• Tribology and Lubricants
• /
• v.27 no.3
• /
• pp.125-133
• /
• 2011

The purpose of this study is to develop an engine oil quality monitoring system to warn the abnormal condition of engine oil. To do this, first of all, it is needed a personal controller development to measure the capacitance of a pre-developed engine oil deterioration detection sensor integrated with an oil filter. To measure the capacitance of engine oil in the sensor, it is used the way measuring the electric charging time in a capacitor by impressing DC volt. This method has merits on cost and signal stability. The measured capacitance is compensated by comparing with the one measured by an impedance analyzer. Also, using the dielectric constant gained by an impedance analyzer, the calculating equation of the dielectric constant of engine oil related with the currently developed sensor is decided. Then, the deterioration degree of engine oil is estimated according to the change rate of dielectric constant between green oil and used oil. Finally, using this dielectric constant information together with engine oil temperature and pressure, the currently developed engine oil quality monitoring system is to tell the abnormal state of engine oil.

• The Transactions of The Korean Institute of Electrical Engineers
• /
• v.56 no.2
• /
• pp.317-324
• /
• 2007

Most conventional hybrid systems using renewable energy sources have been applied for stand-alone operation, but Utility-interface may be an useful and viable option for hybrid systems. Grid-connected operation may have benefits such as reduced losses in power system distribution, utility support in demand side management, and peak load shaving. This paper addresses power control and dynamic performance of a grid-connected PV/wind/BESS hybrid system. At all times the PV way and the wind turbine are individually controlled to generate the maximum energy from given weather conditions. The battery energy storage system (BESS) charges or discharges the battery depending on energy gap between grid invertger generation and production from the PV and wind system. The BESS should be also controlled without too frequently repeated shifts in operation mode, charging or discharging. The grid inverter regulates the generated power injection into the grid. Different control schemes of the grid inverter are presented for different operation modes, which include normal operation, power dispatching, and power smoothing. Simulation results demonstrate that the effectiveness of the proposed power control schemes for the grid-interactive hybrid system.

• Proceedings of the KIEE Conference
• /
• 2008.07a
• /
• pp.2317-2318
• /
• 2008

This report is about wireless energy transform system. It means something to charge without a line of contact. Existing charging has been many defect, including badness of the line, limitation of the space and the time and so on But this is one of the way that can complement it. So our goal is making the wireless charger that is effective and easy to use.

• 한국태양에너지학회:학술대회논문집
• /
• 2011.11a
• /
• pp.249-255
• /
• 2011

This paper is about the study of a stand-alone photovoltaic power conditioning system with an energy storage system with battery. The paper proposes the appropriate circuit model of stand-alone PV PCS considering the maintenance of the battery system. It also proposes the buck converter modeling by a state-space averaging method considering characteristics of solar cell. Lastly, it shows the way to choose the suitable battery and to design the model of bi-directional converter for charging and discharging battery. PSIM simulation is used to validate the proposed algothim of the system.

• Journal of the Korean Society of Manufacturing Technology Engineers
• /
• v.23 no.5
• /
• pp.443-449
• /
• 2014

This study aims to develop a Flywheel Energy Storage System (FESS) that uses wind power produced when an urban train is in motion, by utilizing a mounted turbine. This system was designed to generate and store electric power from wind power of a travelling urban train. The flywheel was designed to continue rotation using a one-way clutch bearing installed in the turbine shaft pulley, even in cases where the urban train decelerates or stops. This FESS can generate an additional 44% of electric power in comparison to a system not equipped with a flywheel. The generated power and operational features of the FESS were evaluated and verified through a wind tunnel test. The results show that the electric power stored in the FESS could supply auxiliary power for urban train components or service equipment, such as charging mobiles, Wi-Fi modules, and electric lights.

• Journal of the Korean Chemical Society
• /
• v.5 no.1
• /
• pp.66-72
• /
• 1961

A small size Fischer-Tropsch Catalyst testing apparatus, designed for an operating pressure of 150 psig, was test fabricated from ordinary schedule 40 iron pipes. The operability of the apparatus was tested by charging the reactor tube with the Lurgi Fischer-Tropsch iron Catalyst and passing through it the water gas obtained by gasifying the Korean anthracite using steam and oxygen. With the kind of catalyst charged, the apparatus was proven to daily produce about 50c.c. of synthetic greasy product, water and water soluble compounds, by running at a temperature of $250^{\circ}C$ and at a space velocity of 180 volume of gas per volume of catalyst/hr. About 20 consecutive days of operation is claimed to be sufficient for gathering an enough amount of synthetic products for such ordinary tests as distillation analysis, density measurement, iodine value determination etc. This trial fabrication of apparatus may be the first case of its kind in Korea in that the work has been conducted out in much a pilot plant scheme rather than a routine laboratory way which depends on small glass ware apparatus.

• Proceedings of the KIPE Conference
• /
• 2008.10a
• /
• pp.13-15
• /
• 2008

Charging or discharging secondary batteries such as a lithium-ion battery is essential in the stage of production and takes long time over two hours. And the charge/discharge system is operated with high switching frequency over several tens kHz. Therefore, to simulate such a system in the conventional way takes very long time and huge files are produced. Finally, the simulation would be unable with general PC class. In this paper, the lithium-ion battery charge/discharge system is analyzed by using state space averaging method. As a result, the simulation time is reduced dramatically and the charge/- discharge characteristics of the lithium-ion battery can be observed.

• Journal of Climate Change Research
• /
• v.8 no.1
• /
• pp.41-50
• /
• 2017

As serious consequences of climate change became indisputable, vehicles based on fossil fuel has to be shifted toward more sustainable way to drastically reduce carbon emissions. Eco-friendly vehicles contribute mitigating climate change through reducing the greenhouse gas emissions. The goal of this research is to find ways to promote the eco-friendly vehicle industry in Korea. In order to achieve this goal, surveys are collected from the professionals of eco-friendly vehicle industry, and analyzed through Delphi method. Results show that the first thing is to promote the eco-friendly vehicle market by introducing the economic incentives. The second thing is to allow more emission credit for eco-friendly vehicle manufacturers. The third thing is to build more concrete infrastructure for the eco-friendly vehicles. The increase of the number of the electric or hydrogen charging system would be one of the good examples of the infrastructure. The fourth thing is that the government supports the research & development of eco-friendly vehicles. The fifth is to regulate that the government agency is mandatory to use the eco-friendly vehicles. The sixth thing is to provide the low-carbon certification for eco-friendly vehicles. The seventh thing is to support advertising the eco-friendly vehicles. The results from this research can be used as a guideline to make policies to stimulate the eco-friendly vehicle industry in Korea.

• IEMEK Journal of Embedded Systems and Applications
• /
• v.18 no.2
• /
• pp.75-80
• /
• 2023

Unmanned drone stations for automatic charging have been developed in order to overcome the flying time limitation of rotary wing drones. Since the drone stations is an unmanned operating system, each of the drones will be required to have a high degree of landing accuracy. Drone precision landing has been mainly studied depended on image processing technologies, but the image processing systems make several problems, such as the mission weight, the drone cost, and the development complexity increases, and the flight time decrease. Thus, this paper researched accuracy of precision landing based on RTK (real time kinetics) for rotary wing drones. For the experiments of RTK based precision landing, a drone repeatedly performed three missions. The survey accuracies of the RTK about missions respectively were set as 0.3, 0.2, and 0.1 meters. Each mission has one take-off point, two way-points and one landing-point, and was repeated ten times. The experiment results revealed landing error distance means of around 0.258, 0.12 and 0.057 meters on each of RTK setting.

• Journal of the Korea Academia-Industrial cooperation Society
• /
• v.21 no.12
• /
• pp.339-345
• /
• 2020

In the field of defense, one-shot devices such as missiles are stored for a long period of time after they are manufactured, so it is essential to predict their storage life. A study was conducted to find the shelf life of a Li-ion battery used in one-shot devices. To do this, a Li-ion battery that has been used in weapon systems for more than 5 years was secured. A non-functional test was performed on the battery to check for external changes or failures. After the non-functional test, a discharge test was performed to measure the performance after storing it. Through the test, the performance was checked, including the initial charging voltage, discharge time, and battery temperature, and the trend of the change was identified. An F-test, One-way ANOVA, and regression analysis were performed to verify the aging, and the shelf life of the battery was estimated by an approximation formula that was derived through a regression analysis. As a result of the ANOVA, the p-value was less than the reference value of 0.05, and the performance of the battery decreased by more than 15% after a certain period of time. This change is assumed to result from the change in physical properties of the lithium polymer cell.