• ETRI Journal
• /
• 제33권6호
• /
• pp.841-848
• /
• 2011

A signal-to-noise ratio (SNR) enhancement algorithm using multiple chirp symbols with clock drift is proposed for accurate ranging. Improvement of the ranging performance can be achieved by using the multiple chirp symbols according to Cramer-Rao lower bound; however, distortion caused by clock drift is inevitable practically. The distortion induced by the clock drift is approximated as a linear phase term, caused by carrier frequency offset, sampling time offset, and symbol time offset. SNR of the averaged chirp symbol obtained from the proposed algorithm based on the phase derotation and the symbol averaging is enhanced. Hence, the ranging performance is improved. The mathematical analysis of the SNR enhancement agrees with the simulations.

• 한국자기학회지
• /
• 제15권6호
• /
• pp.332-335
• /
• 2005

자속계의 경우 입력전압을 적분하여야 되기 때문에 연산증폭기의 입력 바이어스 전류가 있으면 적분기의 출력이 드리프트하게 된다. 본 연구에서는 이 드리프트를 자동으로 측정하고 보상하기 위하여 전압변동이 없는 디지털 sample and hold증폭기를 자속계에 도입하여 제작하였다. 개발한 자속계의 경우 적분기의 시간상수 $RC=10^{-3}$ s에서 드리프트가 $5{\times}10^{-8}\;Wb/s$ 이하였다.

• 한국전기전자재료학회:학술대회논문집
• /
• 한국전기전자재료학회 2003년도 추계학술대회 논문집 Vol.16
• /
• pp.144-147
• /
• 2003

Cu+ ions drift diffusion in formal oxide film and SiOCH film for interlayer dielectric is evaluated. The diffusion is investigated by measuring shift in the flatband voltage of capacitance/voltage measurements on Cu gate capacitors after bias temperature stressing. At a field of 0.2MV/cm and temperature $200^{\circ}C,\;300^{\circ}C,\;400^{\circ}C,\;500^{\circ}C$ for 10min, 30min, 60min. The Cu+ ions drift rate of $SiOCH(k=2.85{\pm}0.03)$ film is considerable lower than termal oxide. As a result of the experiment, SiOCH film is higher than Thermal oxide film for Cu+ drift diffusion resistance. The important conclusion is that SiOCH film will solve a causing reliability problems aganist Cu+ drift diffuion in dielectric materials.

• Archives of Pharmacal Research
• /
• 제11권2호
• /
• pp.99-113
• /
• 1988

Quantitation of ethenzamide, isopropylantipyrine and caffeine takes about 41 hrs by conventional GC method. Quantitation of allylisoprorylacetylurea takes about 40 hrs by conventional UV method. But quantitation of them takes about 6 hrs by DRIFT developing method. Each standard and sample sieved, powdered and acquired DRIFT spectrum. Out of them peak of each component was selected and ratio of each peak to standard peak was acquired, and then linear stepwise multiple regression was performed with these data and concentration. Reflectance value, Kubelka-Munk equation and Inverse-Kubelka-Munk equation were modified by us. Inverse-Kubelka-Munk equation completed the deficit of Kubelka-Munk equation. Correlation coefficients acquired by conventioanl GC and UV against DRIFT were more than 0.95.

• Ocean Systems Engineering
• /
• 제9권1호
• /
• pp.97-109
• /
• 2019

Accurate calculation of the mean drift forces and moments is necessary when studying the higher order excitations on the floater in waves. When taking the time average of the second order forces and moments, the second order potential and motion diminish with only the first order terms remained. However, in the results of the first order forces or motions, the irregular frequency effects are often observed in higher frequencies, which will affect the accuracy of the calculation of the second order forces and moments. Therefore, we need to pay close attention to the irregular frequency effects in the mean drift forces. This paper will discuss about the irregular frequency effects in the calculations of the mean drift forces and validate our in-house program MDL Multi DYN using some examples which are known to have irregular frequency effects. Finally, we prove that it is necessary to remove the effects and demonstrate that the effectiveness of the formula and methods adopted in the development of our program.

• 제어로봇시스템학회:학술대회논문집
• /
• 제어로봇시스템학회 1994년도 Proceedings of the Korea Automatic Control Conference, 9th (KACC) ; Taejeon, Korea; 17-20 Oct. 1994
• /
• pp.611-615
• /
• 1994

In this paper, the sensitivity, linearity and temperature drift characteristics of various capacitive force sensors are evaluated and compared using new experimental methods. In particular, two designs were employed to reduce temperature drift. Both types of sensor use high-sensitivity Al coated PET film, and their externals are miniaturized. The first has a layered design consisting of two dielectric substances with different temperature characteristics. The prototype of this design had a temperature drift of only 0.1% of the sensor's capacity in the 20-80.deg. C range. The second type uses both a dummy sensor ind an active sensor with the same characteristics. The temperature drift of the prototype was one-fifth the temperature drift of a single sensor.

• 한국해양공학회:학술대회논문집
• /
• 한국해양공학회 2003년도 추계학술대회 논문집
• /
• pp.187-191
• /
• 2003

The motion and time-mean drift force of a 2-D floating BBDB in waves are studied with and without taking account of fluctuating air pressure in the air chamber. It has been found numerically that the drift for a of the BBDB is in the reverse direction of propagation of the incident waves over specific frequency ranges as found by McCormick through his experiment work. The drift force is calculated by Pinkster's near-field method. Since Maruo's formula method for the drift force is always positive, Maruo's formula is only approximate and should be replaced by the correct near-field method.

• 한국원자력학회:학술대회논문집
• /
• 한국원자력학회 1996년도 춘계학술발표회논문집(2)
• /
• pp.284-289
• /
• 1996

The predictions of the COBRA-IV-I code with the modified turbulent mixing and void drift models have been compared with the diabatic two-phase flow data on equilibrium quality. The turbulent mixing model based on an equal mass exchange of the existing COBRA-IV-I code has been modified to that based on an equal volume exchange between adjacent subchannels, and a void drift model has been newly incorporated in the code. To evaluate the performance of the equal volume exchange turbulent mixing model and the effects of the void drift model, the diabatic steam-water two-phase flow data obtained for the 9-rod bundle test under the typical operating conditions of the boiling water reactor(BWR) conducted by the General Electric (GE) were analyzed by the modified COBRA-IV-I code. The analysis indicates that the equal volume exchange turbulent mixing model with void drift predicts the observed two-phase flow data trends better than the equal mass exchange model, and to predict the correct data trends a more physically based void drift model need to be developed.

• 정보과학회 논문지
• /
• 제43권6호
• /
• pp.718-723
• /
• 2016

스트리밍 데이터 분석에서 개념 변화가 일어나는 시점을 정확히 탐지하는 것은 분류 모델의 성능을 유지하는 데 있어서 매우 중요한 작업이다. 오류율은 스트리밍 데이터에서 개념 변화 탐지를 위해 많이 사용되는 척도이다. 그러나 0과 1로 이루어진 이진 값만으로 예측 결과를 묘사하는 것은 분류 모델의 행동 패턴을 나타내는 유용한 정보의 손실을 초래할 수 있다. 이 논문에서는 오류율을 이용하는 대신에 확률 예측치를 사용하여 분류기의 성능 패턴을 묘사하고 급격한 변화를 탐지하는 효과적인 개념 변화 탐지 방법을 제안한다. 합성데이터와 실제 스트리밍 데이터를 이용한 실험 결과는 제안한 방법이 개념 변화 시점을 탐지하는데 뛰어난 성능을 가짐을 보여준다.

• Structural Engineering and Mechanics
• /
• 제27권4호
• /
• pp.425-438
• /
• 2007

Large changes in stiffness associated with cracking and yielding of reinforced concrete sections may be expected to occur during the dynamic response of reinforced concrete frames to earthquake ground shaking. These changes in stiffness in stories that experience cracking might be expected to cause relatively large peak interstory drift ratios. If so, accounting for such changes would add complexity to seismic design procedures. This study evaluates changes in an index parameter to establish whether this effect is significant. The index, known as the coefficient of distortion (COD), is defined as the ratio of peak interstory drift ratio and peak roof drift ratio. The sensitivity of the COD is evaluated statistically for five- and nine-story reinforced concrete frames having either uniform story heights or a tall first story. A suite of ten ground motion records was used; this suite was scaled to five intensity levels to cause varied degrees of damage to the concrete frame elements. Ground motion intensity was found to cause relatively small changes in mean CODs; the changes were most pronounced for changes in suite scale factor from 0.5 to 1 and from 1 to 4. While these changes were statistically significant in several cases, the magnitude of the change was sufficiently small that values of COD may be suggested for use in preliminary design that are independent of shaking intensity. Consequently, design limits on interstory drift ratio may be implemented by limiting the peak roof drift in preliminary design.