• Journal of the Korean Ceramic Society
• /
• v.26 no.2
• /
• pp.235-241
• /
• 1989

A study on the APCVD(atmospheric pressure chemical vapor deposition) Al2O3 was done by using the aluminum-tri-isopropoxide/N2 reaction system at 40$0^{\circ}C$. When the flow rate of the carrier gas(N2) was over 2SLPM, heterogeneous reaction was observed. However, when the flow rate of the carrier gas was below 2SLPM, a porously deposited film or powder formation was observed. The film formed by a heterogeneous reaction was optically dense. The dense film is thought to be a kind of a hydrated alumina. After a thermal treatment of the film in the range of temperature from $600^{\circ}C$ to 1, 20$0^{\circ}C$, properties of the film seems to be changed due to dehydration and densification process. In the case of the powder on heat treatment(600~1, 20$0^{\circ}C$), both a phase transformation and the change of OH peak was observed.

• Journal of Korean Society for Atmospheric Environment
• /
• v.22 no.1
• /
• pp.73-84
• /
• 2006

Hazardous Air Pollutants (HAPs) are characterized by being relatively heavier and denser than that of ambient air due to the various reasons such as higher molecular weight, low temperature and other complicated chemical transformations (Witlox, 1994). In an effort to investigate transport and diffusion from instantaneous emission of heavy gas, Lagrangian Particle Dispersion Model (LPDM) coupled with the RAMS output was employed. Both deposition process and buoyancy term were added on the atmospheric diffusion equations of LPDM, and the locations and concentrations of dense gas particle released from instantaneous single point source (emitting initially for 10 minutes only) were analyzed. The result overall shows that adding deposition process and buoyancy terms on the diffusion equation of LPDM has very small but detectable effect on the vertical and horizontal distribution of Lagrangian particles that especially transported for a fairly long traveling time. Also the slumping of dense gas can be found to be ignored horizontally compared to the advection by the horizontal wind suggesting that it was essential to couple the Lagrangian particle dispersion model coupled with the RAMS model in order to explain the dispersion of HAPs more accurately. However, during the initial time of instantaneous emission, buoyancy term play an important role on the vertical locations of dense particles for near surface atmosphere and around source area, indicating the importance of densities of HAPs in the beginning stage or short duration for the risk assessment of HAPs or management of heavy vapors during the explosive accidents.

• The Bulletin of The Korean Astronomical Society
• /
• v.43 no.1
• /
• pp.57.2-57.2
• /
• 2018

We present the preliminary result from our KVN single-dish observations of the MALATANG sample. The MALATANG (Mapping the dense molecular gas in the strongest star-forming Galaxies) is one of the JCMT legacy surveys on the nearest 23 IR-brightest galaxies beyond the Local Group. The goal of the MALATANG survey is to map the sample in the dense gas tracers (HCN and HCO+J=4-3), and probe the relationships between the dense molecular gas and star formation activities. As a complementary study, we recently launched a KVN/KaVA program on the same sample, in order to measure their flux densities and parsec-scale jet/outflows in the millimeter regime, which will be greatly useful in understanding the initial conditions of the feedback process. In this work, we present the preliminary result from our pilot KVN single-dish program on a sub-sample, which will be used to select the future VLBI imaging study under plan. We investigate the KVN spectral energy distributions (SED) of the sample as a function of the power source of the luminous IR brightness of each target (starburst? AGN? or hybrid?). We also discuss the technical challenges that we experienced during our KVN observations due to the large size of the sample in the sky.

• Journal of the Korean Ceramic Society
• /
• v.53 no.2
• /
• pp.134-138
• /
• 2016

Porous $Co_3O_4$ spheres with bimodal pore distribution (size: 2-3 nm and ~ 30 nm) were prepared by ultrasonic spray pyrolysis of aqueous droplets containing Co-acetate and polyethylene glycol (PEG), while dense $Co_3O_4$ secondary particles with monomodal pore distribution (size: 2-3 nm) were prepared from the spray solution without PEG. The formation of mesopores (~ 30 nm) was attributed to the decomposition of PEG. The responses of a porous $Co_3O_4$ sensor to various indoor air pollutants such as 5 ppm $C_2H_5OH$, xylene, toluene, benzene, and HCHO at $200^{\circ}C$ were found to be significantly higher than those of a commercial sensor using $Co_3O_4$ and dense $Co_3O_4$ secondary particles. Enhanced gas response of porous $Co_3O_4$ sensor was attributed to high surface area and the effective diffusion of analyte gas through mesopores (~ 30 nm). Highly sensitive porous $Co_3O_4$ sensor can be used to monitor various indoor air pollutants.

• Macromolecular Research
• /
• v.11 no.3
• /
• pp.157-162
• /
• 2003

6FDA-based polyimides were prepared from the thermal imidization reaction of 6FDA with diamines of BAPAF, DAP, and DABA having a polar group of hydroxyL or carboxyl. Properties of the dense polyimide membranes were characterized and their gas permeation properties for H$_2$, $CO_2$, $O_2$, $N_2$, and CH$_4$ were investigated. Permeabilities, diffusion coefficients and diffusivity selectivities of polar group-containing polyimide membranes including 6FDA-BAPAF, 6FDA-DAP, and 6FDA-DABA polymer for the gases did not change largely. The separation properties of 6FDA-TrMPD polyimide membrane used as a reference polymer were compared with those of the polyimide membranes mentioned above. It was found that the polyimides of 6FDA-BAPAF, 6FDA-DAP, and 6FDA-DABA, which were soluble in alcohol or/and 2-methoxyethanol, could be applicable to the preparation of a dense composite membrane by dip-coating method.

• Journal of the Korean Chemical Society
• /
• v.35 no.5
• /
• pp.487-492
• /
• 1991

$[P+a(b/v)^n]$ = RT / (V - b) Above equation of state had been derived from Roulette theory. Three parameters-a, b, n are estimated from the critical point and the inversion temperature. When it is applied to 52 materials and to the regions of high density such as dense gas and supercritical gas, the results are good.

• Journal of Surface Science and Engineering
• /
• v.24 no.3
• /
• pp.119-124
• /
• 1991

Recently, the trend of research in hard coating is concentrate on developing the process of ionization rate under low operating pressure, to get the thin film with high adhesion and dense microstructures. In this study ionization rate enhancement type PVD process using permanent magnet is developed, which enhances the ionization rate by confining the plasma suppressing the wall loss of electron. By the result to investigate the characteristic of glow discharge, the ionization rate of this process is enhanced about twice as high as that of triod BARE process (about 26%), and more dense TiN microstructures are obtained in this process. Cylindrical ion energy analyzer is made and attached in front of a quadrupole mass filter for the analysis of the energy distribution of reactive gas and activated gas ions from the plasma zone. To analyze the operation mechanism of ion energy analyzer, computer simulation is performed by calculation the electric field environment using finite element method. By these analyses of ion energy distribution of outcoming ions from the plasma zone, it is found that magnetic field enhances ion kinetic energy as well as ionization rate. The other results of this study is that the foundation of feed-back system is constructed, which automatically control the partial pressure of reactive gas. In can be possible by recording the data of mass spectrum and ion energy analysis using A-D converter.

• Proceedings of the Membrane Society of Korea Conference
• /
• 2002.05a
• /
• pp.35-41
• /
• 2002

Dense oxygen ionic conducting materials can be used for oxygen separation membranes at high temperatures. However, they show relatively low permeation flux because of their large resistances. To reduce resistances and improve the oxygen permeation flux, thin dense yttria-stabilized-zirconia (YSZ)/Pd composite dual-phase membranes were fabricated by a new approach that combines the reservoir method and chemical vapor deposition (CVD). A thin porous YSZ layer was coated on a porous alumina support by dip-coating the YSZ suspension. A continuous Pd phase was formed inside pores of the YSZ layer by the reservoir method. The residual pores of the YSZ/Pd layer were plugged with yttria/zirconia by CVD to ensure the gas tightness of the membranes. The oxygen permeation fluxes through these composite membrane were 2.0$\times$10$^{-8}$ mol/cm$^2$.s and 4.8$\times$10$^{-8}$ mol/cm$^2$.s at 105$0^{\circ}C$ when air and oxygen were used as the permeate gases, respectively. These oxygen permeation values are about 1 order of magnitude higher than those of pure YSZ membranes prepared under similar conditions.

• Journal of the Korean Ceramic Society
• /
• v.30 no.4
• /
• pp.309-315
• /
• 1993

Gas pressure sintering is a promising process in various densification methods of high strength Si3N4 ceramics. Environmental influences on gas pressure sintering of Si3N4 was investigated with the variationof packing powder, specimen container and N2 gas pressure. The specimens had higher density, larger weight loss and inhomogeneous color in graphite specimen container than in SN26 crucible. The variations of sintering densities in various packing powders (Si3N4, SN26, AlN, BN) were very small but SiC powder was synthesised in graphite crucible with Si3N4 packing powder, aluminium oxynitride compounds were synthesised in SN26 crucible with AlN packing power. Also N2 gas pressure over 20kg/$\textrm{cm}^2$ reduced the densification of Si3N4 in one step-gas pressure sintering. As the result of two step-gas pressure sintering at 700kg/$\textrm{cm}^2$ for 15min., relative density of 99.9% and 3-point bending strength of 1090MPa and dense microstructure of 3~4${\mu}{\textrm}{m}$ grain size were obtained.

• The Bulletin of The Korean Astronomical Society
• /
• v.41 no.1
• /
• pp.70.1-70.1
• /
• 2016

NGC 4402 is a spiral galaxy located in the Virgo cluster. It is undergoing active HI gas stripping due to the strong ICM pressure, showing evidence for recent quenching of star formation. Its CO disk is also highly disturbed as HI, yet unlike HI disk, no sign of significant molecular gas stripping is found. Aiming to better understand how atomic gas stripping and disturbed molecular gas result in star formation quenching, we probe properties of molecular gas in the densest forms. As a pilot study, we observed HCN (1-0) and HCO+ (1-0) in the center of NGC 4402 using one of the Korean VLBI Network (KVN) antennas located at Yonsei site. In this work, we present the result from the KVN single-dish observations and discuss its implications.