• Selected Papers of The Society of Naval Architects of Korea
• /
• 제1권1호
• /
• pp.15-25
• /
• 1993

A potential-based panel method is presented for the analysis of a partially-cavltatlng two-dimensional hydrofoil. The method employs normal dipoles and sources distributed on the foil and cavity surfaces. It is shown that the source plays an Important role in positioning the cavity surface through an iterative process. The cavity closure consition is found very effective in generating the cavity shape. Upon convergence, the method predicts the cavitation nurser, together with the lift, the drag and the surface pressure distribution, for a given cavity length. Systematic convergence tests shows that the present numerical method is fast and stable. The present computations show a good agreement with the previously computed and measured results.

• 대한기계학회:학술대회논문집
• /
• 대한기계학회 2004년도 춘계학술대회
• /
• pp.1921-1926
• /
• 2004

The tone generation mechanism and aeroacoustic characteristics have been investigated for flow over open cavities using direct acoustic numerical simulations. Physically the tone generation mechanism of open cavity is more complicated when flow instabilities are excited by the correlation effects of flow parameters. From non-dimensional parameter studies in very low Mach number range, it is shown that characteristics of cavity resonance inherently involve typical acoustic pattern at each discrete tone frequency, and especially in laminar flow the fundamental tone frequency is determined within flow instability criterion of laminar shear layer as well as cavity geometry, length to depth ratio.

• 한국추진공학회:학술대회논문집
• /
• 한국추진공학회 2008년도 제31회 추계학술대회논문집
• /
• pp.341-344
• /
• 2008

Numerical simulations have been carried out for a supersonic two-dimensional flow over open, rectangular cavities (length-to-depth ratios are L/D = 1.0) in order to investigate the effect of non-equilibrium condensation of moist air on supersonic flows around the cavity for the flow Mach number 1.83 at the cavity entrance. In the present computational investigation, a condensing flow was produced by an expansion of moist air in a Laval nozzle. The results obtained showed that in the case with non-equilibrium condensation for L/D = 1.0, amplitudes of oscillation in the cavity became smaller than those without the non-equilibrium condensation. Furthermore, the occurrence of the non-equilibrium condensation reduced the peaks of power spectrum density and the frequency of the flow field oscillation increased in comparison with the case of $S_0$ = 0.

• 한국추진공학회:학술대회논문집
• /
• 한국추진공학회 2008년도 제31회 추계학술대회논문집
• /
• pp.345-348
• /
• 2008

본 연구는 마하수가 1.83인 초음속 유동이 사각공동 위를 지날 때 공동에서 발생하는 압력진동에 대해 수치해석 연구를 수행하였다. 수치해석방법으로는 3차원 압축성 Navier-stokes에 유한차분법을 사용하였다. 보조공동의 형상변화를 통한 압력진동의 저감효과에 대해 조사하였다. 그 결과 공동에서 발생하는 압력진동은 보조공동의 넓이, 길이, 두께의 크기에 의존함을 확인 할 수 있었다.

• 대한토목학회논문집
• /
• 제39권6호
• /
• pp.789-799
• /
• 2019

교대, 통로박스 등 말뚝기초로 지지된 구조물에서는 침하가 거의 발생하지 않지만, 구조물 저면 하부에는 공동이 발생하게 된다. 이에 따른 문제점으로는 측면지반에서 공동으로 유출된 토사에 의해 구조물 측면 지반의 침하를 가속화하여 더 큰 침하가 발생하게 된다. 따라서 말뚝 기초로 지지된 구조물 하부의 공동 발생으로 인한 문제점을 예방하고자 구조물의 측면에 쉽게 설치가 가능한 토사유입차단판(soil Flow Protector; 이하 'FLP')이 개발되었다. 본 연구에서는 FLP의 침하감소 효과를 입증하고 최적 길이를 산정하고자 실내모형실험을 수행하였고, 그 결과 FLP의 설치함으로서 측면지반의 침하량이 감소하고 공동으로의 토사 유출을 방지하였고, FLP의 강성이 작으면 상부의 토압은 정지 또는 주동영역이 되어 안정성에 유리하지 않지만, 충분히 크면 상부의 토압은 수동영역이 되어 안정성에 유리하다. 또한 FLP의 강성이 작은 경우에는 일정 길이 비 이상에서는 오히려 감소하였으나, 큰 경우에는 설치길이가 증가할수록 침하량 감소에 효과적이다. 이에 따른 박스구조물 높이(H = 250 mm)에 대한 최적 길이 비는 연성 1.38, 강성 0.73으로 산정되었다.

• 한국초전도ㆍ저온공학회논문지
• /
• 제10권2호
• /
• pp.27-29
• /
• 2008

Superconducting RF cavities are being considered for accelerating a proton beam at 700 MHz in the linac of the Proton Engineering Frontier Project (PEFP) and its post-project. Dumbbell fabrication is a mid-process for manufacturing an elliptical superconducting RF cavity. During the dumbbell fabrication, control of the dumbbell length and the $TM010\;{\pi}$ mode frequencies is necessary to build up a desired cavity. A new formula with a perturbation measurement method is used to measure and calculate the frequencies of the individual half-cells of a PEFP low-beta dumbbell, and to tune the frequency and length of the half-cells. In this article, the tuning method and results of the PEFP low-beta dumbbells have been presented.

• Asian Journal of Atmospheric Environment
• /
• 제12권1호
• /
• pp.47-58
• /
• 2018

The aim of this work is to investigate the effect of atmospheric stability on near-field pollutant dispersion from rooftop emissions of a single cubic building using computational fluid dynamics (CFD). This paper used the shear stress transport (here after SST) k-${\omega}$ model for predicting the flow and pollutant dispersion around an isolated cubic building. CFD simulations were performed with two emission rates and six atmospheric stability conditions. The results of the simulations were compared with the data from wind tunnel experiments and the result of simulations obtained by previous studies in neutral atmospheric condition. The results indicate that the reattachment length on the roof ($X_R$) obtained by computations show good agreement with the experimental results. However, the reattachment length of the rooftop of the building ($X_F$) is greatly overestimated compared to the findings of wind tunnel test. The result also shows that the general distribution of dimensionless concentration given by SST k-${\omega}$ at the side and leeward wall surfaces is similar to that of the experiment. In unstable conditions, the length of the rooftop cavity was decreased. In stable conditions, the horizontal velocity in the lower part around the building was increased and the vertical velocity around the building was decreased. Stratification increased the horizontal cavity length and width near surface and unstable stratification decreased the horizontal cavity length and width near surface. Maintained stability increases the lateral spread of the plume on the leeward surface. The concentration levels close to the ground's surface under stable conditions were higher than under unstable and neutral conditions.

• 한국수산과학회지
• /
• 제56권3호
• /
• pp.324-330
• /
• 2023

We investigated the relative growth and squamation of larvae and juveniles of cultured Larimichthys polyactis. Analysis of the relative growth of larvae and juveniles showed that their preanal length, head length, eye diameter, body depth, and snout length increased with growth. There was no significant chage in the relative growth. The ratio of preanus length to standard length (SL) increased rapidly until SL was approximately 12 mm, and then increased gradually. Cycloid scales first appeared on the lateral line, progressed to the abdominal cavity at 15.13 mm SL, and expanded to the occipital region, base of pectoral fin, and ventral region of the eye at 17.82 mm SL. At 18.03 mm SL, scales formed on the cheek, and those at the base of pectoral fin and in the abdominal cavity were connected to each other. At 19.06 mm SL, major part of the head was covered by scales, except near the lower jaw. Cycloid scales on the lateral line changed to ctenoid scales at the range of 31.71-32.24 mm SL, and those on the nape changed at the range of 69.02-70.84 mm SL. Our results may help to establish conservation and management strategy for Larimichthys polyactis aquaculture.

• 한국광학회지
• /
• 제8권3호
• /
• pp.230-235
• /
• 1997

광섬유의 단면을 적절한 곡률의 곡면으로 가공함으로써 종래 구조에 비해 우수한 특성의 광섬유 Fabry-Peror(FP)간섭 필터를 제작할 수 있음을 이론적으로 분석하였다. 광섬유 단면의 가공된 오목거울의 곡률은 계단형 단일모드 광섬유의 도파모드를 Gaussian빔으로 가정했을 때 광섬유에서 나와 일정거리의 자유공간을 진행한 빔의 파면의 곡률과 일치하여야 하며, 이때 거울의 기울기 0.2.deg., 곡률오차 70.mu.m, 공극거리 오차 8.mu.m, 광축의 횡편차 0.5.mu.m이내의 범위에서 이상적인 배치를 벗어난 경우에도 광섬유간의 거리가 15.mu.m일 때 0.5%이하의 결합손실을 가져 종래에 비해 훨씬 간단한 새로운 구조의 광섬유 FP필터가 제작될 수 있음을 확인하였다. 마지막으로 곡면가공된 광섬유 단면의 간섭파형을 통하여 광섬유 단면을 의도된 구조로 가공할 수 있음을 보였다.

• 한국지반공학회논문집
• /
• 제27권1호
• /
• pp.5-16
• /
• 2011

본 연구에서는 3차원 유한요소해석을 이용하여 석회공동형성 암반에 시공된 말뚝기초의 하중지지 메카니즘 변화를 분석하였다. 이를 위하여 공동의 기하학적 조건을 변화시키며 말뚝기초의 극한지지력, 지반의 항복형태, 말뚝과 공동 주위의 응력분포 및 말뚝기초의 침하와 공동의 변형 등 해석결과를 고찰하여 말뚝기초의 역학적 거동을 검토하였다. 본 연구결과, 말뚝의 하중지지 메카니즘, 지반의 파괴형태 및 말뚝기초의 극한지지력 감소율은 공동의 기하조건에 의해 결정되며 이러한 경향을 토대로 공동의 특정조건에 대한 말뚝의 극한지지력 감소율 그래프를 제시하였다.