• 한국건축시공학회:학술대회논문집
• /
• 한국건축시공학회 2008년도 춘계 학술논문 발표대회
• /
• pp.57-60
• /
• 2008

This study investigated the results of insulation heat curing method using double layer bubble sheet in slab concrete and mass concrete in cold weather environment. First of all, when double bubble sheets are applied, it was shown that slab concrete was protected from early freezing by remaining between 6 and 15℃ even in case outside temperature drops -9℃ below zero until the 2nd day from piling, and in the case of mass concrete, with the maximum temperature difference between the center and surface less than 4℃, crack occurrence index was close to 2 and no hydration heat crack occurred by internal constraint. The insulation heat preservation curing method using the double bubble sheet applied in this field prevented early freezing owing to stable curing temperature management, deterring concrete strength development delay at low temperature, and obtained the needed strength. Also, it was proven that the method is highly effective and economic for cold weather concrete quality maintenance through curing cost reduction like construction period shortening and labor cost reduction, etc by reducing the process of temporary equipment installation and disassembling.

• 한국정밀공학회지
• /
• 제25권3호
• /
• pp.126-133
• /
• 2008

The main objective of the present study is to achieve linear temperature distribution of cooling surface of plunger. K type thermocouples are attached at the surface of plunger to measure temperature. Nozzle and insulating material are inserted in the pin hole of the plunger for this study. Cooling water flow enters at one nozzle and leaves at three nozzles. Flow through nozzle can be activated in the pin hole, temperature of hot point around hole is decreased. Meanwhile, insulating material blocks off heat transfer, temperature of cold point around hole is increased. By combination of nozzle and insulation, heat transfer of hole is controlled effectively, as result its, temperature of plunger surface shows linear temperature distribution.

• 한국콘크리트학회:학술대회논문집
• /
• 한국콘크리트학회 2001년도 가을 학술발표회 논문집
• /
• pp.913-918
• /
• 2001

This paper investigates insulating effects and strength properties of concrete under cold climate carrying out the experiment with insulating forms on the slab member. According to test results, under $-10^{\circ}C$ of outer temperature, the surface of concrete exposed to outer temperature goes below zero after 10hours since exposed. And, the surface of concrete covered with vinyl and blanket goes below zero after 42hours. However, the surface of concrete covered with insulating materials such as polystyrene foam does not drop below zero until 55hours. And, according to coring sample strength test, compressive strength cured with insulation shows much higher strength than no insulation curing condition and vinyl and blanket curing condition.

• Asian Journal of Atmospheric Environment
• /
• 제7권4호
• /
• pp.199-208
• /
• 2013

Mercury exchange fluxes between atmosphere and soil surface were measured in two different types of soils; lawn soil (LS) and forest soil (FS). Average Hg emission from LS was higher than from FS although the soil Hg content was more than 2 times higher in forest soil. In LS, Hg emissions were much greater in warm season than in cold season; however, deposition was dominant in FS during warm season because of leafy trees blocking the solar radiation reaching on the soil surface. In both LS and FS, Hg fluxes showed significantly positive correlations with UV radiation and soil surface temperature during cold season. In addition, it was observed that emission showed positive correlation with UV radiation and soil temperature while there was negative relationship between deposition and UV radiation.

• 해양환경안전학회:학술대회논문집
• /
• 해양환경안전학회 2004년도 추계학술발표회
• /
• pp.123-127
• /
• 2004

It is known that cold water appears and fog frequently forms in the southwest coastal waters of Korea in summer. The authors investigate the time and place. of cold water existence, and also whether the cold water affects the occurrence of fog formation. As a result, cold water begins to appear around Daeheugsando at the early summer. It gets colder with times and cold water area moves toward southwest of Jindo in mid-summer, then disappears in this area around mid-Oct. Fog mostly forms in April through August and most frequently occurs at Chukdo(Jindo) where sea surface temperature shows lower than that at the adjacent area. Accordingly it is taken that the cold water is considerably contributed to form the dense and frequent fog around Jindo area.

• 대한한방체열의학회지
• /
• 제1권1호
• /
• pp.52-56
• /
• 2002

Causes of infertility include a wide range of physical, as well as emotional factors. In Oriental medicine, women's infertility is believed to be caused by the deficiency of the Chung and Ren vessel. Then the Kidney Qi is collapsed and cold. Many infertility women complain the cold hypersensitivity and/or body coldness, especially on the lower abdomen, back and knee. The aim of this study is to examine the interrelationship between infertility and body surface temperature. The 25 infertility women were allocated as infertility group and 25 fertility women (experienced delivery or pregnancy), as control group at the Kangnam Korean Hospital, KyungHee University, Seoul, Korea, from April to December 2000. Thermographic observations for this study were made using the Dorex DITI on 3 different areas's cold hypersensitivity: lower abdomen, back and knee. All data were coded for computer analysis and significances were tested by Mann-Whitney Test. The mean ${\Delta}T$ for abdomen cold hypersensitivity was $0.25{\pm}1.77^{\circ}C$ On control group and $1.00{\pm}0.39^{\circ}C$, infertility group. The mean ${\Delta}T$ for back cold hypersensitivity was $1.75{\pm}0.40^{\circ}C$ on control group and $1.21{\pm}0.58^{\circ}C$, infertility group. The mean ${\Delta}T$ for knee cold hypersensitivity was $0.65{\pm}0.70^{\circ}C$ on control group and $1.32{\pm}0.58^{\circ}C$, infertility group. It was revealed that the cold hypersensitivity on the lower abdomen, back and knee are significantly inter-related to the women infertility. These results do not conflict with the view of Oriental medicine. According to the above results, it is concluded that the body surface temperature, cold hypersensitivity and/or body coldness, have a great effect on women infertility.

• 한국건축시공학회:학술대회논문집
• /
• 한국건축시공학회 2007년도 춘계학술논문 발표대회
• /
• pp.1-4
• /
• 2007

This study investigated the applicability of insulation curing method with double layer bubble sheets to the man concrete subjected to cold weather. Temperature history of the mass concrete indicated that the highest temperature of center section was exhibited at $34^{\circ}C$ while the that of surface section was $25^{\circ}C$. Difference between center and surface was shown to be less $10^{\circ}C$ when the temperature of center section was peak section, and thereby associated temperature cracking index was calculated 1.5, and occurrence probability of temperature cracking was 5%, so there was no temperature cracking caused by internal restraint. No temperature crack was observed by naked eye. It was clear that early frost demage and temperature cracking could be restrained due to reducing temperature difference between inner part and outside in the case double bubble sheets applied to insulation curing method in cold weather. The maturity of mass concrete is higher than outside about $72\sim89^{\circ}$ DD, so it was demonstrated to prevent early frost demage and ensure strength excellently. Insulation curing method with double bubble sheets was more economic than heating curing method.

• 한국정밀공학회:학술대회논문집
• /
• 한국정밀공학회 2001년도 춘계학술대회 논문집
• /
• pp.784-789
• /
• 2001

In order to investigate the fracture behaviors(penetration modes) and the resistance to penetration during ballistic impact of cold-rolled Al 5052 H34 alloy laminates, anodized Al 5052 H34 alloy laminates, and Al 5052 H34 alloy after cold-rolling, ballistic testing was conducted. In general, superior armor material is brittle materials which have a high hardness. Ballistic resistance of these materials was measured by protection ballistic limit(V50), a statical velocity with 50% probability for incomplete penetration. Fracture behaviors and ballistic tolerance, described by penetration modes, are observed respectfully, resulting from V50 test and Projectile Through Plate(PTP) test at velocities greater than V50. PTP tests were conducted with 0$^{\circ}$obliquity at room temperature using 5.56mm ball projectile. V50 tests with 0$^{\circ}$obliquity at room temperature were also conducted with projectiles that were able to achieve near or complete penetration during PTP tests. Surface Hardness, resistance to penetration, and penetration modes of Al 5052 H34 alloy laminates compared to those of cold-rolled Al 5052 H34 alloy laminates and anodized Al 5052 H34 alloy laminates anodized Al 5052 H34 alloy after cold-rolling.

• 한국정밀공학회지
• /
• 제20권3호
• /
• pp.178-186
• /
• 2003

In order to investigate the fracture behaviors (penetration modes) and the resistance to penetration during ballistic impact of Al 5052-H34 alloy laminates, cold-rolled Al 5052-H34 alloy laminates, anodized Al 5052-H34 alloy laminates, and anodized Al 5052-H34 alloy after cold-rolling, a ballistic testing was conducted. In general, superior armor materials are brittle materials which have a high hardness. Ballistic resistance of these materials was measured by a protection ballistic limit (V$_{50}$), a statistical velocity with 50% probability fur incompletete penetration. Fracture begaviors and ballistic tolerance, described by penetration modes, ate observed from the results from the results of V$_{50}$ test and Projectile Through Plates (PTP) test at velocities greater than V$_{50}$, respectively. PTP tests were conducted with 0$_{\circ}$obliquity at room temperature using 5.56mm ball projectile. V$_{50}$ tests with 0$_{\circ}$obliquity at room temperature were concucted with projectiles that could achieve neat or complete penetration during PTP tests. Surface hardness, resistance to penetration, and penetration modes of Al 5052-H34 alloy laminates are compared to those of cold-rolled Al 5052-H34 alloy laminates and anodized Al 5052-H34 alloy laminates and anodized Al 5052-H34 cold-rolled alloy.

• 한국수산과학회지
• /
• 제16권2호
• /
• pp.111-116
• /
• 1983

1965년부터 1979년까지의 해양관측자료를 사용하여 우리나라 남해에서 일어나는 수온역전현상을 조사하였다. 그 결과를 요약하면 다음과 같다. 1) 역전현상은 여름보다 겨울에 6배정도 많이 일어난다. 2) 겨울의 경우, 남해 서부해역에서는 수온역전이 모든 수심에서 골고루 일어나는 반면, 동부해역에서는 주로 표층에서 일어난다. 3) 여름의 경우, 서부해역에서는 역전층이 주로 수온약층 아래에 형성되는 반면, 동부해역에서는 주로 표층에 형성된다. 겨울의 역전현상은 기본적으로는 표면 냉각효과에 의해서 생기는 것으로 생각된다. 다만, 서부와 동부해역에서 역전층이 형성되는 수심에 차이가 있는 것은 쓰시마난류 영향의 정도가 양해역에서 크게 다르기 때문이라고 보여진다. 여름의 경우 서부해역에서는 쓰시마난류와 황해 저층냉수가 수온약층 밑에서 혼합되는 과정에서 생기는 것으로 보이고, 동부해역에서는 보다 수온이 낮은 물이 표층을 따라 유입하기 때문에 일어나는 것으로 생각된다.