• Journal of computational fluids engineering
• /
• v.19 no.1
• /
• pp.73-79
• /
• 2014

Three-dimensional turbulent flows of a distribution manifold are studied by a turbulence model. To investigate the geometrical effects of the manifold, the length and area of exit port are changed. From the results, flow structures related to the outflow uniformity are examined and the deparure angles are obtained. The exit configuration depending on the departure angle has advantages to the outflow uniformity. That is, the decreased exit area in the streamwise direction improves the uniformity of exit flow. For the uniform effusion, the change of exit port by departure angle is more effective them the change of exit area.

• Journal of Korean Society of Transportation
• /
• v.24 no.2 s.88
• /
• pp.157-168
• /
• 2006

Spatial detection system such as AVI, GPS, and Beacon etc. can provide spatial travel time only after a vehicle Passes through a road section. In this context, majority of the existing studies on the link travel time estimation area has focused on the arrival time-based link travel time estimation. rather than departure time-based link travel time estimation. Even if some of the researches on this area have developed departure time-based link travel time estimation algorithms, they are limited in that they are not applicable in a real-time mode. The objective of this study is to develop an departure time-based link travel time estimation algorithm which is applicable in a real-tine mode. Firstly, this study discussed the tradeoff between accuracy and timeliness of the departure time-based on-line link travel time estimates. Secondly, this study developed an departure time-based on-line link travel time estimation algorithm which utilizes the Baysian inference logic. It was found that the proposed approach could estimate departure time-based link travel times in a real-time context with an acceptable accuracy and timeliness.

• Journal of Advanced Navigation Technology
• /
• v.24 no.6
• /
• pp.515-520
• /
• 2020

The development of autopilot system and flight management system (FMS) equipment in today's aircraft navigation can be attributed to the reduction of pilots' workload and the navigation safety. The effect of autopilot and FMS equipment is greater, especially in heavy airport traffic or complicated of the departure. However, some airport specific departure procedures result in an uncommanded turn event due to an error in the FMS, causing aircraft to deviate from the center line of the route. With most departure procedures requiring area navigation (RNAV) operation, pilot situation awareness and corrective action are the only ways to minimize aircraft deviation to maintain the safety of area navigation. Through analysis of the occurrence status of the uncommended turn event by aircraft type, airport and flight phase, and comparative analysis of the survey results of foreign airlines and the airlines self-reduction plan with the aircraft manufacturer's corrective action, it is intended to give implications for the need for more fundamental measures to prevent recurrence of such events.

• Journal of Korean Society of Transportation
• /
• v.13 no.4
• /
• pp.105-115
• /
• 1995

This paper deals with an operation concept of "time-transfer of buses", in which buses arrive a transfer center at the same time and allow passengers to transfer to other bus lines, so that passengerscan go anywhere all the timed-transfere buses operate with only one transfer. This timed-transfer bus system is known as an efficient operating technique which can be adopted in an area with sparsely distrubuted bus demand. A model of timed-transfer is estabilished in terms of vaious factors such as the expected(or average) arrival time, distribution of arrival time, timed-transfer cycle, shceduled departure time, etc. It is assumed that the objective of timed-transfer bus system is to minimize the total transfer waiting time. The optimal schedualed arrival time or buffer time(time required to arrive ealy in consideration of delay) is analyzed for a general case and various speicial cases. It was found that the optiaml buffer time is an inverse funcion of the timed-transfer cycl and increases with the cycle time, assumin g that there is a fixed scheduled departure time at the transfer cetner regardless of whether one or more buses fail to arrive before the scheduled departure time. If buses are to wait uhtil all the buses arrive at the transfer center, that is, the transfer departure time is vairable, the optimal scheduled arrival times can be obtained by a mathmatical programming.

• Proceedings of the KSR Conference
• /
• 2009.05a
• /
• pp.813-821
• /
• 2009

In general, the analysis of travelers' mode choice behavior is accomplished by developing the utility functions which reflect individual's preference of mode choice according to their demographic and travel characteristics. In this paper, we propose a methodology that takes the spatial effects of individuals' departure locations into account in the mode choice model. The proposed methodology allows us to estimate mode shares by departure places even though the survey does not cover all areas. This will help transportation agencies to evaluate how the difference of individuals' departure places such as residential, retail, and commercial area affects on mode choice behaviors.

• Journal of the Korean Society of Fisheries and Ocean Technology
• /
• v.59 no.1
• /
• pp.1-8
• /
• 2023

In this study, the stability of fishing boat inducing the change of fishing lamp in accordance with the installation of induction lamp in comparison with metal halide lamp was investigated. Inclining test for 8.55 ton class of hair-tail angling fishing boat was performed in order to find a GM and light weight. A stability calculation of the target fishing boat on the basis of KST-SHIP program was evaluated. The stability of the fishing boat with a metal halide lamp such as induction lamp according to the result obtained by the inclining test is slightly different, and the stability is not so much affected. Due to the induction lamp installation, the wind area increased by about 3.178 m². Before installing the induction fishing lamp, G₀M was found to be 0.209 at full load departure and 0.296 at departure from fishing ground. After installing the induction lamp, the full load departure condition is 0.178 and the fishing ground departure condition is 0.260. The G₀M value before and after installation of the induction fishing lamp shows a difference of about 3% at the full load departure condition. The value of the critical angle of inclination definition showed a difference of about 16%. Despite these differences, it is lower than the regulations; it was confirmed that there will be no significant difference unless it is in an overloaded state.

• KSCE Journal of Civil and Environmental Engineering Research
• /
• v.35 no.5
• /
• pp.1103-1110
• /
• 2015

Ratio of a day's tour for Geoje-si, 22.6 percent, has increased to 48.6 percent since the opening of Busan-Geoje fixed link. Eight cities of Yeungnam area including Busan-Ulsan and Daegu-Gyeongbuk has been directly affected by the changed route from GJ Bridge to BG Bridge. In order to compare the range of departure area for a one-day trip in Geoje tourist attractions before and after the new fixed link, duration variation of visitors is described as individual difference by normal distribution function. One-day tour trip model based on a circular trip is also suggested under comparatively simple supposition. Since average area after the opening is equal to maximum area before as minimum area after is equal to average area before, the effect of access improvement by the new bridge is revealed definitely. In addition, the effect of cities located in the middle and long distance is greater. Although cities proximity to Geoje are not influenced significantly, every citizen is capable of taking a one-day trip anywhere.

• Journal of the Korean Society of Marine Environment & Safety
• /
• v.29 no.4
• /
• pp.307-315
• /
• 2023

Korea controls the departure of vessels based on the Maritime Safety Act such that only ships with seaworthiness can navigate in bad weather, but scientific evaluation results and quantitative basis for the designation of ships subject to control are insufficient. Opinions for improvement are being raised for a reasonable departure control operation. The purpose of this study is to evaluate the adequacy of the current departure control standards through actual measurement of tugboats, which are the type of vessels subject to control when a wind and wave advisory is effective, and to present quantitative grounds for improvement of controls. A sensor was installed on the tugboat to measure the ship's three-axis motion and hull acceleration, and the hull motion performance was measured by operating in the sea area with a significant wave height of 3 m. The measured values were compared and analyzed based on seaworthiness evaluation factors and limit value standards. The actual ship was excluded from the current control standard according to tonnage, but as a result of the analysis, the pitch value exceeded the operation standard, and a risk to navigation safety existed. The results of this study suggest the need for additional actual measurement studies that can represent various ship types and specifications and review ship departure control targets.

• Proceedings of the Korean Society for Noise and Vibration Engineering Conference
• /
• 2007.05a
• /
• pp.604-608
• /
• 2007

The INM simulation program is used to estimate the condition of the exposed area to the noise near a military airport in Korea. $WECPNL_k$, the evaluation unit of korean airport noise, is different from the ICAO $WECPNL_I$ that is used in the simulation program. Therefore, it is inappropriate to compare these units each other directly. This study presents method of comparison between them by using $LA_{MAX}$. The aircraft events are classified into three classes, as departure, overfly and approach. In result, the measurement and simulation seemed to be similar at departure and approach pattern. However, overfly pattern had higher errors between measurement and simulation. Finally, it is necessary to examine the method to determine flight events and duration for the $WECPNL_k$ application.

• Journal of the Korean Institute of Rural Architecture
• /
• v.5 no.2
• /
• pp.42-51
• /
• 2003

Need suitable development project and support, political care in the village for reasonable development of farm village area.. In these process, first of all, important thing is local resident's participation. Because Forwarded businesses had occupied bulk without absolute participation of local resident who the biggest problem that appear in government-initiated farm village policy past is real subject of Ready front business and recipient. First departure of these rural development policy plan sees that it is local resident's participation will. In this study, present role of access method and expert to inculcate inhabitants participation relationship of relevant area as early study for development project establishment that can coincide in special quality of relevant farm village area, role of a concern interested. Investigation area did the Chung chong-bukdo Chung-ju city Ang-seong village to the dimension.