• The Journal of the Institute of Internet, Broadcasting and Communication
• /
• v.13 no.4
• /
• pp.1-7
• /
• 2013

In the next generation of mobile communication systems, high data rates and high capacity will be possible if multiple antennas are used at new frequencies. This paper presents the correlations between channel parameter path loss (PL), delay spread (DS), angular spread (AS) and K-factor established based on channel measurements. To avoid interference from Korean DTV broadcasting, we measured the channel characteristics in urban/rural/suburban areas on Jeju Island using a channel sounder and $4{\times}4$ antennas. The correlations between channel parameter show that the wireless channel characteristics can be determined and effective communication system design can be produced for use in similar environments.

• The Journal of Korean Institute of Communications and Information Sciences
• /
• v.33 no.6C
• /
• pp.505-511
• /
• 2008

The global navigation satellite system (GNSS) is using a direct sequence/spread spectrum (DS/SS) modulation. In order to recover the information data, the DS/SS system first performs a two-step synchronization process: acquisition and tracking. The acquisition process adjusts the phase difference between the received and locally generated acquisition sequences within ${\pm}T_c/2$ or less, where $T_c$ is the chip period. The tracking process performs fine synchronization. In this paper, we focus on the tracking issue. The single delta delay locked loop($\Delta$-DLL) is the optimal tracking scheme for a GNSS in the absence of multipath signals, where $\Delta$ means the spacing between the early and late correlation time offset. In the multipath environments, however, the $\Delta$-DLL suffers from huge estimation bias(denoted by $\beta$) caused by distorted correlation values. Although some modified schemes such as a $\Delta$-DLL with a narrow $\Delta$ and a double delta DLL (${\Delta}^{(2)}$-DLL) were proposed to reduce the estimation bias, they cannot remove the estimation bias completely and need more accurate acquisition process. This paper proposes a novel tracking scheme that can dramatically reduce the estimation bias, using the maximum slope change among the correlation outputs.

• Journal of Advanced Navigation Technology
• /
• v.11 no.4
• /
• pp.454-460
• /
• 2007

In this paper, we implemented a ray-tracing simulator with a ray-launching technique and generated the propagation path of each ray in an multiple-wall indoor environment. In this simulator, we adopted two dimension ray-tracing techniques considering the reflection and penetration were dominant propagation factor in the indoor channel. From the result, we verified that this ray-tracing simulator shows the similar pattern and delay distribution with the experiment results of the previous research.

• Transactions of the Korean Society of Mechanical Engineers A
• /
• v.24 no.4 s.175
• /
• pp.972-981
• /
• 2000

The phased array transducer has two distinct advantages. One is rapid scanning comparing with the conventional mechanical or manual scanning system. Therefore, output image is represented in real-time. The other is the dynamic focusing and the dynamic steering of ultrasonic beam. Only the delay times that are controlled electrically are used to focus and to steer beam without any lenses or wedges. In this study, the profile of the ultrasonic beam for the phased array transducer has been simulated in the Huygens principle with varying the inter-element spacing of the linear phased array transducer. From the result of this study, it was found that the ultrasonic beam spread wider as the inter-element spacing was decreased. However, the focusing effect was improved, even when the number of the element was not big. In addition, there was grating lobes that are constructed when the inter-element spacing is more than half wavelength. However, this grating lobe has lower amplitude than the main lobe.

• Korean System Dynamics Review
• /
• v.16 no.2
• /
• pp.53-74
• /
• 2015

Nutria(Myocastor coypus) is one of the most notorious invasive species in many countries. The Nutria's original range was South America like Brazil, Chile and Argentina. But it has been introduced to North America, Europe, Africa, and Asia including Korea, by fur ranchers. Like most invasive and disturbing species, nutria not only destroys habitats but also impacts many native species throughout most of its range with destructive feeding behavior. The purpose of this study is to investigate the dynamics of survival mechanism, population increase and spatial distribution, and eradication effect of Nutria on Nakdong River Area with the systems thinking. The result of this study revealed that Nutria can survive during winter with the behavior that the colder the winter was, the more deeply it burrowed. Further, the study uncovered the dynamics that nutria has survived more and more strongly during the extreme cold winter in almost every region and their population has increased dramatically as a result of the uncontrolled reproduction. Finally, the result showed that the action delay in eradicating Nutria, which was originated from the information delay of perception of nutria's survival and reproduction structure, reinforced the spread of Nutria across the nation.

• KSII Transactions on Internet and Information Systems (TIIS)
• /
• v.11 no.11
• /
• pp.5200-5222
• /
• 2017

The separation of control plane and data plane in Software Defined Network (SDN) makes it flexible to control the network behavior, while also causes some inconveniences to the link failure recovery due to the delay between fail point and the controller. To avoid delay and packet loss, pre-defined backup paths are used to reroute the disrupted flows when failure occurs. However, it may introduce large overhead to build and maintain these backup paths and is hard to dynamically construct backup paths according to the network status so as to avoid congestion during rerouting process. In order to realize congestion aware fast link failure recovery, this paper proposes a novel method which installs multi backup paths for every link via source routing and per-hop-tags and spread flows into different paths at fail point to avoid congestion. We carry out experiments and simulations to evaluate the performance of the method and the results demonstrate that our method can achieve congestion aware fast link failure recovery in SDN with a very low overhead.

• The Journal of Korean Institute of Communications and Information Sciences
• /
• v.36 no.4A
• /
• pp.303-311
• /
• 2011

In this paper, we propose the adaptive multibeamforming algorithm to remove the same subcarrier interference and multipath signals in the MIMO(Multi-Input Multi-Out)-OFDMA (Orthogonal Frequency Division Multiplexing Access)system allocated the same subcarrier partially in order to improve spectrum efficiency. In addition to removing the interference, we can get diversity gain and combat the detriment of the performance according to time delay by the proposed approach. BER performance improvement and combating the delay spread detrimental effects of the proposed approach is investigated through computer simulation by applying it to MIMO-OFDMA.

• Journal of Digital Contents Society
• /
• v.8 no.4
• /
• pp.459-465
• /
• 2007

In this paper, we implemented a ray-tracing simulator with a ray-launching technique and generated the propagation path of each ray in a multiple-wall indoor environment. In this simulator, we adopted two dimension ray-tracing techniques considering the reflection and penetration were dominant propagation factor in the indoor channel. From the result, we verified that this ray-tracing simulator shows the similar path pattern and delay distribution with the experiment results of the previous research. Especially, impulse responses of the ray were corresponding to reference result in non-line of sight of multiple-wall indoor environment. Furthermore, we confirmed that channel profiles having respectively different departure angle 1 degree to 7 degree were similar between them.

• Journal of the Architectural Institute of Korea Structure & Construction
• /
• v.33 no.12
• /
• pp.71-80
• /
• 2017

The purpose of this study is to applied reinforcement method at the joint part of the sandwich panel. Becasue the joint part of the sandwich panel has a disadvantage that flame spreads fast inside steel plates in the event of fire, leading to a big fire rapidly. In this study, the combustion performance was measured through KS F ISO 13784-1 "Reaction-to-fire tests for sandwich panel building systems" according to the application of reinforcement method to prevent flame from being brought into the internal joint of the sandwich panel. For the reinforcement inside the panel, the tape produced using expanded graphite-based heat-expandable glass fiber was attached. As a result, it was confirmed that the prevention of flame from being brought into the internal joint could delay the flash over time and the collapse of the test specimen.

• Journal of the Institute of Electronics Engineers of Korea TC
• /
• v.46 no.1
• /
• pp.40-47
• /
• 2009

This paper presents the method of measuring the feedback interference channel, which is developed between the transmit and receive antennas of a wireless repeater by receiving the transmit signal at the receive antenna of the identical repeater, and experiment results obtained by analyzing the measurements. This experiment uses 2 GHz WCDMA signal and is carried out near a highway. The high-speed mobiles on highways cause reflected signals with high Doppler frequencies and large energy. In order to characterize the feedback channel, the power delay profile and the scattering function are estimated by identifying the delay spread, the Doppler spread, the number of fingers, and the attenuation with delay. Since the feedback interference channel is constructed between the fixed TX and RX antennas, which is dependent upon the multipaths developed by moving or fixed objects around the antennas, the channel shows different properties comparing to the conventional channels between the base station and the mobile station. Therefore, the results presented in the paper are expected to provide guidelines for designing and evaluating wireless repeater systems.