• Progress in Superconductivity
• /
• v.14 no.1
• /
• pp.1-10
• /
• 2012

We fabricated a closed coils by using resistive-joint method and the joint resistance of the coils were estimated by field decay technique in liquid nitrogen. We used the Runge-kutta method for the numerical analysis to calculate the decay properties. The closed coil was wound by $(Bi,Pb)_2Sr_2Ca_2Cu_3O_x$/Ag tape. Both ends the tape were overlapped and soldered to each other. The current was induced in a closed coils by external magnetic flux density. Its decay characteristic was observed by means of measuring the magnetic flux density generated by induced current at the center of the closed coil with hall sensor. The joint resistance was calculated as the ratio of the inductance of the loop to the time constants. The joint resistances were evaluated as a function of critical current of loop, contact length, sweep time, and external magnetic flux density in a contact length of 7 cm. It was observed that joint resistance was dependent on contact length of a closed coil, but independent of critical current, sweep time, and external magnetic flux density. The joint resistance was measured to be higher for a standard four-probe method, compared with that for the field decay technique. This implies that noise of measurement in a standard four-probe method is larger than that of field decay technique. It was estimated that joint resistance was $8.0{\times}10^{-9}{\Omega}$ to $11.4{\times}10^{-9}{\Omega}$ for coils of contact length for 7 cm. It was found that 40Pb/60Sn solder are unsuitable for persistent mode.

• Journal of the Society of Naval Architects of Korea
• /
• v.52 no.6
• /
• pp.460-470
• /
• 2015

In general ships and FPSOs, roll damping is very small and consequently roll motion is very large at the roll resonance frequency. Proper evaluation of the roll damping coefficient at the resonance frequency is an important task in the study of roll motion and usually it is done by the analysis of free roll decay tests. The relative decrement method based on energy relation has been used mainly for the evaluation of roll damping coefficient from the roll decay test so far. As another method, the logarithmic decrement method based on equivalent linear decay assumption can be used for the same purpose and it is relatively simple. In this paper, both of the relative decrement method and the logarithmic decrement method are used for the evaluation of roll damping coefficient including quadratic damping from the free roll decay tests, and their results are cross-checked for verifying the obtained damping coefficients. Through applications to a box-type floating body equiped with bilge keels, it is shown that the two methods give almost the same damping coefficients in a practical view point and the cross-check of their results is to be a good tool to prevent a possible error. And also the quantitative effects of the bilge keels on the roll damping of box-type floating body are shown and discussed.

• Nuclear Engineering and Technology
• /
• v.56 no.7
• /
• pp.2659-2665
• /
• 2024

This study proposes an algorithm that combines a Kalman Filter method with effective decay constant correction to improve the accuracy of predicting radiation dose rate distribution during emergencies. The algorithm addresses the limitations of relying solely on measurement data by incorporating calculation data and refining the estimations. The effectiveness of algorithm was assessed using hypothetical test scenarios, which demonstrated a significant improvement in the accuracy of dose rate prediction compared to the model predictions. The estimates generated by the algorithm showed a good agreement with the measured data, and the discrepancies tend to decrease over time. Furthermore, the application of the effective decay constant correction accelerated the reduction of prediction errors. In conclusion, it was confirmed that the combined use of the Kalman filter method and effective decay constant correction is an effective approach to improve the accuracy of dose rate prediction.

• Structural Engineering and Mechanics
• /
• v.38 no.3
• /
• pp.349-359
• /
• 2011

Input excitation and output response of structure are needed in conventional modal analysis methods. However, input excitation is often difficult to be obtained in the dynamic load test of bridge structures. Therefore, what attracts engineers' attention is how to get dynamic parameters from the output response. In this paper, a structural experimental modal analysis method is introduced, which can be used to conveniently obtain dynamic parameters of the structure from the free decay response. With known damping coefficients, this analysis method can be used to identify the natural frequencies and the mode shapes of MDOF structures. Based on the modal analysis theory, the mathematical relationship of damping ratio and frequency is obtained. By using this mathematical relationship to improve the previous method, an improved experimental modal analysis method is proposed in this paper. This improved method can overcome the deficiencies of the previous method, which can not identify damping ratios and requires damping coefficients in advance. Additionally, this improved method can also identify the natural frequencies, mode shapes and damping ratios of the bridge only from the free decay response, and ensure the stability of identification process by using modern mathematical means. Finally, the feasibility and effectiveness of this method are demonstrated by a numerical example of a simply supported reinforced concrete beam.

• Journal of applied mathematics & informatics
• /
• v.6 no.1
• /
• pp.185-196
• /
• 1999

This paper is concerned with investigating the global asymptotic behavior of the solution to a nonlinear wave equation with variable coefficients. noreover an estimate of the rate of decay of the solution is obtained.

• East Asian mathematical journal
• /
• v.19 no.2
• /
• pp.173-187
• /
• 2003

We study decay estimates of the energy for the nonlinear wave equation in the whole space. We note that the method of proof is based on the multiplier technique and on the unique continuation, and no geometrical condition is imposed on the boundary.

• East Asian mathematical journal
• /
• v.19 no.2
• /
• pp.189-205
• /
• 2003

In this paper we prove the existence of solution and uniform decay rates of the energy to viscoelastic problems with nonlinear boundary damping term. To obtain the existence of solutions, we use Faedo-Galerkin's approximation, and also to show the uniform stabilization we use the perturbed energy method.

• Journal of the Korean Mathematical Society
• /
• v.42 no.6
• /
• pp.1137-1152
• /
• 2005

In this article we prove the existence of the solution to the mixed problem for Euler-Bernoulli beam equation with memory condition at the boundary and we study the asymptotic behavior of the corresponding solutions. We proved that the energy decay with the same rate of decay of the relaxation function, that is, the energy decays exponentially when the relaxation function decay exponentially and polynomially when the relaxation function decay polynomially.

• Communications of the Korean Mathematical Society
• /
• v.16 no.1
• /
• pp.153-161
• /
• 2001

In the course of working on the preconditioning $C^1$ polynomial spline collocation method, one has to deal with the exponential decay of $C^1$ Lagrange polynomial splines. In this paper we show the exponential decay of $C^1$ Lagrange polynomial splines using the Chebyshev-Gauss points as the local data points.

• KIEE International Transactions on Electrophysics and Applications
• /
• v.12C no.4
• /
• pp.214-219
• /
• 2002

The influence of ultraviolet (UV) irradiation and corona on the surface degradation of high temperature vulcanized (HTV) silicone rubber used for outdoor insulation through measuring surface voltage decay after corona charging, surface resistivity, contact angle and X-ray photoelectron spectroscopy (XPS) analysis was studied. The surface resistivity calculated by the surface voltage decay was compared with a value directly obtained from the three electrode method having the guard ring electrode. A good agreement between the two methods for surface resistivity was obtained. UV treated specimens showed the slower decrease of surface voltage decay, while the corona exposed specimens showed a dramatically faster decrease. Although both artificial treatments cause the same oxidative products, which was confirmed with XPS, we could distinguish the difference between the reactions of the two treatments by monitoring the surface voltage decay on corona-charged specimen. In addition, we could derive the specific surface states of the silicone rubber treated by accelerated artificial aging factors and the degradation process.