• Journal of the Institute of Electronics Engineers of Korea SD
• /
• v.43 no.10 s.352
• /
• pp.97-103
• /
• 2006

This paper presents the method of improving second order intermodulation distortion(IMD2) and dc-offset problems in down-conversion mixer. A simple analysis reveals the IMD2 and dc-offset can be eliminated by controlling the duty cycles of local oscillator(LO) inputs. A mixer with the proposed method has been simulated with a $0.13{\mu}m$ RF CMOS technology with 5% mismatch in the load resistance, the mixer shows 2.04dBm IIP2 and 22mnV input referred DC-offset. By controlling two duty cycles of LO inputs, IIP2 and DC-offset can be improved to 38.8dBm and $777{\mu}V$, respectively.

• Proceedings of the Korea Information Processing Society Conference
• /
• 2017.04a
• /
• pp.123-125
• /
• 2017

최근 에너지 시장에 많은 변화가 일어나면서 국내 에너지 수급 현황에도 큰 영향을 끼치고 있다[1-2]. 발전소의 블랙 다운시 Battery Panel에서 전원을 공급받아 DC MOTOR를 기동하여 중요한 시설에 전원을 공급한다. 따라서 본 논문에서는 PSIM 시뮬레이션을 이용하여 37kW급 DC MOTOR 기동제어를 시뮬레이션 하였다. 시뮬레이션 결과 초기 기동 전류는 정격전류 170A의 200% 이내에서 동작해야 하는 조건을 만족 시켰다.

• KEPCO Journal on Electric Power and Energy
• /
• v.6 no.4
• /
• pp.473-480
• /
• 2020

In this paper, we proposed a high frequency equivalent circuit considering parasitic impedance components for differential noise analysis on the input stage during DC-DC buck converter switching operation. Based on the proposed equivalent circuit model, we presented a method to measure parasitic impedance parameters included in DC bus plate, IGBT, and PCB track using the gain phase method of a network analyzer. In order to verify the validity of this model, a DC-DC prototype consisting of a buck converter, a signal analyzer, and a LISN device, and then resonance frequency was measured in the frequency range between 150 kHz and 30 MHz. The validity of the parasitic impedance measurement method and the proposed equivalent model is verified by deriving that the measured resonance frequency and the resonance frequency of the proposed high frequency equivalent model are the same.

• Preventive Nutrition and Food Science
• /
• v.13 no.1
• /
• pp.33-39
• /
• 2008

The volatile flavor components of Zanthoxylum pipperitum A.P. DC. produced in Korea and China were isolated using a Clevenger-type apparatus by steam distillation extraction, and analyzed by gas chromatography-mass spectrometry (GC/MS). The yields of oils from Korean and Chinese Z. pipperitum A.P. DC. were 2.0 and 1.2% (w/w), respectively. From the two Z. pipperitum A.P. DC. oils, sixty and fifty-four volatile flavor compounds were tentatively identified, and they constituted 94.78 and 87.34% of the total peak area, respectively. Piperitone(p-menth-1-en-3-one) (13.48%) was the most abundant compound in the Chinese Zanthoxylum pipperitum A.P. DC. oil, followed by $\beta$-phellandrene, sabinene, terpinen-4-ol and linalool (each >5%). Whereas, the most abundant compound in the Korean Zanthoxylum pipperitum A.P. DC. oil was limonene (18.04%), followed by geranyl acetate, cryptone, citronellal, cuminal and phellandral (each >5%).

• Journal of the Korean Magnetics Society
• /
• v.12 no.6
• /
• pp.224-230
• /
• 2002

The statistical experiment method is employed to optimize the deposition condition of Co film with DC magnetron sputtering process. The statistical treatment results showed the significance value below 0.05, low RMS error and R-sq value close to 1, which implied that our experiment and design were very reliable. We found that the sheet resistance decreased to -1.83Ω/$\square$ with the deposition temperature, increased to 11.17Ω/$\square$ with the deposition pressure, and decreased into -0.65Ω/$\square$ with the DC power. We also confirmed that the sheet resistance uniformity was mainly influenced by the deposition temperature as it decreased -4.04％ at the temperature range of 25$\^{C}$∼147$\^{C}$. Finally, we report that the optimum condition of Co film using our statistical method of design of experiment is the deposition temperature of 25$\^{C}$, the deposition pressure of 12mTorr, and the DC power of 1500W.

• The Transactions of The Korean Institute of Electrical Engineers
• /
• v.58 no.9
• /
• pp.1769-1774
• /
• 2009

An algorithm for extracting the BJT DC model parameter values for SPICE model is proposed. The nonlinear optimization method for analyzing the device I-V data using the Levenberg-Marquardt algorithm is proposed and the method for calculating initial conditions of model parameters to improve the convergence characteristics is proposed. The base current and collector current obtained from the proposed method shows the root mean square error of 6.04% compared with the measured data of the PNP BJT named 2SA1980.

• KEPCO Journal on Electric Power and Energy
• /
• v.6 no.4
• /
• pp.419-425
• /
• 2020

DC distribution system has been evaluated as an excellent one in comparison with existing AC distribution network because it needs fewer power conversion stages and the full capacity of the equipment can be used without consideration for power factor. Recently, research and development on the implementation of DC distribution networks have been progressed globally based on the rapid advancement in power-electronics technology, and the technological developments from the viewpoint of infrastructure are also in progress. However, to configure a distribution network which is a distribution line for DC, more accurate and rapid introduction of analysis technology is needed for the monitoring, control and operation of the system, which ensure the system run flexible and efficiently. However, in case of a bipolar DC distribution network, there are two buses acting as slack buses, so the Jacobian matrix cannot be configured. Without solving this problem, DC distribution network cannot be operated when the network is unbalanced. Therefore, this paper presented a comprehensive method of analysis with consideration of operating elements which are directly connected between neutral electric potential caused by the unbalanced of load in DC distribution network with bipolar structure.

• Food Science and Biotechnology
• /
• v.17 no.3
• /
• pp.669-674
• /
• 2008

Zanthoxylum schinifolium and Zanthoxylum piperitum A.P. DC. belong to the Rutaceae family and are perennial, aromatic, and medicinal herbaceous plants. In this study, their aroma compounds were isolated by steam distillation extraction using a Clevenger-type apparatus, and then further analyzed by gas chromatography (GC) and gas chromatograph/mass spectrometry (GC/MS). The yields of the essential oils from Z. schinifolium and Z. piperitum AP. DC. were 2.5 and 2.0%(w/w), respectively, and the color of their oils was quite similar, a pale yellow. From the distilled oil of Z. schinifolium, 60 volatile compounds which make up 87.24% of the total composition were tentatively identified, with monoterpenes predominating. $\beta$-Phellandrene (22.54%), citronellal (16.48%), and geranyl acetate (11.39%) were the predominantly abundant components of Z. schinifolium. In the essential oil of Z. piperitum AP. DC., 60 volatile flavor components constituted 94.78% of the total peak area were tentatively characterized. Limonene (18.04%), geranyl acetate (15.33%), and cryptone (8.52%) were the major volatile flavor compounds of Z. piperitum A.P. DC.

• KEPCO Journal on Electric Power and Energy
• /
• v.5 no.4
• /
• pp.275-286
• /
• 2019

This paper presents real-time Direct Current (DC) network analysis applications for operation of DC distribution system or DC microgrid. These applications are installed on central Energy Management System (EMS) and provide solutions of DC network operation. To analysis DC distribution network, this paper proposes composition and sequence of applications. Algorithm of applications is presented in this paper. Demonstration tests are performed on DC distribution site in Gochang Power Testing Center of Korea Electric Power Corporation (KEPCO). To verify the performance, developed DC applications installed on EMS. Scenarios for demonstration test of voltage control are presented. Finally, measured data, application output data and simulation data (by PSCAD/EMTDC) are compared and analyze accuracy of applications.

• Korean Journal of Food Science and Technology
• /
• v.21 no.4
• /
• pp.562-568
• /
• 1989

The essential oils from ripe fruit peel and leaf of Zanthoxylum piperitum DC were extracted by gas co-distillation method and analyzed by gas chromatography/mass spectrometry (GC/ MS) and retention index matching. The experimental results revealed the presence of over 100 volatile components. Major components were 1,8-cineol (25.47%), limonene (11.91%), geranyl acetate (9.01%), myrcene (6.15%) in fruit peel and citronellal (23.11%), 1,8-cineol (18.38%), citronellol (6.04%) in leaf. Among the components identified were the following; in fruit peel, ${\alpha}-pinene$ and 13 hydrocarbons, linalool and 8 alcohols, citronellal and 3 aldehydes, carvone and 2 kotones, methyl salicylate and 7 esters, and 1,8-cineol and oxides, and in leaf, ${\alpha}-pinene$ and 7 hydrocarbons, linalool and 7 alcohols, citronellyl acetate and 5 esters, citronellal and 1 aldehyde, carvone, and 1,8-cineol and 1 oxide.