• Journal of Power Electronics
• /
• v.11 no.4
• /
• pp.408-417
• /
• 2011

The plug-in hybrid electric vehicles (PHEVs) are specialized hybrid electric vehicles that have the potential to obtain enough energy for average daily commuting from batteries. The PHEV battery would be recharged from the power grid at home or at work and would thus allow for a reduction in the overall fuel consumption. This paper proposes an integrated power electronics interface for PHEVs, which consists of a novel Eight-Switch Inverter (ESI) and an interleaved DC/DC converter, in order to reduce the cost, the mass and the size of the power electronics unit (PEU) with high performance at any operating mode. In the proposed configuration, a novel Eight-Switch Inverter (ESI) is able to function as a bidirectional single-phase AC/DC battery charger/ vehicle to grid (V2G) and to transfer electrical energy between the DC-link (connected to the battery) and the electric traction system as DC/AC inverter. In addition, a bidirectional-interleaved DC/DC converter with dual-loop controller is proposed for interfacing the ESI to a low-voltage battery pack in order to minimize the ripple of the battery current and to improve the efficiency of the DC system with lower inductor size. To validate the performance of the proposed configuration, the indirect field-oriented control (IFOC) based on particle swarm optimization (PSO) is proposed to optimize the efficiency of the AC drive system in PHEVs. The maximum efficiency of the motor is obtained by the evaluation of optimal rotor flux at any operating point, where the PSO is applied to evaluate the optimal flux. Moreover, an improved AC/DC controller based Proportional-Resonant Control (PRC) is proposed in order to reduce the THD of the input current in charger/V2G modes. The proposed configuration is analyzed and its performance is validated using simulated results obtained in MATLAB/ SIMULINK. Furthermore, it is experimentally validated with results obtained from the prototypes that have been developed and built in the laboratory based on TMS320F2808 DSP.

• The Journal of The Korea Institute of Intelligent Transport Systems
• /
• v.7 no.6
• /
• pp.121-132
• /
• 2008

Recently, there is a growing interest in promoting safe and convenient roadway and traffic conditions for elderly drivers. This paper analyzed the driving characteristics, self recognition, and any inconvenience of elderly drivers over age 65 through an extensive survey, and drew some action plans to improve the driving conditions for elderly drivers. Survey results showed that the major trip purposes of the elderly driver were found to be commuting(50%) and business(33%), and this pattern was similar to the general drivers. The elderly drivers are interested in "safety", but "brand recognition" was the more important factor for the general drivers in the process of vehicle selection. The elderly drivers had no technical skill difference in driving as compared to the general drivers, but they fully recognized the physical deterioration such as reaction time and sight distance. In addition, the elderly drivers had a tendency to feel psychological contraction as to high workload driving conditions, thus it was necessary to make safe driving conditions by improving the design elements of traffic control devices on the roadways including visibility.

• Journal of the Korea Academia-Industrial cooperation Society
• /
• v.14 no.5
• /
• pp.2430-2436
• /
• 2013

This study suggests a method of detecting the still object, which becomes a cause of danger within the crossroad. The Inverse Perspective Transform was performed in order to make the object size consistent by being inputted the real-time image from CCTV that is installed within the crossroad. It established the detection area in the image with the perspective transform and generated the adaptative background image with the use of the moving information on object. The detection of the stop object was detected the candidate region of the stop object by using the background-image differential method. To grasp the appearance of truth on the detected candidate region, a method is proposed that uses the gradient information on image and EHD(Edge Histogram Descriptor). To examine performance of the suggested algorithm, it experimented by storing the images in the commuting time and the daytime through DVR, which is installed on the cross street. As a result of experiment, it could efficiently detect the stop vehicle within the detection region inside the crossroad. The processing speed is shown in 13~18 frame per second according to the area of the detection region, thereby being judged to likely have no problem about the real-time processing.

• KIPS Transactions on Computer and Communication Systems
• /
• v.11 no.12
• /
• pp.437-444
• /
• 2022

Recently, research on mobile edge services has been conducted to handle computationally intensive and latency-sensitive tasks occurring in wireless networks. However, MEC, which is fixed on the ground, cannot flexibly cope with situations where task processing requests increase sharply, such as commuting time. To solve this problem, a technology that provides edge services using UAVs (Unmanned Aerial Vehicles) has emerged. Unlike ground MEC servers, UAVs have limited battery capacity, so it is necessary to optimize energy efficiency through load balancing between UAV MEC servers. Therefore, in this paper, we propose a load balancing technique with consideration of the energy state of UAVs and the mobility of vehicles. The proposed technique is composed of task offloading scheme using genetic algorithm and task migration scheme using Q-learning. To evaluate the performance of the proposed technique, experiments were conducted with varying mobility speed and number of vehicles, and performance was analyzed in terms of load variance, energy consumption, communication overhead, and delay constraint satisfaction rate.

• Journal of Korean Society of Environmental Engineers
• /
• v.33 no.9
• /
• pp.644-655
• /
• 2011

VOCs (Volatile Organic Compounds) have adverse effects on human health and have caused serious global air pollution problems such as ozone depletion and cimate changes. The total of 56 target VOCs were selected to be monitored in this study for 4 years (2006~2009). The VOCs were measured every hour. The concentration of BTEX was higher than the other target compounds. Generally, the levels of VOCs measured in this study were higher than those measured by the other studies because Gamjeon and Jangrim monitering sites are located in industrial areas. The seasonal variations showed that the VOCs were the highest in winter. The temporal variations showed that the VOCs were high during commuting time on weekday. PMF model was used to resolve source types and source contributions of VOCs in this study. Identified sources and quantified contributions resolved by PMF were vehicle exhaust (15.22%), thinning solvent (29.83%), surface coating (17.13%), industries (13.95%), LPG vehicle (15.22%), combustion boiler (7.11%) and biogenic source (6.61%). Thinning solvent and Surface coating were the most contributed sources possibly due to manufactures and automobile garages in Gamjeon and solvent and paint manufactures in Sasang-Gu.

• Journal of the Economic Geographical Society of Korea
• /
• v.11 no.1
• /
• pp.59-77
• /
• 2008

The purpose of this study is to investigate the impact of traffic-related air pollution on the urban population in the Metropolitan Seoul area. In particular, this study analyzes urban population exposure to traffic-related particulate materials(PM). For the purpose, this study examines the relationships between traffic flows and PM concentration levels during the last fifteen years. Traffic volumes have been decreased significantly in recent year in Seoul, however, PM levels have been declined less compare to traffic volumes. It may be related with the rapid growth in the population and vehicle numbers in Gyenggi, the outskirt of Seoul, where several New Towns have been developed in the middle of 1990's. The spatial pattern of commuting has changed, and thus and travel distances and traffic volumes have increased along the main roads connecting CBDs in Seoul and New Towns consisting of large residential apartment complexes. These changes in traffic flows and travel behaviors cause increasing exposure to traffic-related air pollution for urban population over the Metropolitan Seoul area. GIS techniques are applied to analyze the spatial patterns of traffic flows, population distributions, PM distributions, and passenger flows comprehensively. This study also analyzes real time base traffic flow data and passenger flow data obtained from T-card transaction database applying data mining techniques. This study also attempts to develop a space-time model for assessing journey-time exposure to traffic related air pollutants based on travel passenger frequency distribution function. The results of this study can be used for the implications for sustainable transport systems, public health and transportation policy by reducing urban air pollution and road traffics in the Metropolitan Seoul area.