• Proceedings of the KIEE Conference
• /
• 1987.07b
• /
• pp.874-877
• /
• 1987

In this paper a DPLL circuit realizable by digital IC's is propose and the principles of general DPLL are described. An all Digital phase locked loop is designed, analyzed, and tested. In particular, the approach of invoking Gaussian assumption on the decision variable and based on S.O.Rices theory is used. As a performance of the above PLL detector operating on low data rate FSK is given and demonsrtated to be FSK reception.

• Proceedings of the Korean Institute of Electrical and Electronic Material Engineers Conference
• /
• 2001.07a
• /
• pp.271-274
• /
• 2001

In this paper, we propose a charge pump phase-locked loop (PLL) with multi-PFD which is composed of a sequential phase frequency detector(PFD) and a precharge PFD. When the Phase difference is within - $\pi$ ∼ $\pi$ , operation frequency can be increased by using precharge PFD. When the phase difference is larger than │ $\pi$ │, acquisition time can be shorten by the additional control circuit with increased charge pump current. Therefore a high frequency operation, a fast acquisition and an unlimited error detection range can be achieved.

• Proceedings of the Korean Institute of Electrical and Electronic Material Engineers Conference
• /
• 1995.11a
• /
• pp.187-189
• /
• 1995

A Surface Acoustic Wave Gas sensor for NO, CO, H$_2$gas detection was designed fabricated, and tested. A delay line device was designed to composite a single mode SAW oscillator which enables to measure a SAW velocity. To reduce the effect of temperature and humidity, dual delay line oscillator circuit was used. And final output was measured by digital frequency counter. NO, CO, H$_2$gas were detected by WO$_3$thin film deposited on the path of the Delay Line.

• Proceedings of the Korean Institute of Electrical and Electronic Material Engineers Conference
• /
• 2002.07b
• /
• pp.699-702
• /
• 2002

A DC current sensor is disclosed in which two pairs of saturable cores are provided so as enclose a conductor carrying a direct current to be measured. On each of the saturable cores, a bias winding, a feedback winding and an output winding are wound. Circuit for detection of an asymmetry in the magnetization current, generated by a reference alternating voltage, in a signal-conditioner. The reference alternating voltage is fed to the respective series circuits such that no resultant induction current is induced in the modulating current. The voltages over the resistor form input signals for two peak value detectors, the strength of the output signal of which represents the degree of asymmetry of magnetization current. This paper describes the development a DC current sensor and its signal-conditioner.

• Proceedings of the Korean Society Of Semiconductor Equipment Technology
• /
• 2006.10a
• /
• pp.43-46
• /
• 2006

본 논문은 PCB(printed circuit board)에 납땜이 되어 장착된 부품들의 들뜸 상태 검사 알고리즘에 관한 연구이다. 전자산업의 발달로 제품이 소형화, SMD화, 고집적화가 함께 추구되고 있으며, 특히 리드(lead)의 fine-pitch화 현상으로 인해 부품의 들뜸 상태 검사의 중요성은 매우 부각되고 있다. 따라서 본 논문에서는 2차원 포인터 레이저 거리센서를 이용하여 PCB위에 장착된 부품의 들뜸 상태를 검사하고자 한다. 이를 위해 레이저 측정용 장치를 제작하여 부품의 들뜸 검사 알고리즘의 유용성 및 들뜸의 상태 판단 여부를 확인하였다. 본 논문에서 사용한 기준 부품은 각칩 형태로 된 저항, 커패시터와 BGA 및 QFP이며 이 부품들을 이용하여 리드와 바디의 들뜸 상태를 검사하였다. 검사 기준으로 리드의 들뜸은 Scan Teaching 방식을 이용하였으며, 바디의 들뜸은 단차 Teaching 방식을 이용하였다.

• 제어로봇시스템학회:학술대회논문집
• /
• 1996.10b
• /
• pp.828-831
• /
• 1996

Radiation monitoring system is needed at nuclear power plant and nuclear facility. Manual survey techniques are commonly used, but they are time consuming and somewhat inaccurate. Automatic radiation surveys are very important because it provides significant savings in men-rem and wages. Unmanned, remote automatic radiation measurement system should be small and light-weighted in order to mount on robotic system. The system we have developed consists of detection parts, signal processing part, interface, and software part. Position information is provided by using of a collimator. The measurement process is achieved by the scanning of detector and image processing techniques are used to display radiation levels. We designed collimators, detectors, signal processing circuit, and constructed prototype system. The goal of this system is the mapping of camera image and radiation level distribution.

• Proceedings of the KIPE Conference
• /
• 1999.07a
• /
• pp.274-277
• /
• 1999

The paper describes a implementation of space vector pulse-width modulation (SVPWM) voltage source inverter using Field Programmable Gate Array(FPGA) for a induction motor control system. The implemented chip is included logic circuits for SVPWM, dead time compensation and speed detection using Quick Logic, QL16X24B. The maximum operating frequency and delay time can be set to 110MHz and 6 nsec. The designed FPGA for SVPWM can be incorporated with a digital signal processing to provide a simple and effective solution for high performance voltage source inverter drives. Simulation and Implementation results are shown to verify the usefulness of FPGA as a Application Specific Integrated Circuit(ASIC) in power electronics applications

• KIEE International Transactions on Electrophysics and Applications
• /
• v.2C no.5
• /
• pp.273-278
• /
• 2002

Even though the modulating signal frequency of the light is too high to detect directly, the signal can be extracted by frequency conversion at the same time as the detection by means of the non-linearity of the APD. An analysis is presented for super-high-speed optical demodulation by an APD with electronic mixing. A normalized gain is defined to evaluate the performance of the frequency conversion demodulation. The nonlinear effect of the internal capacitance was included in the small signal circuit analysis. We showed theoretically and experimentally that the normalized gain is dependent on the down converted difference frequency component. In the experiment, the down converted different frequency outputs became larger than the directly detected original signal for the applied local signal of 20㏈m.

• Proceedings of the KIEE Conference
• /
• 2004.07d
• /
• pp.2634-2636
• /
• 2004

다목적실용위성2호의 위성 본체시스템에는 지상과 연락을 담당하는 주 컴퓨터인 OBC, 위성의 자세를 제어를 위한 원격구동장치인 RDU 그리고 위성의 전원분배를 제어장치인 ECU인 3개의 동일 프로세서(386)가 탑재되어 각 담당 임무를 수행하는 분산형 구조를 갖고 있다. 각 프로세서는 EEPROM과 SRAM 데이터 메모리를 갖고 있는데 전원 리셋이 일어나면 모든 프로그램은 EEPROM에서 SRAM으로 복사되어 운영 프로그램이 실행하도록 되어 있다. 그러나 SRAM은 우주환경에서 위성체는 방사선에 노출되어 손상을 입을 때 SEU이 발생되어 정보가 왜곡되거나 상실되는 문제를 갖고 있다. 그러므로 본 논문에서는 변형된 해밍코드 기법을 이용하여 데이터를 수신하는 곳에서 에러를 검출 및 수정하는 디지털 회로 설계방법을 기술하고자 한다.

• Proceedings of the KIEE Conference
• /
• 1992.07a
• /
• pp.434-436
• /
• 1992

In this paper, we propose a new multilevel nonlinear filter for simultaneous edge detection and noise suppression, which we call a order statistic-median hybrid(OMH) filler. The median-related filters cause an edge shift in the presence of an impulse near the edge. The proposed filter reduces such edge shifting while suppressing impulsive as well as nonimpulsive noise. We show that at the noisy edge point the OMH filter is substantially superior to the median filter, the $\alpha$-TM filter and the STM filter[I] in two respects: (a) the output bias error and (b) the output mean square error. Test results confirm that the OMH filter is robust in preserving sharp edges, inhibiting edge shifting, and suppressing a wide variety of noise. The structure for the OMH filter integrated circuit is also described.