• 한국가스학회:학술대회논문집
• /
• 2006.11a
• /
• pp.123-128
• /
• 2006

This paper describes NDIR $CO_2$ gas sensor that shows the characteristics of temperature compensation. It consists of novel optical cavity that has two elliptical mirrors and a thermopile detector that includes ASIC chip in the same metal package for the amplification of detector output voltage and temperature sensor. The newly developed sensor modules shows high accuracy (less than +/-40 ppm) throughout the measuring concentration of $CO_2$ gas from 0 ppm to 2,000 ppm. After implementing the calculation methods of gas concentration, which is based upon the experimental results, the sensor module shows high accuracy less than +/- 5 ppm error throughout the measuring temperature range $(15^{\circ}C\;to\; 35^{\circ}C)$ and gas concentrations.

• The Transactions of the Korean Institute of Electrical Engineers P
• /
• v.59 no.2
• /
• pp.173-178
• /
• 2010

Frequency is an important operating parameter of a power system. Due to the sudden change in generation and loads or faults in power system, the frequency is supposed to deviate from its nominal value. It is essential that the frequency of a power system be maintained very close to its nominal frequency. And monitoring and an accurate estimation of the power frequency by timing synchronized signal provided by FDR is essential to optimum operation and prevention for wide area blackout. As most conventional frequency estimation schemes are based on DFT filter, it has been pointed out that the gain error by change in magnitude could cause the defects when the power frequency is deviated from nominal value. In this paper, an advanced frequency estimation scheme using gain compensation for fault disturbance recorders (FDR) is presented. The proposed scheme can reduce the gain error caused when the power frequency is deviated from nominal value. Various simulation using both the data from EMTP package and user's defined arbitrary signals are performed to demonstrate the effectiveness of the proposed scheme. The simulation results show that the proposed scheme can provide better accuracy and higher robustness to harmonics and noise under both steady state tests and dynamic conditions.

• Proceedings of the Korean Society for Technology of Plasticity Conference
• /
• 1999.03b
• /
• pp.203-206
• /
• 1999

The shift of flow behavior due to dynamic recrystallization during hot forming process is investigated, A series of load relaxation and compression tests has been conducted at various temperatures Constitutive relations and recrystallization behaviors were formulated from the mechanical test results, The consideration of dynamic recrystallization during a specific forming process was implemented to commercial FEM package by conditioned remeshing and remapping of state variables. Improvement of Load-Stroke prediction was validated by comparison with experimental results.

• The Journal of Fisheries Business Administration
• /
• v.22 no.2
• /
• pp.53-74
• /
• 1991

Interest on ocean environment has increased with the development of industrialized activities. Public marine resorces are defined broadly to include fish stocks, beaches, marine waters, recreational fishing, biota, waterfowls, shorebirds, seabirds and marine mammals But, it is not easy to analyze compensation for injury to publicly owned marine resources because the claimants do not exist clearly and the economic methodology of damage on public goods is not developed fully. This paper introduces basic idea of welfare economic theory and environmental legislation to the research question : How the economics and law can be applied to the case of damage on publicly owned marine resource. The paper discusses the concepts of willingness to pay (WTP) and willingness to accept (WTA). It is accepted generally that WTA is correct concept of welfare change in the case of damaged public goods. Four methods (compensating variation, equivalent variation, compensating surplus, equivalent surplus of measuring welfare changes are compared. Compensating variation(CV) is the best measure of welfare changes are compared. Compensating variation(CV) is the best measure of welfare changes caused by environmental damage. Vartia (1983) showed CV could be measured from the ordinary demand function using the differential equations. This paper also provides an overview of the emerging U.S. and Korea legal system for compensation for natural resource damages, with particular emphasis on U.S. legal system under Comprehensive Environmen-tal Response Compensation and Liability Act (CERCLA). These regulations are to include two different types of standardized procedures for assessing natural resources injury : Type A or simplified assessment techniques for small releases ; and Type B protocols that would include detailed and extensive assessment methodologies for major releases. Type A procedures are specified by Natural Resources Damage Assessment Model for Coastal and Marine Environment (NRDAM/CME) of the U.S. CERCLA provides a legal 'legitimization for the use of economic-based nonmarket valuation in the courts and have introduced appropriate and accurate nonmarket valuation methods based on willingness to-pay for damage assessment. By briefly reviewing economic theory and environmental legislation, we hope to help provide a better understanding of the compensation process and the economics of publicly owned marine resources in the U.S. and to integrate the economics and law of natural resources valuation into a single comprehensive package in Korea.

• Journal of the Korean Institute of Gas
• /
• v.11 no.1 s.34
• /
• pp.40-45
• /
• 2007

This paper describes NDIR $CO_{2}$ gas sensor that shows the characteristics of temperature compensation. It consists of novel optical cavity that has two elliptical mirrors and a thermopile that includes ASIC chip in the same metal package for the amplification of detector output voltage and temperature sensor. The newly developed sensor module shows high accuracy ($less\;than {\pm}40\;ppm$) throughout the measuring concentration of $CO_{2}$ gas from 0 ppm to 2,000 ppm. After implementing the calculation methods of gas concentration, which is based upon the experimental results, the sensor module shows high accuracy less than ${\pm}5\;ppm$ error throughout the measuring temperature range ($15^{\circ}C\;to\;35$^{\circ}C$) and gas concentrations with self-temperature compensation.

• Journal of the Institute of Electronics Engineers of Korea SD
• /
• v.49 no.7
• /
• pp.1-9
• /
• 2012

In this paper, resistance temperature detector (RTD) integrated into the LED package is proposed in order to solve the temperature dependence of LED's optical properties. To measure the package temperature in real time, the RTD type temperature sensor having excellent accuracy and linearity between temperature change and resistance change was adopted. A stable metallic film is required for long term reliability and stability of the RTD type temperature sensor. Therefore, deposition and annealing condition for the film were determined. Based on the determined condition, the RTD type temperature sensor with the sensitivity of about $1.560{\Omega}/^{\circ}C$ was fabricated inside the LED package. In order to configurate the LED package system keeping the constant brightness regardless of the temperature, additional conversion circuit and control circuit boards were fabricated and added to the fabricated LED package. The proposed system was designed to compensate the light intensity caused by temperature change using the variable duty rate of driving current. As a result, the duty rate of PWM signal which is the output signal of the configurated system was changed with the temperature change, and the duty rate was similarly varied with the target duty rate. Consequently, it was focused the fabricated RTD can be used for compensating the optical properties of LED and the LED package which exhibits constant brightness regardless of the temperature change.

• The Transactions of The Korean Institute of Electrical Engineers
• /
• v.57 no.12
• /
• pp.2276-2280
• /
• 2008

In this paper, we present thermal dependancy of LED package element by changing temperature of MCPCB for design high efficiency LED lamp, and confirmed influence of LED chip against temperature with analysis of thermal resistance and thermal capacitance. As increasing temperature, WPOs were decreased from 25 to 22.5 [%] and optical power were also decreased. that is decreased reason of optical power that forward voltage was declined by decrease of energy bandgap. Therefore optical power by temperature of MCPCB should consider to design lamp for street light and security light. Moreover, compensation from declined optical efficiency is demanded when LED package is composed. Also, thermal resistances from chip to metal PCB were decreased from 12.18 to 10.8[$^{\circ}C/W$] by changing temperature. Among the thermal resistances, the thermal resistance form chip to die attachment was decreased from 2.87 to 2.5[$^{\circ}C/W$] and was decreased 0.72[$^{\circ}C/W$] in Heat Slug by chaning temperature. Therefore, because of thermal resistance gap in chip and heat slug, reliability and endurance of high power LED affect by increasing non-radiative recombination in chip from heat.

• Journal of the Korean housing association
• /
• v.17 no.1
• /
• pp.77-84
• /
• 2006

Government uses some sections of intended areas of abolition in Development Restricted Zones(DRZ) to construct a million national rental houses. It has been opposed by environmental NGOs, local governments and land owners. Therefore, government carried out a questionnaire survey to make plans for the better development of housing estates for national rental houses in DRZ. The results of the survey are as follows: First, using abolished DRZ has to be kept to a minimum, though the continued construction of this kind of houses is inevitable. Second, it has to be designed using pro-environmental techniques. Third, the discussion between the interested groups was not enough. Fourth, residents were dissatisfied with the compensation package. The policies based on this research, are as follows: First, meetings for projects presentation and public hearings have to be held on a regular basis. In addition, the consultative council with residents, local NGOs, and local governments should be combined. Second, The plan should promote social integration through the mixing of rental and owner-occupied houses. Third, a compensation policy, which offers land or houses, and not only cash, needs to be introduced.

• Journal of Korean Society of Rural Planning
• /
• v.9 no.1 s.18
• /
• pp.11-17
• /
• 2003

The purpose of this study is to examine farmers' intentions, attitudes, and the type of filming they are involved in, including to provide supporting data for planning the agricultural strategy and Green Belt policy in Seoul. All the collected data was analyzed using the contingency tables and the Chi-square test using the SAS computer statistical package. The leaseholders did not want to change the current Green Belt policy for the study area, while the landowning farmers hoped for either its revision or dissolution. Both groups pointed out that the Green Belt policy resulted in the delay of development and complained about the difficulty of changing the land use type. The older generation supported the dissolution of the Green Belt, policy, as compared with the younger generation who wanted to maintain or modify the policy. The leaseholders worried that the possible changes in the Green Belt policy might affect the current agricultural land contract system, whereas the landowning farmers were very interested in easing restrictions on changing land use. The compensation plan, which is indemnified land owners for their loss of restrictions on land use, might be useful to sustain urban farming in the Green Belt.

• Journal of Distribution Science
• /
• v.12 no.1
• /
• pp.29-33
• /
• 2014

Purpose - The focal point of this research is to study the implications of retention, various reasons for attrition and also different ways to control attrition along with the employee retention strategies implementing by the Indian IT sector. Research design, data and methodology - After thorough literature review on employee attrition and retention, questionnaire has prepared to collect the opinions of 200 employees which were chosen from 20 IT companies (10 each from large and medium size companies) with simple random sampling technique and also gathered the opinion of these companies HR managers on strategies they are implementing to retain their talent pool through personal and telephonic interviews. Results -The research completely limited to the IT companies located in the city of Pune which is emerged as a new IT hub of India. The collected data was analyzed with Microsoft Excel and frequency distribution. Conclusions - The researchers identified job associated, compensation related and inter-personal relations for quitting their positions along with the outlook of Indian IT companies related to the identification and implementation of retention strategies like incessant hikes in compensation package, improved working conditions, continuous introduction of employee welfare facilities, and genuine promotional policy, recognition and rewards, career planning and development, and exemplary leadership.