• Journal of the Korean Geosynthetics Society
• /
• v.19 no.3
• /
• pp.35-44
• /
• 2020

This study described the result of laboratory model tests, in order to compare the improvement effect of the DCM column installed on the soft ground according to DCM column type. In the laboratory model test, the non-reinforced type and the 3 types of DCM column were applied, and the behavior (settlement, lateral flow) of soft ground was evaluated under the surcharge load condition for each type. The settlement evaluation result showed that the settlement of soft ground without DCM column occurred rapidly under the low load condition, but the settlement of the soft ground with the DCM column had relatively small settlement. The evaluation result of lateral flow in the soft ground showed that the soft ground with DCM column had lower lateral displacement than the soft ground without DCM column. Especially, the lateral displacement under the same load condition decreased in the order of pile type, wall type, and grid type. Therefore, it confirmed that the improvement effect of soft ground was excellent when the DCM of grid type was applied for settlement and lateral flow.

• Proceedings of the Korean Institute of Electrical and Electronic Material Engineers Conference
• /
• 2010.06a
• /
• pp.168-168
• /
• 2010

DCM derivatives were newly synthesized. The OLEDs with a DCM-A as an emitting layer was fabricated and analyzed their opto-electrical properties. The structures of OLEDs were I) ITO/DCM-A/Al, II) ITO/-NPD/DCM-A/LiF/Al, and III) ITO/-NPD/DCM-A/Alq3/LiF/Al. The EL peak of the DCM-A shows the red emission in the range of 700 nm. The structure I) shows that 1050 nW/cm2 at 510 mA/cm2. The structure II) shows that takes the most excellent luminance about 39,000 nW/cm2 at 290 mA/cm2. The EL structure ill shows luminance about 13,000 nW/cm2 at 6 mA/cm2.

• Asian-Australasian Journal of Animal Sciences
• /
• v.11 no.3
• /
• pp.239-244
• /
• 1998

Dried carrot meal (DCM) prepared from fresh carrot was found to be a good source of xanthophyll (54 mg/kg) and morderate source of protein (188.3 g/kg) and energy (2,510 kcal/kg) with low level of fibre (80 g/kg). DM, EE and NFE content of DCM were 895, 35 and 661.7 g/kg respectively. The ingredient was used in laying hen diet to evaluate its pigmenting value for egg yolk. Thirty-two laying hens from Starcross strain were divided into four groups and fed four different diets: a control diet containing 62% ground wheat, a corn-based diet (50% ground yellow corn), control + 4% DCM and control + 8% DCM. Use of DCM at 8% level in layer mash significantly improved yolk colour at 3rd, 6th and 9th week of supplementation in comparison with wheat-based control diet. This improvement was statististically similar to that obtained from yellow corn-based diet. DCM at 4% level also improved yolk colour score. Wheat-based diet significantly increased feed consumption compared to yellow corn and diet supplied with 8% DCM. Body weight gain, egg production, feed conversion were not significantly affected due to dietary addition of DCM and no mortality was observed during 63-day experimental period. Further works on DCM are suggested.

• Proceedings of the Materials Research Society of Korea Conference
• /
• 2010.05a
• /
• pp.57.1-57.1
• /
• 2010

레이저 색소 분자간의 회합을 막음으로써 높은 레이저 효율을 갖는 고체 색소 레이저를 제조하기 위해 레이저 색소인 DCM을 유-무기 하이브리드 재료에 화학적으로 결합시켰다. 수산화기를 기능기로 갖는 DCM을 합성하여 이를 솔-젤반응의 전구체로 활용하였다. 유기실란을 DCM과 함께 솔-젤반응을 시킴으로써 DCM이 결합된 유무기 하이브리드 재료를 제조하였다. DCM이 결합된 유-무기 하이브리드 재료는 유기물과 무기물의 특성을 각각 갖고 있기 때문에 용액공정을 통해 고체 색소 레이저를 단시간에 제작할 수가 있을 뿐만 아니라 열적 및 광학적으로 우수한 특성을 보여주었다. Nd:YAG 레이저를 여기광으로 이용하여 DCM이 결합된 유-무기 하이브리드 재료의 레이저 효율을 측정하여 DCM을 유기용매에 녹인 색소 레이저의 레이저 효율과 비교하였다. DCM이 결합된 유-무기 하이브리드 재료는 DCM의 농도가 높아질 수록 유기용매를 이용한 색소 레이저에 비해서 더 높은 레이저 효율을 가지는 것을 관찰하였다. 이는 DCM이 결합된 유-무기 하이브리드 재료에 각각의 DCM 분자가 실록산 망목구조와 화학적으로 결합이 되어있기 때문에 하이브리드 재료에 안정적으로 존재할 수 있게 되고 망목구조에 둘러쌓여 분자간의 회합이 방지되는 효과를 가지게 되기 때문이다.

• Journal of the Korean Society of Hazard Mitigation
• /
• v.11 no.3
• /
• pp.105-110
• /
• 2011

Recently, a deep mixture method as a soil improvement method of marine soft ground, which causes less noise and vibration than other methods, are widely used. In this study, for DCM(Deep Cement Mixing) method, one of the deep mixture method, optimum mixing ratio of clay-cement was suggested using uniaxial compression tests on specimens with various mixing ratio of claycement. In addition, the stability of a caisson on tangent circle-type and wall-type DCM treated ground was evaluated using centrifuge tests. As a result, optimum mixing ratio of clay-cement was 28.5% and the stability of the caisson on DCM treated ground was confirmed. However, the lateral displacement of the caisson on the wall-type DCM treated ground was 7% less and the settlement of that was 39% less than the case of the tangent-circle-type DCM method.

• Proceedings of the Korean Institute of Electrical and Electronic Material Engineers Conference
• /
• 2001.07a
• /
• pp.939-942
• /
• 2001

We fabricated Red Organic light-emitting devices(OLED). The Basic Device Structure is ITO/hole transfer layer, TPD(50nm)/red emitting layer, Alq3 doped with DCM2 or DCM2:rubrene(xnm)/electorn transfer layer, Alq3(50-xnm)/LiF(0.8nm)/Al(8nm) . The thickness of emitting layer(xnm) changed 5, 10, 20nm. we demonstrate red emitting OLED with dependent on the thickness and concentrators of Alq3 layer doped with DCM2 or co-doped with DCM2:ruberene. The Emission color and Brightness are changed with doping or co-doping condition, dopant concentarton. In the case of rubrene:DCM2 co-doped layer structure, the red color Purity and device efficiency is improved. The CIE index of rubrene co-doped OLED is x=0.67, y=0.31. By co-doping the Alq3 layer with DCM2, rubrene, EL efficiency improved from 0.38cd/A to 0.44cd/A in comparison whit DCM2 doped Alq3 layer.

• Proceedings of the IEEK Conference
• /
• 2003.07b
• /
• pp.999-1002
• /
• 2003

In this study, the white organic light emitting device was fabricated using ITO/a-NPD:DCM/a-NPD/BCP/Alq3/Al structure. Blue emission by a-NPD and orange emission by energy transfer between a-NPD and DCM embodied the white emission. The optimal structure of the white OLED is ITO/a-NPD:DCM(50$\square$)/a-NPD(150$\AA$)/BCP(100$\square$)/Alq$_3$(200$\square$)/Al. We varied the doping concentration of DCM properly and obtained high purity white emitting light. The CIE coordinate and maximum luminance of the devices was obtained (0.310, 0.333) and 400cd/$m^2$ at 11Volt.

• Toxicological Research
• /
• v.12 no.2
• /
• pp.265-270
• /
• 1996

Effects of a single administration of dichloromethane (DCM) on the hepatic drug metabollzing activity were determined using adult female rats. Rats were treated with DCM (3 mmol/kg, ip) and the disappearance of antipyrine (100 mg/kg, iv) or ethanol (2 g/kg, ip) from blood was measured. The blood concentration and half-life of antipyrine was not influenced by DCM administration. And DCM did not alter the blood concentration of ethanol measured for 240 min after the treatment. The effect of DCM treatment on in vitro cytochrome P-450-dependent enzyme activities was examined as well. No significant difference in either aniline hydroxylase or aminopyrine N-demethylase was observed in hepatic microsomal fractiorts of rats treated with DCM 24 hr prior to sacrifice. The present study indicates that acutely given DCM does not alter the metabolism of xenobiotics in vivo. The failure of DCM to alter the in vitro hepatic microsomal drug metabolizing activity was also noted.

• Journal of the Korean GEO-environmental Society
• /
• v.24 no.2
• /
• pp.5-12
• /
• 2023

In this study, the amount of heaving soil and the heave characteristics of the heaving soil generated at the actual site were quantitatively analyzed through DCM laboratory test construction. By reproducing a series of construction processes of the DCM method in a large-scale soil tank close to the actual site, the amount of heaving soil was predicted and the elevation characteristics such as elevation, diffusion range, diffusion angle and amount of elevation of the heaving soil were evaluated. As a result of the laboratory test construction, the actual elevation in terms of similarity within the DCM improvement section is 0~8.18m, and an average of 3.50m is observed. The actual diffusion range of the heaving soil converted to the similarity ratio is distributed from 28.0 to 38.0m on the left and right sides of the improvement section. The total amount of heaving soil calculated by the SUFFER program based on the results of the laboratory test construction is 19,901m³. Compared with the injected slurry amount of 16,992m³, the amount of heave compared to the injected amount is analyzed as 85.4%. The diffusion angle of DCM heaving soil, which analyzed the results of DCM laboratory test construction with the SUFFER program, is measured to be 30.0~38.0° at a depth of 50.0m, and is evaluated as an average of 34.0°. On the other hand, based on the DCM laboratory test construction and the analysis results using the program performed in this study, the amount of heaving soil at the DCM depths of 40.0m and 60.0m is predicted.

• Proceedings of the Korean Institute of Electrical and Electronic Material Engineers Conference
• /
• 2002.04b
• /
• pp.57-60
• /
• 2002

In generally, the guest-emitter doped system has been reported to give a bright electroluminescence(EL). The purpose of using doped system is to improve for increasing lifetime and efficiency, and tuning multicolor light. This indicates an enhanced electron-hole recombination rate in emitting layer. The purpose of this study is to obtain the high performance EL devices for flat panel display with red emission. We fabricated EL devices using the guest-host system. where DCM derivatives were taken as a dopant. The devices are fabricated in multilayer system with various concentration of the dopant (red light emitting dye). We measured the I-V characteristics and EL spectra from these devices. and we compared with photoluminescence(PL) quantum yield among the DCM derivatives. The emission mechanism of devices is participated in energy transfer. The energy transfer from these hosts to DCM generates luminescence spectra that vary from yellow red to red, depending on DCM derivatives. Absorption and emission spectra of organic materials composing the devices depend on the emission materials doped with the DCM derivatives. We demonstrated that the high EL efficiency can be achieved by doping host material with DCM derivatives and molecular steric structures