• Proceedings of the Korean Geotechical Society Conference
• /
• 2003.03a
• /
• pp.725-732
• /
• 2003

It was achieved that Rowecell test for this undisturbed sample was picked by Block sampler($\phi$:250mm, L:500mm) and hydraulic piston sampler($\phi$:76mm, L:850mm) in the marine clay of YONGYUDO and YEONGJONGDO in this research. Ratio of coefficient of consolidation was analyzed through comparison with C$\_$h/ by CPTu and C$\_$v/ and C$\_$h/ by existent consolidation test. According to analysis, coefficient of consolidation of block sample is fairly greater than coefficient of consolidation of piston sample. And the bigger diameter of undisturbed sample, sample disturbance could know decreasing. Coefficient of consolidation by Rowecell test measured more greatly than coefficient of consolidation by existent consolidation test. Rowecell test could know decreasing consolidation rate because of smear effect by Mandrel injection. Also, C$\_$h/ by CPTu shows deviation by each analysis method, selection of suitable analysis method judged by important leading in the coefficient of consolidation.

• Proceedings of the Korean Geotechical Society Conference
• /
• 2000.03b
• /
• pp.309-316
• /
• 2000

When highly compressible, clayey soil layers lies at a limited depth and large consolidtion settlements are expected as the result of construction, precompression of soil may be used to minimize postconstruction settlement. In this study, we tried to find the possibility about the effect of ground improvement using flat dilatometer at the Inchon International Airport where preloading was installed. Field and laboratory tests were performed for soft ground before and after preloading in order to check the effectiveness of the soft ground improvement and compared with the test results of dilatometer which obtained before and after preloading at the same location Field tests such as flat dilatometer, vane, CPTu tests were performed before and after preloading and undisturbed samples are obtained to carry out laboratory tests. As comparing results, after preloading, unit weight, effective stress, undrained shear strength were increased and we can also check the decrease of consolidation late caused of decrease of void ratio. Furthermore, it is assumed that the possibility on the effect of ground improvement by using the flat dilatometer

• Proceedings of the Korean Geotechical Society Conference
• /
• 2008.03a
• /
• pp.619-627
• /
• 2008

In this study, through dissipation test of DMT predicted Horizontal Coefficient of Consolidation at marine clay. CPTu Dissipation test, laboratory consolidation test compared with $C_v$, through it examined application. The result, DMT calculated horizontal coefficient of consolidation by $P_2$-Log(t) method of DMT-A method and C-$\surd$t(min) method. This horizontal coefficient of consolidation calculated larger than $P_2$-Log(t) method. $P_2$-Log(t) method of DMT, Torstensson of CPTu and Houlsby & Teh(1991) appeared similar to tend. This approximate value is possible application in marine clay. It'll need to study continuously through collection of data.

• Proceedings of the Korean Geotechical Society Conference
• /
• 1997.10a
• /
• pp.229-236
• /
• 1997

• Geotechnical Engineering
• /
• v.24 no.9
• /
• pp.27-35
• /
• 2008

• Journal of the Korean Geotechnical Society
• /
• v.17 no.6
• /
• pp.15-24
• /
• 2001

In order to evaluate undrained shear strength of clayey soils using Piezocone Penetration Test (CPTu), piezoncone factor is utilized. Commonly, piezoncone factors determined by empirical basis were preferred, which were established by correlation between measurements of piezocone test and undrained strengths obtained from other shearing tests. However, previous studies on the empirical piezocone factors were site-specific and there have been no systematic investigations on the effect of both engineering characteristics of clayey soils and soil non-homogeneity on the piezocone factor. Accordingly, the direct application of the previous results to Korean clayey soils without verification may be inappropriate. In this study, empirical piezocone factors are evaluated by comparing 46 CPTu results of 10 test sites with undrained shear strength obtained from Field Vane Test (FVT) and laboratory triaxial tests. Their reliabilities are investigated by the comparison with the previous piezocone factors and the deviation of data distribution from the mean values. And the effects of referencing test methods and typical engineering characteristics of clayey soils such as overconsolidation ratio (OCR) and plastic Index (I$_{p}$) are examined. Because piezocone factors obtained for various soil conditions are widely distributed, it is not appropriate to use the mean value as a representative. Instead, it is recommended to apply the piezocone factors with OCR, which is found to be a major factor in deriving piezocone factor. The necessitated piezocone factors are presented.d.

• Journal of the Korean Geotechnical Society
• /
• v.32 no.9
• /
• pp.17-27
• /
• 2016

Parial drainage characteristics of clayey silt with low plasticity from the west coast (Incheon and Hwaseong) was analyzed using CPTU based existing correlation equations and compulsory replacement method. Generally, the estimated $OCRs={\kappa}{\cdot}((q_t-{\sigma}_{vo})/{\sigma}^{\prime}_{vo})$ using Powell and Quartman(1988) were higher than those obtained by the oeodometer tests. These trends were noticeable for the layers containing a lot of silty and sand soils. The assessment of partial drainage conditions was performed through Schnaid et al. (2004)'s equation; it is based on plotting the normalized cone resistance, $Q_t$ versus the pore pressure parameter, $B_q$ in combination with the strength incremental ratio, $s_u/{\sigma}^{\prime}_{vo}$ to the CPTU data. It is evident that more than half of the data fall in the range where $B_q$ < 0.3, corresponding to the domain in which the partial drainage prevails when testing normally consolidated soils at a standard rate of penetration (2 cm/s). To estimate the replacement depth of clayey silt with low plasticity, back analysis was carried out to evaluate the internal friction angle based on where the design depths are equal to the checked depths using bearing capacity equation. The internal friction angels obtained from the back analysis tended to increase as the plasticity index decreases, which is ranged approximately from ${\varphi}^{\prime}=2^{\circ}$ to ${\varphi}^{\prime}=7^{\circ}$.

• Proceedings of the Korean Geotechical Society Conference
• /
• 2002.03a
• /
• pp.133-138
• /
• 2002

Several well-known soil classification charts, like made by Robertson(1986,1990), Olsen(1981), existed already. In Korea, Lee Sun-Jae(1997) made new classification chart based on Unified Soil Classification System with locality In this study, 6 classification charts were applied respective area. Even exact decision is impossible which one is correct, this study can give useful guideline.

• Proceedings of the Korean Geotechical Society Conference
• /
• 2002.03a
• /
• pp.463-468
• /
• 2002

Based on the results obtain from the investigation of Nak-Dong River District, it was classified as very thick, soft soil deposit. Furthermore, during the construction of structures large settlements are expected. Since large settlement affects the structures life, it is very important to accurately determine the consolidation of soil based on the obtained results. In this study piezocone test and laboratory test were performed to determine the consoildtion properties of Nak-Dong River District Pusan, Gyeong-Nam province. Degree of consoildation and the coefficient of consoildation obtained from the data of piezocone test and the results of the Oedometer test were compared and analyzed. Using the results the porewater pressure coefficient($B_q$) was obtained and the relationship with the Plasticity Index was also determined. From the results of this study the effects of the degree of consolidation and consolidation coefficient, and the porewater pressure coefficient and the Plasticity Index was determined.

• Journal of the Earthquake Engineering Society of Korea
• /
• v.12 no.4
• /
• pp.1-10
• /
• 2008

Shear wave velocity($V_S$), which can be obtained using various seismic tests, has been emphasized as representative geotechnical dynamic characteristic mainly for seismic design and seismic performance evaluation in the engineering field. For the application of conventional geotechnical site investigation techniques to geotechnical earthquake engineering, standard penetration tests(SPT) and piezocone penetration tests(CPTu) together with a variety of borehole seismic tests were performed at many sites in Korea. Through statistical modeling of the in-situ testing data, in this study, the correlations between $V_S$ and geotechnical in-situ penetrating data such as blow counts(N value) from SPT and piezocone penetrating data such as tip resistance ($q_t$), sleevefriction($f_s$), and pore pressure ratio($B_q$) were deduced and were suggested as an empirical method to determine $V_S$. Despite the incompatible strain levels of the conventional geotechnical penetration tests and the borehole seismic tests, it is shown that the suggested correlations in this study are applicable to the preliminary estimation of $V_S$ for Korean soil layers.