• Proceedings of the Computational Structural Engineering Institute Conference
• /
• 1993.10a
• /
• pp.139-148
• /
• 1993

A computerized numerical method is presented for the design and/or the investigation of RC members with general shape and material properties subjected to axial load and biaxial bending moment. Slenderness effects can also be considered with the use of the moment magnification factor. The method is based on the summation of stress result- ants on a small area of the cross section which enables the determination of strength interaction diagrams, load contours and moment-curvature relationships for the general section. Thus the presented program HYCOL can be used as a direct tool for design and/or investigation of RC members with general shape subjected to biaxial bending. The accuracy of program HYCOL is established by comparison with experimental results.

• Journal of Korean Society of Steel Construction
• /
• v.14 no.6
• /
• pp.803-811
• /
• 2002

Current composite steel and concrete bridges are designed using full-interaction theory assuming there is no relative slip, between the steel and concrete components along their interface, because of the complexities of partial-interaction analysis techniques. However, in the assessment of existing composite bridges this simplification may not be warranted as it is often necesary to extract the correct capacity and endurance from the structure. This may only be achieved using partial-interaction theory which tuly reflects the behaviour of the structure. In this paper, Parametric analyses have been carried out in order to confirm the partial-interaction curvatures with deflection effect using the finite element method. Therefore, the model is considered for simply supported steel and concrete composite bridges with a uniform distribution of connectors subjected to a single concentrated load. For the case studies, this study applicate a parameters such as the number and space of stud shear connector and elastic modulus of concrete slabs. From this study, it is known that partial-interaction effect was in the increase to the increasing the deflection of composite bridges, and stiffness and strength of slab concrete considering the occurrence of crack effect seriously to the partial-interaction behavior.

• Structural Engineering and Mechanics
• /
• v.69 no.1
• /
• pp.95-104
• /
• 2019

The Standard ASCE 61-14 proposes the Substitute Structure Method (SSM) as a Nonlinear Static Procedure (NSP) to estimate nonlinear displacement demands at the center of mass of piers or wharves under seismic actions. To account for bidirectional earthquake excitation according to the Standard, results from independent pushover analyses in each orthogonal direction should be combined using either a 100/30 directional approach or a procedure referred to as the Dynamic Magnification Factor, DMF. The main purpose of this paper is to present an evaluation of these NSPs in relation to four wharf model structures on soil conditions ranging from soft to medium dense clay. Results from nonlinear static analyses were compared against benchmark values of relevant Engineering Design Parameters, EDPs. The latter are defined as the geometric mean demands that are obtained from nonlinear dynamic analyses using a set of 30 two-component ground motion records. It was found that SSM provides close estimates of the benchmark displacement demands at the center of mass of the wharf structures. Furthermore, for the most critical pile connection at a landside corner of the wharf the 100/30 and DMF approaches produced displacement, curvature, and force demands that were reasonably comparable to corresponding benchmark values.