• Journal of the Korean Institute of Electrical and Electronic Material Engineers
• /
• v.18 no.2
• /
• pp.125-129
• /
• 2005

Two kinds of physical treatments were examined for the analysis both of intrinsic surface and interior nature of CuInS $e_2$[CIS] and CuGaS $e_2$[CGS] films grown in separated systems. For the first method, a selenium protection layer which was immediately deposited after the growth of the CIS was investigated. The Se cap layer protects CISe surface from oxidation and contamination during the transport under ambient atmosphere. The Se cap was removed by thermal annealing at temperature above 15$0^{\circ}C$. After the decapping treatment at 2$25^{\circ}C$ for 60 min, ultraviolet photoemission and inverse photoemission measurements of the CIS film showed that its valence band maximum(VBM) and conduction band minimum (CBM) are located at 0.58 eV below and 0.52 eV above the Fermi level $E_{F}$, respectively. For the second treatment, an Ar ion beam etching was exploited. The etching with ion kinetic energy $E_{k}$ above 500 eV resulted in broadening of photoemission spectra of core signals and occasional development of metallic feature around $E_{F}$. These degradations were successfully suppressed by decreasing $E_{k}$ below 400 eV. CGS films etched with the beam of $E_{k}$ = 400 eV showed a band gap of 1.7 eV where $E_{F}$ was almost centered.st centered.

• Resources Recycling
• /
• v.11 no.6
• /
• pp.12-17
• /
• 2002

Solvent extraction experiments have been performed to separate copper from $CuCl_2$-$NiCl_2$-$CoCl_2$$ solutions using Alamine336 and LIX84. The complex formation tendency between metal ions and chloride ion had a great effect on the distribution coefficients of Cu, Co and Ni ions and separation factor of Cu to Co and Ni. In the experimental ranges of chloride ion concentration from 0.5 to 4.0 M, LIX84 was superior to Alamine336 in separating copper from cobalt. When the volume percentage of LIX84 and Alamine336 was varied from 5 to 40%, LIX84 was more effective than Alamine336 in separating Cu from Co and Ni in solutions in which the chloride ion concentration was 1.0 M.

• Journal of environmental and Sanitary engineering
• /
• v.14 no.3
• /
• pp.63-70
• /
• 1999

A study on the zeolite synthesized of bituminous coal fly ash from power plant has been carried out to reuse industrial waste. The synthesized zeolite was proved to be 4A type by means of the X-ray diffraction analysis and the degree of crystallinity was found to be higher than 90%. Then the synthesized zeolite was used as an adsorbent to remove the heavy metal ions in the CU, Pb, and Cd containing wastewater and water. Also, adsorption characteristics and kinetics of synthesized zeolite in the each metal ion solutions were studied. In each ion solutions, the adsorbed amounts of Pb, Cd, and Cu to the unit weight of synthesized zeolite were 141.6, 118.8, and 131.4mg/g respectively when each metal ion concentration was 500mg/L solution. The adsorption kinetics was fitted well to the Freundlich isotherms. The value of l/n for Pb, Cd, and Cu and 0.27, 0.50, and 0.66, respectively. Those results showed that the synthesized zeolite could be used as an adsorbent to remove single heavy metal ions in the wastewater and water. The heats of adsorption, H values of Pb, Cd, and Cu were 4.87, 14.95, and 18.23kacl/mol by the Henry-van't Hoff equation.

• Journal of the Korean Ceramic Society
• /
• v.32 no.3
• /
• pp.313-320
• /
• 1995

We investigated the preferred orientation, electrical and magnetic properties of the Mn-Zn ferrite thin films deposited on SiO2/Si(100) by ion beam sputtering. The Cu-added Mn-Zn ferrite thin films had a preferred orientation of (111) with a weak orientation, (311). While the Zn-added one had a strong (111) preferred orientation. The saturation magnetization of the Cu- or Zn-doped Mn-Zn ferrite films increased with increasing substrate temperature (Ts) due to the increase of grain size and the enhancement of crystallinity. For the same reason the coercivity of Cu- or Zn-doped Mn-Zn ferrite films deposited at low Ts increased with increasing Ts, but those of the films deposited at high Ts slightly decreased not only because the defect density of the films decreases but because more grains have multi-domains with increasing Ts. The resistivity of Cu- or Zn-added Mn-Zn ferrite thin fims measured by complex impedance method decreased with increasing Ts due to the ehhancement of crystallinity as well as due to the increase of grain size.

• Journal of the Korean Chemical Society
• /
• v.43 no.2
• /
• pp.167-171
• /
• 1999

An investigation of the interaction of Co(II), Ni(II), Cu(II), Zn(II), Cd(II), Pb(II) and Ag(I) with two N,N'-dibenzylated nitrogen-oxygen mixed donor macrocyclic ligands, has been carried out. Tle log K values for the respective complexes in 95% methanol have been determined potentiometrically. Both ligands have formed stable complex with only Cu(II) and Ag(I) ion. Transport measurements in a bulk liquid membrane system exhibited a very high selectivity of Ag(I) ion over the other metal ions used.

• Journal of the Korean Vacuum Society
• /
• v.5 no.3
• /
• pp.251-257
• /
• 1996

The present paper represents the results of development and first experimental tests of a new ionized cluster beam (ICB) source. The novelty of ICB source lies in the fact that the crucible and ionization parts are spaced in one cylindrical shell but are not divided in an electric circuit. The ICB source adapts permanent magnets to increase the ionization efficiency. The maximum obtained $Cu^+$ ion current denisity is $1.5{\mu}A/\textrm{cm}^2$, therewith the ionization rate amounts 3% under deposition rate is 0.2$\AA$/s and the acceleration voltage is 4 kV, the $Cu^+$ ion beam uniformity is better than 95%.

• Membrane and Water Treatment
• /
• v.9 no.3
• /
• pp.189-194
• /
• 2018

Electrochemical reduction of nitrate was studied using Zn, Cu and (Ir+Ru)-Ti cathodes and Pt/Ti anode in a cell divided by an ion exchange membrane. During electrolysis, effects of the different cathode types on operating parameters (i.e., voltage, temperature and pH), nitrate removal efficiency and by-products (i.e., nitrite and ammonia) formation were investigated. Ammonia oxidation rate in the presence of NaCl was also determined using the different ratios of hypochlorous acid to ammonia. The operating parameter values were similar for all types of cathode materials and were maintained relatively constant. Nitrate was well reduced and converted mostly to ammonia using Zn and Cu cathodes. Ammonia, produced as a by-product of nitrate reduction, was oxidized in the presence of NaCl in the electrochemical process and the oxidation performance was enhanced upon increasing the hypochlorous acid-to-ammonia ratio to 1.09:1. Zn and Cu cathodes promoted the nitrate reduction to ammonia and the produced ammonia was finally removed from solution by reacting with hypochlorite ions. Using Zn or Cu cathodes, instead of noble metal cathodes, in the electrochemical process can be an alternative technology for nitrate-containing wastewater treatment.

• Journal of Korean Society of Water and Wastewater
• /
• v.21 no.1
• /
• pp.27-36
• /
• 2007

Milled Korean pine (Pinus densiflora) wood was used to evaluate its adsorption capacity of Cu(II) ions from aqueous solution by running a series of batch experiments. Prior to the tests, the milled woods were pretreated with 1N NaOH, 1N $NHO_3$, and distilled water, respectively, to examine the effect of pretreatment. Within the tested pH range in this study between 3 and 6, copper adsorption efficiency of NaOH-treated wood(96~99%) was superior than $NHO_3$-treated wood(19~31%) and distilled water-treated wood(18~35%). Adsorption behavior of copper onto both raw and $NHO_3$-treated woods was mainly attributed to interaction with carboxylic acid group. For NaOH-treated wood, carboxylate ion produced by hydrolysis was a major functional group responsible for Cu sorption. NaOH treatment of wood changed the ester and carboxylic acid groups into carboxylate group, whereas $NHO_3$ treatment did not affect the production of functional groups which could bind copper. A pseudo second-order kinetic model fitted well for the sorption of copper ion onto NaOH-treated wood. A batch isotherm test using NaOH-treated wood showed that equilibrium sorption data were better represented by the Langmuir model than the Freundlich model.

• Bulletin of the Korean Chemical Society
• /
• v.21 no.4
• /
• pp.393-400
• /
• 2000

2,2￠-Dihydroxyazobenzene (DHAB) was attached to poly(ethylenimine) (PEI) to obtain DHAB-PEI. Spectral titration revealed that uranyl, Fe(III), Cu(II), and Zn(II) ion form 1 : 1-type complexes with DHAB attached to PEI. Formation constants for the metal complexes formed by the DHAB moieties of DHAB-PEI were mea-sured by using various competing ligands. The results indicated thatthe concentrations of uranyl, Fe(III), and Cu(II) ions can be reduced to 10 -16 -10 -23 M at p 8 with DHAB-PEI when the concentration of the DHAB moiety is 1 residue M. By using cyanuric chloride as the coupling reagent, DHAB-PEI was immobilized on Sephadex G-25 resin to obtain DHAB-PEI-Seph. Binding of uranyl,Fe(III), Cu(II), and Zn(II) ion by DHAB-PEI-Seph was characterized by using competing ligands. A new method has been developed for characteriza-tion of metal sequestering ability of a chelating resin. Formation constants and metal-binding capacity of two sets of binding sites on the resin were estimated for each metal ion. DHAB-PI-Seph was applied to recovery of metals such as uranium,Fe, Cu, Zn, Pb, V, Mn, and W from seawater. The uranium recovery from seawaterby DHAB-PEI-Seph does not meet the criterion for economical feasibility partlydue to interference by Fe and Zn ions. The seawater used in the experiment was contaminated by Fe and Zn and, therefore, the efficiency of uranium extractionfrom seawater with DHAB-PEI-Seph could be improved if the experiment is carried out in a cleaner sea.

• Bulletin of the Korean Chemical Society
• /
• v.15 no.7
• /
• pp.581-584
• /
• 1994

A comparative investigation of the complexations of divalent metal ions (Cd, Cu, and Pb) by a well characterized soil humic acid (HA) from Okchun Metamorphic Belt was carried out in 0.05 M $KNO_3$ and pH of 4.5 using ion selective electrodes. A continuous distribution model based on the Scatchard Plot was used to determine the stability constants, because the constants obtained by this modeling technique takes the variations in binding energies into consideration without regards to the manner in which M(II) ion is bound on HA. The mean value of log $K_i$ were $4.05{\pm}0.60,\;4.92{\pm}0.36,\;and\;5.63{\pm}0.34\;{\ell}\;mol^{-1}$ for Cd(II)-, Pb(II), and Cu(II)-humate complexes respectively. The values of intrinsic constant (log $K_{int}$; binding at strongest site) were $7.12{\pm}0.30,\;6.59{\pm}0.32,\;and5.07{\pm}0.56\;{\ell}\; mol^{-1}$ in the order Cu(II) > Pb(II) > Cd(II) ion.