• Biotechnology and Bioprocess Engineering:BBE
• /
• 제11권4호
• /
• pp.368-371
• /
• 2006

The standard procedure outlined by the United States Environmental Protection Agency (US EPA) in Method 1623 for analyzing Giardia lamblia cysts and Cryptosporidium parvum oocysts in water samples consists of filtration, elution, centrifugal concentration, immunomagnetic separation (IMS), and immunofluorescence assay (IFA) followed by microscopic examination. In this study, the extent of (oo)cyst loss in each step of this procedure was evaluated by comparing recovery yields in segmented analyses: (i) IMS + IFA, (ii) concentration + IMS + IFA, and (iii) filtration/elution + concentration + IMS + IFA. The complete (oo)cyst recovery by the full procedure was $52{\sim}57%$. The (oo) cyst loss in the IMS step was only $0{\sim}6%$, implying that IMS is a fairly reliable method for (oo)cyst purification. Centrifugal concentration of the eluted sample and pellet collection before IMS resulted in a loss of $8{\sim}14%$ of the (oo)cysts. The largest (oo)cyst loss occurred in the elution step, with $68{\sim}71%$ of the total loss. The permeated loss of (oo)cysts was negligible during filtration of the water sample with a $1.0-{\mu}m$ pore polyethersulfone (PES) capsule. These results demonstrated that the largest fraction of (oo)cyst loss in this procedure occurred due to poor elution from the filter matrix. Improvements in the elution methodology are therefore required to enhance the overall recovery yield and the reliability of the detection of these parasitic protozoa.

• 한국식품저장유통학회지
• /
• 제5권2호
• /
• pp.133-137
• /
• 1998

In order to establish effectiveness of CA storage and adequate CO2 concentration, it was investigated the quality chanties of Singer during CA storage for 150 days at different CO2 concentrations ranging from 3% to 12% and 3% fixed oxygen concentration. Weight loss tend to decrease with increase of CO2 concentrations. Sprouting ratio and the loss of gingerol was shown to be less as CO2 concentration increase but to be more than control stored at 12$^{\circ}C$, 95% RH within the concentration less than 6% CO2.

• 대한기계학회논문집B
• /
• 제33권7호
• /
• pp.486-494
• /
• 2009

One-dimensional modeling of $CH_4$/air premixed flame was conducted to validate the heat loss model and investigate NOx formation characteristics in the postflame region. The predicted temperature and NO concentration were compared to experimental data and previous heat loss model results using a constant gradient of temperature (100 K/cm). The following conclusions were drawn. In the heat loss model using steady-state heat transfer equation, the numerical results using the effective heat loss coefficient ($h_{eff}$) of $1.0\;W/m^2K$ were in very good agreement with the experiments in terms of temperature and NO concentration. On the other hand, the calculated values using the constant gradient of temperature (100 K/cm) were lower than that in the experiments. Although the effects of heat loss suppress NO production near the flame region, a significant difference in NO concentration was not found compared to that under adiabatic conditions. In the postflame region, however, there were considerable differences in NO emission index as well as the contribution of NO formation mechanisms. In particular, in the range of ${\phi}\;{\geq}\;0.8$, the prompt NO mechanism plays an important role in the NO reduction under the adiabatic condition. On the other hand, the mechanism contributes to the NO production under the heat loss conditions.

• 한국환경과학회지
• /
• 제27권6호
• /
• pp.349-358
• /
• 2018

In this study, using coke dust from ironwork, the pulse pressure on a pulse air jet bag filter was investigated considering the influence of the pressure loss due to filtration velocity and pressure intervals. The research on the optimal pulse pressure prediction of a pulse air jet type bag filter using coke dust showed the following results. Pressure loss volatility produced by the pulse pressure under low dust concentration(0.5, $1g/m^3$) and low face velocity(1.25 m/min) was less than $10mmH_2O$. This suggests that the pulse pressure has a low impact on the pressure loss. In contrast, pressure loss volatility under high dust concentration($3g/m^3$) and high face velocity(1.75 m/min) was $25mmH_2O$. Therefore, pulse pressure with high dust concentration and high face velocity has a strong influence on the pressure loss volatility, compared to the condition of low dust concentration and low face velocity. The optimal pulse pressure of inlet dust concentration($0.5g/m^3$) was $6kg/cm^2$ under the same face velocity(1.75 m/min). As concentration increased from 1 to $2g/m^3$, the pulse pressure gradually reached $5kg/cm^2$ thus indicating that the pulse pressure($5kg/cm^2$) is pertinent at a high concentration($3g/m^3$). The pulse intervals: 20, 25 and 30 sec, which are relatively longer than 10 and 15 sec, corresponded to high pressure loss volatility produced by the pulse pressure. Furthermore, low pressure loss volatility was noted at $5kg/cm^2$ of the overall pulse pressure.

• 유체기계공업학회:학술대회논문집
• /
• 유체기계공업학회 2000년도 유체기계 연구개발 발표회 논문집
• /
• pp.373-378
• /
• 2000

The crevice corrosion of local corrosion occur when the gap exist on metal surface. This crevice corrosion happen to region such as flange of pipe, contact part of casing, under gasket and packing, between valve disk and seat of pump etc. Especially The crevice corrosion of mild steel(SS 400) get serious. This paper was studied on the crevice corrosion of SS 400 in fluid environment. In $0\%,\;2\%,\;3.5\%,\;5\% NaCl$ solution, the aspect of the crevice corrosion and polarization behavior under the crevice corrosion was investigated. And Weight loss rate of SS 400 with crevice and non-crevice was measured according to the NaCl concentration. The main results obtained are as follows : 1) Under crevice corrosion, the corrosion potential become less noble as the concentration of NaCl solution increased. 2) The current density under open circuit potential was high drained as concentration of NaCl solution increased by $3.5\%$ but the concentration increased over $3.5\%$, the current density was low drained. 3) The weight loss rate of SS 400 was increased as concentration of NaCl solution Increased by $3.5\%$, but the concentration increased over $3.5\%$, that of SS 400 was decreased. 4) Effect of oxygen for crevice corrosion in the concentration of $3.5\%$ NaCl solution become sensitive than that $0\%$ NaCl solution.

• 한국염색가공학회지
• /
• 제13권1호
• /
• pp.9-17
• /
• 2001

The purpose of this study is to present basic data for the enzymatic modification of acetate fabrics. The weight loss and rate of weight loss of acetate fabrics increased with increasing NaOH concentration and treating time. Acetyl value decreased as the weight loss became higher. The weight loss of alkaline-treated acetate fabrics were directly proportional to the concentration and treating time of cellulase. The optimum temperature and pH in cellulase treatment were $55^\circ{C}$ and pH 3.5. The surface shape revealed that density of fiber decreased by alkaline-treatment. With the treating time of cellulase, fibrillation occurred. In case of higher weight loss in alkaline treatment, fibril is removed after 180 min. The tensile strength decreased by alkaline and cellulase treatment. Especially, in case of higher weight loss of alkaline treatment, tensile strength decreased suddenly. Alkaline treatment increased the drapability of acetates, while cellulase treatment increased it initially but decreased gradually with treatment time. The dyeability after alkaline treatment was improved for reactive dye, but deteriorated for disperse dye. The cellulase treatment of acetate lowered the dyeability for both types of dyes.

• Preventive Nutrition and Food Science
• /
• 제8권3호
• /
• pp.230-234
• /
• 2003

Mass transfer characteristics during osmotic dehydration of carrots were studied as functions of immersion temperature and time, and sugar and salt concentrations. The effect of osmotic dehydration on the degree of browning of air-dried carrots was also evaluated. Increasing the immersion temperature and time, sugar concentration, and salt addition increased water loss, sugar gain, molality and rate of dehydration. The water loss and increases in solids, and molality were rapid in the beginning of the process and then increased slowly during remainder of the process. Increasing 1 or 2% salt concentration in the 40$^{\circ}$Brix sugar solution at 6$0^{\circ}C$ increased water loss and solid gain. Salt addition was not able to significantly affected on water loss and solid gain compare to temperature (40～8$0^{\circ}C$) and sugar concentration (20～60$^{\circ}$Brix) changes due to the low salt concentration. A minimum degree of browning of the air-dried carrots (O.D. = 0.048) could be achieved using binary solutions (40$^{\circ}$Brix sugar solution with 2% salt addition) with 24 min of immersion time compared to control (O.D. = 1.308) or blanching with 24 min of immersion time (O.D. = 0.174).

• The Korean Journal of Ecology
• /
• 제26권6호
• /
• pp.313-319
• /
• 2003

Dry weight loss and nutrient release from leaf litter for six tree species were studied using litter bag methods. The litter bags were incubated for f6 months on the forest floor in temperate deciduous forest in Mt. Cheonma, located at the middle part of Korean Peninsula. The changes in nutrient content and the rate of dry weight loss in leaf litter varied with litter types. The litter of Pinus densiflora showed the lowest rate of mass loss (k=0.33), nitrogen concentration (0.89%) and ash concentration (2.50%), while showed the highest C/N ratio (63.40). On the other hand, the litter of Acer pseudo-sieboldianum showed the fastest rate of mass loss (k=0.82), the highest nitrogen concentration (1.11%), and the lowest C/N ratio (49.40). During the decomposition, nitrogen, phosphorus and calcium in the leaf litters showed relatively slow decreasing pattern compared to other elements (carbon, potassium, magnesium, manganese and sodium), but potassium and sodium decreased at early stage of the decomposition for all leaf litters. Differences in annual decomposition rates of litter among species were consistent with the particular chemical characteristics of their leaf litters. The initial concentration of nitrogen was positively correlated with litter decomposition rate for six species, while litter decomposition rate of six species was negatively correlated with C:N ratio of initial leaf litters.

• Asian-Australasian Journal of Animal Sciences
• /
• 제28권3호
• /
• pp.369-373
• /
• 2015

An experiment was conducted to determine the effect of cellulose concentration in diets containing no phosphorus (P) on the basal endogenous loss (BEL) of P in growing pigs. Twelve barrows (an initial mean body weight = $49.6{\pm}3.2kg$) were individually housed in metabolism crates. Pigs were allotted to 4 experimental diets according to a cross-over design with 12 animals and 2 periods. Four P-free diets were mainly based on corn starch, sucrose, and gelatin, and were formulated to contain 0%, 4%, 8%, or 12% cellulose. Each period consisted of a 5-d adaptation and a 5-d collection period. The marker-to-marker method was used for fecal collection. The feed intake (p<0.05, linear and quadratic) and dry feces output (p<0.01, linear and quadratic) were increased with increasing dietary cellulose concentration. However, P concentration in the feces was decreased (p<0.01, linear and quadratic) with increasing dietary cellulose concentration. There was no significant difference in total P output and the BEL of P as mg per kg DMI (ranging from 157 to 214 mg/kg of dry matter intake) among experimental diets. However, values for the apparent total tract digestibility of energy, dry matter, organic matter, crude protein, and calcium were linearly decreased (p<0.01) with increasing cellulose concentration in the diet. In conclusion, dietary cellulose affected the amount of feces and digestibility of energy and nutrients, but did not affect the endogenous loss of P.

• 한국염색가공학회지
• /
• 제11권2호
• /
• pp.55-63
• /
• 1999

The purpose of this study was to investigate the purification of chitin and chitosan for textile finishing agent from crab shell. Weight loss rate(removing Ca and protein), degree of deacetylation, solubility and MIC(Minimum growth inhibitory concentration) value of chitosan and molecular weight of the treated crab shell were measured. The results of this study were as follows : 1) Weight loss rate(removing Ca) of crab shell treated with HCI increased with the concentration of HCI and treatment time, but it became constant over 60 min. of treatment time. 2) Weight loss rate(removing protein) of crab shell treated with NaOH(0.5N∼2N) increased with the concentration of NaOH and treatment temperature and time, but it became constant above loot of temperature and over 200 min. of treatment time. 3) Degree of deacetylation of chitin treated with NaOH increased with the concentration of NaOH(40∼60％), but molecular weight decreased and thus MIC value increased. 4) Concentration of acetic acid should be above 0.3％ to dissolve chitosan easily. Solubility for chitosan was the highest with formic acid, and the next was acetic acid, hydrochloric acid, lactic acid and sulfuric acid in order.