals could be sensed by synchrnous rectifier method from the LPM stator scale. Experimental results show that the position precisions are good enough to perform the LPM position control.

• Journal of the Semiconductor & Display Technology
• /
• v.12 no.3
• /
• pp.29-34
• /
• 2013

Solar cell has been considered as renewable green energy. Its silicon wafer thickness is thinner due to manufacturing cost and accordingly micro cracks is often generated in the process. Micro cracks result in bad quality of solar cell, and so their accurate and reliable detection is required. In this paper, near-infrared optics system is newly designed based on the analysis of near-infrared transmittance characteristics and its important parameters are optimally selected using the design of experiment for micro crack detection in solar cell wafer. The performance of the proposed method is verified using several experiments.

• Proceedings of the Korean Institute of Electrical and Electronic Material Engineers Conference
• /
• 1999.11a
• /
• pp.286-289
• /
• 1999

In order to detect the partial discharge with the metallic particle in GIS, AE sensor was designed and simulated by ANSYS, and manufactured as the coupled vibration mode. The resonant frequency of three Coupled AE sensors were as follows ; 147.88 kHz in 8.1 mm$\Phi$ $\times$ 8.1mm, 128.82 kHz in 9.5 mm$\Phi$ $\times$ 9.5mm, 85.22 kHz in 14.3mm$\Phi$ $\times$14.3mm. That frequency is λ/2 resonant frequency. AE sensor of 9.5mm$\Phi$ $\times$9.5mm responded higher than the other coupled vibration mode AE sensor at the partial discharge detection in GIS.

• Journal of Electrical Engineering and Technology
• /
• v.9 no.4
• /
• pp.1171-1181
• /
• 2014

Different power quality (PQ) disturbance sources can have major impacts on the power supply grid. This study proposes, for the first time, an early warning approach to identifying PQ problems and providing early warning prompts based on the monitored data of PQ disturbance sources. To establish a steady-state power quality early warning index system, the characteristics of PQ disturbance sources are analyzed and summed up. The higher order statistics anomaly detection (HOSAD) algorithm, based on skewness and kurtosis, and hierarchical power quality early warning flow, were then used to mine limit-exceeding and abnormal data and analyze their severity. Cases studies show that the proposed approach is effective and feasible, and that it is possible to provide timely power quality early warnings for limit-exceeding and abnormal data.

• The Journal of Korean Institute of Communications and Information Sciences
• /
• v.41 no.1
• /
• pp.83-85
• /
• 2016

The OFDM with LS signal detection performs worse in fast time varying channels as the channel matrix has higher chance of becoming ill-conditioned. Various regularization methods are applied to avoid performance degradation in LS signal detection. In this paper, we proposed a CGLS method with the stopping criteria imposed by the characteristics of the modulation method, which shows performance comparable to that of the optimal LMMSE.

• The Transactions of the Korean Institute of Electrical Engineers C
• /
• v.55 no.1
• /
• pp.20-25
• /
• 2006

We suggest a novel temperature detection method utilized in temperature monitoring system. Suggested method detects temperature variation by using $R_{ds(on)}$ characteristics of MOSFET, while conventional methods are using extra devices such as a temperature sensor or an over-temperature detection transistor. For voltage detection between drain and source, 10 bits resolution ADC is needed. Therefore possible measurement signal range is about ten mV. If detected temperature's voltage exceed protection temperature's voltage then controller generates OT (Over Temperature) signal to stop MOSFET's trigger signal. Whole process of measurement is controlled by software. Experimental results show that the developed temperature monitoring system can provide the suitable temperature monitoring method and difference between detected and data sheet value of the suggested system is about $3\%$.

• Proceedings of the KIEE Conference
• /
• 2003.07c
• /
• pp.1776-1778
• /
• 2003

Partial Discharge(PD) pulses propagate in gas insulated substation(GIS) with rise time shorter than one nanosecond. Therefore, Ultra high frequency(UHF) couplers which have ultra wide band(UWB) characteristics from hundreds of MHz to several GHz are desirable for the detection of the PB pulses in GIS. In this paper, the authors proposed a log-periodic antenna for GIS PD detection. Various parameters of the coupler such as frequency bandwidth, coupler gain, radiation pattern, coupler geometry were considered through the simulations and the experiments together.

• Transactions of the Korean Society of Automotive Engineers
• /
• v.8 no.2
• /
• pp.41-49
• /
• 2000

To understand the signal fluctuation of a wide-range oxygen sensor installed at the exhaust confluence point, when a misfiring is triggered in a cylinder, the steady state and the transient response characteristics of the sensor to the flow of the misfired gas were investigated quantitatively. It was recognized that the steady state output voltage of the sensor increased higher when it contacted the misfired gas even though the fueling condition was the same as the normal combustion case and this characteristic enabled the application of the wide-range oxygen sensor for the misfire detection. The transient response was compared at different engine speeds and it was found that the response speed increased with the engine speed. The signal fluctuation was also estimated quantitatively, using these steady state and transient response of the sensor, and the estimated signal showed satisfactory correlation with the measurements.

• Journal of Biosystems Engineering
• /
• v.34 no.2
• /
• pp.82-88
• /
• 2009

This study was conducted to detect faults in a gearbox comprised of gears, bearings and shafts. The envelope analysis was used as a method of detection, which could detect breakage and pitting of gears and bearings, and misalignment of shafts effectively. Vibration measured at the increaser was analyzed to characterize the faults. When the increaser has a defect, peaks with a constant period appear in the time history of vibration and its harmonic components also in the envelope spectrum. The envelope analysis showed that a crack in the stepped output shaft caused the increaser to generate the abnormal peaks.

• The Transactions of the Korea Information Processing Society
• /
• v.6 no.2
• /
• pp.522-533
• /
• 1999

This paper proposes speaker recognition algorithm which includes both the pitch parameter and the fuzzy inference. This study proposes a pitch detection method PVPF(peak and valley pitch detection fuction) by means of comparing spectra which utilizes the transform characteristics between time and frequency. In this paper, makes reference pattern using membership function and performs vocal tract recognition of common character using fuzzy pattern matching in order to include time variation width for non-linear utterance time.