• Economic and Environmental Geology
• /
• 제31권2호
• /
• pp.127-139
• /
• 1998

A new technique of simultaneous inversion for 3-D seismic velocity structure by using direct, reflected, and refracted waves is applied to the southeast part of the Korean Peninsula including Pohang Basin, Kyongsang Basin and Ryongnam Massif. Pg, Sg, PmP, SmS, Pn, and Sn arrival times of 44 events with 554 seismic rays are inverted for locations and crustal structure. $6{\times}6$ with $0.5^{\circ}$ and 8 layers (4 km each layer) model was inverted. 3-D seismic crustal velocity tomography including eight sections from surface to Moho, ten profiles along latitude and longitude are analyzed. The results are as follows: 1) the average velocity and thickness of sediment are 5.04 km/s and 3-4 km, and the velocity of basement is 6.11 km/s. The shape of velocity in shallower layer is agreement with Bouguer gravity anomaly (Cho et al., 1997). 2) the velocities fluctuate strongly in the upper crust. The velocity distribution of the lower crust under Conrad appears basically horizontal. 3) the average depth of Moho is 30.4 km, and velocity is 8.01 km/s. 4) from the velocity and depth of the sediment, the thickness, velocity and form of the upper crust, and the depth and form of Moho, we can find the obvious differences among Ryongnam Massif, Kyongsang Basin and Pohang Basin. 5) the deep faults (a Ulsan series faults) near Kyongju and Pohang areas can be found to be normal and/or thrust faults with detachment extended to the bottom of the upper crust.

• Geophysics and Geophysical Exploration
• /
• 제12권3호
• /
• pp.225-232
• /
• 2009

As part of seismic experiments investigating crustal velocity structures of the Korean peninsula, permanent (fixed) seismographs of the Korea Meteorological Administration (KMA) network recorded seismic signals from four and eight large explosions in Korean Crustal Research Team (KCRT) profiles shot in 2004 and 2008, respectively. Among the seismograms recorded by 43 velocity sensors and 103 accelerometers at KMA stations distributed throughout the southern Korean Peninsula, 156 records with epicentral distances less than 120 km and high signal-to-noise ratios were analyzed to determine velocity anisotropy of the Pg phase. Relative elevation corrections of -101.6 to 105.3 ms were made using velocity information derived from the 2004 KCRT profile data and differences in elevation between the permanent KMA stations and the temporary stations in the KCRT profiles at the same source-receiver offsets. To remove site effects, receiver-station corrections of -89.6 to 192.2 ms were additionally made to the KMA station data by subtracting the average differences in traveltimes between KMA stations and portable stations at the same offsets for all available shots with different azimuths. With the exception of anomalously fast velocities along trends of the Chugaryeong fault zone and the Okchon fold belt and anomalously slow velocities in the regions of high terrestrial heat near Yeongduk and Ulsan, the analysis of crustal velocity anisotropy using the Pg phase indicates overall isotropy in the southern half of the Korean peninsula.

• 한국지구물리탐사학회:학술대회논문집
• /
• 한국지구물리탐사학회 2009년도 학술대회 초록집
• /
• pp.127-127
• /
• 2009

• Journal of Korean Society for Geospatial Information Science
• /
• 제23권1호
• /
• pp.47-54
• /
• 2015

In this study, we developed strategies for pre-processing GNSS data for the purpose of separating geodetic factors from crustal deformation due to the earthquakes. Before interpreting GNSS data analysis results, we removed false signals from GNSS coordinate time series. Because permanent GNSS stations are located on a large tectonic plate, GNSS position estimates should be affected by the tectonic velocity of the plate. Also, stations with surrounding trees have seasonal signals in their three-dimensional coordinate estimates. Thus, we have estimated the location of an Euler pole and angular velocities to deduce the plate tectonic velocity and verified with geological models. Also, annual amplitudes and initial phases were estimated to get rid of those false annual signals showing up in the time series. By considering the two effects, truly geodetic analysis was possible and the result was used as preliminary data for analyzing post-seismic deformation of the Korean peninsula due to the Tohoku-oki earthquake.

• Proceedings of the International Union of Geodesy And Geophysics Korea Journal of Geophysical Research Conference
• /
• IUGG한국위원회 2003년도 정기총회 및 학술발표회
• /
• pp.15-15
• /
• 2003

The first crustal refraction survey in the Korean Peninsula was carried out over the survey line connecting Seosan-Yeongdong-Kyeongiu on Dec. 15, 2002. The total length of the survey line was about 300 Km and 198 portable seismometers were deployed with approximately 1.5-km interval. The survey line itself was geologically important since it was almost normal to the so-called Sino-Korean structural trend. Two shots, one at Seosan (west end point) and the other at Yeongdong (mid-point), were exploded. They were 100-m deep drill well explosions. The Seosan shot consisted of a ton emulsion type explosive, while Youngdong consisted of 500 kg one. Both shots generated signals with good S/N ratios to the farthest receivers. Seismic signals were recorded by 195 receivers out of 198 ones. Although the originally planned Kyeongju shot (east end point) could not be exploded due to public discontent, the experiment was evaluated very successful. First breaks in all recorded traces were picked up and two preliminary analyses were carried out. The one is conventional flat layer analysis and the other was refraction tomographic analysis. The one resulted in average 32-km thick two-layer crust and the underlying mantle with 8.05-km/s P-velocity. The top crust layer with 3.86 kw/s P-velocity was 2.5-km thick and the lower crust layer with 6.0l km/s P-velocity was 29.5-km thick. The other resulted in a velocity cross-section. The confidence level of the velocity cross-section could not be evaluated at this time because only two shot were exploded. Detailed analyses such as surface wave dispersion are on going. Continuing crustal scale refraction surveys are planned in Korea.

• Economic and Environmental Geology
• /
• 제16권1호
• /
• pp.51-61
• /
• 1983

By using local earthquake data, the Korean crust model and travel-time tables were determined. The upper crustal earthquakes (Hongsung event and Ssanggyesa event) were considered as auxiliary information, and the lower crustal earthquakes (Uljin event and Pohang event) played an important role in determining model parameters. The possible existence of Low Velocity Layer (LVL) in the upper mantle was suggested by discrepancy in the arrival times of Sariwon earthquake which occurred below Moho discontinuity. Computer program for the determination of the model parameters was developed in order to screened out the optimum parameters by comparing the travel times of observed data with theoretical ones. We found that the discontinuities of Conrad, Moho, and upper and lower boundaries of LVL have their depth of 15, 32, 55 and 75 Km, respectively. The velocities of P-and S-wave in the layers between those discontinities were found to be (1) 5.98, 3.40 Km/sec (2) 6.38, 3.79 Km/sec (3) 7.95, 4.58 Km/sec (4) unknown (5) 8.73, 5.05 Km/sec, respectively from the top layer. Travel-time tables were also computed for the inter-local earthquakes which have their direct wave paths above the LVL.

• Journal of the Korean Geophysical Society
• /
• 제9권4호
• /
• pp.351-359
• /
• 2006

We investigated subsurface structures of the Bransfield Basin, the Antarctic with AUH (Autonomous Underwater Hydrophne) which was designed to record abyssal T-waves generated from submarine earthquakes. The data obtained from a multi-channel seismic survey and an AUH were used for this study. A seismic reflection method was applied to the multi-channel seismic survey data in order to identify bathymetry and sedimentary structures, and the signals recorded in the AUH were used to obtain deep structures as we applied a seismic refraction method. Even though we couldn’t investigate deeper and detailed structure in study area because of lack of Airgun’s capacity, the AUH showed possibilities for being used for a marine seismic survey. From this experiment, we decided the upper and lower sediment layer velocities, detected irregular basement topography probably caused by submarine volcanic/magmatic activities, and retrieved the velocity of the basement and the depth of the sediment layer/basement boundary.

• Korean Journal of Geomatics
• /
• 제5권1호
• /
• pp.51-58
• /
• 2005

GPS measurements from Feb. 2002 through Mar. 2004 were used to estimate recent crustal movement across the Lai Chau - Dien Bien fault system in North-West Vietnam. Four GPS campaign data were processed and combined with appropriate constraints using automatic GAMIT/GLOBK run in order to estimate ITRF2000 coordinates, local horizontal velocity and extensive/compressive strain rates. ITRF2000 velocities are consistent with east-southeastward movement of Sundaland i.e. Indochina. Local velocities show not much left-lateral strike-slip of the fault system and derived strain rates are insignificant from zero at $95\%$ confidence.

• Journal of the Korean Geophysical Society
• /
• 제3권3호
• /
• pp.153-160
• /
• 2000

Crustal velocities around the Korea peninsula are estimated and investigated from eight IGS permanent stations in eastern Asia area. GPS data for the period of May 1995 to December 1991 were analyzed to estimate daily coordinates of each site relative to TAEJ site. The velocity vector of each site is estimated from linear regression analysis with time series of coordinates. As the result, horizontal velocity components for four stations(Tsukuba, Usuda,Taiwan and Shanghai) using thirty-two months data were estimated with the standard error less than 1 mm/year. Our GPS velocity of six sites on the interiors of the Eurasia plate are similar within 1 cm/year with small differences respectively. On the other hand, the velocities of Tsukuba and Usuda showed the great differences from the other six sites. This can be explained by the fact that these two sites are enforced by the surrounding four plates, such as the Pacific, Eurasia, North America and Philipine plate. This study showed that the distance between Korea and Japan is shortened with the rate of 3 cm per year.

• Geophysics and Geophysical Exploration
• /
• 제11권1호
• /
• pp.26-33
• /
• 2008

The analysis of wide-angle seismic reflection and refraction data plays an important role in lithospheric-scale crustal structure study. However, it is extremely difficult to develop an appropriate velocity structure model directly from the observed data, and we have to improve the structure model step by step, because the crustal structure analysis is an intrinsically non-linear problem. There are several subjective processes in wide-angle crustal structure modelling, such as phase identification and trial-and-error forward modelling. Because these subjective processes in wide-angle data analysis reduce the uniqueness and credibility of the resultant models, it is important to reduce subjectivity in the analysis procedure. From this point of view, we describe two software tools, PASTEUP and MODELING, to be used for developing crustal structure models. PASTEUP is an interactive application that facilitates the plotting of record sections, analysis of wide-angle seismic data, and picking of phases. PASTEUP is equipped with various filters and analysis functions to enhance signal-to-noise ratio and to help phase identification. MODELING is an interactive application for editing velocity models, and ray-tracing. Synthetic traveltimes computed by the MODELING application can be directly compared with the observed waveforms in the PASTEUP application. This reduces subjectivity in crustal structure modelling because traveltime picking, which is one of the most subjective process in the crustal structure analysis, is not required. MODELING can convert an editable layered structure model into two-way traveltimes which can be compared with time-sections of Multi Channel Seismic (MCS) reflection data. Direct comparison between the structure model of wide-angle data with the reflection data will give the model more credibility. In addition, both PASTEUP and MODELING are efficient tools for handling a large dataset. These software tools help us develop more plausible lithospheric-scale structure models using wide-angle seismic data.