• 전기학회논문지
• /
• 제60권6호
• /
• pp.1103-1111
• /
• 2011

This paper is developed to Energy Balance Flow show the flow of total energy resource be used nationally. The Energy Balance Flow is applicable of demand management factor through the analysis of foreign energy model of supply and demand and energy statistic data in the country. This study is based on and developed to Energy system management model is able to appraisal efficient of energy cost cutting, CO2 emission reduction and Energy saving at the national level calculated effect reached amount of primary energy to change of energy flow followed application of demand side management factor is able to appraisal quantitatively at the total energy to model of demand and supply.

• 대한전기학회:학술대회논문집
• /
• 대한전기학회 2011년도 제42회 하계학술대회
• /
• pp.679-680
• /
• 2011

This paper is developed to Energy Balance Flow show the flow of total energy resource be used nationally. The Energy Balance Flow is applicable of demand management factor through the analysis of foreign energy model of supply and demand and energy statistic data in the country. This study is based on and developed to Energy system management model is able to appraisal efficient of energy cost cutting, CO2 emission reduction and Energy saving at the national level calculated effect reached amount of primary energy to change of energy flow followed application of demand side management factor is able to appraisal quantitatively at the total energy to model of demand and supply.

• 상하수도학회지
• /
• 제30권3호
• /
• pp.225-231
• /
• 2016

Peak load rate(i.e., maximum daily flow/average daily flow) has not been considered for industrial water demand planning in Korea to date, while area unit method based on average daily flow has been applied to decide capacity of industrial water treatment plants(WTPs). Designers of industrial WTPs has assumed that peak load would not exist if operation rate of factories in industrial sites were close to 100%. However, peak load rates were calculated as 1.10~2.53 based on daily water flow from 2009 to 2014 for 9 industrial WTPs which have been operated more than 9 years(9-38 years). Furthermore, average operation rates of 9 industrial WTPs was less than 70% which means current area unit method has tendency to overestimate water demand. Therefore, it is not reasonable to consider peak load for the calculation of water demand under current area unit method application to prevent overestimation. However, for the precise future industrial water demand calculation more precise data gathering for average daily flow and consideration of peak load rate are recommended.

• 한국ITS학회 논문지
• /
• 제9권3호
• /
• pp.30-40
• /
• 2010

고속도로 본선 정체의 원인으로 진출램프에서 발생한 대기행렬의 본선 역류가 크게 작용하며, 이에 고속도로 진출램프 대기행렬 발생으로 인한 본선 영향을 적절히 표현하는 연속류 모형과 실제 제어 시 기반이 되는 적용성 연구가 필요하다. 본 연구에서는 고속도로 용량 변화에 따른 공급과 수요 곡선을 탄력적으로 적용하여 진출램프 대기행렬 영향으로 인한 고속도로 본선 교통류를 표현할 수 있는 Supply-Demand 모형의 적용성을 평가하였다. 먼저 Supply-Demand 모형 적용 시 요구되는 입력자료인 구간별 Sending & Receiving function과 진출램프 대기행렬의 본선 영향 등을 고려한 고속도로 본선 용량제약을 처리하는 방안을 제시하였다. 실시간 data를 사용하여 Supply-Demand 모형을 적용하는 일련의 과정을 모형화 한 후, 극심한 상습정체가 발생하는 내부순환로의 홍은진출을 포함하는 구간에 적용, 조정 및 발전시켜 분석하였다. 적용결과, 대기행렬의 본선 영향 범위와 대기행렬 패턴이 실제 교통류와 유사하게 예측되었다. 즉, Supply-Demand 모형이 Sending & Receiving function을 탄력적으로 적용함으로써, 진출램프 대기행렬의 본선 역류 등으로 인한 고속도로 본선의 용량 변화가 적절히 반영되는 것으로 검증되었다.

• 대한전기학회논문지:전력기술부문A
• /
• 제52권2호
• /
• pp.107-113
• /
• 2003

In a deregulated electric power market, a demand function to consider the characteristics of electric power consumers should be required. It is essential that the optimal power flow algorithm with object function of social welfare maximization using the demand function for a competitive electric power market is applied to resolve in a point of economic benefits as well as the security of power systems. Therefore, in this paper, we implement the optimization problem based on linear programming to consider the characteristics of electric power consumers using the demand function and analyze not only the nodal cost for generations and demands but also the variation of demands as a function of the characteristics of electric power consumers through numerical studies.

• 보건행정학회지
• /
• 제32권1호
• /
• pp.73-93
• /
• 2022

Background: Appropriate physician workforce projection through reasonable discussions and decisions with a broad view on supply and demand of the workforce, thus, is very important for high-quality healthcare services. The study expects to provide preliminary research data on the workforce diagnosis standard model for Korean physician workforce policy decision through more flexible and objective physician workforce projection in reflection of diverse changes in healthcare policy and sociodemographic environments. Methods: A low flow rate through the causal map was developed, and an objective workforce demand projection from 2019 to 2040 was conducted. In addition, projections by scenarios under various situations were conducted with the low flow rate developed in the study. Lastly, the demand projection of the physician workforce by region of 17 cities and provinces was conducted. Results: First, demand of physicians in 2019 was 110,665, 113,450 in 2020, 129,496 in 2025, 146,837 in 2030, 163,719 in 2035, and 179,288 in 2040. Second, the scenario for the retirement of baby boomers led to a decrease in the growth rate due to time delay. Third, Seoul and Gyeonggi-do account for a high percentage of demand, a very high upward trend was identified in Gyeonggi-do, and as a result, the projection showed that the demand of the physician workforce in Gyeonggi-do would worsen over time. Conclusion: This study is meaningful in that rational and collective physician workforce supply and demand and its imbalance in workforce distribution were verified through various projections by scenarios and regions of Korea with System Dynamics.

• Membrane and Water Treatment
• /
• 제12권2호
• /
• pp.65-73
• /
• 2021

Sponge ball cleaning can generate an abrasion effect, which leads to an attractive increasing in both permeate flux and membrane rejection. The aim of this study was to investigate the influence of the daily sponge ball cleaning (SBC) on the performance of different UF cross-flow membrane modules integrated with a bioreactor. Two 1"-membrane modules and one 1/2"-membrane module were tested. The parameters measured and controlled are temperature, pH, viscosity, particle size, dissolved organic carbon (DOC), total suspended solids (TSS), and permeate flux. The permeate flux could be improved by 60%, for some modules, after 11 days of daily sponge ball cleaning at a transmembrane pressure of 350 kPa and a flow velocity of 4 m/s. Rejection values of all tested modules were improved by 10%. The highest permeate flux of 195 L/㎡.h was achieved using a 1"-membrane module with the aid of its negatively charged membrane material and the daily sponge ball cleaning. In addition, the enhancement in the permeate flux caused by daily sponge ball cleaning improved the energy specific demand for all tested modules. The negatively charged membrane showed the lowest energy specific demand of 1.31 kWh/㎥ in combination with the highest flux, which is a very competitive result.

• 전기학회논문지
• /
• 제60권7호
• /
• pp.1339-1346
• /
• 2011

This paper is developed to demand management scenario of energy consumption efficiency improvement, electricity generation efficiency improvement, network efficiency improvement, change of distribution ratio, movement of energy source, change of heating system, put of CHP to quantitatively assess to impact on energy use of demand management at the national level. This scenario can be applied Energy System Management model was developed based on Energy Balance Flow. In addition, effect analysis through built demand management scenario was quantitatively evaluated integrated demand management effectiveness of energy cost saving, CO2 emission reduction and energy savings of national level by calculating to primary energy source usage change in terms of integration demand management effect more often than not a single energy source separated electricity, heat and gas.

• 한국경영과학회지
• /
• 제23권3호
• /
• pp.49-62
• /
• 1998

In the ring loading problem, traffic demands are given for each pair of nodes in an undirected ring network with n nodes and a flow is routed in either of the two directions, clockwise and counter-clockwise. The load of a link is the sum of the flows routed through the link and the objective of the Problem is to minimize the maximum load on the ring. In the ring loading problem with integer demand splitting, each demand can be split between the two directions and the flow routed in each direction is restricted to integers. Recently, Vachani et al. ［INFORMS J. Computing 8 (1996) 235-242］ have developed an Ο(n$^3$) algorithm for solving this integer version of the ring loading problem and independently, Schrijver et al. ［to appear in SIAM J. Disc. Math.］ have presented an algorithm which solves the problem with ｛0,1｝ demands in Ο（n$^2$｜K｜ ) time where K denotes the index set of the origin-desㅇtination pairs of nodes having flow demands. In this paper, we develop an algorithm which solves the problem in Ο(n ｜K｜) time.

• 수산경영론집
• /
• 제39권1호
• /
• pp.17-42
• /
• 2008

This study tried to build a structure model for the Korean flatfish aquaculture market by a system dynamics approach. A pool of several factors to influence the market structure was built. In addition, several reasonable factors related to the flatfish aquaculture market were selected to construct the causal loop diagram (CLD). Then the related stock/flow diagrams of the causal loop diagrams were constructed. This study had been forecasting a production price and supply, demand, and consumption volume for the flatfish market by a monthly basis, and then made some validation to the forecasting. Finally, four governmental policies such as import, storage, reduction of input, and demand control were tentatively evaluated by the created model. As a result, the facts that the demand control policy is most effective, and import and storage policies are moderately effective were found.