• The korean journal of orthodontics
• /
• v.34 no.5 s.106
• /
• pp.465-472
• /
• 2004

Tooth movement facilitated by corticotomy and distraction osteogenesis, a new paradigm in orthodontics, was discussed. Molar uprighting was thought to be either difficult or nearly impossible. In this study, a section of cortical bone, which may act as resistance to tooth movement in alveolar bone, was removed. Active bone deposition was also made possible in the tension side This forms the main concept of tooth movement facilitated by corticotomy and distraction osteogenesis. Molars in two cases were uprighted at such a speedy rate as we could not imagine in conventional tooth movement. which lead to reduction of the total treatment period. And molar uprighting was possible without side effects. for example, supraversion oif the tooth or anterior anchorage loss. These were the superior aspects to conventional orthodontics.

• Journal of the Korean Magnetics Society
• /
• v.9 no.2
• /
• pp.104-110
• /
• 1999

The effect of the composition and the heat treatment on the magnetic and magnetoresistance properties in AgCo alloy films and Fe/AgCo/Fe trilayers prepared by the co-evaporation method were studied. As the alloy film thickness decreases, especially below 50 nm thick, the magnetoresistance decreases and the saturation field increases significantly. The change of the Co content, heat treatment, and deposition of the Fe under/over-layer were effective to prevent the reduction of the and the increasing of the saturation field. For 40 at.%Co sandwiches, the minimum saturation field was obtained in the 20 nm alloy film with 30nm Fe under-over layer annealed at 300 $^{\circ}C$ for 10 min. Its saturation field and the MR ratio were 1.01 kOe 5.16% respectively.

• Molecules and Cells
• /
• v.41 no.2
• /
• pp.140-149
• /
• 2018

The $TIS21^{/BTG2/PC3}$ gene belongs to the antiproliferative gene (APRO) family and exhibits tumor suppressive activity. However, here we report that TIS21 controls lipid metabolism, rather than cell proliferation, under fasting condition. Using microarray analysis, whole gene expression changes were investigated in liver of TIS21 knockout (TIS21-KO) mice after 20 h fasting and compared with wild type (WT). Peroxisome proliferator-activated receptor alpha ($PPAR{\alpha}$) target gene expression was almost absent in contrast to increased lipid synthesis in the TIS21-KO mice compared to WT mice. Immunohistochemistry with hematoxylin and eosin staining revealed that lipid deposition was focal in the TIS21-KO liver as opposed to the diffuse and homogeneous pattern in the WT liver after 24 h starvation. In addition, cathepsin E expression was over 10 times higher in the TIS21-KO liver than that in the WT, as opposed to the significant reduction of thioltransferase in both adult and fetal livers. At present, we cannot account for the role of cathepsin E. However, downregulation of glutaredoxin 2 thioltransferase expression might affect hypoxic damage in the TIS21-KO liver. We suggest that the $TIS21^{/BTG2}$ gene might be essential to maintain energy metabolism and reducing power in the liver under fasting condition.

• Journal of the Korean Vacuum Society
• /
• v.7 no.4
• /
• pp.306-313
• /
• 1998

The electrochromic $WO_3$thin films were prepared by using the electron-beam evaporatin technique. Flms prepared at a vacuum pressure of $10^{-4}$ mbar were found to be most stable during repeated potential cycles. The chemical stability of the film in aqueous solutions was also affected by the vacuum pressure during evaporation. The redox current and the optical properties of the degraded films were affected by the thickness of the film. The 5,000$\AA$-thick films were found to be most stable, undergoing the least degradation during the repeated coloring and bleaching cycles. The origin of the mechanism dominating the degradation during the repeated coloring and bleaching cycles was the accumulation of lithium in the film, which results in decreasing redox current. Tungsten oxide films with titanium content of about 10-15 mol% was found to be most stable, undergoing the least degradation during the repeated cycles. The origin of the mechanism dominating the least degradation during the repeated cycles was the reduction of lithium ion trapping sites in the films, which results in a increased durability.

• Journal of Environmental Science International
• /
• v.8 no.5
• /
• pp.593-600
• /
• 1999

In order to determine the changes of sediment facies and metal levels in surface sediments after the construction of Shiwha Lake, surface sediments were sampled at 8 sites located on the main channel monthly from June, 1995 to August, 1996 and analysed for 12 metals (Al, Fe, Mn, V, Cr, Co, Ni, Cu, Zn, Cd, As and Pb) by ICP/AES and ICP/MS. Two groups of sampling sites(the inner lake with 3 sites and the outer lake with 5 sites) are subdivided by the surface morphology ; the inner lake is a shallow channel area with a gentle slope, while the outer lake is relatively deep and wide channel with a steep slope which has many small distributaries. After the construction of dam, fine terrestrial materials were deposited near the outer lake, which resulted in the change of major sediment facies from sandy silt to mud. With the deposition of fine sediments in the outer lake, anoxic water column induced the formation of sulfide compounds with Cu, Cd, Zn and part of Pb. Metal (Cr, Ni, Cu, Zn and Cd) contents in sediments increased up to twice within 2 years after the construction of dam. This is due to the direct input of industrial and municipal wastes into the lake and the accumulation of metals within the lake. In addition, frequent resuspension of contaminated sediments in a shallow part of the lake may make metal-enriched materials transport near the outer lake with fine terrestrial materials. As the enrichment of Cu, Zn, Cd and part of Pb in the Shiwha Lake may be related to the formation of unstable sulfide compounds by sulfate reduction in anoxic water or sediment column, the effect of mixing with open coastal seawater is discussed.

• Journal of Environmental Health Sciences
• /
• v.27 no.2
• /
• pp.145-152
• /
• 2001

The purpose of this study was to determine nitrogen dioxide(NO$_2$) decay rate by reaction between NO$_2$ and interior materials in Korean residence. The results of this research could be helpful to choose the interior construction materials and to study on reduction of indoor air pollutants. The results of this research are as follows; For 30 residences in Seoul and Incheon from October 2000 to march 2001, the mean of infiltration rate was 0.70$\pm$0.44 ACH, and single-detached houses (7 houses) and apartments (19 houses) were 0.97$\pm$0.55 ACH and 0.61$\pm$0.34 ACH, respectively. The $CO_2$ decay followed approximately first-order process ($R^2$=0.97$\pm$0.02). There existed a statistic significance in filtration rate between houses built in 1980’s and built in 1990’s by t-test (p<0.02). Mean of NO$_2$ decay rates in 26 residence3s except 4 residences was 0.94$\pm$0.49hr$^{-1}$ , and also 0.86$\pm$0.49hr$^{-1}$ , 0.97$\pm$0.50hr$^{-1}$ in single-detached houses and apartments, respectively. Mean NO$_2$ decay rates in houses built in 1980’s were 0.78$\pm$0.37hr$^{-1}$ , 1.33$\pm$1.03hr$^{-1}$ , respectively. Nothing were showed statistical significance among indoor temperature, indoor humidity, and NO$_2$ decay rate. However, NO$_2$ decay rates had a tendency to increase by increase of temperature and humidity. Average volume/surface of participated houses was 0.55$\pm$0.07m and mean NO$_2$ deposition velocity was calculated as 1.46$\pm$0.59msec$^{-1}$ .

• Journal of Society of Preventive Korean Medicine
• /
• v.14 no.1
• /
• pp.97-110
• /
• 2010

The wound healing process can be categorized as follows : inflammation, fibroplasia, neovascularization, collagen deposition, epithelialization, and wound contraction. During the healing process, various growth factors are secreted to accelerate wound healing. Previous studies have demonstrated that endogenous growth factors, such as vascular endothelial growth factor(VEGF) are the important regulatory polypeptides for coordinating the healing process. They are released from macrophages, fibroblasts, and keratinocytes at the site of injury and participate in the regulation of reepithelization, granulation tissue formation, collagen synthesis and neovascularization. Onchung-Um has been used clinically to treat various skin diseases. In addition, Onchung-Um has been also used for congestive inflammations. In the present study, we evaluated the effects of Onchung-Um on wound healing process and wound size reduction in rats. Full-thickness skin wounds ($15mm\;{\times}\;15mm$) were created on the back of rats. Rats were then divided into 2 groups : The Onchung-Um treated group that was orally administered with a dose of 193.9mg/100g of Onchung-Um extract per day for 15 days and Control group without Onchung-Um administration. Moreover, the histological changes and VEGF immunoexpressions of two groups were estimated. In results, wound closures were significantly accelerated by oral administration of Onchung-Um extract. Furthermore, in Onchung-Um treated group, there were significant increases in fibroblast migration, epithelialization compared with the Control group. VEGF expressions were also increased in Onchung-Um treated group. This study has therefore demonstrated the Onchung-Um can significantly improve the quality of wound healing and scar formation and the oral administration of Onchung-Um extract may increase early tissue angiogenesis in the incisional wound of an experimental animal model.

• Journal of the Korea Academia-Industrial cooperation Society
• /
• v.16 no.11
• /
• pp.7433-7438
• /
• 2015

Deactivation characteristics of $V_2O_5/TiO_2$ catalysts were studied for selective catalytic reduction(SCR) of NOx with ammonia in the presence of $SO_2$. Performance of catalyst was investigated for $deNO_x$ activity while changing temperature, $SO_2$ concentration. The activity of catalyst was decreased with the increase of $SO_2$ concentration and reaction time. Also, degree of activity drop was largely decreased with the increase of reaction temperature in the range of $250{\sim}300^{\circ}C$. Physicochemical properties of deactivated catalysts were characterized by BET, XRD, SEM, TPD analysis. According to the analysis results, deactivation phenomena occur due to the relatively high formation of ammonium sulfate salts, which created by unreacted ammonia and water in the presence of $SO_2$. It was revealed that ammonium sulfate cause the pore plogging of support and deposition of active matter.

• Journal of the Korean institute of surface engineering
• /
• v.43 no.3
• /
• pp.148-153
• /
• 2010

Transparent conducting films having a hybrid structure of GZO/Metal/GZO were prepared on glass substrates by sequential deposition using DC magnetron sputtering. Silver, copper, aluminum and zinc thin films were used as the intermediate metal layers in the hybrid structure. The electrical and optical properties of hybrid transparent conducting films were investigated with varying the thickness of metal layer or GZO layers. With increasing the metal thickness, hybrid films showed a noticeable improvement of the electrical conductivity, which is mainly dependent on the electrical property of the metal layer. GZO(40 nm)/Ag(10 nm)/GZO(40 nm) film exhibits a resistivity of $5.2{\times}10^{-5}{\Omega}{\cdot}cm$ with an optical transmittance of 82.8%. For the films with Zn interlayer, only marginal reduction in the resistivity was observed. Furthermore, unlike other metals, hybrid films with Zn interlayer showed a decrease in the resistivity with increasing the GZO thickness. The optimal thickness of GZO layer for anti-reflection effect at a given thickness of metal (10 nm) was found to be critically dependent on the refractive index of the metal. In addition, x-ray diffraction analysis showed that the insertion of Ag layer resulted in the improvement of crystallinity of GZO films, which is beneficial for the electrical and optical properties of hybrid-type transparent conducting films.

• Proceedings of the Korean Institute of Electrical and Electronic Material Engineers Conference
• /
• 2005.07a
• /
• pp.388-389
• /
• 2005

In this paper, the electric properties of mercury Iodide multi-layer samples has been investigated. We measured and analyzed their performance parameters such as the X-ray sensitivity and dark-current for a mercury Iodide multi-layer X-ray detector with a dielectric layer. The digital X-ray image detector can be constructed by integrating photoconduction multi-layer that dielectric layer has characteristics of low dark-current, high X-ray sensitivity. However this process has found to have complexity on the performance of the sample. We have investigate dielectric layer that it substitute dielectric layer for HgO(Mercury Oxide). We have employed two approaches for producing the mercury Iodide sample : 1) Physical Vapor Deposition(PVD) and 2) Particle-In-Binder(PIB). In this paper fabricated by PIB Method with thicknesses ranging from approximately 180um to 240um and we could produce high-quality samples for each technique particular application. As results, the dielectric materials such as HgO between the dielectric layer and the top electrode may reduce the dark-current of the samples. Mercury Iodide multi-layer having HgO has characteristics of low dark-current, high X-ray sensitivity and simple processing. So we can acquired a enhanced signal to noise ratio. In this paper offer the method can reduce the dark-current in the X-ray detector.