• Journal of Broadcast Engineering
• /
• v.15 no.1
• /
• pp.63-75
• /
• 2010

In this paper, the equalizer techniques that is able to adopt the digital on-channel repeater for 8VSB-based DTV system has been analyzed and we propose an effective equalizer structure which can reduce the error propagation phenomenon by the feedback signal and improve the receiver performance at the same time. In order to confirm the effective cancellation of the feedback signal, the multi-level Correlation LMS scheme is proposed through the analysis of conventional basic LMS based DFE and Correlation LMS algorithm and as compared with the conventional method, we can confirm the reduction of error propagation. When performing the computer simulation, as the Brazil channel model which is very popular for DTV broadcasting system is adopted, the result is drawn by comparing and analysing the equalizer algorithm. We have examine the symbol error rate which is in the range of 15~25dB of operation receipt SNR and MSE(Mean Square Error) in the DTV broadcasting system. As a result of comparing with the existing method, the signal-noise ratio which is necessary for maintain the bit error correction ability that the means of proposal is same is reduced by about 2~5dB, and in the rate of convergence through the MSE, we found the reduction of needed time.

• Proceedings of the IEEK Conference
• /
• 2004.06a
• /
• pp.71-74
• /
• 2004

We present an improved V-BLAST receiver that cancels co-channel interference (CCI), based on reliability normalization over frequency-selective channels, in log-likelihood ratio (LLR) sense. The performance has been evaluated in the exponential decay channel model with various normalized ms delay spread and different filter taps. It is also compared with the ordered successive interference cancellation-decision feedback equalizer (OSIC-DFE). Simulation results show that the performance of the proposed receiver with (2,1) is close to OSIC-DFE with (6,3) at normalized ms delay spread 0.5 symbol periods.

• Journal of Communications and Networks
• /
• v.12 no.5
• /
• pp.442-448
• /
• 2010

Cooperative relaying methods have attracted a lot of interest in the past few years. A conventional cooperative relaying scheme has a source, a destination, and a single relay. This cooperative scheme can support one symbol transmission per time slot, and is caned full rate transmission. However, existing fun rate cooperative relay approaches provide asymmetrical gain for different transmitted symbols. In this paper, we propose a cooperative relaying scheme that is assisted with dual relays and provides full transmission rate with the same macro-diversity to each symbol. We also address equalization for the dual relay transmission system in addition to addressing the issues concerning the improvement of system performance in terms of optimal power allocations.

• Journal of the Korea Institute of Military Science and Technology
• /
• v.11 no.3
• /
• pp.19-29
• /
• 2008

Underwater acoustic(UWA) communication is one of the most difficult field in terms of severe channel environments such as multipath propagation, high temporal and spatial variability of channel conditions. Therefore, it is important to model and analyze the characteristics of underwater acoustic channel such as multipath propagation, transmission loss, reverberation, and ambient noise. In this paper, UWA communication channel is modeled with a ray tracing method and applied to image transmission. Quadrature phase shift keying(QPSK) and multichannel decision feedback equalizer(DFE) are utilized as phase-coherent modulation method and equalization technique, respectively. The objective is to improve the performance of the image transmission using vertical sensor array instead of single sensor in the viewpoint of bit error rate(BER), constellation diagram, and received image quality.

• Proceedings of the IEEK Conference
• /
• summer
• /
• pp.110-113
• /
• 2004

Underwater acoustic(UWA) communication is one of the most difficult field because of several factors such as multipath propagation, high temporal and spatial variability of channel conditions. Therefore, it is important to model and analyze the characteristics of underwater acoustic channel such as multipath propagation, transmission loss, reverberation, and ambient noise. In this paper, UWA communication channel is modeled with a ray tracing method and applied to image transmission. Quadrature phase shift keying(QPSK) and multichannel decision feedback equalizer(DFE) are utilized as phase-coherent modulation method and equalization technique, respectively. The objective is to improve the performance of vertical sensor array than that of single sensor in the viewpoint of bit error rate(BER), constellation output, and received image quality.

• Journal of the Semiconductor & Display Technology
• /
• v.14 no.2
• /
• pp.9-16
• /
• 2015

In this paper, selection criterions on selection diversity are researched. The diversity is applied to the multiple antenna system based on wireless access in vehicular environment (WAVE) standard for rapid varying channel. Least squares (LS) based decision feedback equalizer (DFE) are used for channel equalization. Received signal is regenerated by means of the decision feedback path. In the selection diversity, the regenerated signal as well as the received signal is selected according to selection criterion. The decision feedback algorithm can follow the fast speed of WAVE fading channel. To control the tracking speed of the time-varying channel, simple low pass filter is used. Finally, the estimated channel value recovers the distorted payloads. Signal power before automatic gain control (AGC) in analog stage can be used as a selection criterion. In the digital stage, signal power after AGC, noise power after AGC, signal to noise ratio after AGC and cross-correlation method can be used as selection criterions. According to the simulation results, the performance of the selection diversity is improved in comparison with that of the combining diversity for the WAVE fading channel.

• Journal of Broadcast Engineering
• /
• v.4 no.2
• /
• pp.103-118
• /
• 1999

This paper analyzes the performance of symbol timing recovery and equalizer in 8VSB digital terrestrial TV receiver under various multipath signals and proposes equalization techniques which improve indoor reception performance. Data segment sync is used for symbol timing recovery and timing offset is measured for echoes of various delays and amplitudes by using symbol timing detection filter whose pattern is +1. +1. -1. and -1. Measured timing offsets were below 10% for long echoes with more than 5 symbol delay and above 30% for short echoes with around 1 symbol delay. Indoor reception is always more challenging than outdoor reception due to lower signal strength. large and short multipaths. and moving interfering objects. So it is considered to use FSE (Fractionally Spaced Equalizer) which is very robust to timing offset and blind equalizer which can update equalizer tap coefficients even by information data. We compare the performance of conventional DFE (Decision Feedback Equalizer) and FSE-DFE using LMS algorithm and Stop and Go algorithm for the indoor reception. Experiments reveals FSE has excellent performance for large timing offset and Stop and Go algorithm shows good performance for Doppler shift. so we propose to use FSE-DFE structure with Stop and Go algorithm for the reliable indoor reception.

• The Journal of Korean Institute of Communications and Information Sciences
• /
• v.35 no.7A
• /
• pp.623-631
• /
• 2010

In this paper, various of pilot-assisted channel estimation techniques for 3GPP LTE downlink are tested under multipath Rayleigh fading channel. At first, the conventional channel estimation techniques are applied with linear zero-forcing (ZF) equalizer, such as one dimensional least square (1-D LS) linear interpolation, two dimensional (2-D) wiener filter, the time and frequency dimension separate wiener filter and maximum likelihood estimator (MLE). Considering the practical implementation, we proposed two channel estimation techniques by combining time-dimension wiener filter and MLE in two manners, which showed a good tradeoff between system performance and complexity when comparing with conventional techniques. The nonlinear decision feedback equalizer (DFE) which can show a better performance than linear ZF equalizer is also implemented for mitigating inter-carrier interference (ICI) in our system. The complexity of these algorithms are calculated in terms of the number of complex multiplications (CMs) and the performances are evaluated by showing the bit error rate (BER).

• Journal of the Korea Institute of Information and Communication Engineering
• /
• v.2 no.1
• /
• pp.45-51
• /
• 1998

In the realization of a high speed digital transmission over several tens kbps in mobile communications, it follow delay distortion on a count of transmission path variation by multipath interference waves. Therefore it is inevitably necessary to establish the techniques overcoming the frequency selective fading. In this paper, a feedback running RLS algorithm which is improved the RLS algorithm using exponential weighting factor, is proposed for the control algorithm of DFE and by the computer simulation method, and the performance characteristics of DFE is analyzed for the one-ray and two-ray waves model under the random Gaussian noise. The computer simulation results of proposed RLS algorithm for the $\pi$/4QPSK signal with one symbol time delayed interference signal of S/I = 20［dB］, under the S/N = 10［dB］ with $\lambda$= 0.9 showed excellent following characteristics and equalization characteristics.

• Electronics and Telecommunications Trends
• /
• v.19 no.5 s.89
• /
• pp.107-113
• /
• 2004

광섬유의 분산특성에 의한 신호의 왜곡을 완화하기 위한 방법의 하나로 수신단에서 전기적 등화에 의한 분산 보상법이 개발되고 있다. 이 기술은 이미 유무선 전송에 널리 사용되었으며 근래에 고속의 광 전송에도 도입되고 있다. 본 논문은 이와 관련된 기술을 소개하고자 한다. 현재까지 비교적 구현이 용이한TF(Transversal Filter)와 DFE(Decision Feedback Equalizer)에 관한 결과가 주로 발표되었다. 전송속도는 대부분이 현재 상용화된 10Gb/s이며 40Gb/s에 관한 결과도 최근 발표되었다. 등화기의 효과적인 적응 제어 방법에 관하여도 몇 가지 기술이 제시되었다. 이 기술의 대표적인 적용분야는 단일모드 광섬유의 편광모드 분산에 대한 보상이며 그 외에 다중모드 광섬유의 모드간 분산 보상에도 활용될 수 있다. 이 기술의 사용으로 전송거리의 확장에 의한 경제성 향상을 기대할 수 있다.