• Journal of the Institute of Electronics Engineers of Korea SP
• /
• v.42 no.2 s.302
• /
• pp.27-36
• /
• 2005

This thesis proposed an effective encryption method for the DCT-based image/video contents and made it possible to operate in a high speed by implementing it as an optimized hardware. By considering the increase in the amount of the calculation in the image/video compression, reconstruction and encryption, an partial encryption was performed, in which only the important information (DC and DPCM coefficients) were selected as the data to be encrypted. As the result, the encryption cost decreased when all the original image was encrypted. As the encryption algorithm one of the multi-mode AES, DES, or SEED can be used. The proposed encryption method was implemented in software to be experimented with TM-5 for about 1,000 test images. From the result, it was verified that to induce the original image from the encrypted one is not possible. At that situation, the decrease in compression ratio was only $1.6\%$. The hardware encryption system implemented in Verilog-HDL was synthesized to find the gate-level circuit in the SynopsysTM design compiler with the Hynix $0.25{\mu}m$ CMOS Phantom-cell library. Timing simulation was performed by Verilog-XL from CadenceTM, which resulted in the stable operation in the frequency above 100MHz. Accordingly, the proposed encryption method and the implemented hardware are expected to be effectively used as a good solution for the end-to-end security which is considered as one of the important problems.

• The Journal of Korean Institute of Communications and Information Sciences
• /
• v.29 no.3C
• /
• pp.398-407
• /
• 2004

In this paper, a blind watermarking method which is suitable to the video compression using 2-D discrete wavelet transform was proposed and implemented into the hardware using VHDL(VHSIC Hardware Description Language). The goal of the proposed watermarking algorithm is the authentication about the manipulation of the watermark embedded image and the detection of the error positions. Considering the compressed video image, the proposed watermarking scheme is unrelated to the quantization and is able to concurrently embed or extract the watermark. We experimentally verified that the lowest frequency subband(LL4) is not sensitive to the change in the spatial domain, so LL4 subband was selected for the mark space. And the combination of the bitplanes which has the properties of both the minimum degradation of the image and the robustness was chosen as the embedded Point in the mark space in LL4 subband. Since we know the watermark embedded positions and the watermark is embedded by not varying the value but changing the value, the watermark can be extracted without the original image. Also, for the security when exposing the watermark embedded position, we embed the encrypted watermark by the block cipher. The proposed watermark algorithm shows the robustness against the general image manipulation and is easily transplanted into the image or video compressor with the minimal changing in the structure. The designed hardware has 4037 LABs(24％) and 85 ESBs(3％) in APEX20KC EP20K400CF672C7 FPGA of Altera and stably operates in 82MHz clock frequency.

• Geophysics and Geophysical Exploration
• /
• v.10 no.4
• /
• pp.314-321
• /
• 2007

Recently, multi-dimensional joint inversion of geophysical data based on fundamentally different physical properties is being actively studied. Joint inversion can provide a way to obtaining much more accurate image of the subsurface structure. Through the joint inversion, furthermore, it is possible to directly estimate non-geophysical material properties from geophysical measurements. In this study, we developed a new algorithm for jointly inverting dc resistivity and seismic traveltime data based on the multiple constraints: (1) structural similarity based on cross-gradient, (2) correlation between two different material properties, and (3) a priori information on the material property distribution. Through the numerical experiments of surface dc resistivity and seismic refraction surveys, the performance of the proposed algorithm was demonstrated and the effects of different regularizations were analyzed. In particular, we showed that the hidden layer problem in the seismic refraction method due to an inter-bedded low velocity layer can be solved by the joint inversion when appropriate constraints are applied.

• Korean Journal of Remote Sensing
• /
• v.19 no.6
• /
• pp.421-430
• /
• 2003

The extraction technique for Doppler information(Doppler centroid frequency(f$_{dc}$) and it's rate(f$_{r}$) is very important to make an image from the radar echo signal data. Clutterlock and auto-focusing techniques have been widely used to extract accurate Doppler information. But both techniques are not easy to implement in SAR processor and need quite lots of time to calculate accurate f$_{dc}$ and f$_{r}$ because they are generally based on echo signal data only. In this paper we suggest hybrid method for Doppler extraction using both of echo signal data and orbital and attitude information of satellite. In this method CDE(Correlation Doppler Estimation) technique is only used to estimate exact modular f$_{dc}$ using received echo signal data and rest of other algorithms are based on simple mathematical model of geometry between satellite and ground targets as well as the Doppler frequency ambiguity resolving problem. The experimental results using Radarsat-1 signal data shows that the proposed method can be effectively used for the extraction of Doppler information.

• Journal of Sensor Science and Technology
• /
• v.30 no.6
• /
• pp.436-440
• /
• 2021

The impact of the gate length (L_g) on the DC and high-frequency characteristics of indium-rich In_0.8Ga_0.2As channel high-electron mobility transistors (HEMTs) on a 3-inch InP substrate was inverstigated. HEMTs with a source-to-drain spacing (L_SD) of 0.8 ㎛ with different values of L_g ranging from 1 ㎛ to 19 nm were fabricated, and their DC and RF responses were measured and analyzed in detail. In addition, a T-shaped gate with a gate stem height as high as 200 nm was utilized to minimize the parasitic gate capacitance during device fabrication. The threshold voltage (V_T) roll-off behavior against L_g was observed clearly, and the maximum transconductance (g_{m_max}) improved as L_g scaled down to 19 nm. In particular, the device with an L_g of 19 nm with an L_SD of 0.8 mm exhibited an excellent combination of DC and RF characteristics, such as a g_{m_max} of 2.5 mS/㎛, On resistance (R_ON) of 261 Ω·㎛, current-gain cutoff frequency (f_T) of 738 GHz, and maximum oscillation frequency (f_max) of 492 GHz. The results indicate that the reduction of L_g to 19 nm improves the DC and RF characteristics of InGaAs HEMTs, and a possible increase in the parasitic capacitance component, associated with T-shap, remains negligible in the device architecture.

• Journal of the Korean Institute of Telematics and Electronics B
• /
• v.29B no.11
• /
• pp.93-101
• /
• 1992

HVS based transform coding techniques for still images take the lowest spatial frequency and luminance contrast sensitivity as the most crucial factors in determining the image quality perceived by human eye. Only the frequency weighting has been main issue. The proposed Weighted Discrete Cosine Transform (WDCT) has the lowest frequency of about 4 [cyc/deg] in 8$\times$8 subblock with the contrast-weighted DC coefficient. The error criteria have been rederived to adapt the contrast weighting for performance evaluation. The proposed scheme has produced higher quality images compared to the unweighted and other schemes.

• Proceedings of the KIEE Conference
• /
• 2009.07a
• /
• pp.1751_1752
• /
• 2009

The accurate measurement of soil resistivity and earthing system resistance is fundamental to electrical safety. However, geological and meterological factors can have a considerable effect on the accuracy of conventional measurements and the validity of the measurement methods. This paper presents optimization method of dc resistivity data acquisition system using ERT.

• Journal of the Korean Institute of Telematics and Electronics B
• /
• v.32B no.11
• /
• pp.1464-1472
• /
• 1995

In this paper, we propose an error diffusion image halftoning technique based on the noise spectrum shaping. The new technique can arbitrarily control the shape of the display error spectrum whereas conventional halftoning algorithms have been known to minimize dc errors only in which case edge information cannot be properly rendered. As a method for estimating the error diffusion coefficients, a least mean square (LMS) approach is adopted.

• Journal of the Korean Institute of Telematics and Electronics S
• /
• v.34S no.2
• /
• pp.94-103
• /
• 1997

The WCHF-FSJTC (wavelet circular harmonic function frequency selective joint transform correlator) using th wavelet transformed CHF as the reference image in FSJTC is proposed for rotation invariant pattern recognition. Since the wavelet transform has the property of feature extraction, the proposed system can have the better DC (discrimination cpability) and the higher SNR(signal to noise ratio) compared with the conventional CHF-CJTC(circular harmonic function conventional joint transform correlator). And since the structure of the proposed system is FSJTC which can eliminate auto-correlation and cross-correlation between input images, it can eliminate false alarm caused by the overlapping among correlation peaks. The used wavelet functio is the morlet function, which is proper for the reference image used in this paper. the optimal dialation parameter and oscillation frequency of the wavelet function are also achieved with varying the parameters of the wavelet function. The computer simulation shows that the proposed system has the best performance when the dilation parameter is 0.8 and the oscillation frequency is 0.48.

• Journal of Institute of Control, Robotics and Systems
• /
• v.14 no.8
• /
• pp.767-773
• /
• 2008

This paper presents a localization system based on the use of electric compass and tracking IR light source. Digital RGB(Red, Green, Blue)signal of digital CMOS Camera is sent to CPLD which converts the color image to binary image at 30 frames per second. CMOS camera has IR filter and UV filter in front of CMOS cell. The filters cut off above 720nm light source. Binary output data of CPLD is sent to DSP that rapidly tracks the IR light source by moving Camera tilt DC motor. At a robot toward north, electric compass signals and IR light source angles which are used for calculating the data of the location system. Because geomagnetic field is linear in local position, this location system is possible. Finally, it is shown that position error is within ${\pm}1.3cm$ in this system.