• Journal of the Korean Institute of Electrical and Electronic Material Engineers
• /
• v.17 no.5
• /
• pp.508-514
• /
• 2004

A fluxgate magnetic sensor consists of a solenoid excitation coil, pick-up coil, and magnetic core. We presents the effect of magnetic core shape in a micromachined fluxgate sensor. To observe the performance of fluxgate sensor with magnetic core side width and gap, side width of 125 ${\mu}{\textrm}{m}$, 250 ${\mu}{\textrm}{m}$, and 500 ${\mu}{\textrm}{m}$ were designed in a rectangular-ring shaped core and the gaps of 0 ${\mu}{\textrm}{m}$, 50 ${\mu}{\textrm}{m}$, and 100 ${\mu}{\textrm}{m}$ were also fabricated in a racetrack shaped core. The solenoid coils and magnetic core were separated by benzocyclobutane(BCB) which had high insulation and good planarization characters. Copper coil patterns of 10 ${\mu}{\textrm}{m}$ width and 6${\mu}{\textrm}{m}$ thickness were electroplated on Ti(300 $\AA$) / Cu(1500 $\AA$) seed layers. 3 ${\mu}{\textrm}{m}$ thick N $i_{0.8}$F $e_{0.2.}$(permalloy) film for the magnetic core was also electroplated under 2000 gauss to induce the magnetic anisotropy. The magnetic core had the high DC effective permeability of ∼1,300 and coercive field of ∼0.1 Oe. Because the magnetic cores of 500 ${\mu}{\textrm}{m}$ side width and 0 gap had a low magnetic flux leakage, high sensitivity of ∼350 V/T were measured at excitation condition of 3 $V_{P-P}$ and 2 MHz square wave. The power consumption of ∼14 ㎽ was measured. The fabricated fluxgate sensor had the very small actual size of 3.0${\times}$1.7 $\textrm{mm}^2$. When two fluxgates were perpendicularly aligned in terrestrial field, their two-axis output signals were very useful to commercialize an electronic azimuth compass for the portable navigation system.m.m.m.

• Ocean and Polar Research
• /
• v.37 no.4
• /
• pp.327-332
• /
• 2015

Isotopic compositions of ice and meltwater play a very crucial role in paleoclimate studies based on ice cores and water resources research conducted in alpine hydrogeology. Better understanding of variations in the stable isotopic compositions of water is required since changes from ice to liquid water are gaining more attention due to recent climate change. In this work, a melting experiment was designed and conducted to investigate how the isotopic compositions of ice vary with time by heat sources, such as solar radiation. We conducted the melting experiment for 22 hours. The discharge rate rose to a maximum value after 258 minutes and gradually declined because we fixed the heat source. The isotopic compositions of meltwater increased linearly or to a second degree polynomial. The linear relationship between oxygen and hydrogen has a slope of 6.8, which is less than that of the Global Meteoric Water Line (8) and higher than a theoretical value (6.3). The deuterium excess decreased when ${\delta}D$ or ${\delta}^{18}O$ increases or vise versa since the slope of the relationship for ice-liquid exchange is less than 8. These findings and the apparatus of the melting experiments will make a helpful contribution to the studies of stable isotopes and the melting process in temperate and polar regions.

• Ocean and Polar Research
• /
• v.38 no.4
• /
• pp.339-345
• /
• 2016

Stable water vapor isotopes have been utilized as a tracer for studying atmospheric global circulations, climate change and paleoclimate with ice cores. Recently, since laser spectroscopy has been available, water vapor isotopes can be measured more precisely and continuously. Studies of water vapor isotopes have been conducted over the world, but it is the early stage in south Korea. For vapor isotopes study, a cryogenic sampling device for water vapor isotopes has been developed. The cryogenic sampling device consists of the dewar bottle, filled with extremely low temperature material and impinger connected with a vacuum pump. Impinger stays put in the dewar bottle to change the water vapor which passes through the inside of impinger into the solid phase as ice. The fact that water vapor has not sampled completely leads to isotopic fractionation in the impinger. To minimize the isotopic fractionation during sampling water vapor, we have tested the method using a serial connection with two sets of impinger device in the laboratory. We trapped 98.02% of water vapor in the first trap and the isotopic difference of the trapped water vapor between two impinger were about 20‰ and 6‰ for hydrogen and oxygen, respectively. Considering the amount of water vapor trapped in each impinger, the isotopic differences for hydrogen and oxygen were 0.33‰ and 0.06‰, respectively, which is significantly smaller than the precision of isotopic measurements. This work can conclude that there is no significant fractionation during water vapor trapping.

• Environmental and Resource Economics Review
• /
• v.21 no.2
• /
• pp.271-299
• /
• 2012

The relationship between environment and economic growth has been controversial for a long time. The cores of controversy are endogeneity problem and omitted variable bias. This paper tests EKC (Environmental Kuznets Curves) hypothesis by considering econometric issues and estimates the effects of energy mix on $CO_2$ emissions empirically and tests with time series during 1981~2008. By the results of this analysis, we convince EKC Hypothesis which the relationship between $CO_2$ emissions and economic growth is the inverted U-shaped and the national energy mix contributes significantly to GHG mitigation. We also find that the nuclear energy has the greatest contribution for $CO_2$ mitigation and the renewable energy does not seem to contribute little to the $CO_2$ mitigation because the proportion of renewable energy in Korea is negligible. In terms of final energy consumption, $CO_2$ increases and transportation sector is statistically and significantly associated.

• Journal of Conservation Science
• /
• v.29 no.2
• /
• pp.103-110
• /
• 2013

Since its development in the United Kingdom, the stapler has been used extensively to bind books. Staples comprising almost entirely of iron, first made in the early 1900s, are used to staple the cores of books. These staples change the colour of paper to brown and this browned paper ultimately crumbles. Basic research is being performed on solutions to prevent the deterioration in the quality of paper in the area around the staples. In this study, the cause of this browning of paper in the area was investigated. SEM-EDS, optical microscopy and FT-IR were used to analyze a browned area of three paper samples. It was found that the browned area had shortened fibres. In addition, iron was detected in this area. The corrosion of this iron led to this area of the paper being partially covered by iron(III) oxide, the product of the corrosion, as determined by FT-IR spectroscopy.

• Economic and Environmental Geology
• /
• v.36 no.1
• /
• pp.9-15
• /
• 2003

Two piston cores, obtained from the southwestern Ulleung Basin in East Sea, were analyzed to study the geochemical characteristics of the late Quaternary sediments and to detect any changes in sedimentary environment. The results show that the capacity of Total Organic Carbon is remarkably higher (average 1.8%) than that known from general open-sea. According to tephrochronology from known eruption ages, the sedimentation rates are high, ranging from 12.1 to 14.9 cm/kyr. The ratios of nitrogen and TOC (average 6.18-7.42) imply that the organic matter in the study area would be of oceanic origin. The correlation between sedimentation rates and sulfur contents suggests that the study area may be on the whole anoxic and somewhat high in primary productivity. During the Termination 1, inflows of organic matters were high. The sedimentary environments are characterized by rapid rates of sedimentation, and high anoxic values were compatible with accumulation of organic matters.

• Journal of Biosystems Engineering
• /
• v.36 no.1
• /
• pp.33-39
• /
• 2011

An optical sensing approach based on diffuse reflectance has shown potential for rapid and reliable on-site estimation of soil properties. Important sensing ranges and the resulting regression models useful for soil property estimation have been reported. In this study, a similar approach was applied to investigate the potential of reflectance sensing in estimating soil properties for Korean paddy fields. Soil cores up to a 65-cm depth were collected from 42 paddy fields representing 14 distinct soil series that account for 74% of the total Korean paddy field area. These were analyzed in the laboratory for several important physical and chemical properties. Using air-dried, sieved soil samples, reflectance data were obtained from 350 to 2500 nm on a 3 nm sampling interval with a laboratory spectrometer. Calibrations were developed using partial least squares (PLS) regression, and wavelength bands important for estimating the measured soil properties were identified. PLS regression provided good estimations of Mg ($R^2$ = 0.80), Ca ($R^2$ = 0.77), and total C ($R^2$ = 0.92); fair estimations of pH, EC, $P_2O_5$, K, Na, sand, silt, and clay ($R^2$ = 0.59 to 0.72); and poor estimation of total N. Many wavelengths selected for estimation of the soil properties were identical or similar for multiple soil properties. More important wavelengths were selected in the visible-short NIR range (350-1000 nm) and the long NIR range (1800-2500 nm) than in the intermediate NIR range (1000-1800 nm). These results will be useful for design and application of in-situ close range sensors for paddy field soil properties.

• Tunnel and Underground Space
• /
• v.22 no.6
• /
• pp.393-402
• /
• 2012

A behavior of ridge-cut rock slope had been monitored by installing inclinometers and regional slope movement toward rear side of cut face was detected. To delineate the governing factors of slope behavior, especially backward slip of ridge-cut slope, petrographic characteristics of rock cores obtained from four drilled boreholes had been examined. BIPS images inside boreholes had been acquired and structural characteristics of slope rock had been studied. Mechanical properties of discontinuity planes distributed in the drilled core had been measured and the shear strength of coal seam imbedded-discontinuity planes also had been obtained by performing the direct shear test. Monitoring results of slope behavior had been analyzed by comprehensibly considering both the mechanical and structural characteristics of slope rock and coal seam-imbedded discontinuity planes, and the potential governance of coal seam and clay minerals embedded in the joint plane on the regional slope behavior has been also identified.

• Korean Journal of Head & Neck Oncology
• /
• v.21 no.2
• /
• pp.121-125
• /
• 2005

Objectives: To investigate the role of MMP-2 and TIMP-2 in the invasion and metastasis of thyroid papillary microcarcinomas. Materials and Methods: We performed immunohistochemical study on MMP-2 and its tissue inhibitor (TIMP-2) using tissue microarrays containing 2 cores of 40 microPTC and 8 non-neoplastic thyroid tissue. The expression intensity was semiquantitatively scored as -, ${\pm}$, +1, +2, and +3. Results: Both MMP-2 and TIMP-2 expression was observed in all tumors(100%) and in 1 of 8 non-neoplastic tissue(12.5%), and the positive staining was restricted to the epithelial cells. In 17 and 23 tumors with or without extrathyroid invasion, respectively, 8(47%) and 10(43%) cases showed moderate to strong(+23) positivity for MMP-2. TIMP-2 expression was moderate to strong in 13 cases(76%) and 16 cases(70%) in each group. In multifocal and solitary tumors, 3 of 6(50%) and 11 of 21(52%) cases showed moderate to strong MMP-2 expression, and 5/6(83%) and 15/21(71%) showed moderate to strong TIMP-2 expression. Conclusion: There is no relationship between MMP-2 or TIMP-2 expression and extrathyroid invasion or tumor multifocality in papillary microcarcinoma of the thyroid gland.

• KSII Transactions on Internet and Information Systems (TIIS)
• /
• v.10 no.7
• /
• pp.2952-2971
• /
• 2016

Outsourcing jobs to a public cloud is a cost-effective way to address the problem of satisfying the peak resource demand when the local cloud has insufficient resources. In this paper, we studied the management of deadline-constrained bag-of-tasks jobs on hybrid clouds. We presented a binary nonlinear programming (BNP) problem to model the hybrid cloud management which minimizes rent cost from the public cloud while completes the jobs within their respective deadlines. To solve this BNP problem in polynomial time, we proposed a heuristic algorithm. The main idea is assigning the task closest to its deadline to current core until the core cannot finish any task within its deadline. When there is no available core, the algorithm adds an available physical machine (PM) with most capacity or rents a new virtual machine (VM) with highest cost-performance ratio. As there may be a workload imbalance between/among cores on a PM/VM after task assigning, we propose a task reassigning algorithm to balance them. Extensive experimental results show that our heuristic algorithm saves 16.2%-76% rent cost and improves 47.3%-182.8% resource utilizations satisfying deadline constraints, compared with first fit decreasing algorithm, and that our task reassigning algorithm improves the makespan of tasks up to 47.6%.