• Proceedings of the Korean Vacuum Society Conference
• /
• 2011.08a
• /
• pp.218-218
• /
• 2011

The CIGS Solar Cells have the highest conversion efficiency in the film-type solar cells. They consist of p-type CuInSe2 film and n-type ZnO film. The CdS films are used as buffer layer in the CIGS solar cells since remarkable difference in the lattice constant and energy band gap of two films. The CdS films are toxic and make harmful circumstances. The CdS films deposition process need wet process. In this works, we design and make the hitter and lamp reflection part in the sputtering system for the ZnS films deposition as buffer layer, not using wet process. Film thickness, SEM, and AFM are measured for the uniformity valuation of the ZnS films. We conclude the optimum deposition temperature for the films uniformity less than 1.6%. The ZnS films deposited by the sputtering system are more dense and uniform than the CdS films deposited by the Chemical Bath Deposition Method(CBD) for the CIGS Solar Cells.

• Journal of the Korean Vacuum Society
• /
• v.6 no.1
• /
• pp.50-60
• /
• 1997

Undoped, cobalt-doped and erbium-doped $ZnAl_2S_4, ;ZnAl_2Se_4, ;CdAl_2S_4, ;and;CdAl_2Se_4$ single crystals were grown by the chemical transport reaction method. The crystal structures, the lattice constants, the optical energy gaps, and the photoluminescence properties of these single crystals were investigated. Also, the optical transition mechanisms by the impurities of cobalt and erbium were identified from these results.

• Solar Energy
• /
• v.8 no.1
• /
• pp.41-48
• /
• 1988

Heterojunction solar cells of $n-Cd_{1-x}Zn_xS/p-Si$ were fabricated by solution growth technique. The crystal structure, spectral response, surface morphology, and I-V characteristics of the $n-Cd_{1-x}Zn_xS/p-Si$ heterojunction solar cells were studied. The $Cd_{1-x}Zn_xS$ layer deposited on a silicon substrate (111) were found to be a cubic structure with the crystal orientation (111), (220) of the CdS and to be a hexagonal structure with crystal orientation (100) of the ZnS. The open-circuit voltage, short-circuit current, fill factor, and conversion efficiency of $n-Cd_{1-x}Zn_xS/p-Si$ heterojunction solar cell under $100mW/cm^2$ illumination were found to be 0.43V, 38mA. 0.76, and 12.4%, respectively.

• Journal of the Korean Electrochemical Society
• /
• v.10 no.4
• /
• pp.262-264
• /
• 2007

This paper describes a two-step approach for the electrochemical deposition of CdZnS thin films on the polycrystalline Au electrode. Initially, an Au substrate is electrochemically modified with a sulfur layer. In the second step, the layer is electroreduced to $S^{2-}$ in the electrolyte dosed with the requisite amount of $Cd^{2+}$ and $Zn^{2+}$ ions to generate CdZnS films in situ. This approach was validated using a combination of linear sweep voltammetry and electrochemical quartz crystal microgravimetry. Thus synthesized CdZnS thin films have different composition depending on the composition of electrolytes. CdZnS thin films are characterized by energy-dispersive X-ray analysis and Raman spectroscopy.

• Proceedings of the Korean Institute of Electrical and Electronic Material Engineers Conference
• /
• 1989.06a
• /
• pp.56-58
• /
• 1989

All-polycrystalline Cd$_1$-xZnxS/CdTe solar cells have been fabricated by coating CdTe slurries with 4.5 wt% of CdCl$_2$on the sintered Cd$_1$-xZnxS films and by sintering CdTe layer at 6$25^{\circ}C$ for lh in nitrogen atmosphere. Solar efficiency of the sintered Cd$_1$-xZnxS/CdTe solar cells increases as the Zn content increases up to x=0.06 and then decreases with further increase in the Zn content. A solar efficiency of 12.5% under a solar intensity of 76mW/$\textrm{cm}^2$ was observed in a Cd 0.94 Zn0.06S/CdTe solar cell. By optimizing the amount of CdCl$_2$in the slurry and sintering conditions, it is possible to produce Cd$_1$-xZnxS/CdTe solar cells with efficiency higher than 12%.

• Proceedings of the Korean Vacuum Society Conference
• /
• 2011.02a
• /
• pp.471-471
• /
• 2011

1차원 나노 와이어는 나노 디바이스를 구현하는데 있어 중요한 요소로 연구되고 있다. 하지만 나노 와이어를 바람직한 위치에 선택적으로 배열하는 부분은 해결할 과제로 남아있다. DNA 분자가 가지고 있는 음의 전하를 띄는 phosphate backbone과 자기조립 특성은 이러한 문제점들을 해결할 수 있는 중요한 요소이다. 본 연구에서는 DNA 분자 형틀을 이용해서 CdSe/ZnS core-shell 나노입자의 pH 의 변화에 따른 표면 전위 변화를 이용하여 선택적 위치의 나노입자 배열을 통한 나노 와이어를 제작하는 연구를 하였다. 1-step 방법을 이용하여 합성한 CdSe/ZnS core-shell 나노입자를 무극성 용매인 chloroform 용액에 분산시키고 dimethylaminoethanethiol (DMAET) 를 이용하여 표면을 양전하로 치환하였다. 그리고 치환한 CdSe/ZnS 나노입자 용액에 HCl 을 이용해서 pH 7, 6, 5, 4로 변화를 주어 zeta potential 변화를 측정하였고 3-aminopropyltriethoxysilane (APTES) 코팅된 Si 기판에 ${\lambda}$-DNA를 정렬하고 이를 형틀로 이용하여 CdSe/ZnS 나노입자를 정렬하는 실험을 하였고 FE-SEM 을 이용하여 측정하였다. 그 결과 CdSe/ZnS 나노입자의 pH 값이 작아지면서 전위가 커짐에 따라서 APTES 코팅된 기판 표면에 나노입자들이 반응하는 것보다 음전하를 띄는 ${\lambda}$-DNA의 phosphate backbone에 반응하는 것이 커짐에 따라 DNA 분자 형틀에 선택적으로 나노입자가 배열되는 것을 확인하였다.

• Journal of Electrical Engineering and Technology
• /
• v.7 no.6
• /
• pp.965-970
• /
• 2012

Structure and optical properties of cadmium sulphide-zinc oxide composite nanorods have been evaluated by suitable characterization techniques. The X-ray diffraction spectrum contains a series of peaks corresponding to reflections from various sets of lattice planes of hexagonal ZnO as well as CdS. The above observation is supported by the Micro-Raman spectroscopy result. The optical reflectance spectra of CdS-ZnO is compared with that of ZnO where we observe an enhanced absorption and hence diminished reflection from CdS-ZnO compared to that from only ZnO. A very small intensity of the visible photoluminescence peak observed at 550 nm proves that the ZnO nanorods have very low concentrations of point defects such as oxygen vacancies and zinc interstitials. The photocurrent in the visible region has been significantly enhanced due to deposition of CdS on the surface of the ZnO nanorods. CdS acts as a visible sensitizer because of its lower band gap compared to ZnO.

• Proceedings of the Korean Vacuum Society Conference
• /
• 2013.02a
• /
• pp.671-671
• /
• 2013

실리콘 태양전지와 박막형 태양전지의 뒤를 이어, 제3세대로 분류되는 양자점 감응형 태양전지(QDSC)에 대한 연구가 활발히 진행되고 있다. 이 태양전지의 TCO로는 주로 ZnO, TiO2가 대부분 사용되고 있으며, 양자점 물질로는 CdS, CdSe, CdTe, PbS, PbSe 등의 카드뮴 및 납을 주 성분으로 하는 물질들에 대한 연구만 중점적으로 이루어지고 있는 실정이다. 이런 물질들은 현재까지 알려진 한도 내에서는 QDSC 효율 중 가장 좋은 효율을 나타내고는 있으나 이런 타입의 QDSC가 상용화된다면 환경에 노출되었을 때에 미치는 악영향이 매우 큰 중금속 물질들로 이루어져 있어, 이를 극복할 수 있는 친환경 성분의 물질에 대한 연구 또한 필요한 시점이다. 따라서 본 연구에서는 CdS를 대체할 수 있는 물질로 Ag2S를 선정, 이에 대한 연구를 진행하였다. Ag2S는 밴드갭이 1.1eV의 물질로, CdS의 2.3 eV와 비교해 상당히 작은 밴드갭을 가져 월등히 넓은 영역에서 빛을 흡수할 수 있다는 장점을 가지고 있으며, 동시에 이로 인한 전자-정공 재결합이 빨라 태양전지로 제작시에 Voc가 낮게 형성된다는 단점도 가지고 있다. 태양전지에 사용된 TCO물질은 ZnO 나노선을 사용했으며, 본 연구실에서 기존에 개발한 수열합성법을 통해 제작하였다. 이를 활용하여 최종적으로 제작한 태양전지의 효율은 CdS/ZnO QDSC가 1.2%, Ag2S/ZnO QDSC가 1.2%로 동일한 성능을 나타냈으며, CdS를 대체할 물질로 Ag2S의 가능성을 보여준 결과라 할 수 있다.

• Proceedings of the Korean Institute of Electrical and Electronic Material Engineers Conference
• /
• 2004.07b
• /
• pp.973-976
• /
• 2004

The results of numerous studies in III-V semiconductors show that sulfur treatment improves the electrical parameters of III-V compound devices. In this article, we examine the effects of sulfidation of HgCdTe surface on the interfacial characteristics of metal-ZnS-HgCdTe structures. Different from sulfidation in III-V material, S can not be act as an impurity because II-S compounds (ZnS, CdS) generally used as passivant for HgCdTe. Our studies of sulfur-treatment on HgCdTe surface show that sulfur agent forms the S- S, II-S bonds at the surface layer. These bonds are very effective to improve the electrical properties of ZnS layer on HgCdTe by reducing the possibility of native oxides formation. After the sulfidation process, MIS capacitors of HgCdTe show great improvement in electrical properties, such as low density of fixed charge and reduced hystereisis width.

• Journal of Ecology and Environment
• /
• v.33 no.3
• /
• pp.245-251
• /
• 2010

We evaluated the interaction between Cd and Zn in the bioaccumulation of seven clones of Salix caprea, which were exposed both to Cd and Zn alone and to a combination of Cd and Zn. Cadmium (Cd) and Zn concentration in the four treatments were administered in the following order: root > leaf > stem, and obvious differences were noted among the treatments and clones. The leaf Cd concentration of clone BH2 and stem Cd concentration of clone BH5 in the combined Cd and Zn treatment group was increased by 62% and 110%, respectively, relative of that of the Cd alone treatment group. On the other hand, the leaf and stem Zn concentration of clone BH8 in the combined Cd and Zn treatment group was reduced by 66% and 61%, respectively, relative to that of the Zn alone treatment group. Translocation of Cd and Zn from the root was higher in the leaf than in the stem, and the combined Cd and Zn treatment stimulated the translocation of Cd from the root to the leaf and stem, whereas it suppressed the translocation of Zn from the root to the leaf and stem. Therefore, the interaction effects were considered strongly synergistic with Cd in the presence of Zn, but proved antagonistic to Zn in the presence of Cd in the combined Cd and Zn treatment group. The phytoremediation potentials of the seven clones, which were estimated from standard indices of Cd and Zn concentration in Cd and Zn alone and the combined Cd and Zn treatment groups, were highest in clone BH3, and lowest in clone BH5. Therefore, we recognize S. caprea as an appropriate material for phytoremediation, and this is particularly the case with clone BH3. However, further research will be required to evaluate the effects of Cd and Zn on the physiological changes as well as tolerance mechanisms against metal toxicity in S. caprea clones.