• Korean Chemical Engineering Research
• /
• 제49권6호
• /
• pp.851-856
• /
• 2011

본 연구에서는 하수슬러지의 열분해로 촤를 제조하였고, 열분해 반응 조건이 슬러지 촤의 특성에 미치는 영향을 조사하였다. 열분해 온도가 $300^{\circ}C$에서 $800^{\circ}C$로 증가함에 따라 슬러지 char의 비표면적은 증가하였으나, $700^{\circ}C$에서는 일시적으로 감소하였다. 열분해 속도는 char의 비표면적과 기공부피에 미치는 영향이 크지 않은 것으로 나타났다. 반면, 열분해 반응시간이 증가함에 따라 비표면적과 기공부피는 증가하였으나, 평균 기공크기는 감소하는 결과를 나타내었다.

• 한국연소학회지
• /
• 제21권4호
• /
• pp.23-29
• /
• 2016

Reactivity of gasification defined by bouardard reaction is critical parameter in efficiency of the gasifier. In this study, char reactivity of the gasification was derived from the experiments using the intrinsic reaction kinetics model. Pressurized wire mesh heating reactor (PWMR) can produce high temperature and high pressure conditions up to 50 atm and 1750 K, respectively and PWMR was designed to evaluate the intrinsic reaction kinetics of $CO_2$ gasification. In this study, Kideco and KCH (sub-bituminous Indonesian coal) were pulverized and converted into char. Experiments used the PWMR were conducted and the conditions of the temperature and pressure were 1373~1673 K, 1~40 atm. To distinguish the pressure effect from high pressurized condition, internal and external effectiveness factors were considered. Finally, the intrinsic kinetics of the Kideco and KCH coal char were derived from $n^{th}$ order reaction rate equations.

• 에너지공학
• /
• 제18권1호
• /
• pp.9-16
• /
• 2009

국내 Y 화력발전소에서 사용중인 5개 석탄에 대한 열분해, 촤 - 공기 반응에 대한 반응성 실험을 TGA를 이용하여 수행하였다. 탄종별 열분해 및 촤 반응특성을 살펴보았으며 반응성 지수를 구하여 서로 비교, 분석하였다. 열분해 속도는 Peabody, Flame, MIP, Indominco, Elk valley의 순이었으며 열분해 거동은 2단계, 1차 열분해 모델에 의하여 잘 모사되어졌다. 5개 탄종에 대한 촤 - 공기 반응은 그레인 모델로 잘 모사되었으며 촤의 반응 속도는 Flame 촤가 가장 컸으며 Elk valley 촤가 가장 작은 값을 보여주었다. Flame 촤의 경우 1,000 K 이상의 온도 영역에서 반응속도가 다른 촤에 비해 월등히 빠른 것을 보여주었다.

• 에너지공학
• /
• 제12권3호
• /
• pp.231-240
• /
• 2003

국내 발전용으로 수입되는 5개 석탄 촤의 이산화탄소 가스화 반응성을 전압력 0.5∼2.0 MPa, 반응온도 850∼100$0^{\circ}C$의 범위에서 가압열중량분석기를 사용하여 고찰하였다. 석탄 등급, 촤의 초기 물성, 그리고 압력이 반응속도에 미치는 영향을 평가하였다. 낮은 등급의 석탄 촤의 반응성이 높은 등급의 석탄 촤보다 좋았으며 이는 촤의 기공구조와 반응 표면적의 항으로 설명되었다. 기공특성 데이터중 대/중간 기공이 반응성에 미치는 영향이 켰으며 이는 반응가스가 촤 표면적으로 확산하는 통로를 제공하기 때문인 것으로 보인다. $CO_2$ 분압 0.18∼0.495 MPa 범위에서 촤의 반응속도는 분압에 비례하였으며 반응 차수는 약 0.4∼0.7의 범위에 있었다. 반응속도에 대한 전압력의 영향은 작은 것으로 나타났으며 미반응핵 모델에 근거한 5개 촤의 반응성 지수를 구하였다.

• 한국신재생에너지학회:학술대회논문집
• /
• 한국신재생에너지학회 2006년도 추계학술대회
• /
• pp.87-90
• /
• 2006

The experimental study has been done for two kinds of pelletized RDFs to Investigate the carbonization effect to the chlorine concentrations, the heating value and the yield of Produced char in variable conditions of the carbonizing temperature and reaction time. One(RDF-1) is made of 100% wasted plastics and the other(RDF-2) is made of 60% wasted paper with 40% wasted plastics. The screw type carbonizer heated Indirectly by oil burner was used for the experiment and RDF feeding rate was 3kg/hr. The carbonizing temperature was 300, 350 400 and $45^{\circ}C$ and the reaction tine was 5, 10 and 15 minutes respectively. As the increase of carbonizing reaction time and temperature, the chlorine reduction rate was increased and oppositely the yield of char was decreased At the temperature of $400^{\circ}C$ and reaction time of 10 minutes the chlorine reduction rate was 60% and the char yield rate was 80% for the RDF-1 and those of RDF-2 were 80% and 75%, respectively. Additional activation experiment to the char produced from RDF-2 was done in the activation reactor by hot steam supply. As the increase of activation time the iodine number was increased. At the activation time of 20 minutes the iodine number was 552mg/g and the yield of activated carbon was 16%.

• 한국연소학회지
• /
• 제20권3호
• /
• pp.35-42
• /
• 2015

Investigating coal combustion in a large-scale boiler using computational fluid dynamics (CFD) requires a combination of flow and reaction models. These models include a number of rate constants which are often difficult to determine or validate for particular coals or furnaces. Nonetheless, CFD plays an important role in developing new combustion technologies and improving the operation. In this study, the model selection and rate constants for coal devolatilization, char conversion, and turbulent reaction were evaluated for a commercial wall-firing boiler. The influence of devolatilization and char reaction models was found not significant on the overall temperature distribution and heat transfer rate. However, the difference in the flame shapes near the burners were noticeable. Compared to the coal conversion models, the rate constant used for the eddy dissipation rate of gaseous reactions had a larger influence on the temperature and heat transfer rate. Based on the operation data, a value for the rate constant was recommended.

• 한국연소학회지
• /
• 제22권4호
• /
• pp.19-26
• /
• 2017

This study investigates the gasification of coal char by $CO_2$ under high pressures in a drop tube furnace(DTF). The rate constants are derived for the shrinking core model using the conventional method based on the set reactor conditions. The computational fluid dynamic(CFD) simulations adopting the rate constants revealed that the carbon conversion was much slower than the experimental results, especially under high temperature and high partial pressure of reactants. Three reasons were identified for the discrepancy: i) shorter reaction time because of the entry region for heating, ii) lower particle temperature by the endothermic reaction, and iii) lower partial pressure of $CO_2$ by its consumption. Therefore, the rate constants were corrected based on the actual reaction conditions of the char. The CFD results updated using the corrected rate constants well matched with the measured values. Such correction of reaction conditions in a DTF is essential in deriving rate constants for any char conversion models by $H_2O$ and $O_2$ as well as $CO_2$.

• 공업화학
• /
• 제22권3호
• /
• pp.308-311
• /
• 2011

하수슬러지 촤에 MnOx를 담지한 촉매를 사용하여 $NH_3$를 환원제로 하는 선택적 촉매 환원반응의 반응 메커니즘 분석을 수행하였다. XRD 분석 결과 활성 Mn phase는 $Mn_3O_4$인 것으로 여겨졌다. 또한 $150^{\circ}C$ 이하에서는 흡착반응이 주요한 질소산화물 저감 메커니즘으로 작동하였으나, $100{\sim}150^{\circ}C$에서는 환원반응도 질소산화물 저감에 관여하는 것으로 보여졌다. 실험결과에 기초하여 활성 촤와 여기에 MnOx를 담지한 촤에서의 반응속도상수를 비교하였다. MnOx 담지촤는 높은 충돌계수와 낮은 활성화 에너지에 기인하여 높은 반응속도 상수와 높은 NOx 제거 효율을 나타내었다. 두 가지 촤 모두 본 실험 조건하에서 활성화 에너지는 상대적으로 낮았다(10~12 kJ/mol).

• 한국연소학회:학술대회논문집
• /
• 한국연소학회 2007년도 제34회 KOSCO SYMPOSIUM 논문집
• /
• pp.47-53
• /
• 2007

The laminar combustion characteristics of interacting coal particles in a convective flow are numerically investigated at particle arrangement and size difference. The numerical simulations, which use the two-step global reaction model to account for the surrounding gas effect, show the detailed interaction among the inter-space particles, undergoing devolatilization and subsequent char burning. Several parametric studies, which include the effect of the gas temperature (1700 K), high pressure(10 atm) and variation in geometrical arrangement of the particle diameter on the volatile release rate and the char combustion rate, have been carried out. The comparison indicates that the shift to the multiple particle arrangement resulted in the substantial change of the combustion characteristics and that the volatile release rate of the interacting coal particles exhibits a strong dependency on the particle spacing and size difference.

• 한국연소학회:학술대회논문집
• /
• 한국연소학회 2015년도 제51회 KOSCO SYMPOSIUM 초록집
• /
• pp.69-72
• /
• 2015

Computational fluid dynamics (CFD) modeling of large-scale coal-fired boilers requires a complicated set of flow, heat transfer and combustion process models based on different degrees of simplification. This study investigates the influence of coal devolatilization, char conversion and turbulent gas reaction models in CFD for a tangential-firing boiler at 500MWe capacity. Devolatilization model is found out not significant on the overall results, when the kinetic rates and the composition of volatiles were varied. In contrast, the turbulence mixing rate influenced significantly on the gas reaction rates, temperature, and heat transfer rate on the wall. The influence of char conversion by the unreacted core shrinking model (UCSM) and the 1st-order global rate model was not significant, but the unburned carbon concentration was predicted in details by the UCSM. Overall, the effects of the selected models were found similar with previous study for a wall-firing boiler.