• Elastomers and Composites
• /
• v.52 no.4
• /
• pp.237-241
• /
• 2017

The tensile strength (TS) and elongation-at-break (EB) loss of a CR/CB rubber composite sample prepared for the automotive parts were measured after accelerated thermal ageing at temperatures of 100, 120, 140, and $150^{\circ}C$. The change in TS was observed to be linear from the master curve prepared using the time-temperature superposition-principle (TTSP). An Arrhenius type of shift factor, $a_T$ was used to predict the life time of the sample, and a plot of ln $a_T$ vs. 1/T was also shown to be linear. The activation energy ($E_a$) of the sample was calculated as 70.30 kJ/mole from the Arrhenius plot. The expected life time of the sample was predicted at the given operating conditions by applying Arrhenius analysis. Assuming the $E_a$ value was constant at lower operating condition, life time of the sample was calculated as 2.3 years when the life limit was set as time to reach the 20% decrease of the initial TS value at operating temperature of $40^{\circ}C$.

• The Transactions of the Korean Institute of Power Electronics
• /
• v.21 no.4
• /
• pp.312-319
• /
• 2016

Zero-sequence Circulating Current (ZSCC) flows inevitably in parallel converters that share common DC and AC sources. The ZSCC commonly flowing in all converters increases loss and decreases the overall capacity of parallel converters. This paper proposes a simple and effective ZSCC suppression method based on the Space Vector PWM (SVPWM) with the ZSCC controller. The zero-sequence voltage for the proposed SVPWM is calculated on the basis of the grid voltage and not on the phase voltage references. The limit of the linear modulation region of the converters with the proposed method is analyzed and compared with other methods, thereby proving that the limit of the region can be extended with the proposed method. The effectiveness of the proposed method has been verified through the experimental setup comprising four parallel three-level converters. The ZSCC is confirmed to be well suppressed, and the linear modulation region is extended simultaneously with the proposed method. Moreover, the proposed control method does not require any communication between the converters to suppress the ZSCC unlike other conventional methods.

• Journal of The Korean Society of Integrative Medicine
• /
• v.6 no.3
• /
• pp.141-147
• /
• 2018

Purpose : Aim of the this study was conducted to determine whether hearing aids are responsible for the quality of life by comparing quality of life between the elderly who are suspected of difficulty in hearing selected by Hearing Handicap Inventory of Elderly (HHIE) without using hearing aids and who are using hearing aids. Methods : For the study, two groups of 33 people were analyzed for independent t-test based on whether they wore Hearing Aids (HA) or not whom wearing hearing aids (hearing aids users) and suspected difficulty in hearing. who are attending the Religious organization Senior Welfare Center in the OO region. Result : The quality of life of hearing aid users is generally observed to be higher than that of non-users in general, and by the section, psychological (p=0.019) and living environment (p=0.032) were appeared statistically signigicant. The elderly showed a significant difference. In the section, "Operation Satisfaction (p=0.038)" in the physical health area, "relationship of reason (p=0.018)" in the social relationship area, "Economic margin (p=0.021)" in the environmental area, "Information accessibility (p=0.020)", In the psychological area, hearing aid was used for "self satisfaction (p=0.033)", "concentration of work (p=0.045)". Conclusion : The use of hearing aids by hearing loss elderly improves the quality of life in the psychological health and living environment section.

• The Journal of the Korea institute of electronic communication sciences
• /
• v.10 no.1
• /
• pp.7-12
• /
• 2015

In this paper, we studied the design and fabrication of dual T type antenna to be used in LTE communication systems operating at around 1.8 GHz band. In order to improve of frequency properties of antenna, single feed microstrip patch antenna and CPWG antenna was simulated by HFSS(High Frequency Structure Simulator). The fabricated dual T type antennat showed that the measured center frequency, the minimum return loss and -10dB bandwidth were 1.79 GHz, -23.26 dB and 23 MHz, respectively.

• Journal of Sensor Science and Technology
• /
• v.6 no.3
• /
• pp.194-199
• /
• 1997

When voltage or current gets out of the magnetic sensor as it is, we have often faced the problems such as introduction of noise and loss of voltage. In order to reduce these problems, a 2 drain MAGFET operating in the saturation region and fabricated by CMOS process, the system of I/V converter, VCO with operational amplifier, and V/F conversion circuits with Schmitt Trigger are designed and fabricated in one package. The absolute sensitivity of magnetic sensor shows 1.9 V/T and the product sensitivity is $3.2{\times}10^{4}\;V/A{\cdot}T$. The characteristic of V/F conversion is very stabilized and has the value of 190 kHz/T.

• Proceedings of the KIEE Conference
• /
• 2006.04b
• /
• pp.386-389
• /
• 2006

BIPV(Building Integrated PV) system can expect dual effects that reduce expenses for establishment of PV system by adding new function as outer covering material of building expect producing the electricity. In case of PV(photovoltaic system) there are many generation differences according to the exterior environmental facts(solar cell array, design and installation condition of interactive inverter system). In this paper, we compared constitute factors of 3kW BIPV(solar cell module, inverter), operating characteristic and total system characteristic(utilization, generation efficiency, loss fact) and found out long time operating data using a watch instrumentations. By use of long time operating result, compare a totally operating characteristics, and we proposed a next building application of BIPV. BIPV system that is proposed in this paper, was established in Solar Energy research center of Chosun University, composed with system. The objective of this paper, is to provide a efficient BIPV design method through the considerations for the integration of PV system.

• The Transactions of the Korean Institute of Electrical Engineers A
• /
• v.53 no.9
• /
• pp.507-512
• /
• 2004

HTS (High Temperature Superconducting) Transformer has the several useful characteristics in the viewpoints of technical and economical. Especially, an HTS transformer replaces the copper wire coils in a conventional transformer with lower loss HTS wire. In addition, inexpensive, environmentally benign liquid nitrogen replaces the conventional oil as the electrical insulation (dielectric) and provides the necessary cooling for the HTS transformer Therefore, the Life-cycle cost of an HTS transformer is much more attractive than conventional because it is more energy efficient, lighter in weight, smaller in size, and environmentally compliant. HTS transformer can be the best way to replace with conventional transformer in the future. In these days, companies world-wide have conducted researches on HTS transformer. A development project for a 154kV HTS transformer is proceeding at a research center and university in Korea. In this paper, we investigate the expected price of HTS transformer to have a merit in viewpoint of economic aspect. First, life-cycle cost of conventional transformer is calculated and based on this, the expected price of HTS transformer is evaluated. which HTS transformer is competitive against conventional transformer.

• Proceedings of the Korean Society For Composite Materials Conference
• /
• 2001.05a
• /
• pp.250-253
• /
• 2001

Recently, based on the smart structure concept, optical fiber sensors have been increasingly applied to monitor the various engineering and civil structural components. Repairs based on adhesively bonded fiber reinforce composite patches are more structurally efficient and much less damaging to the parent structure than standard repairs based on mechanically fastened metallic patches. As a result of the high reinforcing efficiency of bonded patches fatigue cracks can be successfully repaired. However, when such repairs are applied to primary structures, it is needed to demonstrate that its loss can be immediately detected. This approach is based on the "smart patch" concept in which the patch system monitors its own health. The objective of this study is to evaluate the potentiality of application of transmission-type extrinsic Fabry-Perot optical fiber sensor (TEFPI) to the monitoring of crack growth behavior of composite patch repaired structures. The sensing system of TEFPI and the data reduction principle for the detection of crack detection are presented. Finally, experimental results from the tests of center-cracked-tension aluminum specimens repaired with bonded composite patch is presented and discussed.

• Journal of the Korean Recycled Construction Resources Institute
• /
• v.4 no.3
• /
• pp.269-275
• /
• 2016

In this study, the mechanical properties and the neutron shielding rate of concrete with the borosilicate glass and the amorphous boron steel fiber were investigated. The measures of this investigation includes air contents, slump loss, compressive strength, static modulus of elasticity, compressive toughness, flexural strength, flexure toughness and neutron shielding rate. As a result, the neutron shielding rate of the concrete with borosilicate glasses increased even though the compressive strength and flexural strength decreased in comparison with that of plain concrete. Also, the mechanical toughness and the neutron shielding rate of the concrete with amorphous boron steel fiber increased in comparison with that of plain concrete.

• Publications of The Korean Astronomical Society
• /
• v.32 no.1
• /
• pp.101-103
• /
• 2017

We have carried out the near-infrared spectroscopic observations of recent classical novae (e.g., V2468Cyg, V1280Sco) within a few years from the outburst with AKARI as a part of AKARI Open Time Observing Program for Phase 3-II "Spectral Evolution of Novae in the Near-Infrared based on AKARI Observations (Proposal ID: SENNA)". The homogeneous datasets of near-infrared spectra from $2.5{\mu}m$ to $5{\mu}m$ with AKARI/IRC collected in this program are useful to infer the physical conditions of the shell formed by the ejected materials, to examine the chemical properties of the ejecta gas, and to examine the properties of dust formed in the nova ejecta.