• Bulletin of the Korean Chemical Society
• /
• 제26권2호
• /
• pp.215-216
• /
• 2005

• Bulletin of the Korean Chemical Society
• /
• 제25권6호
• /
• pp.775-776
• /
• 2004

• 한국연소학회:학술대회논문집
• /
• 대한연소학회 2003년도 제27회 KOSCO SYMPOSIUM 논문집
• /
• pp.209-214
• /
• 2003

Numerical simulations are performed at atmospheric pressure in order to understand the effect of additives on flame speed, flame temperature, the radical concentration, the NOx formation in freely propagating $CH_4/O_2/N_2$ flames. The additives used are carbon dioxide and hydrogen chloride which have a combination of physical and chemical behavior on hydrocarbon flame. In the flame established with the same mole of methane and additive, $CO_2$ addition significantly contributes toward the reduction of flame speed and flame temperature by the physical effect, whereas addition of HCl mainly does by the chemical effect. The impact of HCl addition on the decrease of the radical concentration is about 1.6-1.8 times as large as $CO_2$ addition. Hydrogen chloride addition is higher on the reduction of EINO than $CO_2$ addition because of the chemical effect of HCl.

• Journal of Ceramic Processing Research
• /
• 제19권6호
• /
• pp.479-482
• /
• 2018

Polystyrene superstructure films show faint rainbow color, and this low color saturation limits its wide application. In this paper, polystyrene superstructure films with single bright blue color were prepared by vertical deposition self-assembly method using polystyrene microspheres with average diameter of $310{\pm}10nm$ as raw material. Polystyrene superstructure films were modified by adding nano-carbon powder, and effect of the amount of nano-carbon powde on color performance was studied. The results showed that without addition of nano-carbon powder, the superstructure films showed a faint rainbow color, while with addition of nano-carbon power, the superstructure films exhibited a single bright blue under the same natural light source. Changing the amount of nano-carbon powder addition could adjust color saturation of the film. With increasing the amount of nano-carbon powder addition from 0.008 wt% to 0.01 wt%, color saturation of the superstructure film increased gradually. Further increasing the amount of nano-carbon powder addition to 0.011wt%, color saturation of the superstructure film didn't increase anymore and tended to get dark.

• 산업기술연구
• /
• 제39권1호
• /
• pp.1-5
• /
• 2019

In this study, we examined the effect of NO addition on the ozone-induced soot oxidation activity of $LaMnO_3$ perovskite catalysts. The addition of 10~20% NO ($NO_2$) with respect to the concentration of ozone effectively enhanced the rate of ozone-induced soot oxidation rate over $LaMnO_3$. However, the excessive addition of NO ($NO_2$) was detrimental to ozone-induced soot oxidation activity. It is supposed nitrogen oxides would adsorb on the catalyst and then react with carbon-oxygen species developed on soot surface, but an excessive addition of nitrogen oxide would inhibit the formation of carbon-oxygen species, which is a key intermediate in the reaction, and consequently suppress the oxidation rate of soot.

• Bulletin of the Korean Chemical Society
• /
• 제31권4호
• /
• pp.869-873
• /
• 2010

A series of novel chiral tert-amino alcohols 4a-h derived from enantiomerically pure phenylalanine were synthesized efficiently and used as chiral ligands in the catalytic enantioselective ethylation of aldehydes with diethylzinc (diethylzinc-to-aldehyde addition). The use of 10 mol % of the amino alcohols led to the corresponding sec-alcohols with excellent enantioselectivities (up to 100% ee) and high yields.

• Korean Chemical Engineering Research
• /
• 제62권3호
• /
• pp.253-261
• /
• 2024

The impact of temperature on electrode reactions in 100 cm² molten carbonate cells operating as Fuel Cells (FC) and Electrolysis Cells (EC) was examined using the Reactant Gas Addition (RA) method across a temperature range of 823 to 973 K. The RA findings revealed that introduction of H₂ and CO₂, reduced the overpotential at Hydrogen Electrode (HE) in both the modes. However, no explicit temperature dependencies were observed. Conversely, adding O₂ and CO₂ to the Oxygen Electrode (OE) displayed considerable temperature dependencies in FC mode which can be attributed to increased gas solubility due to the electrolyte melting at higher temperatures. In EC mode, there was no observed temperature dependence for overpotential. Furthermore, the addition of O₂ led to a decrease in overpotential, while CO₂ addition resulted in an increased overpotential, primarily due to changes in the concentration of O₂ species.

• Bulletin of the Korean Chemical Society
• /
• 제23권3호
• /
• pp.509-510
• /
• 2002

• Bulletin of the Korean Chemical Society
• /
• 제18권5호
• /
• pp.469-471
• /
• 1997

• 한국응용과학기술학회지
• /
• 제14권1호
• /
• pp.27-32
• /
• 1997

Furfurylidene acetophenone derivatives were synthesis, it was measured that nucleophilic addition made use of UV at a wide pH 1.0${\sim}$13.0 range in 30% dioxane-$H_2O$ solution, 25$^{\circ}C$. On the basis of general base catalysis, substitutent effect, confirmation of nucleophilic addition products, it was measured the reaction rate of furfurylidene acetophenone derivatives for the pH change. It may be concluded that a part was unrelated to pH and another part was in proportion to concentration of hydroxide ion: Above pH 10.0. sulfide anion adds to the double bond (Michael type addition), a part having no concern with pH, addition reaction to double bond is initiated by addition of neutral thiourea molecule. From the result of measurement the reaction rate, nucleophilic addition of furfurylidene acetophenone derivatives confirmed to the irreversible first order. Through measurement the substituent effect. It found that reaction rate was accelerated by electron attracting group. On the basis of these findings, nucleophilic addition of thiourea for the furfurylidene acetophenone derivative was proposed a fitting mechanisms.