• Transactions of the Korean Society of Automotive Engineers
• /
• v.11 no.3
• /
• pp.71-76
• /
• 2003

A numerical simulation of selective catalytic reduction (SCR) for NO with $NH_3$ is conducted over the $V_2O_5/TiO_2$ and $WO_3-V_2O_5/TiO_2$ catalysts. The governing $NH_3$ and NO transport equations are considered by using the time-dependent FCT (Flux-Corrected Transport) algorithm. After a validating simulation for $NH_3$ step feed and shut-off experiments is analyzed, transient behavior of $NH_3$ and NO concentration in a SCR catalyst is investigated by changing such parameters as inflow $NH_3$ concentration, temperature of the catalyst, and $NH_3$/NOx ratios.

• Journal of the Korean Applied Science and Technology
• /
• v.17 no.2
• /
• pp.113-119
• /
• 2000

Alkylation of phenol with tert-butanol in the liquid phase on mordenite was studied. The influence of many reaction parameters such as calcination temperature, reaction temperature, t-butanol/phenol molar ratio on catalytic properties was discussed. The main products were 2,4-di-t-butylphenol, o-t-butylphenol, p-t-butylphenol, the last of these was wanted product. In order to enhance the selectivity of p-t-butylphenol, optimum conditions were recommended at $500^{\circ}C$ calcination temperature, $140^{\circ}C$ reaction temperature, 1.0 molar ratio of reactants over mordenite. P-t-butylphenol was formed with 90% isomer selectivity at optimum conditions after 4hr reaction. On the basis of the behavior obtained in the cases mentioned, optimum conditions and catalytic properties for t-butylation of phenol were provided.

• Journal of environmental and Sanitary engineering
• /
• v.14 no.2
• /
• pp.113-119
• /
• 1999

In this study, the incineration of MEK and toluene was studied on a Pt supported alumina catalyst at temperature range from 200 to $350^{\circ}C$. An approach based on the Mars-van Krevelen rate model was used to explain the results. The object of this study was to study the kinetic behavior of the platinum catalyst for deep oxidation. The conversions of MEK and toluene were increased as the inlet concentration was decreased and the reaction temperature was increased. The maximum deep conversion of MEK and toluene were 91.81% and 55.69% at $350^{\circ}C$, respectively. The ${\kappa}_3$ constant increases with temperature faster than the ${\kappa}_1$ constant, that is, the surface concentration of ($VOCs{\cdots}O$) is higher than that of (O) at higher temperature according to the Mars-van Krevelen mechanism. Also the activation energy of toluene was larger than MEK for toluene is aromatic compound which have stronger bonding energy.Therefore, the catalytic incineration kinetics of MEK and toluene with Mars-van Krevelen mechanism could be used as the basic data for industrial processes.

• Bulletin of the Korean Chemical Society
• /
• v.35 no.4
• /
• pp.1091-1097
• /
• 2014

Tageteserecta flower like zinc oxide nanostructures composed of hexagonal nanorods were synthesized via sonochemical method at room temperature. The synthesized nanomaterials exhibited wurtzite hexagonal phase structure with the single crystalline nature. The diameter of the individual nanorods that constitute the flower shaped zinc oxide structures is in the range of 120-160 nm. The sonication time effectively determined the morphological properties of the prepared materials. The catalytic activity of prepared zinc oxide nanostructures towards N-formylation reactions were evaluated without any surface modification and the nanostructures exhibited good reaction yield with the prompt recyclability behavior.

• Journal of the Korean Chemical Society
• /
• v.11 no.1
• /
• pp.38-43
• /
• 1967

In order to explain the positive catalytic action of copper compound for the rate of leaching of zinc sulfide minerals, the electrode and redox potentials of both synthetic and natural sulfides were measured at various conditions of temperatures and pressures. The potentials of Chalcopyrite and copper sulfide were considerably higher than that of zinc sulfide, whereas lead sulfide and Galena had slightly lower potentials than that of zinc sulfide. At elevated temperatures and pressures, the same tendency was obtained. By means of comparing the calculated and measured values of potentials for sulfides, it was suggested that the electrode potentials in acid solution were generated by oxidation of sulfur ion. As a result, it was concluded that the catalytic action of copper compound in the leaching of synthetic zinc sulfide should be arised from the galvanic action between sulfides keeping intimate contact one another in which copper sulfide worked as cathodic and zinc sulfide as anodic part analogous to the metal corrosion under galvanic action.

• Proceedings of the Korean Society of Propulsion Engineers Conference
• /
• 2004.03a
• /
• pp.111-116
• /
• 2004

An experiment was carried out to confirm the validity of time series evaluation of supersonic mixing condition by using catalytic reaction on a platinum wire. Geseous hydrogen was injected parallel to supersonic freestream (M$\infty$ $\approx$ 1.81) from a slit injector, which was located at backward facing step. Time series condition of supersonic mixing was evaluated by using W-type probe which has a platinum wire and reference wire (nickel wire). The evaluation was by simultaneously measuring each electric circuit which kept the temperature of wire constant. Investigations were also conducted for helium, air and no secondary injectant cases to compare with the hydrogen injectant case. The results indicated that it was possible to measure the time series behavior of air and hydrogen supersonic mixing layer or coherent motion of turbulence by using this evaluation.

• Applied Chemistry for Engineering
• /
• v.18 no.3
• /
• pp.255-261
• /
• 2007

The catalytic behavior of the manganese oxides was studied for the selective catalytic reduction with ammonia at a low temperature condition under $200^{\circ}C$. Outlet unreacted ammonia increases with decreasing temperature and increasing $NH_3/NOx$ mole ratio, however $NO_2$ shows an opposite result. $NO_2$ is generated by the adsorption of NO on the catalyst and the following oxidization to nitrates. Unreacted NH3 slip is not observed even at the $NH_3/NOx$ feed ratio above 1.0 due to the reaction between formed nitrates on the catalyst and adsorbed ammonia. The addition of Zr increases $NO_2$ generation, whereas the addition of CeO2 on the catalyst decreases $NO_2$ generation. Furthermore, the additon of the metal oxide induce DeNOx efficiency to reduce.

• Advances in nano research
• /
• v.12 no.3
• /
• pp.291-300
• /
• 2022

The behavior of hydrogen species on the surface of the catalyst during the Lewis acid transformation to form Brønsted acid sites over the spherical silica-supported WO_x catalyst was investigated. To understand the structure-activity relationship of Lewis acid transformation and hydrogen bonding interactions, we explore the potential of using the in situ diffuse reflection infrared Fourier transform spectroscopy (DRIFTS) with adsorbed ammonia and hydrogen exposure. From the results of in situ DRIFTS measurements, Lewis acid sites on surface catalysts were transformed into new Brønsted acid sites upon hydrogen exposure. The adsorbed NH₃ on Lewis acid sites migrated to Brønsted acid sites forming NH⁴⁺. The results show that the dissociated H atoms present on the catalyst surface formed new Si-OH hydroxyl species - the new Brønsted acid site. Besides, the isolated Si-O-W species is the key towards H-bond and Si-OH formation. Additionally, the H atoms adsorbed surrounding the Si-O-W species of mono-oxo O=WO₄ and di-oxo (O=)₂WO₂ species, where the Si-O-W species are the main species presented on the Inc-SSP catalysts than that of the IWI-SSP catalysts.

• Applied Chemistry for Engineering
• /
• v.26 no.2
• /
• pp.154-158
• /
• 2015

In this study, the catalytic activity of ${\gamma}-Al_2O_3$ was investigated for the decomposition of $NF_3$. Reactions for $NF_3$ decomposition were carried out in the range of reaction temperature of $330{\sim}730^{\circ}C$ and GHSV of $3,000{\sim}15,000mL/g-cat{\cdot}h$ in a fixed-bed catalytic reactor system. Thermal decomposition of $NF_3$ was also performed in order to compare with the catalytic decomposition of $NF_3$. The conversion of $NF_3$ by the catalytic decomposition at $400^{\circ}C$ was four times higher than that of the thermal decomposition. It was confirmed that the reaction behavior of $NF_3$ over ${\gamma}-Al_2O_3$ exhibited two reaction pathways in the presence of steam. Fluorine in $NF_3$ over ${\gamma}-Al_2O_3$ was chemically absorbed to $AlF_3$ by the gas-solid reaction in the absence of steam. The catalytic decomposition of $NF_3$ occurred by hydrolysis with steam. It was also confirmed by FT-IR analysis that $NF_3$ was completely decomposed to NOx and HF above $500^{\circ}C$.

• Applied Chemistry for Engineering
• /
• v.29 no.3
• /
• pp.350-355
• /
• 2018

In this study, the effect of biomass torrefaction on the thermal and catalytic pyrolysis of cork oak was investigated. The thermal and catalytic pyrolysis behavior of cork oak (CO) and torrefied CO (TCO) were evaluated by comparing their thermogravimetric (TG) analysis results and product distributions of bio-oils obtained from the fast pyrolysis using a fixed bed reactor. TG and differential TG (DTG) curves of CO and TCO revealed that the elimination amount of hemicellulose in CO increased by applying the higher torrefaction temperature and longer torrefaction time. CO torrefaction also decreased the oil yield but increased that of solid char during the pyrolysis because the contents of cellulose and lignin in CO increased due to the elimination of hemicellulose during torrefaction. Selectivities of the levoglucosan and phenolics in TCO pyrolysis oil were higher than those in CO pyrolysis oil. The content of aromatic hydrocarbons in bio-oil increased by applying the catalytic pyrolysis of CO and TCO over HZSM-5 ($SiO_2/Al_2O_3=30$). Compared to CO, TCO showed the higher efficiency on the formation of aromatic hydrocarbons via the catalytic pyrolysis over HZSM-5 and the efficiency was maximized by applying the higher torrefaction and catalytic pyrolysis reaction temperatures of 280 and $600^{\circ}C$, respectively.