• Journal of the Korean Geotechnical Society
• /
• v.37 no.4
• /
• pp.39-47
• /
• 2021

Recently, the enzyme-induced carbonate precipitation (EICP) technique has been considered as one of the alternatives to the cement-based soil reinforcing method. However, the problem with the emission of ammonium ion has not been solved. In this study, an experimental study on the EICP without releasing an environmental contaminant (Ze-EICP) is performed using calcium-exchanged zeolite. The results show that the Ze-EICP using calcium-exchanged zeolite reduced the amount of ammonium ions by 96.96% and precipitated almost the same amount of calcium carbonate, compared to the EICP using calcium chloride. In addition, the Ze-EICP shows higher strength improvement rate than the EICP due to densification of zeolite and cementation of calcium carbonate.

• Journal of the Korean Ceramic Society
• /
• v.33 no.11
• /
• pp.1276-1284
• /
• 1996

Ultrafine calcim carbonate powders with the size of 0.05~0.1 ${\mu}{\textrm}{m}$ and the calcite phase were prepared by the nozzle spouting method which was conducted by spouting calcium hydroxide slurry in reactor filled with CO2 gas. Well dispersed ultra-fine particles were synthesized in condition of high Ca(OH)2 concentration of the slurry ( 0.5wt%) synthesized calcium carbonate powder was shown the large particle size with agglo-meration.

• Journal of Life Science
• /
• v.17 no.12
• /
• pp.1701-1708
• /
• 2007

Seed pelleting is generally conducted in order to save the labor for sowing and thinning by enabling the precision mechanical planting. In the present study, the influence of physical and chemical properties of pelleting solid materials was investigated on carrot seed germination. Among the pelleting solid materials evaluated, dialite, kaolin, and talc showed low bulk density and high porosity. Bentonite and dialite carried high water holding capacities of 184% and 173%, respectively, while calcium carbonate, calcium oxide, and fly ash showed relatively low water holding capacity. The pH of kaolin (6.8) and dialite (7.4) were close to neutral, while limestone (12.8), calcium oxide (13.0), and bentonite (10.0) were highly basic. High electro-conductivity was shown in limestone and calcium oxide. EDS analysis revealed that the main elemental compositions of talc were Si (71.0%) and Mg (29.0%), and those of calcium carbonate were Ca (66.6%), Si (22.9%), and Mg (10.5%). High granulation capacity was observed from talc and the mixture of talc and calcium carbonate. Seeds pelleted with bentonite showed the highest hardness. The dissolving type of the pellet layer after imbibition was split type in talc, limestone, zeolite, and fly ash, melt type in calcium carbonate and calcium oxide, and swell type in bentonite and vermiculite. The shortest dissolving time of pellet layer was observed from calcium carbonate and kaolin. The germination speed $(T_{50})$ was delayed as the size of pelleted seeds increased. The optimum size of pelleting was 19 ratio in carrot.

• Journal of the Korean Wood Science and Technology
• /
• v.20 no.4
• /
• pp.57-64
• /
• 1992

The unique cell wall micropores of pulp fiber can be utilized as loading site in variety of important practical application which could be the basis of new papermaking technologies. One of these includes the manufature of paper containing higher levels of in situ filler precipitated. Hardwood pulp fiber were first impregnated with the solution of sodium carbonate($Na_2CO_3$). The micropores in cell wall of pulp fibers were filled with the liquid salt solution. The second calcium nitrate($Ca(NO_3)_2$) solution formed an insoluble calcium carbonate($CaCO_3$) precipitate within the cell wall micropores by interacting with the first sodium carbonate solution. The effects of chemical concentration and dryness of pulp fibers on the retention of cell wall micropore loaded filler were investigated. The paper properties of cell wall micropore loaded pulp fibers were compared with those of conventionally loaded and lumen loaded pulp fibers. Also the presense of the fillers within the cell wall micropore was observed by SEM. Increasing the chemical concentration to generate the calcium carbonate increased the retention of filler in cell wall micropore loaded pulp fibers. The particle size distribution of precipitated calcium carbonate ranged from $0.1{\mu}m$ to $80{\mu}m$. But, the average particle size of cell wall micropore loaded calcium carbonate was $4{\mu}m$. The paper made from never dried pulp fibers, the cell wall micropores which were filled with calcium carbonate, had better mechanical and optical properties than those of conventionally loaded or lumen loaded pulp fibers.

• Applied Chemistry for Engineering
• /
• v.3 no.3
• /
• pp.522-526
• /
• 1992

Carbonation process of an aqueous solution of $Ca(OH)_2$ with $CO_2$ gas at $10^{\circ}C$ has been studied to investigate the formation and transformation processes of amorphous calcium carbonate. It was suggested that the amorphous calcium carbonate consisting of spherical particles with the diameter in the range of $0.02{\sim}0.05{\mu}m$ be a non-stoichiometric $CaCO_3$ phase containing small amounts of $H_2O$ and small incorporations of $HCO^-_3$. Amorphous $CaCO_3$ is unstable in the aqueous solution and converts to calcite, and its morphology depends on the carbonate species present in the slurry such that with [$CO_3^{2-}$] prevailing, chain-like calcite composed of ultrafine colloidal particles and with [$HCO^-_3$] prevailing, rhombohedral particles of calcite are formed respectively. Therefore, morphological control of calcium carbonate crystals could be expected by the adequate controls of transformation process of the amorphous calcium carbonate.

• Food Science and Preservation
• /
• v.7 no.1
• /
• pp.19-22
• /
• 2000

This study was carried out investigate the storability of onions on calcium spraying, after cutting foliage, 6 different treatemnt , the dilution spraying of calcium nitrate 9 3%, 6%) , calcium carbonate(3%, 6%), dust scattering and the controls were evaluated for rotting, sprouting, healthy bulb and total weight loss ratio during storage. Rotting ratio on the dilution spraying of 6% calcium carbonate was lower than that of the control after 4 months storage by 16.7%. Sprouting and total weight loss were decreased in the dilution spraying of 6% calcium carbonate.

• Journal of the Korean Society of Food Science and Nutrition
• /
• v.16 no.1
• /
• pp.42-47
• /
• 1987

The present studies were undertaken to prepare calcium acetate from sea-mussel shell and then, to investigate the calcium absorption ratio for calcium acetate by using young albino rate male. Purities such as chloride, nitrate, nitrate, sulfate, phosphate and heavy metal passed to test as reagent grade and calcium acetate assay was 99.0%. No significant differences in the body weight gain between calcium acetate group, calcium gluconate group and calcium carbonate group were not recognized. Diet consumptions of calcium acetate group was almost similar with calcium gluconate group and calcium carbonate group. It was found that absorption rate of calcium acetate was $57.68{\pm}0.83%,\;58.08{\pm}0.94%$ and was $2.0{\sim}3.0%$ high than calcium gluconate and calcium carbonate group.

• Korean Chemical Engineering Research
• /
• v.59 no.1
• /
• pp.118-126
• /
• 2021

The experiments to produce the vaterite type calcium carbonate were conducted for using the waste oyster shell as the recycling resources. Firstly, the oyster shell were calcinated at 800 ℃ for 24 h. Calcinated oyster shell were reacted with the nitric acid solution, and were diluted to 0.1 M Ca(NO3)2 solution. This solution was mixed with 0.1 M Na2CO3 contained 0.1 mol lysine/1 mol CaO at 20 ℃ and 600 rpm mixing condition for 1 h. The reaction products were identified to vaterite type calcium carbonate (84.5% vaterite, 15.5% calcite) by XRD and SEM analysis. Mean particle diameter was 6.87 ㎛, and the lysine content in calcium carbonate was analyzed to 0.1%.

• The Sea:JOURNAL OF THE KOREAN SOCIETY OF OCEANOGRAPHY
• /
• v.24 no.3
• /
• pp.389-399
• /
• 2019

The calcium carbonate saturation state in the Ulleung Basin of East Sea was calculated using bottle data set of pH, dissolved inorganic carbon and total alkalinity obtained from the year 1999, 2014, 2017, and 2018 cruise. In the 2010s calcium carbonate saturation state was significantly lowered at all depth compared to the 1999 reference state. Accordingly calcite saturation horizon and aragonite saturation horizon shoaled to 500 m and 200 m, respectively. A key chemical species for the calcium carbonate saturation state, carbonate ion showed distinctive profile between upper and deep waters: it is moderately high (${\sim}175{\mu}mol\;kg^{-1}$) in upper waters and very low (< ${\sim}50{\mu}mol\;kg^{-1}$) in the deep waters. However the decreasing trend of carbonate ion concentration was pronounced in the upper water than deep waters, suggesting atmospheric $CO_2$ penetration is largely confined to the upper waters in the 2000s.

• Bulletin of the Korean Chemical Society
• /
• v.28 no.3
• /
• pp.457-462
• /
• 2007

Amorphous calcium carbonate (ACC) can readily be prepared using ethanol as the reaction medium and ammonium carbonate as the source of carbon dioxide. Other additives, or any elaborate pH control are not needed to form the initial calcium carbonate precipitate. Ammonia generated from ammonium carbonate maintains the reaction medium in a neutral or weakly basic condition, retarding the crystallization of ACC, while ethanol itself inhibits the dissolution of ACC. The ACC prepared in this way provides a rare opportunity to fabricate molded biomimetic crystals in vitro, but the ACC is too fragile to be fabricated into proper shapes. The malleability of ACC is, however, greatly enhanced by incorporating poly(ethylenimine) (PEI). The ACC/PEI composite can then be fabricated, using a proper mold or template, into mechanically durable biomimetic crystals of definite shape. The ACC in the ACC/PEI composite can further be transformed into vaterite by heating under N2 atmosphere, while the native ACC simply converts into calcite.