• Journal of the Korean Vacuum Society
• /
• v.12 no.2
• /
• pp.123-129
• /
• 2003

Thin transparent Cu films in the thickness range of 10 ~ 40 nm are deposited by rf-magnetron sputtering on porous silicon (PS) anodized on p-type silicon in dark. Microstructural features of the Cu films are investigated using SEM, AFM and XRD techniques. The RMS roughness of the Cu films is found to be around 1.47 nm and the grain growth is columnar with a (111) preferred orientation and follows the Volmer-Weber mode. The photoluminescence studies showed that a broad luminiscence peak of PS near the blue-green region gets blue shifted (~0.05 eV) with a small reduction in intensity and therefore, Cu-related PL quenching is absent. The FTIR absorption spectra on the PS/Cu structure revealed no major change of the native PS peaks but only a reduction in the relative intensity. The I-V characteristic curves further establish the Schottky nature of the diode with an ideality factor of 2.77 and a barrier height of 0.678 eV. An electroluminiscence (EL) signal of small intensity could be detected for the above diode.

• Korean Journal of Materials Research
• /
• v.10 no.8
• /
• pp.551-557
• /
• 2000

Cu-based leadframe sheets were oxidized ic a hot alkaline solution to black-oxide layer on the surface and molded with epoxy molding compound(EMC), and finally machined to form sandwiched double-cantilever beam(SDCB) and sandwiched Brazil-nut(SBN)specimers to measure the adhesion strength of leadframe-EMC interface. The SDCB and the SBN specimens were designed to measure the adhesion strength in terms fracture toughness under puasi-mode I and mixed mode loadinf, respectively. After the tests, fracture surfaces were analyzed paths were observed in the SDCB-tested speciments, failure paths varied with crack speed and loading conditions.

• Applied Chemistry for Engineering
• /
• v.27 no.5
• /
• pp.483-489
• /
• 2016

Here, we examined the photo-degradation efficiency of $Cu_2Se$-graphene nanocomposites synthesized by a facile and fast microwave-assisted technique. The prepared composites were characterized by X-ray diffraction (XRD), scanning electron microscopy (SEM), transmission electron microscopy (TEM), Raman spectroscopy, XPS and UV-Vis spectrophotometry. The photocatalytic performance was studied through the decomposition of Rhodamine (Rh B) as a standard dye under visible light radiation. A 95% of Rh B degradation after visible light irradiation for 180 min indicates that the $Cu_2Se$-graphene composite exhibited significant photodegradation efficiency. Therefore, it can be concluded that the synthesized $Cu_2Se$-graphene can be used as a suitable catalyst for decomposing dye pollutants.

• Solar Energy
• /
• v.12 no.3
• /
• pp.28-36
• /
• 1992

The performance of a latent heat storage system using a thermosyphon as the heat transfer device between the heat source and the phase change material was investigated experimentally. In order to increase the effective conductivity of the phase change material, layers of copper wire mesh were immersed in the paraffin wax(Sunoco P-116) in such a way that they also may be considered as fins of the thermosyphon. The important results are as follows : (1) The void space of the wire mesh allowed the convection to occur, thus enhanced the performance of the system : (2) The increase of the number of layer of wire mesh increased the conduction heat transfer. However, it also had adverse effect of subduing convective motion of liquid wax : and (3) Overall heat transfer coefficient and thermosyphon conductance increased with the increase of the number of layer of wire mesh, whereas the heat transfer coefficient between the thermosyphon and the wax decreased.

• Resources Recycling
• /
• v.21 no.6
• /
• pp.45-50
• /
• 2012

The room-temperature electrodeposition of metallic lithium was investigated from ionic liquid, 1-methyl-1-propylpiperidinium bis(trifluoromethanesulfonyl)imide (PP13TFSI) with lithium bis (trifluoromethanesulfonyl)imide (LiTFSI) as a lithium source. Cyclic voltammograms on gold working electrode showed the possibility of the electrodeposition of metallic lithium, and the reduction current on a gold electrode was higher than the value on platinum and copper. The metallic lithium could be electrodeposited on the gold electrode under potentiostatic condition at -2.4 V (vs. Pt-QRE) and was confirmed by analytical techniques including XRD and SEM-EDS. The dendrite-typed electrodeposits were composed of a metallic lithium and a alloy with gold substrate. And any impurity could be detected except for trace oxygen introduced during handling for the analyses.

• Applied Biological Chemistry
• /
• v.31 no.2
• /
• pp.162-168
• /
• 1988

The contents of minerals of the milled fractions of degermed Japonica and J/Indica brown rices were determined. The fraction I(about 4.4% of the kernel weight) contained 14.8 times as much sodium as did the original kernel; phosphorus, 5.7 times; potassium and iron, 5.4 times; magnesium, 4.2 times; calcium, 3.8 times; manganese, 3.7 times; Copper, 3.6 times; and Zinc, 2.3 times. Concentrations of these minerals were the lowest in the residual kernel, which contained less than the original brown rice. Sodium showed the most deepest concentration gradient, while iron was the most evenly distributed within the kernel in all samples.

• Polymer(Korea)
• /
• v.35 no.3
• /
• pp.244-248
• /
• 2011

Poly(2,6-dimethyl-1,4-phenylene ether) (PPE) was synthesized by oxidative polymerization using various Cu(I)-amine catalyst system. The effects of catalyst/monomer ratio, different amine ligand, and the content of 2,4,6-trimethylphenol (TMP) additive on the polymer yield and molecular weight were investigated by using gel permeation chromatography. The catalytic activity of various Cu-amine systems on the 2,S-dimethylphenol (DMP) polymerization was monitored and compared each other through oxygen-uptake experiment. In addition, the effect of catalyst removal using aqueous EDTA on the thermal stability of the prepared polymer was elucidated by thermogravimetric analysis.

• Journal of the Korean Electrochemical Society
• /
• v.25 no.2
• /
• pp.81-87
• /
• 2022

In this study, the effect of alkylamine on copper electroplating was analyzed using cyclic voltammetry. When water-soluble alkylamines were added to the plating solution, the reduction reaction of Cu²⁺ was inhibited. The inhibition effect of 1,12-diaminododecane has been investigated at various concentrations and conditions of the plating solution. 1,12-diaminododecane was protonated in the acidic plating solution, and therefore, it did not act as a complexing agent for Cu²⁺. Accordingly, it was confirmed that the inhibiton effect of 1,12-diaminododecane was attributed to adsorption on the Cu surface. The adsorption of 1,12-diaminododecane exhibits two characteristics: (i) protonation and subsequent electrostatic attraction with anions pre-adsorbed on Cu surface, and (ii) direct adsorption on Cu surface via amine functional group. The adsorbed 1,12-diaminododecane caused three-dimensional growth and grain refining, as well as the inhibition effect, during Cu electroplating.

• Food Science of Animal Resources
• /
• v.43 no.1
• /
• pp.46-60
• /
• 2023

Slaughterhouse blood is a by-product of animal slaughter that can be a good source of animal protein. This research purposed to examine the functional qualities of the blood plasma from Hanwoo cattle, black goat, and their hydrolysates. Part of the plasma was hydrolyzed with proteolytic enzymes (Bacillus protease, papain, thermolysin, elastase, and α-chymotrypsin) to yield bioactive peptides under optimum conditions. The levels of hydrolysates were evaluated by 15% sodium dodecyl sulfate polyacrylamide gel electrophoresis. The antioxidant, metal-chelating, and angiotensin I-converting enzyme (ACE) inhibitory properties of intact blood plasma and selected hydrolysates were investigated. Accordingly, two plasma hydrolysates by protease (pH 6.5/55℃/3 h) and thermolysin (pH 7.5/37℃/3-6 h) were selected for analysis of their functional properties. In the oil model system, only goat blood plasma had lower levels of thiobarbituric acid reactive substances than the control. The diphenyl picrylhydrazyl radical scavenging activity was higher in cattle and goat plasma than in proteolytic hydrolysates. Ironchelating activities increased after proteolytic degradation except for protease-treated cattle blood. Copper-chelating activity was excellent in all test samples except for the original bovine plasma. As for ACE inhibition, only non-hydrolyzed goat plasma and its hydrolysates by thermolysin showed ACE inhibitory activity (9.86±5.03% and 21.77±3.74%). In conclusion, goat plasma without hydrolyzation and its hydrolysates can be a good source of bioactive compounds with functional characteristics, whereas cattle plasma has a relatively low value. Further studies on the molecular structure of these compounds are needed with more suitable enzyme combinations.

• Transactions of the Korean hydrogen and new energy society
• /
• v.34 no.4
• /
• pp.350-357
• /
• 2023

In this study, the experimental investigation and theoretical analysis were conducted to verify the cooling capacity of the cryocooler used for pre-cooling of hydrogen gas. The effect of the flow rate on a copper pipe attached to the bottom of the cryocooler, which has a coil shape in a hydrogen line, was investigated. Temperature sensors were strategically placed at various positions on the cryocooler to analyze the temperature variations with respect to the flow rate. In this study, the thermal properties of hydrogen for the pressure and temperature were utilized using REFPROP to analyze the cooling capacity of the cryocooler. Based on the experimental results derived from this study, the cooling capacity of the cryocooler for pre-cooling hydrogen gas was considered by calculating the cooling temperature according to the flow rate through theoretical analysis.