• 한국해양공학회지
• /
• 제23권6호
• /
• pp.44-52
• /
• 2009

In this study, the behavior of a breasting dolphin with various dolphin heights and formations in the coastal area of Incheon was investigated. The dynamic deflection, shear stress, and moment of the pile were analyzed using the coefficient of the horizontal subgrade reaction that resulted from loading tests of different DWT (Dead Weight Tonnage). In the case of a vertical pile type dolphin, the deflection, shear stress, and moment increased as the dolphin height increased. In the case of the battered pile type dolphin, small values of shear stress and moment were shown at a low dolphin height, and the characteristics of the dynamic behavior of the dolphin showed that the deflection, shear stress, and moment increased as the pile slope of the dolphin decreased or the DWT increased.

• 한국정밀공학회지
• /
• 제16권5호통권98호
• /
• pp.194-199
• /
• 1999

For the purpose of improving accuracy in friction and wear test, a hydraulic pin-on-disk type tribotester was developed and its performance was evaluated experimentally. The performance estimation of the tribotesrer was accomplished by comparing both the consistency of the applied normal load and the robustness of the control against the mechanical disturbances with those of the pneumatic and the dead weight loading method respectively. The developed hydraulic pin-on-disk type tribotester showed the better reliability in the performance and the hydraulic loading method provided the more accurate friction coefficient.

• 한국한의학연구원논문집
• /
• 제9권2호
• /
• pp.95-105
• /
• 2003

Kami-honghwa-tang(KH-19) is a prescription for reducing the side effect of radiotherapy. In this study, safety of KH-19 was evaluated by GLP guideline of Korea Food and Drug Administration. In acute oral toxicity study on rat, transient inhibition of weight increase was shown, but change in general symptom was not detected. No dead animal was observed up to 5,000 mg/kg in both male and female animals. In acute oral toxicity study on Beagle dog, transient vomiting, diarrhea, anorexia, and weight reduction was observed. However, no dead animal was observed up to 2,000 mg/kg in both male and female animals.

• 한국초지조사료학회지
• /
• 제13권2호
• /
• pp.78-85
• /
• 1993

This experiment was carried out to select for the varieties with high environmental adaptability in mountainous pastures of Taekwalyong area, and the evaluation was based on the data of varietal differences of dry matter production and yield components in Tall fescue cutting at various developmental stages in growth period of autumn. The results were summarized as follows; 1. The varieties with high number of tillers per plant(NT) showed a high dry weight of plant(DW) in all autumn cuttings. These varieties(Barce1 and Fuego) may be more adaptable to mountainous pastures of Taekwalyon area than other varieties. 2. The number of tillers per plant(NT) was significantly positive correlated with dry weight of plant (DW), but dry weight of tiller(WT) was not significantly correlated with dry weight of plant(DW) in all autumn cuttings. 3. The multiple regression equations of autumn cutting stages with mean dry weight of plant(DW) and number of tillers per plant(NT) can be used to estimate the cutting time to obtain maximum mean dry weight of plant(DW) and the highest number of tillers per plant(NT). The maximum mean dry weight of plant(DW) and the highest number of tillers per plant(NT) was estimated at the time of 21 Oct. and 26 Oct, respectively. 4. Dead leaves tended to increase greatly after the 2nd cutting(l4 Oct.) in growth period of autumn. 5. The number of tillers per plant(NT) was an important yield component before tiller density achieved equilibrium, but dry weight of tiller(WT, including dead leaves) was of most significant as a yield determinant after maximum tiller density reached in growth period of autumn.

• 한국수소및신에너지학회논문집
• /
• 제26권2호
• /
• pp.136-147
• /
• 2015

Dead-ended operation of Proton Exchange Membrane Fuel Cell(PEMFC) provides the simplification of fuel cell systems to reduce fuel consumption and weight of fuel cell. However, the water accumulation within the channel prohibits a uniform supply of fuel. Optimization of the purge strategy is required to increase the fuel cell efficiency since fuel and water are removed during the purge process. In this study, we investigated the average voltage output which depends on two interrelated conditions, namely, the supply gas pressure, purging valve open time. In addition, flow visualization was performed to better understand the water build-up on the anode side and cathode side of PEMFC in terms of a variety of the current density. We analyzed the correlation between the purge condition and water flooding.

• 한국농공학회논문집
• /
• 제46권2호
• /
• pp.93-103
• /
• 2004

In trench excavation, essential factor of earth-retaining temporary work structure should be easy taking to pieces and movement, and dead weight must be less. This paper studies about the light weight material and application as earth-retaining structure to prevent the slope failure of sand soil ground caused by the variation of groundwater level in trench excavation. That is, light weight earth-retaining structural is proposed and a simulation with FEM on application of proposed structural in sandy soil is presented. The results are summarized as follows; (1) The study proposed FRP H-shaped pannel for the light weight member, and also presented estimation method about stability. (2) Mechanical property (bending moment, shear force, axial force, displacement) were changed according to groundwater level, but these values had been within enough safety rate and allowable stress. Therefore, proposed light weight pannel with FRP is available for bracing structure in trench excavation.

• 전력전자학회:학술대회논문집
• /
• 전력전자학회 1998년도 연구회 합동 학술발표회 논문집
• /
• pp.73-77
• /
• 1998

The conventional sliding mode controller (SMCr) approach is often impractical or difficult when applied to high order process because the number of tuning parameters in the SMCr increases with the order of the plant. Camacho(1996) proposed the design of a fixed structure sliding mode controller based on a first order plus dead time approximation to the higher-order process. But, there are such problems as overshoot, settling time and command following. They are mainly due to the approximation errors of the time delay term by Taylor series. In this paper, in order to improve Camcho's method, a new Taylor approximation technique considering a weight is proposed.

• 멤브레인
• /
• 제26권4호
• /
• pp.266-272
• /
• 2016

전량여과(dead-end filtration)를 사용하여 계란 난백용액으로부터 라이소자임 효소의 분리정제에 대한 연구를 수행하였다. 전량여과 시 사용된 한외여과 막의 분획분자량과 난백용액의 pH 변화에 따른 라이소자임의 난백에 존재하는 다른 종류의 단백질인 오발부민과 콘알부민에 대한 막을 통한 투과선택도(permselectivity)를 측정하여 투과선택도가 가장 큰 값을 나타내는 전량여과의 최적 운전조건을 결정하였다. 이 결과 난백용액으로 라이소자임을 효과적으로 투과 분리시키기 위한 최적 운전조건은 한외여과 막의 분획분자량 30 kDa, 난백용액의 pH 11이었다. 최적 운전조건에서 난백 내 총 단백질에 대한 라이소자임의 투과선택도가 약 83의 가장 큰 값을 나타내었다.

• 대한간호학회지
• /
• 제4권2호
• /
• pp.57-66
• /
• 1974

This study was attempted for clinical investigation regarding with Apgar score changing phase of newborns and their sucking power related the score and weight. The data for this study obtained from 545 newborns who were born at Dept. of obstetric WooSok Hospital, Korea University from Jan. to Sept.. 1373. It is hoped that this study will contribute to nursing care planning of newborns in nursery. The Apgar score was checked in the delivery room at 1 minute after delivery by Doctor and rechecked at 30 minutes and 1 hour after delivery by nurses. The results obtained were as follows: 1. The total newborn numbers at 1 minute after delivery were 545, at 30 minutes were 542 (3 dead) and at 1 hour were 540. The babies were divided into 3 groups by the Apgar score. The frequency of group 1 (score 1 to 4) at each times were 5.0%, 0.9%, 0.4%, group 2 (score 5 to 7) 11.2%, 4.1%, 1.7% and group 3 (score 8 to 10) 83.8%, 95.0%, 97.9%. 2. The group I was found most frequently among the cases of less than 2, 500g and group 3 was found among the cases over 2.500g. It was found that there was a tendency of delaying in recovery process of low score among the premature and low birth weight newborns. 3. The type of delivery, breech and other I e was found worst and C-Section was the second, however normal spontaneous delivery was found the best. 4. In observation of sucking power of the newborn related its score and weight, good, fair, poor marks were given. But for convenience of statistical analysis. good and fair was collected together and poor alone evaluated. The result of group 1.2 examined statistically by F.E.T shown no relation between newborn weight and sucking power. however group 3, examined by X$^2$test shown very significant relation between newborn weight and sucking power. 5. The mortality rate of newborn while they were in hospital was found 2.6% to 545 of birth and all cases of dead belonged to group 1 at 1 minutes after delivery. 64.3% of the dead was found among the cases less than 2, 500g. 6. It was found that in this observation premature and Newborn asphyxia had influence to low score at birth. Conclusively, good anthemata carr should be emphasized in order to prevent main causes of these and should avoid abnormal delivery as possible.

• 한국정밀공학회:학술대회논문집
• /
• 한국정밀공학회 2001년도 춘계학술대회 논문집
• /
• pp.639-642
• /
• 2001

The possibility of weight reduction of rotor part in gas-gas geater(GGH) is studied from the viewpoint of allowable stress. In this work, finite element analysis(FEA) is performed with original model and three weight-reduced models with different diaphragm thickness, respectively. Stress concentrations at rotor diaphragm happen due to the dead weight, pressure difference between treated gas and untreated gas and thermal distribution in the rotor. As the thickness of diaphragm is decreased, the stress level is increased. The direction of treated gas and untreated gas flow may affect the stress level. Fatigue life assessment is not considered because pressure difference, the only cyclic load, can be ignored. The possible weight-reduced model is presented.