• Journal of the Society of Cosmetic Scientists of Korea
• /
• v.20 no.1
• /
• pp.52-63
• /
• 1994

It was investigated that the effects of surfactant to cosurfactant ratio on the stability and rheological properties of o/w microemulsion. The stability of microemulsion was good in the surfactant to cosurfactant ratio 20/40 - 30/30. In the point of rheological properties, a yield stress meande the inner structure formation was detected and the area of hysteresis loop was increased with increasing of surfactant content of the ratio. The microemulsion prepared by the Microfluidizer was characterized by rheopetic.

• Korean Chemical Engineering Research
• /
• v.46 no.2
• /
• pp.330-339
• /
• 2008

Effect of additives such as NP series nonionic surfactant and cosurfactant on AgCl nanoparticles was investigated where nanoparticles were prepared using two different types of water-in-oil (W/O) microemulsions containing silver nitrate and sodium chloride, respectively. Phase behavior experiments showed that the region of one phase W/O microemulsion was found to be broadened with an increase in the ethylene oxide length of a nonionic surfactant mainly due to an increase in hydrophilic nature of a surfactant. Photomicrographs obtained by transmission electron microscopy indicated that an increase in ethylene oxide length of a nonionic surfactant results in both increases in particle size and size distribution. Phase behavior experiments for the systems containing AOT surfactant, isooctane and aqueous solution of an inorganic salt showed that addition of a cosurfactant caused a shrinkage in phase region of one phase W/O microemulsion, especially water contents contained in W/O microemulsion with an increase in the chain length or the concentration of a cosurfactant used. Photomicrographs obtained by transmission electron microscopy indicated that characteristics of AgCl nanoparticles produced were dependent both on the radius of spontaneous curvature and film rigidity of a microemulsion.

• Applied Chemistry for Engineering
• /
• v.22 no.4
• /
• pp.416-422
• /
• 2011

In this study, the effect of cosurfactant on the phase equilibrium and dynamic behavior was studied in systems containing NP7 nonionic surfactant solutions and nonpolar hydrocarbon oils. All cosurfactants used during this study such as n-pentanol, n-octanol and n-decanol acted as a hydrophobic additive and thus promoted the transition from an oil in water (O/W) microemulsion (${\mu}E$) in equilibrium with an excess oil phase to a three-phase region containing excess water, excess oil, and a middle-phase microemulsion and further to a water in oil (W/O) ${\mu}E$ in equilibrium with the excess water phase. The transition temperature was found to decrease with both increases in the chain length and amount of addition of a cosurfactant. Dynamic behavior studies under O/W ${\mu}E$ conditions showed that an oil drop size decreased with time due to the solubilization into micelles. On the other hand, both the spontaneous emulsification of water into the oil phase and the expansion of oil drop were observed under W/O ${\mu}E$ conditions because of the diffusion of surfactant and water into the oil phase. Under conditions of a three-phase region including a middle-phase ${\mu}E$, both the rapid solubilization and emulsification of the oil into aqueous solutions were found mainly due to the existence of ultra-low interfacial tension. Dynamic interfacial tension measurements have been found to be in a good agreement with dynamic behavior results.

• Korean Chemical Engineering Research
• /
• v.46 no.2
• /
• pp.356-368
• /
• 2008

The effects of cosurfactant on silica nanoparticles were investigated in systems containing surfactant, oil and aqueous ammonia solution where nanoparticles were prepared using a single phase water-in-oil (W/O) microemulsion. For the same oil phase, a single phase region was dependent on the interaction between surfactant and oil. For the cyclohexane system, NP-5 surfactant showed a wider single phase region than NP-4. The addition of n-propanol as a cosurfactant resulted in an increase or a decrease of a single phase W/O microemulsion region depending on the continuous oil phase. For both cyclohexane and isooctane systems, the addition of n-propanol resulted in a decrease in the single phase region. On the other hand, for n-heptane system, the addition of n-propanol expanded a single phase W/O microemulsion region. Silica nanoparticles prepared within a single phase region showed that relatively large number of particles of irregular shape were obtained with the addition of n-propanol to NP surfactant system. The addition of n-propanol to LA-5 surfactant and n-heptane system produced a decrease in average particle size and an increase in the number of particles formed due to a decrease in the intermicellar exchange rate among microemulsion droplets.

• Journal of the Society of Cosmetic Scientists of Korea
• /
• v.21 no.2
• /
• pp.22-48
• /
• 1995

This study was investigated to search for the effects of the structure of each component in four-component O/W microemulsion system on its formation region, droplet size and stablilty. The results was that the more number of OH site, the shorter carbon chain length of polyol, the larger formation region of microemulsion was showed. The small microemulsion droplet was obtained on condition that the polatry of oil was large and carbon chain length of hydrophobic group of surfactant was long. In using satrated hydrocarbon (such as liquid paraffin, squalane) as dispersed phase, the stability of microemulsion was better than aromatic oil phase.

• Journal of Pharmaceutical Investigation
• /
• v.28 no.3
• /
• pp.141-149
• /
• 1998

In order to reduce systemic side effects following administration, flurbiprofen was formulated as O/W microemulsion consisting of the surfactant, oil phase and aqueous phase. Particle size distribution, apparent viscosity, solubility and skin permeation of flurbiprofen in various vehicles and microemulsion were evaluated. The domain of O/W microemulsion s phase diagram had difference between oil types and the area of O/W microemulsion was wide distributed by adding to PG and cosurfactant than that of water alone. As increasing 10, 15 and 20% of Brij 97 content and 1, 2.5, 5% of oil content, the solubility of flurbiprofen in O/W microemulsions and various vehicles was $400{\sim}1,000$ and $10{\sim}500$ times higher than that of control. Also, apparent viscosity of soybean oil microemulsions was higher than that of IPM microemulsions and that of vehicle were increased as increasing vehicle content. Since skin permeation of flurbiprofen decreased as increasing viscosity, in each vehicle, it was not affected 2% ${\beta}-CD$ and decreased as increasing PG content and to 2, 5 and 10% of $HP-{\beta}-CD$. In O/W microemulsion, 5% soybean oil. 20% Brij 97 and 75% water(A-1) with high viscosity showed low skin penetration.

• Archives of Pharmacal Research
• /
• v.27 no.3
• /
• pp.351-356
• /
• 2004

A transdermal preparation containing diclofenac diethylammonium (DDA) was developed using an O/W microemulsion system. Of the oils tested, lauryl alcohol was chosen as the oil phase of the microemulsion, as it showed a good solubilizing capacity and excellent skin permeation rate of the drug. Pseudoternary phase diagrams were constructed to obtain the concentration range of oil, surfactant and cosurfactant for microemulsion formation, and the effect of these additives on skin permeation of DDA was evaluated with excised rat skins. The optimum formulation of the microemulsion consisted of 1.16% of DDA, 5% of lauryl alcohol, 60% of water in combination with the 34.54% of Labrasol (surfactant)/ethanol (cosurfactant) (1:2). The efficiency of formulation in the percutaneous absorption of DDA was dependent upon the contents of water and lauryl alcohol as well as Labrasol: ethanol mixing ratio. It was concluded that the percutaneous absorption of DDA from microemulsions was enhanced with increasing the lauryl alcohol and water contents, and with decreasing the Labrasol:ethanol mixing ratio in the formulation.

• Journal of the Society of Cosmetic Scientists of Korea
• /
• v.22 no.2
• /
• pp.20-40
• /
• 1996

The oil in water type ME of 4 component system was composed with POE monoalkyl ether and POE sorbitan monoalkyl ester as surfactant, saturated hydrocarbon, side chain structure and aromatic structure as oil, and glycerine as cosurfactant using high pressure homogenizer. The objective of this study was to examine the role of surfactant and oil structure on droplet size and stability. The experimental results showed that the droplet size was smaller with bigger polarity of oil, less hydrocarbon, longer hydrophilic chain of surfactant and higher concentration of glycerine. SQ and LP systems showed very stable but AB and ISB system unstable microemulsion.

• Journal of Pharmaceutical Investigation
• /
• v.29 no.1
• /
• pp.37-45
• /
• 1999

ABSTRACT-A self-microemulsifying drug delivery system (SMEDDS) was developed to enhance the solubility and dissolution rate of poorly water soluble drug, biphenyl dimethyl dicarboxylate, DDB. The system was optimized by evaluating the solubility of DDB and the microemulsion existence range after the preparation of microemulsions with varying compositions of triacetin and surfactant-cosurfactant mixtures (Labrasol as surfactant (S) and the combination of Transcutol, Cremophor RH 40 and Plurol oleique as cosurfactant (CoS)). SMEDDS in this study markedly improved the solubility of DDB in water up to 10 mg/ml and the size of the o/w microemulsion droplets measured by dynamic light scattering showed a narrow monodisperse size distribution with an average diameter less than 50 nm. The microemulsion existing range is increased proportional to the ratio of S/CoS, however, it decreased remarkably as the oil content was more than 20%. In vitro dissolution study of SMEDDS showed a significantly increased dissolution rate of DDB in water (> 12 fold over DDB powder), and SMEDDS also had significantly greater permeability of DDB in Caco-2 cell compared to powders.

• Korean Chemical Engineering Research
• /
• v.40 no.6
• /
• pp.769-777
• /
• 2002

Using four components - nonionic surfactants, water, hydrocarbon oil and an alcohol as cosurfactant, 12 types of cleaning agents were prepared, and their physical properties such as surface tension, viscosity, electroconductivity and phase stability were measured. As the formulated cleaning agents have low surface tensions(30.5-31.1 dyne/cm) and low viscosities (1.6-7.2 c.p.), they are satisfied with the general physical properties of water-in-oil(W/O) microemulsions for their industrial use. They showed a tendency that their temperature range for stable one-phase microemulsion decreased in accordance with the increase of alcohol/surfactant(A/S) ratio in the formulations. However, the temperature range of one-phase microemulsion was much more affected by hydrophilic lipophillic balance(HLB) value of the nonionic surfactant which increased its temperature range and it increased in accordance with the higher HLB value in the formulations. And the maximum content of water which can keep stable one-phase W/O microemulsion was measured at each sample. In addition, their temperature range for stable one-phase microemulsion was also measured. It was confirmed that the selection of surfactant type was very important for formulating a cleaning agent, since the W/O microemulsion system with the nonionic surfactant of the lower HLB value showed better cleaning efficacy that of the higher HLB value for abietic acid as a soil, which was used for preparing a rosin-type flux. In the formulated cleaning agents with the increase of A/S ratio in the formulations, however, there was no significant difference in cleaning efficacy. It was investigated that the differences of their cleaning efficacy was affected by the change of the condition of temperature and sonicating frequency as important factors in the industrial cleaning. That is, the higher, their cleaning temperature and the lower, their sonicating frequency, the more increased, their cleaning efficacy. Furthermore, using optical instruments like UV/Visable Spectrophotometer and FT-IR Spectrometer, their cleaning efficacy for abietic acid was measured. The removal of soil from the contaminated rinse water was measured by gravity separation method in the rinse bath. As a result, the cleaning agent system having the nonionic surfactant of HLB value 6.4 showed over 85% water-oil separation efficacy at over $25^{\circ}C$. Therefore, it was demonstrated in this work that the formulating cleaning agents were very effective for cleaning and economical in the possible introduction of water recycling system.