• Geomechanics and Engineering
• /
• v.35 no.4
• /
• pp.385-393
• /
• 2023

To analyze the consolidation with horizontal sand drains, the plane strain consolidation model under multi-ramp loading is established, and its corresponding analytical solution is derived by using the separation of variables method. The proposed solution is verified by the field measurement data and finite element results. Then, the effects of the loading mode and stress distribution on consolidation and dissipation of pore pressure are investigated. At the same time, the influence of hydraulic conductivity and thickness of sand blankets on soil consolidation are also analyzed. The results show that the loading mode has a significant effect on both the soil consolidation rate and generation-dissipation process of pore water pressure. In contrast, the influence of stress distribution on pore pressure dissipation is obvious, while its influence on soil consolidation rate is negligible. To guarantee the fully drained condition of the sand blanket, the ratio of hydraulic conductivity of the sand blanket to that of clay layer k_d/k_v should range from 1.0×10⁴ to 1.0×10⁶ with soil width varying from 100 m to 1000 m. A larger soil width correspondingly needs a greater value of kd/kv to make sure that the pore water can flow through the sand blanket smoothly with little resistance. When the soil width is relatively small (e.g., less than 100 m), the effect of thickness of the sand blanket on soil consolidation is insignificant. And its influence appears obvious gradually with the increase of the soil width.

• Journal of the Korean Geosynthetics Society
• /
• v.11 no.2
• /
• pp.11-20
• /
• 2012

Partially penetrated SCP method is to install sand compaction piles in a soft clay layer not penetrating to the bed layer. In this study, consolidation behaviors of soft grounds improved by both partially and fully penetrated SCP methods are presented. When the replacement ratio is low, the settlement characteristic of the ground improved by fully penetrated SCP method seems to be consistent regardless the degree of consolidation. On the other hands, the ground improved by partially penetrated SCP method appears to decrease depending on the degree of consolidation. In addition, the settlement of upper clay layer is more increasing as the penetration ratio ($H_d/H$) is decreasing. No effect of stress concentration at the lower part of the partially penetrated SCP method is developed. The ratio of stress sharing appears to be almost consistent regardless the degree of consolidation.

• Journal of the Korean Geotechnical Society
• /
• v.19 no.6
• /
• pp.299-306
• /
• 2003

Dredged soil experiences large settlement during consolidation because of its high water contents. Large settlement alters the thickness of the consolidation layer greatly with time. However, the consolidation theory proposed by Terzaghi assumes the thickness of the consolidation layer to stay constant. Mikasa has developed a more rational theory considering the change of thickness of consolidation layer but it is not well applied at the site. In this study consolidation tests have been performed using Rowe cell for the four dredged clay samples with a water content of 100%, 120%, 133% and 150%. From the test results compression index characteristics and coefficient of consolidation characteristics have been investigated. Coefficients of consolidation obtained by Terzaghi's and Mikasa's theories, have been evaluated and compared with each other. When Mikasa theory is applied in the field design, the period to reach the required degree of consolidation has been reduced compared with the result by Terzaghi theory because the time factor $T_{v}$ by Mikasa theory decreases with increasing of final strain of consolidation layer, Calculation method consolidation time by Mikasa theory was concisely explained for its practical use.e.

• Journal of the Korean Geotechnical Society
• /
• v.27 no.4
• /
• pp.77-87
• /
• 2011

To investigate the effect of drainage spacing and smear on the rate of consolidation and the efficiency of vertical drain method, a series of consolidation tests with a large consolidation chamber and special equipment for inserting mandrels were conducted. As the smeared region increases, total settlement in over-consolidated clay increases whereas apparent change in settlement does not appear in normally consolidated clay. Vertical drain generally accelerates the rate of consolidation, while it could also deteriorate the efficiency of vertical drain method even for the decreasing drainage length and spacing ratio.

• Geotechnical Engineering
• /
• v.12 no.1
• /
• pp.5-20
• /
• 1996

In order to accelerate the rate of consolidation settlement and to gain a required shear strength for a given soft clay deposit, the preloading technique combined with a vertical drainage system has been widely applied. In this'study, the theory of axisymmetric consolidation which considers the variation of compressibility and permeability during the conslidation process, has ben developed. A computer program named AXICON for the analysis of axisymmetric nonlinear consolidation is developed by adopting an explicit finite difference method. Smear and well resistance effects are also considered. The AXICON is capable of analyzing the consolidation behavior of multi -layered deposits and simulates time dependent loading sequence. The results of AXICON are validated with analytical solutions of Hansbo and Barron, and compared with insitu settlements and pore pressures measured in a soft clay deposit.

• Proceedings of the Korean Geotechical Society Conference
• /
• 2006.10a
• /
• pp.515-520
• /
• 2006

Yano method had been used in predicting the settlement of self-weight consolidation of dredged soil in the construction of reclamating the dredged soil. Its estimation was found to show some different results from field measurements. The numerical analysis with PSDDF was peformed find such differences, considering the effect of desiccation on the consolidation during the remaining time after reclamation. For the parametric study, numerical analyses with/without consideration of desiccation were carried out with changing the conditions of desiccation such as the number of placing the fill and the time period between each placement. As results of analysis, estimations about consolidation settlement and distribution of water contents with consideration of desiccation was in good agreements with field measurements. It was also found that the number of placing the fill and the time period between each placement did not affect the behavior of self-weight consolidation as much as the effect of desiccation.

• Journal of the Korean Geotechnical Society
• /
• v.21 no.5
• /
• pp.143-151
• /
• 2005

This paper presented a method to estimate the consolidation yield stress of compacted soil with an unsaturated soil mechanics, especially considering the effect of matric suction. Then two kinds of experiments were conducted. One is a series of static compaction tests to monitor the matric suction, and the other is a series of consolidation tests on compacted soil without soaking. The results indicate that it is possible to derive the distribution of matric suction on compaction curves and to hypothesize the changes of the void ratio depending on the matric suction in the consolidation tests. With this experimental results, a new method was introduced to estimate the consolidation yield stress of compacted soil including compaction curves.

• Proceedings of the Korean Geotechical Society Conference
• /
• 2008.10a
• /
• pp.1328-1339
• /
• 2008

For a commonly used piezocone with a shoulder filter element, dilatory dissipation behavior, which shows an initial temporary increase in pore pressure, has been observed in overconsolidated cohesive soils. However, there is no appropriate way to estimate a consolidation parameter from a dilatory dissipation curve because currently available interpretation methods were developed based on the monotonic decrease of the excess pore pressure. In this study, the interpretation method for evaluation of coefficient of consolidation from a dilatory dissipation result of piezocone test was developed by performing the finite difference analysis on the dissipation after cone penetration. The distribution of the initial excess pore pressure induced by cone penetration, which is the core of the analysis, was estimated from the empirical modification of a solution proposed by cavity expansion theory and critical state concept. And the proposed interpretation method was applied to the field piezocone data and the results were compared to those obtained from laboratory tests. Its reliability was confirmed by the insignificant difference between the values of coefficient of consolidation from piezocone tests and laboratory consolidation tests.

• Proceedings of the Korean Geotechical Society Conference
• /
• 1998.04a
• /
• pp.37-46
• /
• 1998

Several researchers have developed a number of theoretical time factors to determine the coefficient of consolidation by biezocone excess pore water dissipation test in soft clay deposits. However, depending on the assumptions and analytical techniques, the estimated coefficient of consolidation could be in a considerably wide range even for a specific degree of consolidation. These solutions are obtained from an initial excess porewater pressure distribution which can be determined from. either the cavity expansion theory or the strain path method. The 야ssipation of the initial excess porelvater pressure has been usally simulated by means of linear-uncoupled consolidation analysis and then the dissipation curve is normalized by the initial excess porewater pressure for easy use. However. since there is no guidelines or rules on which method gives the best solution for obtaining the coefficient of consolidation from the dissipation curve, the final selection was only based on engineer's extrience and Judgements. Thus, such an arbitrary selection might be inappropriate for a specific site to characterize the consolidation behavior. In this paper, we reviewed various theoretical time factors and, based on this consideration, we mentioned needs for researches in selecting a specific solution that is compatible for Korean clays. Also we listed some source of errors that can be encountered in the procedure of dissipation analysis.

• Geomechanics and Engineering
• /
• v.19 no.5
• /
• pp.447-462
• /
• 2019

The vacuum preloading method has been used in many countries for ground improvement and land reclamation works. A sand cushion is required as a horizontal drainage channel for conventional vacuum preloading. In terms of the dredged-fill foundation soil, the treatment effect of the conventional vacuum preloading method is poor, particularly in Tianjin, China, where a shortage of sand exists. To solve this problem, straight-line vacuum preloading without sand is widely adopted in engineering practice to improve the foundation soil. Based on the engineering properties of dredged fill in Lingang City, Tianjin, this paper presents field instrumentation in five sections and analyzes the effect of a prefabricated vertical drain (PVD) layout and a vacuum pumping method on the soft soil ground treatment. Through the arrangement of pore water pressure gauges, settlement marks and vane shear tests, the settlement, pore water pressure and subsoil bearing capacity are analyzed to evaluate the effect of the ground treatment. This study demonstrates that straight-line vacuum preloading without sand can be suitable for areas with a high water content. Furthermore, the consolidation settlement and consolidation degree system is developed based on the grey model to predict the consolidation settlement and consolidation degree under vacuum preloading; the validity of the system is also verified.