• Journal of the Korean Institute of Telematics and Electronics A
• /
• v.31A no.9
• /
• pp.26-33
• /
• 1994

In this paper, the performance of the trellis coded CPFSK with the coherent detection over mobile communication channels is calculated. The characteristics of channels, including phase jitter effects and fading effects, are examined and modeled. The phase jitter channel is modeled to have a nonzero mean and a gaussian distribution. The fading channel has a Rayleigh distribution in the multipath. For the optimal decoding method(MLSE), the Viterbi algorithm is used for the trellis structure of trellis coded CPFSK. The results indicate that the trellis coded CPFSK with a small moulation indes gets more sensitive, as the index gets smaller, to the phase noise under the phase jitter channel. Using the interleaving method. It gives considerable improvements in the error rate under the fading channel.

• Transactions of the Korean Society of Mechanical Engineers B
• /
• v.25 no.4
• /
• pp.507-513
• /
• 2001

Time averaged pressure distributions in a high-speed centrifugal compressor channel diffuser at design and off-design flow rates are investigated. Pressure distributions from the impeller exit to the channel diffuser exit are measured for various flow rates from choke to near surge condition, and the effects of operating condition are discussed. The strong non-uniformity in the pressure distribution is obtained over the vaneless space and semi-vaneless space caused by the impeller-diffuser interaction. As the flow rate increases, flow separation near the throat, due to large incidence angle at the vane leading edge, increases aerodynamic blockage and reduces the aerodynamic flow area downstream. Thus the minimum pressure location occurs downstream of the geometric throat, and it is named as the aerodynamic throat. And at choke condition, normal shock occurs downstream of this aerodynamic throat. The variation in the location of the aerodynamic throat is discussed.

• Journal of Mechanical Science and Technology
• /
• v.20 no.6
• /
• pp.840-848
• /
• 2006

We carried out numerical studies to investigate the single- and two-phase flow characteristics in the single- and multi-channels. We used the finite volume method to solve the mass and momentum conservation equations. The volume of fluid model is used to predict the two-phase flow in the channel. We obtained the distribution of velocity fields, pressure drop and air volume fraction for different water mass flow rates. We also calculated the distribution of mass flow rates in the multi-channels to understand how the flow is distributed in the channels. The calculated results for the single- and two-phase flow are partly compared with the present experimental data both qualitatively and quantitatively, showing relatively good agreement between them. The numerical scheme used in this study predicts well the characteristics of single-and two-phase flow in a multi-channel.

• Journal of Korea Water Resources Association
• /
• v.52 no.1
• /
• pp.1-10
• /
• 2019

This study investigates the flow characteristics, such as velocity distributions, size and location of recirculation zone, longitudinal flow change rates, and bifurcation discharge ratio in the bifurcation channel by TELEMAC-2D, a 2D numerical model. The numerical model is validated by previous experimental results and the numerical results are in relatively good agreement with the experimental results, such as the water surface elevation and velocity distribution in the channels. As the inertial force and moment in the main channel decrease, the bifurcation discharge ratio increases, and the relative high velocity distribution becomes wider and the reverse velocity of the main stream decreases in the branch channel. As the bifurcation discharge ratio increases, the size of the recirculation zone in the branch channel decreases and it can be more clearly calculated by determining the point where the longitudinal froude number $Fr{\approx}0$ as well as drawing the distribution of the streamline distribution.

• Journal of the Korean earth science society
• /
• v.27 no.7
• /
• pp.757-767
• /
• 2006

Alluvial-plain deposits in the southeastern part of the Eumsung Basin (Cretaceous) are characterized by coarse-grained channel fills encased in purple siltstone beds. It represents distinct channel geometry, infill organization, and variations in facies distribution. The directions of paleocurrent, sedimentary facies changes, and channel-fill geometry can be used to reconstruct a channel network in the alluvial system developed along the southeastern margin of the basin. The channel-fill facies represent downstream changes: 1) down-sizing and well-sorting in clast and martix of channel fills and 2) internal organization of scour fill or gravel lag and overlying cross-stratified, planar-stratified beds. These findings suggest multiple stages of channel-filling processes according to flooding and subsequent stream flows. In the small-scale pull-apart Eumsung Basin (${\sim}7{\times}33km^2$ in area), vertical-stacked alluvial architecture of the coarse-grained channel fills encased in purple siltstone is expected to result from episodic channel shifting under a rapidly subsiding setting.

• JSTS:Journal of Semiconductor Technology and Science
• /
• v.3 no.4
• /
• pp.217-222
• /
• 2003

A new two-dimensional analytical model for the potential distribution and drain-induced barrier lowering (DIBL) effect of fully depleted short-channel Silicon-on-insulator (SOI)-MESFET's has been presented in this paper. The two dimensional potential distribution functions in the active layer of the device is approximated as a simple parabolic function and the two-dimensional Poisson's equation has been solved with suitable boundary conditions to obtain the bottom potential at the Si/oxide layer interface. It is observed that for the SOI-MESFET's, as the gate-length is decreased below a certain limit, the bottom potential is increased and thus the channel barrier between the drain and source is reduced. The similar effect may also be observed by increasing the drain-source voltage if the device is operated in the near threshold or sub-threshold region. This is an electrostatic effect known as the drain-induced barrier lowering (DIBL) in the short-gate SOI-MESFET's. The model has been verified by comparing the results with that of the simulated one obtained by solving the 2-D Poisson's equation numerically by using the pde toolbox of the widely used software MATLAB.

• JSTS:Journal of Semiconductor Technology and Science
• /
• v.5 no.3
• /
• pp.173-181
• /
• 2005

A new two dimensional (2-D) model for the potential distribution of fully depleted short-channel ion-implanted silicon MESFET's has been presented in this paper. The solution of the 2-D Poisson's equation has been considered as the superposition of the solutions of 1-D Poisson's equation in the lateral direction and the 2-D homogeneous Laplace equation with suitable boundary conditions. The minimum bottom potential at the interface of the depletion region due to the metal-semiconductor junction at the Schottky gate and depletion region due to the substrate-channel junction has been used to investigate the drain-induced barrier lowering (DIBL) and its effects on the threshold voltage of the device. Numerical results have been presented for the potential distribution and threshold voltage for different parameters such as the channel length, drain-source voltage, and implanted-dose and silicon film thickness.

• Journal of Korea Water Resources Association
• /
• v.39 no.12 s.173
• /
• pp.1023-1030
• /
• 2006

The characteristics of the longitudinal velocity in a $180^{\circ}$ constant-radius, recirculating laboratory channel were investigated. Three-dimensional velocity fields were measured using a side-looking ADV. The shortcomings of existing equations for longitudinal velocity are discussed. An eddy viscosity model is adopted in the downstream momentum equation. A mathematical equation was developed to describe the vertical distribution of longitudinal velocity. The comparisons of the longitudinal velocity show generally good agreement. It is found that the curvature change in the curved channel affects the vertical location of maximum velocity and the vertical profile of longitudinal velocity.

• Journal of Internet Computing and Services
• /
• v.15 no.2
• /
• pp.143-147
• /
• 2014

In this paper, a novel MDI(Multiplex Distribution Interface) analyzer is designed in Ethernet-mode for DRM(Digital Radio Mondiale), and DRM+(Digital Radio Mondiale Plus) systems. The proposed MDI analyzer can reduce the overload of MDI packets by using memory sharing techniques into a common module block. In consequence, it verifies the received MDI packets by composition information of IP(Internet Protocol) and FAC(Fast Access Channel)/SDC(Service Description Channel) in DRM/DRM+ systems for the next generation digital radio broadcasting systems.

• Proceedings of the IEEK Conference
• /
• 2004.06b
• /
• pp.485-488
• /
• 2004

As scaling down the cell channel length, the increment of B concentration in channel region is inevitable to overcome the punch-through, especially in flash memory cell with 90nm technology. This paper shows that the high dose ion implantation in channel cause the Si defect. which has been proved to be the major cause of the tailed Vth in distribution. And also mechanical stress due to SiN-anneal process can induce the Si dislocation. and get worse it. With decreasing the channel implantation dose, skipping the anneal and reducing the mechanical stress, Si defect problem is solved completely. We are verify first that the optimization of B concentration in channel must be certainly considered in order to improve Si defect. It is also certainly necessary to stabilize the distribution of cell Vth in the next generation of flash memory.