• Transactions of the Korean hydrogen and new energy society
• /
• v.4 no.1
• /
• pp.11-19
• /
• 1993

The kinetic studies of the hydrogen induced amorphization in $ErCo_2$ Laves phase is observed by the internal standard method using X-ray diffraction intensities. The activation energy and rate constant exponent for the amorphization in $ErCo_2$ are found to be 26 kcal/mole and 0.78, respectively. From these results, it is believed that the mechanism of the hydrogen induced amorphization in $ErCo_2$ is related to the motion of Co atoms. Though there are many similar physical properties between $ErCo_2$ and $ErNi_2$, the activation energy for the amorphizatin in $ErCo_2$ is larger than that in $ErNi_2$ and the amorphization rate in $ErCo_2$ is slower. It is suggested that these differences of activation energy for the hydrogen induced amorphization and the amorphization rate between $ErCo_2$ and $ErNi_2$ is due to the occurence of structural change on forming crystalline hydride.

• Transactions of the Korean hydrogen and new energy society
• /
• v.22 no.4
• /
• pp.465-473
• /
• 2011

To find the optimum mixing ratio of WGS catalyst with $CO_2$ absorbent for SEWGS process, water gas shift reaction tests were carried out in a fluidized bed reactor using commercial WGS catalyst and sand (as a substitute for $CO_2$ absorbent). WGS catalyst content, gas velocity, and steam/CO ratio were considered as experimental variables. CO conversion increased as the catalyst content increased during water gas shift reaction. Variations of the CO conversion with the catalyst content were small at low gas velocity. However, those variations increased at higher gas velocity. Within experimental range of this study, the optimum operating condition(steam/CO ratio=3, gas velocity = 0.03 m/s, catalyst content=10 wt.%) to get high CO conversion and $CO_2$ capture efficiency was confirmed. Moreover, long time water gas shift reaction tests up to 20 hours were carried out for two cases (catalyst content = 10 and 20 wt.%) and we could conclude that the WGS reactivity at those conditions was maintained up to 20 hours.

• New & Renewable Energy
• /
• v.5 no.2
• /
• pp.15-24
• /
• 2009

As new small scale LFG (landfill gas) energy project model which can improve economic feasibility limited due to the economy of scale, LFG-Microturbine combined heat and power system with $CO_2$ fertilization into greenhouses was proposed and investigated including basic design process prior to the system installation at Gwang-ju metro sanitary landfill. The system features $CH_4$ enrichment for stable microturbine operation, reduction of compressor power consumption and low CO emission, and $CO_2$ supplement into greenhouse for enhancement plant growth. From many other researches, high $CO_2$ concentration was found to enhance $CO_2$ assimilation (also known as photosynthesis reaction) which converts $CO_2$ and $H_2O$ to sugar using light energy. For small scale landfills which produce LFG under $3\;m^3$/min, among currently available prime movers, microturbine is the most suitable power generation system and its low electric efficiency can be improved with heat recovery. Besides, since its exhaust gas contains very low level of harmful contaminants to plant growth such as NOx, CO and SOx, microturbine exhaust gas is a suitable and economically advantageous $CO_2$ source for $CO_2$ fertilization in greenhouse. The LFG-Microturbine combined heat and power generation system with $CO_2$ fertilization into greenhouse gas to enhance plant growth is technologically and economically feasible and improves economical feasibility compared to other small scale LFG energy project model.

• Transactions of the Korean hydrogen and new energy society
• /
• v.24 no.5
• /
• pp.428-436
• /
• 2013

Attrition characteristics of $CO_2$ absorbents for pre-combustion $CO_2$ capture were investigated to check attrition loss of those absorbents and to determine solid circulation direction and the better $CO_2$ absorbent. The cumulative attrition losses of two absorbents increased with increasing time. However, attrition loss under a humidified condition was lower than that under a non-humidified condition case. Between two absorbents, attrition loss of PKM1-SU absorbent was higher than that of P4-600 absorbent. The average particle sizes of the attrited particles were less than $2.5{\mu}m$ for two absorbents under a non-humidified condition case, and therefore, we could conclude that the main mechanism of attrition for two absorbents is not fragmentation but abrasion. Based on the results from the test for the effect of humidity on the attrition loss, we selected solid circulation direction from SEWGS reactor to regeneration reactor because the SEWGS reactor contains more water vapor than regeneration reactor. Attrition loss and make-up rate of two absorbents were compared based on the results from $CO_2$ sorption capacity tests and attrition tests. Required make-up rate of P4-600 absorbent was lower than that of PKM1-SU absorbent. However, more detail investigation on the optimum regeneration temperature, manufacturing cost, solid circulation rate, regeneration rate, and long-term sorption capacity should be considered to select the best $CO_2$ absorbent.

• Transactions of the Korean hydrogen and new energy society
• /
• v.27 no.1
• /
• pp.83-94
• /
• 2016

Performance of absorbent for post-combustion $CO_2$ capture was measured and discussed. Fully saturated fresh absorbent (P2-15F) and absorbents sampled from absorption and regeneration reactor of continuous $CO_2$ capture process, P2-15A, P2-15R, respectively, were used as representative absorbents. Small scale fluidized bed reactor (0.05 m I.D., 0.8 m high) which can measure exhaust gas concentration and weight change simultaneously was used to analyze regeneration characteristics for those absorbents. Exhausted moles of $CO_2$ and $H_2O$ were measured with increasing temperature. $H_2O/CO$ ratio and working capacity were determined and discussed to confirm reason of reactivity decay after continuous operation. Moreover, possibility of side reaction was checked based on the $H_2O/CO_2$ mole ratio. Finally, suitable regeneration temperature range was confirmed based on the trend of working capacity with temperature.

• Journal of the Korean Vacuum Society
• /
• v.1 no.2
• /
• pp.244-253
• /
• 1992

BiSI, BiSI : Co, BiSeI 및 BiSeI : Co 단결정을 고순도의 성분원소와 8.6mole% 과잉의 Iodine를 투명석영관내에 넣고 진공봉입하여 합성한 ingot를 사용하여 수직 Bridgman 방법으로 성장시켰다. 성장된 단결정은 orthorhombic 구조였고, energy band 구 조는 간접전이형으로 293K에서 광학적 energy gap은 각각 1.590eV, 1.412eV, 1.282eV 및 1.249eV로 주어지며, energy gap의 온도의존성은 Varshni 방정식으로 잘 표현된다. Cobalt 를 첨가할 때 나타나는 불순물 광흡수 peak는 Td symmetry점에 위치한 Co2+, Co3+ ion의 energy 준위들 사이의 전자전이에 의해서 나타난다.

• Proceedings of the Korea Society for Energy Engineering kosee Conference
• /
• 2003.05a
• /
• pp.673-677
• /
• 2003

$CO_2$ 의 배출로 인한 지구 온난화 진행을 막기 위하여 국제사회의 노력이 계속되고 있는 가운데, 일련의 기후변화 협약에 대한 기술적 대응수단으로써 $CO_2$ 저감 기술 확보의 중요성이 증대되고 있다. 우리나라도 향후 예상되는 $CO_2$ 배출 저감의무 부과에 대비하여야 할 것이며 발전부문과 같은 대규모 $CO_2$ 배출시설에서의 개선이 우선적으로 이루어져야 할 것이다.(중략)

• Environmental Engineering Research
• /
• v.21 no.1
• /
• pp.74-83
• /
• 2016

The purpose of this study is to identify the driven factors affecting the changes in energy-related $CO_2$ emissions in Hebei Province of China from 1995 to 2013. This study confirmed that energy-related $CO_2$ emissions are correlated with the population, urbanization level, economic development degree, industry structure, foreign trade degree, technology level and energy proportion through an improved STIRPAT model. A reasonable and more reliable outcome of STIRPAT model can be obtained with the introducing of the Ridge Regression, which shows that population is the most important factor for $CO_2$ emissions in Hebei with the coefficient 2.4528. Rely on these discussions about affect abilities of each driven factors, we conclude several proposals to arrive targets for reductions in Hebei's energy-related $CO_2$ emissions. The method improved and relative policy advance improved pointing at empirical results also can be applied by other province to make study about driven factors of the growth of carbon emissions.

• Journal of Industrial Technology
• /
• v.27 no.A
• /
• pp.185-193
• /
• 2007

The object of this study is the development of a Method which is enable to review the preliminary feasibility for co-generation system in new apartment buildings. In Korea co-generation systems have been installed in most of large industrial plants and commercial buildings which consume a large quantity of electric and heat energy, for energy saving and cutting products cost, under positive governmental supports. However for apartment buildings which consume quite a large electric and heat energy, are still remained in conventional energy supply system, and are not popular to utilize useful co-generation system. One of the major reason for these is the lack of clear and easy justification tool. In this circumstance, this study can provide a tool to verify the feasibility of co-generation in apartment buildings with this handy tools for planners and designers beforehand.

• Journal of Radiation Industry
• /
• v.2 no.3
• /
• pp.105-110
• /
• 2008

Poly (VDF-co-HFP)/PEGDMA nanofibrous membranes (NFMs) have been prepared by an electrospinning process. Since electrospun NFMs have a nanoporous structure, they have a potential application for a polymer electrolyte or a separator. Poly (VDF-co-HFP) is a polymer electrolyte binder. In order to improve their mechanical properties, poly (VDF-co-HFP)/PEGDMA NFMs were crosslinked by a gamma-ray irradiation. Then the crosslinked NFMs were characterized through an electrolyte uptake, IR structural analysis, and SEM morphological investigation.