• Proceedings of the Korean Radioactive Waste Society Conference
• /
• 2005.06a
• /
• pp.21-29
• /
• 2005

The HANARO, a multi-purpose research reactor of 30 MWth open-tank-in-pool type, has been under normal operation since its initial criticality in February, 1995. Recently, ten years after the initial operation of the HANARO, one of the two primary cooling pumps was decontaminated for overhaul maintenance in 2004. Before decontamination exposure doserate and surface contamination level of primary cooling pump measured at 4 points. After final decontamination exposure doserate and surface contamination level of primary cooling pump remeasured by same method done before. It is easy to decontaminate the out side exposed surfaces of the pump, but it is difficult to approach the inside surface due to double volute installed in the casing. Therefore, a new decontamination facility has been developed to solve this problem. A concentrated de-contaminant (DX-300) is rotated in the closed pump casing by the impeller actuated by a temporary motor. Nuclide particles are removed by the emulsification effect of the de-contaminant and the surface contaminants are chemically removed from the pump by the corrosion and dissolution effect. The inside surfaces of the primary cooling pump have been decontaminated by using the facility. As results, the contamination level of the inside surfaces was maintained below the surface contamination limit.

• Economic and Environmental Geology
• /
• v.51 no.6
• /
• pp.553-566
• /
• 2018

The occurrence of natural radionuclides like uranium and radon in groundwater was hydrochemically examined based on 40 well groundwaters in Mungyeong area. The range of electrical conductivity (EC) value in the study area was $68{\sim}574{\mu}S/cm$. In addition to the increase of EC value, the content of cations and anions also tends to increase. Uranium concentrations ranged from $0.03{\sim}169{\mu}g/L$ (median value, $0.82{\mu}g/L$) and radon concentrations ranged from 70~30,700 pCi/L (median value, 955 pCi/L). Only 1 out of 40 wells (2.5%) showed uranium concentration exceeding the maximum contaminant level (MCL; $30{\mu}g/L$) proposed by the US Environmental Protection Agency (EPA). Radon concentrations of eight wells (20%) exceeded AMCL(Alternative maximum contaminant level) of the US EPA (4,000 pCi/L). Four out of those eight wells even exceeded Finland's guideline level (8,100 pCi/L). When concentrations of uranium and radon were investigated in terms of geology, the highest values are generally associated with granite. The uranium and radon levels observed in this study are low in comparison to those of other countries with similar geological settings. It is likely that the measured value was lower than the actual content due to the inflow of shallow groundwater by the lack of casing and grouting.

• Korean Journal of Ecology and Environment
• /
• v.55 no.2
• /
• pp.111-119
• /
• 2022

The occurrence of cyanobacterial blooming and the contaminant sources were analyzed in the downstream of Jecheon Stream, a tributary of Chungju Reservoir. The concentrations of chlorophyll a at the Myungseo Fishing Point (GPS; 37°03'25.5"N, 128°03'13.6"E) were 399.2 and 184.8 mg m^-3 on October 18, 2015 and September 25, 2016, respectively, and the concentrations of total microcystins, a cyanobacterial toxin mainly produced by Microcystis, were 124.09 and 79.71 ㎍ L^-1, respectively. The occurrence of cyanobacterial blooming at the downstream of Jecheon Stream was closely related to the water level of Chungju Reservoir. The cyanobacterial blooming occurred after the increase of water level in Chungju Reservoir, when the water body stagnated. As a result of analyzing National Water Quality Monitoring Data of the upper region of Jecheon Stream, the main source of pollutant was Jangpyeong Stream, the tributary of Jecheon Stream, and the discharge water from Jecheon Wastewater Treatment Plant located in Jangpyeong Stream was considered to be the most important source of contaminant.

• The Transactions of the Korean Institute of Electrical Engineers C
• /
• v.54 no.11
• /
• pp.483-489
• /
• 2005

This study performs a simulation for an accumulation mechanism of contaminants, which were produced in an industrial belt of inland, on the surface of insulators. From the simulation, silicon insulators presented higher accumulation than that of EPDM(Ethylene Propylene Diene Terpolymer : EPDM) insulators on the same distance in the case of the Virgin polymer insulator, and this result presented the same result in the insulator applied in actual fields. In the case of the accumulation test for the Virgin insulator and insulators used in actual fields, it is evident that the Virgin insulator presented more accumulation than that of the insulator used in actual fields. The results can be caused by the generation of LMW (Low Molecular Weight) on the external material of polymer insulators, and the level of the accumulation can be changed according to the degree of the continuous generation of LMW. In order to simulate a certain pollution of an industrial belt, which is located along the coastline, leakage currents were measured by applying the contaminant compulsively that was produced with salts and Kaolin according to the ratio of its weight on the surface of insulators. The more increase in the content of Kaolin pollution, the level of leakage currents on the surface of polymer insulator more increased. In addition, the approaching time to the maximum value of leakage currents presented a nearly constant level regardless of the content of Kaolin. The level of leakage currents significantly decreased according to the passage of time, and the level of leakage currents on the surface maintained a constant level at a specific time regardless of the content of Kaolin.

• Proceedings of the Korean Environmental Health Society Conference
• /
• 2005.06a
• /
• pp.303-305
• /
• 2005

3-Monochloro-1,2-propanediol (3-MCPD) is a contaminant of acid-hydrolyzed vegetable protein. Several reports have suggested that chronic exposure to 3-MCPD could produce neurotoxicity in vitro or neurobehavioral effects inaspects of experimental animals. Disturbance of the nitric oxide signaling pathway by chronic exposure to 3-MCPD may be a causal factor of neurological disorders in rats. In order to investigate the relationship between 3-MCPD administration and expression of inducibal nitric oxide synthase (iNOS), the numbers and distribution patterns of iNOS-immunoreactive neurons were examined. At the all three bregma level examined, the optical density of iNOS-postive neurons was significantly increased following exposure to 3-MCPD. The change was more severe in the upper layer than in deep layer of the cortex. These data suggest that 3-MCPD toxicity may be mediated through disturbances to the nitric oxide signaling pathway.

• Analytical Science and Technology
• /
• v.12 no.6
• /
• pp.583-586
• /
• 1999

The quantitative analysis of nitrate and nitrite in rain, milk and infant formula was done by Ion Chromatography. The nitrite was not detected(<0.1 mg/L) in all the samples. However, the nitrate was detected in the range of 0.1~4.9 mg/L in rain, 9.8~19.8 mg/L in milk, and 80~300 mg/L in infant formula, respectively. Some content of nitrate is close to the maximum contaminant level(MCL) which is 10 mg/L as $NO_3-N$, 44.3 mg/L as $NO_3$.

• Environmental Analysis Health and Toxicology
• /
• v.21 no.2 s.53
• /
• pp.93-102
• /
• 2006

Methyl tert-butyl ether (MTBE), an octane booster that is added to the reformulated gasoline, has been a widespread contaminant in aquatic ecosystem. MTBE is a recalcitrant pollutant having low biodegradability. Due to its higher water solubility and low octanol-water partition coefficient, it can be rapidly transported to the surrounding water environment. Also, MTBE is a known animal carcinogen, and is classified as a possible human carcinogen by U. S. Environmental Protection Agency. The adverse effect of MTBE to aquatic biota was widely reported. In Korea, the recent detection of MTBE in groundwater near gasoline filling stations has drawn concern to public health and ecosystem. To address this concern, the effect of MTBE to human health and ecosystem was discussed in this review. Also, ecotoxicity data of MTBE for fish, invertebrates, and algae were extensively compared to estimate the hazard concentration 5($HC_5$) of MTBE as a screening level.

• Proceedings of the Korean Society of Soil and Groundwater Environment Conference
• /
• 1998.11a
• /
• pp.183-188
• /
• 1998

The efficiency of removing cadmium, copper, and lead from a contaminated soil of abandoned metal mine was studied in a laboratory investigation where citric acid were used to extract the metal from the soil. The contamination level of Pb, Cu in the soil A were 875.5, 667.5mg/kg respectively. The mobility and bioavailability of the metals in soil were also estimated by Sequential Chemical Extractions. Citric acid were examined for its potential extractive capabilities. Concentrations of the acid examined in this study ranged from 0.025 to 0.15M. The pH of the suspensions and S/S ratio in which the extractions were performed ranged from 2.4 to 8.1, and from 2.1:1 to 20:1. Results showed that the removal of contaminant using citric acid was pH and S/S raton dependent.

• Proceedings of the Korean Institute of Electrical and Electronic Material Engineers Conference
• /
• 2005.11a
• /
• pp.145-146
• /
• 2005

This study performs a simulation for an accumulation mechanism of contaminants, which were produced in an industrial belt of inland, on the surface of insulators. From the simulation, silicon insulators presented higher accumulation than that of EPDM(Ethylene Propylene Diene Terpolymer : EPDM) insulators on the same distance in the case of the Virgin polymer insulator, and this result presented the same result in the insulator applied in actual fields. In the case of the accumulation test for the Virgin insulator and insulators used in actual fields, it is evident that the Virgin insulator presented more accumulation than that of the insulator used in actual fields. The results can be caused by the generation of LMW (Low Molecular Weight) on the external material of polymer insulators, and the level of the accumulation can be changed according to the degree of the continuous generation of LMW.

• Proceedings of the Korean Institute of Building Construction Conference
• /
• 2018.11a
• /
• pp.29-30
• /
• 2018

The development of the industry has increased the indoor living time of modern people. Therefore, indoor pollution is attracting attention as a social issue. One of the indoor air pollution is formaldehyde. Formaldehyde has been classified as a first-level carcinogen by international cancer research organizations. Formaldehyde has been used to protect products such as construction materials and finish materials, and being diffused in the interior construction process. In this study, we used phytoncide with cement matrix to reduce formaldehyde, an indoor environmental contaminant. The strengths was increased slightly and formaldehyde showed a reduction effect over time.