• The Journal of Korean Institute of Electromagnetic Engineering and Science
• /
• v.16 no.2 s.93
• /
• pp.222-227
• /
• 2005

The permittivity profile of PCB substrate in a wide bandwidth is obtained by applying the moment method to the reflection coefficients measured by an open-ended coaxial probe. In this paper, the relation between a reflection coefficients and the corresponding permittivity is expressed into an integral form and the reflection coefficient of PCB substrates with different thickness are calculated using the dispersive FDTD method. The simulation results assure the validity of our conversion procedure within $2.015\%$ error.

• Journal of the Institute of Electronics Engineers of Korea SC
• /
• v.43 no.6 s.312
• /
• pp.27-32
• /
• 2006

A temperature-compensated hygrometer has been developed using resistive humidity sensors. It consist of a sine wave generator, logarithm converters, rectifiers, and amplifiers. The hygrometer accomplishes the linearization and temperature compensation of sensor characteristics. The theory of operation is presented and experimental results are used to verify theoretical predictions. The experimental results show that the conversion sensitivity of the hygrometer is about 24.8 mV/%RH and the linearity error of the conversion characteristic is less than 17.2 % over a relative humidity range from 30 to 80 %RH. The results also show that the temperature coefficient of the output voltage is less than $10149ppm/^{\circ}C$ over a temperature range from 22 to $40^{\circ}C$.

• Proceedings of the KIEE Conference
• /
• 1996.07c
• /
• pp.1645-1647
• /
• 1996

Polycrystalline CdTe thin films -have been studied for photovoltaic application because of their high absorption coefficient and optimal band gap energy (1.54 eV) for solar energy conversion. In this study, we prepared CdTe films using RF-magnetron sputtering method and investigated structural, optical and electrical properties with spectrophotometer, XRD, EDX, and resistivity meter. CdTe films at $200\;^{\circ}C$ showed a mixture of zinc blend (Cubic) and wurtzite (hexagonal) phase. On the other hand, the films at $400\;^{\circ}C$ showed highly oriented structure having hexagonal structure. The resistivity of CdTe films deposited on $SiO_2$ substrates was about $10_7\;{\Omega}cm$. The value of resistivity decreased with the increase of the substrate temperature. CdTe were sputtered on CdS thin films prepared by chemical bath deposition for the formation of the heterojunction. I-V characteristics of these cells were measured at a light density of $100mw/cm^2$, AM. 1.0. The present thin film solar cells showed a conversion efficiency of about 5%.

• Journal of Environmental Impact Assessment
• /
• v.21 no.2
• /
• pp.289-296
• /
• 2012

The shock vibration such as machine vibration, blasting vibration etc. has effect on nearby structure as well as human body. The purpose of this study is to predict allowable limit distance of vibration about human body. First of all, vibration velocity such as PPV, PVS was measured by shock vibration experiment, and vibration level was calculated by conversion formula of vibration velocity. And then, allowable limit distance was analyzed by converted vibration level. The results are as follows : Firstly, the correlation coefficient of converted vibration level was over R=0.94, and vibration level caused by PVS was usually represented to high curve line. Secondly, the cross point of vibration level between ground and concrete condition was represented to 66.68dB(V), and allowable limit distance was represented to difference over three times when vibration regulation was raised from 65dB(V) to 80dB(V).

• Journal of Korean Society of Rural Planning
• /
• v.26 no.3
• /
• pp.25-38
• /
• 2020

The purpose of this study is constructing a regional-level crop acreage choice model incorporating the impacts of producer risk aversion, and applying the constructed model to the Korean policy that promotes rice paddy conversion into non-rice crop fields. The study adopts the approach of Paris (2018) which estimates the absolute risk aversion coefficient inside of a positive mathematical programming model. A panel data set of 143 cities/counties is used for the empirical study where agricultural land in each region is allocated to 8 crops. Our estimated absolute risk aversion coefficients are smaller than those of Paris (2018), but are a little bit larger than those of the existing Korea studies based on survey or econometric methods. We found that there are close relationships among the estimated risk aversion, regional characteristics, and farming patterns. We also found that incorporating the estimated risk attitudes results in substantial differences in the impacts of the rice paddy conversion policy.

• Korean Journal of Materials Research
• /
• v.28 no.12
• /
• pp.748-757
• /
• 2018

Inorganic semiconductor compounds, e.g., CIGS and CZTS, are promising materials for thin film solar cells because of their high light absorption coefficient and stability. Research on thin film solar cells using this compound has made remarkable progress in the last two decades. Vacuum-based processes, e.g., co-evaporation and sputtering, are well established to obtain high-efficiency CIGS and/or CZTS thin film solar cells with over 20 % of power conversion. However, because the vacuum-based processes need high cost equipment, they pose technological barriers to producing low-cost and large area photovoltaic cells. Recently, non-vacuum based processes, for example the solution/nanoparticle precursor process, the electrodeposition method, or the polymer-capped precursors process, have been intensively studied to reduce capital expenditure. Lately, over 17 % of energy conversion efficiency has been reported by solution precursors methods in CIGS solar cells. This article reviews the status of non-vacuum techniques that are used to fabricate CIGS and CZTS thin films solar cells.

• Journal of the Korean GEO-environmental Society
• /
• v.8 no.3
• /
• pp.35-40
• /
• 2007

The vertical drain method recently being used in Korea is divided into the sand drain method, the pack drain method, the paper drain method, and the PBD method according to the drainage. However, these methods generate the disturbed zone called the smear zone when the drainage is penetrated into the in-situ ground. The characteristics of the smear zone generated cause the problems that the coefficient of permeability decreases and the consolidation time becomes longer than expected in the design. Although the size of the smear zone is a very important factor directly influencing the degree of consolidation, in the existing studies, the general value for the size of the smear zone proposed has been used in the design. However, the size of the smear zone proposed by the existing studies cause a loss of economical efficiency because of the inaccuracy of the design. Hence, in this study, the characteristics on the size of the smear zone were analyzed by carrying out the three dimensional numerical analysis and the method to determine the conversion size of the smear zone considering the change of the coefficient of permeability was proposed in order to consider the change of the coefficient of permeability in the actual design.

• Journal of Magnetics
• /
• v.16 no.3
• /
• pp.211-215
• /
• 2011

The dynamic magnetostriction characteristics of an Fe-based nanocrystalline FeCuNbSiB alloy are investigated as a function of the dc bias magnetic field. The experimental results show that the piezomagnetic coefficient of FeCuNbSiB is about 2.1 times higher than that of Terfenol-D at the low dc magnetic bias $H_{dc}$ = 46 Oe. Moreover, FeCuNbSiB has a large resonant dynamic strain coefficient at quite low Hdc due to a high mechanical quality factor, which is 3-5 times greater than that of Terfenol-D at the same low $H_{dc}$. Based on such magnetostriction characteristics, we fabricate a new type of transducer with FeCuNbSiB/PZT-8/FeCuNbSiB. Its maximum resonant magnetoelectric voltage coefficient achieves ~10 V/Oe. The ME output power reaches 331.8 ${\mu}W$ at an optimum load resistance of 7 $k{\Omega}$ under 0.4 Oe ac magnetic field, which is 50 times higher than that of the previous ultrasonic-horn-substrate composite transducer and it decreases the size by nearly 86%. The performance indicate that the FeCuNbSiB/PZT-8/FeCuNbSiB transducer is promising for application in highly efficient magnetoelectric energy conversion.

• Applied Biological Chemistry
• /
• v.40 no.4
• /
• pp.334-341
• /
• 1997

In the laboratory experiment, concentration and rate of runoff of 7 pesticides were measured under the simulated rainfall. Total runoff rate of metolachlor, alachlor, chlorothalonil, chlorpyrifos, EPN, phorate and captafol were 57.0, 14.2, 13.2, 7.9, 7.2, 7.1 and 2.8%, respectively, and the average runoff concentrations were 940, 399, 55, 7.0, 9.3, 151 and 7.0 ppb, respectively. Significant relationship was observed between the runoff rate and water solubility in the laboratory experiment(r=0.923). Even though not very high, relatively significant results were obtained in other experimental conditions. Based on the results, runoff rate prediction$[Y=0.2812{\times}10exp(0.261logWS-0.366)+0.3594{\times}10exp(-0.545logKoc+1.747)+0.3594{\times}10exp(-0.362log\;Kow+1.105]$ and conversion equations were calculated to investigate the possibility of estimating runoff rate in the field by natural rain. Calculated runoff rate by conversion equation was similar to experimental result with captafol in the field while 6 times higher result was obtained by the prediction equation. Therefore, those prediction and conversion equations derived from the laboratory experiment data and physicochemical properties of the pesticides could be used for the prediction of field runoff rate of pesticides by natural rainfall.

• Korean Journal of Optics and Photonics
• /
• v.4 no.2
• /
• pp.200-205
• /
• 1993

We generated the second harmonic of Ti:sapphire laser in LiI$O_3$ and BBO crystals. Two LiI$O_3$, crystals and a BBO crystal were used, and the lengths of LiI$O_3$ crystals were 5, 10 mm and that of BBO was 7 mm. We measured the conversion efficiencies of LiI$O_3$ and BBO in the wavelength range of 780-810 nm, and compared with the caculation of theory. The measured second harmonic conversion coefficients were (1.06${\pm}0.05){\times}10^4\;W^1$(10mm), (5.28${\pm}0.33){\times}10^5\;W^1$(5mm), and (2.96${\pm}0.05){\times}10^5\;W^1$(BBO, 7 mm) at the fundamental wavelength of 794 nm.